• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.11a
• /
• pp.133-136
• /
• 2000

We investigated the improvement of viewing angle using a patterned double twisted (PDT) vertical-alignment (VA) cell mode on a homeotropic alignment layer. Good voltage-transmittance curves for negative dielectric anisotropic nematic liquid crystal (NLC) using the PDT-VA cell without a negative compensation film were obtained. The viewing angle of the PDT-VA cell without a negative compensation film was wider than that of a conventional VA cell.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.21 no.6
• /
• pp.49-57
• /
• 2013

In this study, we fabricated a parallelly connected Li-ion battery/supercapacitor hybrid cell to combine the advantageous characteristics of Li-ion battery and supercapacitor, high energy density and high power density, respectively, and investigated its discharging characteristics over a wide temperature range from -40 to $25^{\circ}C$. At the initial state of discharging of the hybrid cell, the power was mostly provided by the supercapacitor and then the portion of the Li-ion battery was gradually increased. By installing a switching system into the hybrid cell, which controls the discharging sequence of Li-ion battery and supercapacitor, the maximum power was improved by 40% compared with non switching system. In addition at low temperatures, the power and discharging time of the hybrid cell were significantly enhanced compared to a battery-alone system. The hybrid cell is expected to be applied in electric vehicles and small domestic appliances that require high power at initial discharging state.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.4
• /
• pp.929-934
• /
• 2010

Improvements in characteristics of a single junction AlGaAs/GaAs solar cell are observed by capping a PMMA lens on it. In order to show the effect of the lens, characteristics of a single junction AlGaAs/GaAs solar cell before and after the lens formation are compared under the one-sun illumination condition ($100mW/cm^2$). Characteristics of the solar cell under very weak illumination condition (about 1200 lux) is also measured with the lighting of a fluorescent desk lamp. About 5% of cell efficiency is improved after the capping of PMMA lens on the single junction AlGaAs solar cell and $83\;{\mu}m/cm^2$ of electrical power was generated with the lighting of a desk lamp.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.2
• /
• pp.53-61
• /
• 2004

Characteristics of half cells of graphite/lithium and LiCoO$_2$/lithium, and full cells of graphite/LiCoO$_2$/ were analyzed by the use of GISOC(the gradual increasing of the state of charge). GISOC analyses generated IIE(the initial intercalation efficiency), which represents lithium intercalation property of the electrode material, and IIC$_{s}$(the initial irreversible capacity by the surface), which represents irreversible reaction between the electrode surface and electrolyte. Linear-fit range of graphite and LiCo/O$_2$electrodes were respectively 370 and 150 mAh/g based on material weight. IIE of graphite and LiCo/O$_2$electrodes were respectively 93∼94 % and 94∼95 %, and IICs of graphite and LiCo/O$_2$electrodes were 15∼17 mAH/g and 0.3∼1.7 mAh/g, respectively. IIE of graphite/LiCo/O$_2$full cell for GX25 and DJG311 as graphite showed 89∼90 %, which IIE value was lower than IIE of half cell of the cathode and the anode. Parameters of IIE and IIC$_{s}$ can also be used to represent not only half cell but also full cell. The characteristics of the full cell can be simulated through the correlative interpretation of potential profile, IIE, and IIC$_{s}$ of half cells.cells.

• Biomolecules & Therapeutics
• /
• v.32 no.4
• /
• pp.424-431
• /
• 2024

Among the therapeutic strategies in cancer immunotherapy-such as immune-modulating antibodies, cancer vaccines, or adoptive T cell transfer-T cells have been an attractive target due to their cytotoxicity toward tumor cells and the tumor antigen-specific binding of their receptors. Leveraging the unique properties of T cells, chimeric antigen receptor-T cells and T cell receptor (TCR)-T cells were developed through genetic modification of their receptors, enhancing the specificity and effectiveness of T cell therapy. Adoptive cell transfer of chimeric antigen receptor-T cells has been successful for the treatment of hematological malignancies. To expand T cell therapy to solid tumors, T cells are modified to express defined TCR targeting tumor associated antigen, which is called TCR-T therapy. This review discusses anti-tumor T cell therapies, with a focus on engineered TCR-T cell therapy. We outline the characteristics of TCR-T cell therapy and its clinical application to non-hematological malignancies.

• Proceedings of the KIEE Conference
• /
• 1997.07d
• /
• pp.1250-1251
• /
• 1997

Among the fuel cell system, solid oxide fuel cell is constructed of ceramics, so stack construction is simple, power density is very high, and there is no corrosion problem. The purpose of this research is to investigate the characteristics of state of art for SOFC.

• Proceedings of the KIEE Conference
• /
• 1997.07f
• /
• pp.2177-2180
• /
• 1997

The solar cell has an optimum operating point to be able to got maximum power. To obtain maximum power from Photovoltaic array, hotovoltaic power system usually requres maximum power point c tracking controller. The output characteristics of solar cell are nonlinear, and these characteristics vary with load solar insolation, solar cell temperature. Therefore the tracking control of maximum power point is the com-plicated problem. This paper presents power characteristics of residential Photovoltaic system applying a buck-boost conversion system.

• Proceedings of the KIEE Conference
• /
• 1997.11a
• /
• pp.413-415
• /
• 1997

The solar cell has an optimum operating point to be able to get maximum power. To obtain maximum power from Photovoltaic array, potovolt aic power syste usually requres maximum power point tracking controller. The output characteristics of solar cell are nonlinear, and these characteristics vary with load solar insolation, solar cell temperature. Therefore the tracking control of maximum power point is the complicated problem. This paper presents power characteristics of residential Photovoltaic system applying a quck-boost conversion system.

• Journal of environmental and Sanitary engineering
• /
• v.13 no.1
• /
• pp.174-184
• /
• 1998

Biosorption characteristics were investigated to discuss the use of agar entrapped Spirulina to remove of heavy metal ions from polluted waters. Agar immobilized algae were used as bioadsorbent in continuous reactor for heavy metal ions removal. The process solution contains Pb, Cu, and Cd as single ion and binary ions. In the adsorption of single heavy metal ions by agar immobilized Spirulina, the adsorption reached within 1hr and observed diffusion limitation differed from the free algal cell adsorption. The optimum pH for the adsorption of heavy metals was 4.5 but the influence of pH decreased less than that of free algal cell. Also, the adsorption characteristics of single heavy metal ions with agar immobilized Spirulina fitted the BET isotherm. Both of experiments of free algal cell and agar immobilized algae showed higher removal efficiency in the single ion solutions than binary ions solutions. The experimental results in the packed column with agar immobilized algae were over 90% of removal efficiency for the Pb, Cu, and Cd in single ion solutions.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.4
• /
• pp.483-490
• /
• 1998

The reflectivity of a grid ferrite electromagnetic wave absorber is analyzed using finite difference time domain (FDTD) method, which is usually used in anechoic chambers for EMI / EMS test. The frequency dispersive characteristics of ferrite medium and its boundary condition are modeled using magnetic flux in addition to E- and H-fields. By applying Floquets theorem, FDTD analysis of the grid ferrite absorber with periodic infinite array is simplified as a unit cell problem. The method of homogenization which is mainly utilized in the calculation of absorber reflectivity as a low frequency technique takes only into account volume fraction of the unit cell of the absorber except for the structure of medium geometry. However, the presented method in this paper can analyze the geometry effect of the unit cell with its medium characteristics up to high frequency region.