• 태양에너지
• /
• 제19권3호
• /
• pp.23-28
• /
• 1999

본 논문에서는 난방용 축열보드에 응용하기 위해서 미세캡슐을 함유한 축열블럭의 열성능 특성을 조사하였다. 상변화 물질인 $CH_3COONa{\cdot}3H_2O$를 미세캡슐 형태로 제조하였고 미세캡슐 함유량이 각각 10%, 20%가 되도록 시멘트 몰타르와 혼합하여 축열블럭을 제작하였다. 축열블럭의 축열 및 방열 특성을 분석하기 위하여 유량과 유입 냉각 온도를 변화시켰다. 실험결과를 보면 미세캡슐 함유량이 증가할 수록 블럭에 축열되는 축열량은 증가를 하였고 방열시간도 증가를 하였다. 그리고 방열과정시 유량이 증가하고 유입 냉각온도가 감소함에 따라 방열시간은 감소하였다. 순수블럭(0% 미세캡슐 함유량)은 방열과정시 총괄 열전달 계수는 시간에 따라서 일정하게 유지를 하지만 축열블럭에서는 시간이 지남에 따라 증가를 하였다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.497-500
• /
• 2006

Masonry buildings constructed using concrete brick and cement mortar after normal Poteulranteu cement appearance, but problem of colloquial Chinese and individual crack etc. happened. Also, domestic standard abroad standard being applied mostly just as it is various kinds problem have. Therefore, purpose of this research is that wish to analyze physical special quality for Masonry individual and mortar and present pabulum that can evaluate deviation structural special quality.

• 한국농공학회지
• /
• 제17권4호
• /
• pp.3931-3942
• /
• 1975

This study was conducted to investigate the strength of soil cement for varied curing temperatures (0,10,20,30,40,50,60$^{\circ}C$) and cement content (3,6,9,12%) in four cement-stabilized soils (KY: sand, MH: sand, SS: sandy loam, JJ:loam). The experimental results obtained from unconfined compressive strength tests were as follows: 1. According to increase of curing temperature as 30,40,50, and 60$^{\circ}C$, the unconfiened compressive strength of soil cement increased, the rate of increase in the early curing period was large, and around 120 hours was suifficient curing time to complete hardening. 2. The strength at 10$^{\circ}C$ decreased to the rate of 30 to 40 percent than that of 20$^{\circ}C$ while the strength at 0$^{\circ}C$ was very small, strength of soil cement increased in cold weather unless that the temperature was below 0$^{\circ}C$ 3. The average maximum temperature, about 30$^{\circ}C$ during July and August in Korea may be recommended for a optimum construction period to increase the strength of soil cement. 4. Accelerated curing time that strength was equivalent to 28-Day norma1 curing decreased in accordance with the increase of curing temperature, and also accelerated curing decreased the effect of cement content. Accelerated curing that strength was equivalent to 28-day normal curing for soil cement of cement content 9% and temperature 60$^{\circ}C$ was 45 hours; KY, 50 hours: MH, 40 hours; SS, 34 hours; JJ. 5. According to the increase of the percent passing of No. 200 sieve, accelerated curing times became shorter to become the required stength. 6. Relation between accelerated curing times and normal curing days was showeda linear of which slope decreased in accordance with the increase of curing temperature, it may be expressed as follows: (1). 30$^{\circ}C$ t=3.6d+6(r=0.97) (2). 40$^{\circ}C$ t=3.2d-5.1(r=0.95) (3). 50$^{\circ}C$ t=2.1d-4.0(r=0.93) (4). 60$^{\circ}C$ t=1.4d+4.0(r=0.90) in which t=accelerate curing time. d=normal curing day. 7. Accelerated curing time that the strength was equivalent to 35kg/$\textrm{cm}^2$ which was the strength of cement brick was 96 hours at temperature 30$^{\circ}C$ to SS 9%, and 120 hours at temperature 50$^{\circ}C$ to JJ 9%, Consequently, a economic soil cement brick may be made in future.

• Computers and Concrete
• /
• 제5권5호
• /
• pp.449-459
• /
• 2008

This paper focuses on the application of two dimensional orthogonal polynomials in the regression analysis for the relationship of product parameters viz. compressive strength, bulk density and water absorption of fly ash cement bricks with other process parameters such as percentages of fly ash, sand and cement. The method has been validated by linear and non-linear two parameter regression models. The use of two dimensional orthogonal system makes the analysis computationally efficient, simple and straight forward. Corresponding co-efficient of determination and F-test are also reported to show the efficacy and reliability of the relationships. By applying the evolved relationships, the product parameters of fly ash cement bricks may be approximated for the use in construction sectors.

• 한국건설순환자원학회논문집
• /
• 제7권1호
• /
• pp.22-28
• /
• 2019

시멘트는 건설업에의 기초소재이지만 시멘트 제조시 고온의 소성이 필요하고, 소성시의 원료 및 연료로부터 발생하는 $CO_2$는 새로운 환경문제로 인식되어 이를 저감하기 위한 노력이 지속되고 있다. 콘크리트 분야에서의 $CO_2$ 저감을 위한 기술은 고로슬래그 및 플라이애시 등의 혼합시멘트 사용을 권장하는 것이 저감 대책의 대부분을 차지하고 있다. 또한 콘크리트 구조물 해체 시 발생하는 건설폐기물도 또 다른 환경문제로 인식되며 재활용률을 높이기 위한 여러 가지 방안들이 시행되고 있다. 본 연구는 구조물 해체 시 발생하는 무기계 재생원료를 리사이클을 통해 시멘트 제조의 원료로서 활용하기 위한 것이다. 폐콘크리트, 폐시멘트블록, 폐점토벽돌 및 폐천장재 미분말의 원료조성 검토를 통해 시멘트의 원료로서 활용하고자 한다. 연구결과 재생원료의 원료조성 및 조합을 통해 저탄소형 수경성 시멘트 결합재 제조가 가능한 것을 확인하였다.

• KIEAE Journal
• /
• 제11권2호
• /
• pp.91-96
• /
• 2011

The purpose of this study is to measure the environmental effects of different alternative building materials. The following building materials were tested: clay bricks, cement wall, and red-clay plaster. Four mock-up models were constructed using clay bricks, cement wall, red-clay plaster and the last model as the control model. The effects of the above four building materials on temperature, humidity, the emissions of formaldehyde, and V.O.C were measured. This experiment was conducted during September. The conclusions are as follows. Clay bricks were able to control temperature, humidity and filter formaldehyde by itself. The environment within the cement wall was not affected by the humidity changes outside. Red-clay plaster walls had little impact on the environment because it is very thin.!

• 건축역사연구
• /
• 제1권1호
• /
• pp.117-128
• /
• 1992

The purpose of this paper is to clarify the introduction of foreigner's architectural engineering such as building materials techniques engineers, focused on the Late Yi-dynasty. Such all kind of building materials as timber brick tile cement lime glass window furniture and so on was imported from the foreign company in opening period of ports in Cho-son. The timer of these materials was imported from Japan, the brick tile from China, and others directly from Western counteries indirectly from Japan China. As it was active in an inflow of building materials and machines about 1890's, the modern building techniques were introduced and elementarily mastered such as timber sewing, manufacturing baking of brick glass, and masonry, The above modern techniques became the direct background in the formation of Korean modern architecture. Building engineers can be divided into three classes : architect engineer apprentice. But It could be apparently not divided the relation between architect and engineer at that time. They could be classified into job-architects who were engaged by the Korean government and leaded an active life in their settlement, and missonaries, They introduced the construction and style of modern architecture in our country, And so many skilled laborers and laborers participated in the construction of their settlement.

• 콘크리트학회논문집
• /
• 제13권2호
• /
• pp.87-92
• /
• 2001

주물공장에서 발생하는 플라이애쉬는 현재까지 그 전부가 매립에 의존하고 있는 상태로 자원절약 및 산업폐기물의 유효이용이라는 측면에서 국가적인 손실이 아닐 수 없다. 따라서 산업폐기물의 유효이용, 콘크리트 제품 제조시 원가 절감, 콘크리트 제품의 품질개선 및 환경보존의 측면에서 플라이애쉬를 시멘트 대체재료로 사용할 수 있도록 이에 대한 연구가 필요하다. 본 연구에서는 주물공장의 폐기물인 플라이애쉬를 건설산업에 활용하는 방안을 수립하는 데 그 목적이 있다. 이를 위하여 주물공장에서 발생하는 플라이애쉬를 시멘트 대체재로 사용한 속빈 콘크리트 블록 및 콘크리트 벽돌을 제작하여, 한국산업규격에 규정한 요구조건에 대한 실험을 실시하였고 제반 특성을 조사하여 콘크리트 제품에 활용할 수 있는 방안을 제시하였다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2011년도 춘계 학술논문 발표대회 1부
• /
• pp.61-62
• /
• 2011

This study reviewed the effect of W/B, WO and curing method on the quality properties of RA using the BS brick under the zero cement condition. compressive strength was found to show an increasing trend as W/B increased, but to show a improvement in case steam curing was conducted, showing a higher increase at 1 day age in comparison with 7 day age. In addition, the compressive strength on the mixing of WO didn't show any specific trend. The absorption tended to decrease as W/B increased and met the less than 10% regulation value at 30~35% W/B in case WO was used, there appeared a decrease attributable to capillary pore filling effect due to saponification. On the other hand, compressive strength increases, th absorption showed a gradually decreasing tendency.

• KIEAE Journal
• /
• 제12권3호
• /
• pp.107-114
• /
• 2012

This is a study that surveyed and analyzed the present status of producing loess construction materials in Korea from 2006 to 2011. The findings are as follows. 1) More than 70% of loess construction material manufacturers are distributed in the capital area. Chungcheong-do and Gyeonggi-do are grown by about 20% on the annual average. 2) Shape of loess brick is possessed mostly by a rectangular parallelepiped. A hole shape, which has 1~5 holes among these things, is possessing a majority. 3) It was indicated to be 42 days as material age for the compressive strength, to be about 2.7Mpa for both extrusion and compression, and to be about 30% for absorptance. 4) Among the whole loess material manufacturers, it accounts for 87 for loess brick 66% for loess mortar and more than 39% for loess paint, but within 10%~15% for other loess products. 5) The main specifications of loess brick are $300{\times}150{\times}150,\;300{\times}150{\times}100,\;300{\times}200{\times}150,\;300{\times}150{\times}200$ in order of the output of 74kinds of loess bricks. 6) In order to improve the strength of building materials, mortar and concrete used loess, it is necessary to examine closely about the effect of ceramic binder and cement on loess products.