• Journal of environmental and Sanitary engineering
• /
• v.21 no.3 s.61
• /
• pp.37-43
• /
• 2006

Recently, needs for reuse of sludge produced from WTP(water treatment plant) have been increased with shortage of landfill sites and difficulties of the treatment and disposal processes. Therefore, Reusing is becoming an Increasingly popular waste management alternative to divert waste from landfills. In order to research the characteristics of WTP sludges, we used the sludges of C WTP which intake the lake Dae-Cheong and the sludges of S WTP which intake Keum river, The specific surface area of C and S WTP sludges were $0.9986m^2/cc\;and\;1.874m^2/cc$, respectively. The gravity was about $2.0{\sim}2.4$ which are scope of peat or loamy clay. The major minerals of C WTP sludges were kaolinite(48.4%), muscovite(19.5%), and quartz(16.7%). Also, muscovite(31.6%), quartz(30.3%), and kaolinite(17.3%) in S WTP sludges were major minerals.

• Journal of Environmental Health Sciences
• /
• v.8 no.2
• /
• pp.13-31
• /
• 1982

Factors affecting on dewatering characteristics of anaerobically digested or/and elutriated sludges were examined from 15 January 1982 to 30 April 1982, results obtained were as follows 1. Sludges, either anaerobically digested or/and elutriated sludges, which were produced at the Joong Rang Cheon Sewage Treatment Plant wore found to be compressive in its nature, coefficient of compressibility ranged from 0.83 for unelutriated and 1.10 for elutriated. 2. Dosage of FeC13 for the anaerobically digested sludges were difficult to establish for the most favorable dosage rate, though the filterability indicated linear improvement with increased dosage from dosing rate excess of over 15% in terms of dry solids by weight, under the conditions of this examination. Optimum filterability were obtained with 9~11% of $FeCl_3$ for elutriated sludges, and required CaO, as aids, were appeared to be 2.5~3.5 times that of the $FeCl_3$ at that point by weight. 3. The specific resistances for anaerobically digested sludges showed higher value than the elutriated one, being $11 \times 10^{12} ~ 20 \times 10^{12}$ cm/g with no chemical conditioning, and $2 \times 10^{12} ~ 11 \times 10^{12}$ cm/g with conditioned ($FeCl_3$ + CaO) contrast to $0.5 \times 10^{12} ~ 2.0 \times 10cm/g$ for the elutriated. 4. The strength of the alkalinities before and after elutriation were measured to 10,000 ~ 15,000 mg/l and 1,500 ~ 2,000mg/l respectively. These alkalinities affected greatly on the filterabilities together with concentration of the organic matters in the sludges. 5. The yields with 11% $FeCl_3$, by weight to the DS, on the elutriated sludges averaged to $14.7 kg/m^2.hr$, and $3.2kg/m^2.hr$ for unelutriated sludges. Which was 4.6 times of not elutriated sludges. Elutriated sludges without chemical conditioner added showed much better filterabilities than with 15% of $FeCl_3$ added to the anaerobically digested and unelutriated sludges.

• Journal of Environmental Health Sciences
• /
• v.31 no.1
• /
• pp.86-93
• /
• 2005

Because generally large amount of sludges are generated from the process of sewage and wastewater treatment, the management and controlment of those sludge has become a important issue in many researches. In this dissertation, we conducted the research to see the physico-chemical characteristics of sludges generated from various sources. Moisture of sludges were 81.5% in textile industries, 81.4% in frame metal industries, 80.7% in 1st metal industries. Volatile solid were 22.1% in hide · rubber industries, 21.9% in coke · petroleum industries. Fixed solid were 18.5% and 17.7% in the 1st metal industries and frame metal industries. High heating value by wet base were 1,850 kcal/kg in coke · petroleum industries, 1,220 kcal/kg in hide · rubber industries, but sludges from the 1st metal industries and frame metal industries were impossible to incinerate because most of those sludges were inorganic. The leaching test showed that hazardous materials was detected in nearly every kinds of sludges. Some of sludges from hide · rubber industries and frame metal industries exceeded the leaching criteria and so they were classified as specific wastes. And other sludges generated in sewage treatment plants or other industries was below the leaching criteria.

• 한국연소학회:학술대회논문집
• /
• 2006.10a
• /
• pp.42-45
• /
• 2006

A new and reusable energy source is water-treatment sludges. There is a significant need for understanding the characteristics of sludge combustion related to improving efficiency and ensuring the safety of this new energy source. Because sludges are composed of solids and gas mixture, the combustion of the mixture may become quite complex. Not only decomposition of conventional organic elements but also dust explosion may be important during the process of converting sludges into a new and safe form of energy. Sludge combustion mainly involves hydrogen, methane, hydro carbons, carbon, and organic particles. Dust explosion during the gasification stage may depend on the surrounding temperature and the composition of gases. The uncertainty in the explosive behavior of energetic source is noted in this work. We study the explosion characteristics of sludge combustion while the reusability of sewage sludges as a new form of energy is also investigated.

• Journal of Environmental Health Sciences
• /
• v.20 no.2
• /
• pp.14-21
• /
• 1994

This study was carried out to find out the elution characteristics of 4 kinds of sludges and a dust by the variation of pH. Four kinds of sludges were obtained from the Industrial wastes, and the dust, from the iron-and-steel waste. These samples were analyzed by "Official Method for Waste", and the results were summarized as follows. 1. The amounts of heavy metals The concentrations of Cu were 1,940

• 한국생물공학회:학술대회논문집
• /
• 2003.04a
• /
• pp.348-350
• /
• 2003

Using acclimated sludges with inorganic nitrogen medium for three months and raw sludges, we investigated characteristics of biological nitrogen removal. As results, the acclimated sludges accomplished nitrification efficiently. But raw sludges have hardly done ammonium-nitrification and there was a increasing of ammonium concentration in flask with raw sludges for established experimental period of 72 hrs.

• Journal of Microbiology and Biotechnology
• /
• v.15 no.2
• /
• pp.287-295
• /
• 2005

In order to compare bacteria] community structure and diversity in activated sludges, terminal restriction fragment length polymorphism (T-RFLP) of PCR-amplified 16s rDNAs was analyzed for 31 domestic and industrial wastewater treatment plants (WTPs). Regardless of the characteristics of the wastewaters, the bacteria] community structures of activated sludges appeared diverse and complex. In particular, activated sludges in domestic WTPs contained higher bacterial diversity than those in industrial WTPs. It was also found that terminal restriction fragment (T-RF) profiles derived from domestic WTPs were very similar with each other, although activated sludges were collected from different plants at different locations. Interestingly, activated sludges of a WTP where restaurant and toilet sewages of a company were managed showed a bacterial community structure similar to that of domestic WTPs. Activated sludges in leather industria] WTPs also showed a high similarity. However, other wastewaters possessed different bacterial communities, so that overall similarity was as low as about $30\%$. Since activated sludges from WTPs for domestic wastewaters and a company sewage appeared to hold similar bacterial communities, it was necessary to confirm if similar wastewaters induce a similar bacterial community. To answer this question, analysis of T-RFs for activated sludges, taken from another 12 domestic WTPs, was conducted by using a 6­FAM$^{TM}$-Iabeled primer and an automated DNA sequencer for higher sensitivity. Among 12 samples, it was again found that T-RF profiles of activated sludges from Yongin, Sungnam, Suwon, and Tancheon domestic WTPs in Kyonggi-do were very similar with each other. On the other hand, T-RF profiles of activated sludges from Shihwa and Ansan WTPs were quite different from each other. It was thought that this deviation was caused by wastewaters, since Ansan and Shihwa WTPs receive both domestic and industrial wastewaters. From these results, it was tentatively concluded that similar bacterial communities might be developed in activated sludges, if WTPs treat similar wastewaters.

• Journal of Environmental Science International
• /
• v.8 no.4
• /
• pp.509-514
• /
• 1999

The sewage sludges and livestock manures, respectively, were composted with sawdust used for control moisture in the static piles system composter. The variations of temperature, pH, moisture, C/N ratio, inorganic content, forms of organic materials and nitrogen, and contents of heavy metals were investigated. The results were summarized as follows ; The temperature for composting the sewage sludges reached the highest temperature of 52$^{\circ}C$, after 3 days and lasted for 7 days, and then went down 3$0^{\circ}C$ after 52 days. In the case of composting livestock manures, the temperature reached to 63$^{\circ}C$ after 10 days, that lasted for 10 days, and then went down gradually. After upsetting the sewage sludges and livestock manures for composting were decreased to 30% and 36%, respectively. The contents of inorganic matters and heavy metals were changed by the characteristics of raw materials but increased gradually during composting process. The total contents of organic materials in the sewage sludges and livestock manures for composting were decreased to 7% and 9%, respectively. The contents of ether extracts, resins, hemicellulose and cellulose were decreased but those of water soluble polysaccharides and lignins were not changed. The total contents of nitrogen in sewage sludges and livestock manures were decreased to 43% and 34%, respectively.

• Journal of Korean Society on Water Environment
• /
• v.18 no.2
• /
• pp.123-130
• /
• 2002

Bench scale experiments were carried out with two biological nutrient removal(BNR) units, A/O and $A^2O$ processes, to investigate the behavior of phosphorus in the system and to compare the characteristics of phosphorus removal in two BNR processes. To achieve this goal, COD/T-P and COD/TKN ratios of the influent was varied in the range of 23~64 and 5~24, respectively. In A/O process, influent COD/T-P ratio should be kept higher than 44mg/L to meet the final effluent T-P concentration lower than 1mg/L and in $A^2/O$ process, influent COD/T-P and COD/TKN ratios higher than 56 and 10, respectively, were required for good phosphorus release and uptake with no influence of nitrate nitrogen in return sludge. At this conditions, the rate of phosphorus release in the anaerobic basin should be kept higher than 0.1 kg S-P/kg MLVSS d In A/O process, the phosphorus content of anaerobic and aerobic sludges was increased as SRT of total system was becoming longer resulting in decreasing the difference of phosphorus content between two sludges while phosphorus release in anaerobic basin and phosphorus uptake in aerobic basin was not incident. In $A^2/O$ process, the phosphorus content of anaerobic and aerobic sludges were not increased with higher SRT of total system due to the relatively high nitrate concentration in return sludge. However, the difference of phosphorus content between anaerobic and aerobic sludges was incident when phosphorus release and uptake was observed.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.17 no.1
• /
• pp.41-47
• /
• 1981

The characteristics of septic tank sludges were investigated and the kinetic coefficients in the aerobic biodegradation were evaluated from bach treatability tests. Using an unbiased statistical method, the estimated values, k (substrate removal rate coefficient) =0. 0175hr-1 at 17\ulcornerC, K. (Michaelis Menten constant) = 248mg/ e, a (cell yield coefficient)=0.625, and Kd (cell decay coefficient:' =0. 00192hr-1 were obtained based on biodegradable COD(mg/ \ulcorner) and volatile suspended solids(mg/\ulcorner). The relationship between COD and BOD, COD (mg/\ulcorner) =2. 1 BOD(mg/\ulcorner) +250, also was established for the septic tank sludges. Dilution was inevitable for the grit removal because of the high viscosity of the sludges. An aerobic activated sludge process rather than anaerobic processes was recommended for the removal of soluble organics after the removal of grit and suspended solids. A multi-stage activated sludge process was adapted for this highly concentrated and not easily-degradable waste. It was estimated that a four-stage activated sludge process would require 40 hours retention time compared to 92 hours for a single-stage process, 52 hours for a double-stage process, and 46 hours for a three stage process in order to achieve an effluent quality of 84mg/ e COD( 40mg/ e BOD) with about 4, OOOmg/ \ulcorner MLSS from an influent quality of I, 500mg/ t COD(714mg/.e BOD), while multi-stages beyond four stage would not save the required retention time significantly.