• Macromolecular Research
• /
• v.16 no.1
• /
• pp.31-35
• /
• 2008

Photoreactive polymers as a color filter resist containing both photoreactive acrylate and cinnamate double bonds were synthesized usin two step reactions. The chemical structures of the synthesized polymers were confirmed by $^1H$-NMR and FT-IR spectroscopy. The photoreactive polymers were quite soluble in most common organic solvents and produced excellent quality thin films by spin-coating. The photocuring kinetics of the acrylate and cinnamate double bonds were examined by FT-IR and UV- Vis spectroscopy, which confirmed the excellent photoreactivity of both the acrylate and cinnamate double bonds in the polymers. Upon UV irradiation, photocuring was almost completed within approximately 5 min, irrespective of the type of the prepolymers. The polymers also exhibited superior thermal stability, showing little change in transmittance in the visible region even after heating to $250^{\circ}C$ for one hour. Photolithographic micropatterns could be obtained with a resolution of a few microns.

• Macromolecular Research
• /
• v.12 no.3
• /
• pp.269-275
• /
• 2004

To graft N-isopropylacrylamide (NIPAAm) onto alginate, varying dosages of ${\gamma}$-rays were irradiated onto alginate films in deionized water and methanol media, which are non-solvents of alginate. We investigated the hydrogels graft ratio, mechanical strength, swelling kinetics and ratio, and behavior with respect to drug release. The graft yield of NIPAAm increased upon increasing the irradiation dose. The use of the aqueous solution increased the graft yield relative to that obtained in methanol. The mechanical strength of the grafted hydrogels increased after grafting with NIPAAm. In a study of the swelling kinetics, we found that all hydrogels reached an equilibrium swollen state within 3 h. The equilibrium swelling ratio of the hydrogels decreased upon increasing the irradiation dose. The swelling ratio of the hydrogels decreased dramatically between 30 and 35$^{\circ}C$ because phase separation of NIPAAm occurred at 32$^{\circ}C$. The swelling process, with respect to the temperature change, was repeatable. An NIPAAm-grafted alginate containing a drug sustained its release rate until 3 h after an initial high drug release caused by a burst effect.

• Journal of the Korean Applied Science and Technology
• /
• v.8 no.2
• /
• pp.175-181
• /
• 1991

The kinetics of the addition of 1-benzylindole-3-(p-substituted) acetophenone derivatives was investigated by ultraviolet spectrophotometery in 30% dioxane -$H_2O\;at\;25^{\circ}C$. A rate equation which can be applied over wide pH range was obtained. The Substituent effects on 1-benzylindole-3-(p-substituted) acetophenone derivatives were studied, and addition were facilitated by electron attracting groups. On the base of the rate equation, substituent effect, and general base effect the plausible addition mechanism was proposed : Below pH 3.0, only neutral thiourea molecule was added to the carbon-carbon double bond, and in the range of pH 0.0${\sim}$14.0, netural thiourea molecule and thiourea anion competitively attacted the double bond. By contrast, above pH 10.0, the reaction was dependent upon only the addition of thiourea anion.

• Korean Chemical Engineering Research
• /
• v.61 no.2
• /
• pp.273-277
• /
• 2023

The biosorption of methylene blue (MB) from aqueous solution was investigated using dried Rhodotorula glutinis as the biosorbent. The effects of pH, initial dye concentration, biosorbent dosage, and kinetic studies were determined to obtain valuable information for biosorption. Results indicated that most of the adsorbed MB bound within 30 minutes of contact and the MB adsorption capacity increased from 21.1 to 101.8 mg/g with the initial MB concentration increased from 50 to 300 mg/L. Additionally, the MB adsorption capacity gradually increased from pH 4.0 to 9.0, reaching its peak at an initial pH of 9.0. As the biomass load was increased from 0.25 to 4.0 g/L, the MB removal efficiency increased from 14.1 to 84.5%. The Langmuir model provided the best fit throughout the concentration range, and the maximum adsorption capacity (q_max) and Langmuir constant (b) were determined to be 135.14 mg/g and 0.026 l/mg, respectively. Furthermore, the biosorbent process of R. glutinis was found to follow pseudo-second-order kinetics and the calculated q_eq,cal value showed good agreement with the experimental q_eq value. Overall, the biosorption of MB by R. glutinis can be characterized as a monolayer, single site type phenomenon, and the rate-limiting step was determined to be the chemical reaction between the adsorbent and the adsorbate.

• Clean Technology
• /
• v.22 no.3
• /
• pp.154-160
• /
• 2016

For any conceivable desalination process using the gas hydrate formation, the kinetics has to be one of the most important parameters from the economic point of view. We thus were to improve the kinetics of the R-134a (also known as HFC-134a) gas hydrate formation by using promoters and three different kinds of edible surfactants were selected for the desalination process targeted to produce potable water; κ-carrageenan, lecithin, and polysorbate 80 among anionic, amphoteric, and nonionic surfactants, respectively. Then, the kinetics change of the R-134a hydrate formation was monitored by varying the surfactant concentration. Experimental results demonstrated that the rate of R-134a hydrate formation increases with the addition of edible surfactants in general and the effect as a promotor has an order of polysorbate 80 > κ-carrageenan > lecithin. As a supportive measure, the atomic charges of each surfactant were calculated by using a DFT (density functional theory)-based molecular modeling and the results showed a positive relationship between the promotor effect of each surfactant and the number of oxygens available for hydrogen bonding and the negativity of their atomic charge values.

• Journal of Microbiology and Biotechnology
• /
• v.21 no.6
• /
• pp.652-658
• /
• 2011

The growth kinetics of Streptomyces noursei NRRL 5126 was investigated under different aeration and agitation combinations in a 5.0 l stirred tank fermenter. Poly-${\varepsilon}$-lysine biosynthesis, cell mass formation, and glycerol utilization rates were affected markedly by both aeration and agitation. An agitation speed of 300 rpm and aeration rate at 2.0 vvm supported better yields of 1,622.81 mg/l with highest specific productivity of 15 mg/l.h. Fermentation kinetics performed under different aeration and agitation conditions showed poly- ${\varepsilon}$-lysine fermentation to be a growth-associated production. A constant DO at 40% in the growth phase and 20% in the production phase increased the poly-${\varepsilon}$-lysine yield as well as cell mass to their maximum values of 1,992.35 mg/l and 20.73 g/l, respectively. The oxygen transfer rate (OTR), oxygen utilization rate (OUR), and specific oxygen uptake rates ($qO_2$) in the fermentation broth increased in the growth phase and remained unchanged in the stationary phase.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.11 no.3
• /
• pp.223-229
• /
• 2006

In this study, we have conducted kinetics and modelling studies of Centella asiatica cell growth and substrate uptake, in an attempt to evaluate cell growth for a better understanding and control of the process. In our bioreactor cultivation experiment, we observed a growth rate of 0.18/day, a value only 20% higher than was seen in the shake flask cultivation trial. However, the observed maximum cell dry weight in the shake flask, 10.5g/L, was 14% higher than was achieved in the bioreactor. Ninety seven percentage confidence was achieved via the fitting of three unstructured growth models; the Monod, Logistic, and Gompertz equations, to the cell growth data. The Monod equation adequately described cell growth in both cultures. The specific growth rate, however, was not effectively predicted with the Logistic and Gompertz equations, which resulted in deviations of up to 73 and 393%, respectively. These deviations in the Logistic and Gompertz models may be attributable to the fact that these models were developed for substrate-independent growth and fungi growth, respectively.

• Bulletin of the Korean Chemical Society
• /
• v.26 no.2
• /
• pp.260-264
• /
• 2005

The nature of the active site of Tobacco acetohydroxyacid synthase (AHAS) in the substrate- and cofactorbinding was studied by kinetics and fluorescence spectroscopy. The substrate saturation curve does not follow Michaelis-Menten kinetics at different temperatures (7, 21 and 37 ${^{\circ}C}$), pH (6.5, 7.5 and 8.5) and buffers (Tris-HCl and MOPS). The concentration of one half of the maximum velocity ($S_{0.5}$) decreased in the following order: pyruvate $\gt$ ThDP $\approx$$Mg^{+2}$ $\gt$ FAD. However, the catalytic efficiency (K$_{cat}/S_{0.5}$) inversely decreased in the following order; FAD $\gt$ $Mg^{+2}$ $\approx$ThDP $\gt$ pyruvate, indicating that the cofactors by in decreasing order; FAD, $Mg^{+2}$, ThDP, affect the catalysis of AHAS. The dissociation constant ($K_d$) of the intrinsic tryptophan fluorescence decreased with the same tendency of the concentration of one half of the maximum velocity ($S_{0.5}$) decreasing order. This data provides evidence that the substrate and cofactor binding natures of the active site, as well as its activation characteristics, resemble those of other ThDP-dependent enzymes.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.5
• /
• pp.726-736
• /
• 2004

In this paper, kinetics of reaction between Bromophenol blue (BPB) and $OH^-$, called fading, has been studied through a spectrophotometric method in the presence of nonionic Triton X-100 (TX-100), anionic sodium dodecyl sulfate (SDS) and cationic dodecyl trimethylammonium bromide (DTAB) surfactants. The influence of changes in the surfactant concentration on the observed rate constant was investigated. The results are treated quantitatively by pseudophase ion-exchange (PPIE) model and a new simple model called "classical model". The binding constants of BPB molecules to the micelles and free molecules of surfactants, their stoichiometric ratios and thermodynamic parameters of binding have been evaluated. It was found that SDS has nearly no effect on the fading rate up to 10 mM, whereas TX-100 and DTAB interact with BPB which reduce the reaction rate. By the use of fading reaction of BPB, the binding constants of SDS molecules to TX-100 micelles and their Langmuir and Freundlich adsorption isotherms were obtained and when mixtures of DTAB and TX-100 were used, no interaction was observed between these two surfactants.

• Resources Recycling
• /
• v.11 no.4
• /
• pp.37-43
• /
• 2002

As the consumption of galvanized steels in cans and automobiles and the quantity of scraps increase, the recycling problems of EAF dust become a important problem. Valuable metals such as Fe, Zn, Pb are of continued interest to metallurgists. To recover the valuable metal and to remove the toxicity of EAF dust, high temperature smelting process is or researching as a pilot scale. The Reduction kinetics of Zn in EAF dust is so important in a view of the economic consideration of the process. In this study, the kinetics behavior of Zn in EAF dust were measured as a point of application in high temperature smelting process. The rate control step in ZnO and franklinite is revealed to be chemical reaction on the reaction surface.