• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.6
• /
• pp.23-32
• /
• 1996

This paper proposes a new buffer management scheme to service delay-sensitive traffic and loss-sensitive traffic fairly in ATM networks. The proposed scheme uses tow buffers for delay-sensitive traffic and loss-sensitive traffic. To satisfy the average delay time of delay-sensitive traffic, cells in real-time buffer are served first. When congestion occurs in nonreal-time buffer, low loss priority cell in real-time buffer can be pushed out by high loss priority cell in nonreal-time buffer can be transferred to real-time buffer considering threshold value in real-time buffer. Using computer simulation, the existing methods and proposed scheme are compared and analyzed with respect to cell loss rate and average delay time. Simulation results show that the proposed scheme have superior performance to conventional schemes.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.8
• /
• pp.3542-3566
• /
• 2018

In this paper, we investigate a buffer-aided wireless powered cooperative communication network (WPCCN), in which the source and relay harvest the energy from a dedicated power beacon via wireless energy transfer, then the source transmits the data to the destination through the relay. Both the source and relay are equipped with an energy buffer to store the harvested energy in the energy transfer stage. In addition, the relay is equipped with a data buffer and can temporarily store the received information. Considering the buffer-aided WPCCN, we propose two buffer-aided relaying protocols, which named as the buffer-aided harvest-then-transmit (HtT) protocol and the buffer-aided joint mode selection and power allocation (JMSPA) protocol, respectively. For the buffer-aided HtT protocol, the time-averaged achievable rate is obtained in closed form. For the buffer-aided JMSPA protocol, the optimal adaptive mode selection scheme and power allocation scheme, which jointly maximize the time-averaged throughput of system, are obtained by employing the Lyapunov optimization theory. Furthermore, we drive the theoretical bounds on the time-averaged achievable rate and time-averaged delay, then present the throughput-delay tradeoff achieved by the joint JMSPA protocol. Simulation results validate the throughput performance gain of the proposed buffer-aided relaying protocols and verify the theoretical analysis.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.11
• /
• pp.5271-5289
• /
• 2016

On large-scale data analysis platforms deployed on cloud infrastructures over the Internet, the instability of the data transfer time and the dynamics of the processing rate require a more sophisticated data distribution scheme which maximizes parallel efficiency by achieving the balanced load among participated computing elements and by eliminating the idle time of each computing element. In particular, under the constraints that have the real-time and limited data buffer (in-memory storage) are given, it needs more controllable mechanism to prevent both the overflow and the underflow of the finite buffer. In this paper, we propose an auto regulated data provisioning model based on receiver-driven data pull model. On this model, we provide a synchronized data replenishment mechanism that implicitly avoids the data buffer overflow as well as explicitly regulates the data buffer underflow by adequately adjusting the buffer resilience. To estimate the optimal size of buffer resilience, we exploits an adaptive buffer resilience control scheme that minimizes both data buffer space and idle time of the processing elements based on directly measured sample path analysis. The simulation results show that the proposed scheme provides allowable approximation compared to the numerical results. Also, it is suitably efficient to apply for such a dynamic environment that cannot postulate the stochastic characteristic for the data transfer time, the data processing rate, or even an environment where the fluctuation of the both is presented.

• Proceedings of the KIEE Conference
• /
• 1987.07b
• /
• pp.1512-1515
• /
• 1987

The buffer circuit having minimum delay time is designed and analyzed in this paper. Considering the parasitic components of the MOS transistor, the optimal transistor size ratio between the individual buffer stages is presented. This paper's result is better than that of the Mead and Conway's analysis [1] with respect to both delay time and total area that buffer occupies.

• Journal of applied mathematics & informatics
• /
• v.33 no.1_2
• /
• pp.185-191
• /
• 2015

This paper considers a discrete-time buffer system with session-based arrivals, an infinite storage capacity and one unreliable output line. There are multiple different types of sessions and the output line is governed by a finite state Markov chain. Based on a generating functions approach, we obtain an exact expression for the mean buffer content.

• Journal of the Semiconductor & Display Technology
• /
• v.3 no.3
• /
• pp.11-17
• /
• 2004

This research has been progressed for adhesive improvement of the Polyimide/Buffer layer/Cu at the COF(Chip On Film) which induced as the alternative plan about high concentration of a circuit or substrates according to demands of miniaturization and high efficiency of various electronic equipment. RF plasma equipment was applied to when plama pretreatment was performed for improvement of adhesive strength of PI and Cr as the buffer layer. Experimental fluents were a species of the buffer layer, depositied time and the ratio of $O_2$/Ar when performed to plasma pretreatment. The results are that Ni was superior to Cr at peel test according to a species of the buffer layer, peel strength and Cu THK were showed proportional relation to deposition structure of the same buffer layer and sample of the Cr depositied time(30 sec) and Cu depositied time(20 min) was showed good adhesion to peel test according to Cr's depositied time and Cu's depositied time. When perform PI's plasma pretreatment peel strength and $O_2$/Ar ratio were showed proportional relation. But $O_2$/Ar(2/5) was best condition since then decreased.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.82.1-82
• /
• 2001

It is known that existence of irregular transmission time delay is a major bottleneck for application of advanced robot control schemes to internet telerobotic systems. In the internet teleoperation system, the irregular transmission time delay causes a critical problem, which is unstable and inaccurate. This paper suggests a practical internet teleoperation system with streaming buffer system, which consists of a buffer, a buffer manager, and a control timer. The proposed system converts the irregular transmission time delay to constant. So, the system effectively transmits the control input to a remote site to operate a robot stably and accurately. This feature enables short control input interval. That means the entire system has ...

• Journal of the Optical Society of Korea
• /
• v.20 no.3
• /
• pp.431-434
• /
• 2016

Tris-HCl buffer solution is extensively used in biochemistry and molecular biology to maintain a stable pH for biomolecules such as nucleic acids and proteins. Here we report on the high-precision THz dielectric spectroscopy of a 10 mM Tris-HCl buffer. Using a double Debye model, including conductivity of ionic species, we measured the complex dielectric functions of Tris-HCl buffer. The fast relaxation time of water molecules in Tris-HCl buffer is ~20% longer than that in pure water while the slow relaxation time changes little. This means that the reorientation dynamics of Tris-HCl buffer with such a low Tris concentration is quite different from that of pure water.

• KSBB Journal
• /
• v.16 no.6
• /
• pp.533-537
• /
• 2001

${\alpha}$-lactalbumin and ${\beta}$-lactoglobulin in whey proteins were separated by high performance membrane chromatography (HPMC). The separation mechanism involved anion-exchange, and the stationary phase was anion CIM (Convective Interaction Media) DEAE, QA disk and cation exchanger SO$_3$(16${\times}$3 mm). Two types of mobile phase were used, buffer A (20 mM Tris-HCI, pH 7.3) and buffer B(buffer A + 1 M NaCl), As the amount of NaCl dissolved in buffer linearly increased, which enabled a gradient elution mode. The optimum mobile phase and operating condition (Buffer A/Buffer B = 100/0 - 30/70 vol%, gradient time 1 min, 30/70 - 10/90 vol.%, gradient time 2 min) were experimentally determined. In this experimental condition, ${\alpha}$-lacta1bumin, ${\beta}$-lactoglobulin were separated within 5 min at a mobile phase flow rate of 4 mL/min.

• Journal of KIISE:Computing Practices and Letters
• /
• v.9 no.1
• /
• pp.13-24
• /
• 2003

MPEG-4 is a standard for multimedia applications and provides a set of technologies to satisfy the needs of authors, service providers and end users alike. In this paper, we suggest a Real-time Multiple Circular Buffer (M4RM Buffer) model, which is suitable for streaming these MPEG-4 contents efficiently. M4RM buffer generates each structure of the buffer, which matches well with each object composing an MPEG-4 content, according to the transferred information, and manipulates multiple read/write operations only by its reference. It divides the decoder buffer and the composition buffer, which are described in the standard, by the unit of frame allocated to minimize the range of access. This buffer unit of a frame is allocated according to the object description. Also, it processes the objects synchronization within the buffer and provides APIs for an efficient buffer management to process the real-time user events. Based on the performance evaluation, we show that M4RM buffer model decreases the waiting time in a buffer frame, and so allows the real-time streaming of an MPEG-4 content using the smaller size of the memory block than IM1-2D and Window Media Player.