• 한국철도학회논문집
• /
• 제12권5호
• /
• pp.732-737
• /
• 2009

본 연구에서는 고속주행 시 팬터그래프에 가해지는 공기역학적 특성을 평가하기 위하여 고속철도차량용 실모형 팬터그래프에 대한 풍동시험을 수행하였다. 시험에 사용된 풍동은 공군사관학교의 중형아음속풍동으로서 폭 3.5m $\times$ 높이 2.45m $\times$ 길이 8.8m의 시험부를 가지며, 시험 모형은 하단의 차체부착용 브라켓에서 50cm의 수직 스트럿을 통해 풍동 바닥면에 지지되어 자유류가 시험부 바닥을 지나면서 성장하는 경계층의 영향을 제거하였다. 시험모델은 표준높이와 최소높이 및 풍동의 시험부를 고려한 최대높이에 대하여 정상주행방향 및 역방향 시의 조건을 바꾸어가며 수행되었다. 각각의 조건에 대해서 팬터그래프가 가선에 미치는 압상력을 측정하였으며, 시험 조건에 따른 압상력의 변화에 대하여 분석하였다.

• Wind and Structures
• /
• 제13권1호
• /
• pp.57-82
• /
• 2010

The 486m-long roof of Shenzhen Citizens Centre is one of the world's longest spatial lattice roof structures. A comprehensive numerical study of wind effects on the long-span structure is presented in this paper. The discretizing and synthesizing of random flow generation technique (DSRFG) recently proposed by two of the authors (Huang and Li 2008) was adopted to produce a spatially correlated turbulent inflow field for the simulation study. The distributions and characteristics of wind loads on the roof were numerically evaluated by Computational Fluid Dynamics (CFD) methods, in which Large Eddy Simulation (LES) and Reynolds Averaged Navier-Stokes Equations (RANS) Model were employed. The main objective of this study is to explore a useful approach for estimations of wind effects on complex curved roof by CFD techniques. In parallel with the numerical investigation, simultaneous pressure measurements on the entire roof were made in a boundary layer wind tunnel to determine mean, fluctuating and peak pressure coefficient distributions, and spectra, spatial correlation coefficients and probability characteristics of pressure fluctuations. Numerical results were then compared with these experimentally determined data for validating the numerical methods. The comparative study demonstrated that the LES integrated with the DSRFG technique could provide satisfactory prediction of wind effects on the long-span roof with complex shape, especially on separation zones along leading eaves where the worst negative wind-induced pressures commonly occur. The recommended LES and inflow turbulence generation technique as well as associated numerical treatments are useful for structural engineers to assess wind effects on a long-span roof at its design stage.

• 설비공학논문집
• /
• 제12권9호
• /
• pp.843-852
• /
• 2000

The flow characteristics and the heat transfer rate on a surface by interaction of a pair of vortices were studied experimentally. The test facility consisted of a boundary-layer wind tunnel with a vortex introduced into the flow by half-delta winglet protruding from the surface. In order to control the strength of the longitudinal vortices, the angles of attack of the vortex generators were varied from $\pm20\;degree\;to\;\pm45$ degree, but spacings between the vortex generators were fixed to 4 cm. The 3-dimensional mean velocity measurements were made using a five-hole pressure probe. Heat transfer measurements were made using the thermochromatic liquid to provide the local distribution of the heat transfer coefficient. By using the method mentioned above, the following conclusions were obtained from the present experiment. The boundary layer was thinned in the regions where the secondary flow was directed toward the wall and thickened where it was directed away from the wall. The peak augmentation of the local heat transfer coefficient occurred in the downwash region near the point of minimum boundary-layer thickness.

• 대한기계학회논문집B
• /
• 제27권1호
• /
• pp.105-116
• /
• 2003

The flow structure around the free end of a finite circular cylinder (FC) embedded in an atmospheric boundary layer (ABL) over open terrain was investigated experimentally with varying the free end shape. The experiments were carried out in a closed-return type subsonic wind tunnel. A finite cylinder with an aspect ratio (L/D) of 6 was mounted vertically on a long flat plate. The Reynolds number based on the cylinder diameter is about Re=7,500. The velocity fields near the FC free end were measured using the single-frame double-exposure PIV method. As a result, for the FC with a right-angled free end, there is a peculiar vortical structure, showing counter-rotating twin vortices near the FC free end. It is caused by the interaction between the entrained irrotational fluids from both sides of FC and the downwash flow from the FC free-end.

• Wind and Structures
• /
• 제26권5호
• /
• pp.317-329
• /
• 2018

Wake characteristics of the flow over a finite square prism at different incidence angles were experimentally investigated using an open-loop wind tunnel. A finite square prism with a width D = 15 mm and a height H = 7D was vertically mounted on a horizontal flat plate. The Reynolds number was varied from $6.5{\times}10^3$ to $28.5{\times}10^3$ and the incidence angle ${\alpha}$ was changed from $0^{\circ}$ to $45^{\circ}$. The ratio of boundary layer thickness to the prism height was about ${\delta}/H=7%$. The time-averaged velocity, turbulence intensity and the vortex shedding frequency were obtained through a single-component hotwire probe. Power spectrum of the streamwise velocity fluctuations revealed that the tip and base vortices shed at the same frequency as that ofspanwise vortices. Furthermore, the results showed that the critical incidence angle corresponding to the maximum Strouhal number and minimum wake width occurs at ${\alpha}_{cr}=15^{\circ}$ which is equal to that reported for an infinite prism. There is a reduction in the size of the wake region along the height of the prism when moving away from the ground plane towards the free end.

• 한국해양공학회지
• /
• 제4권2호
• /
• pp.22-34
• /
• 1990

남극환경은 남극의 거센 바람 및 이에 수반되는 적설현상을 피하기 위해 땅에서 띄우는 고상식 및 지하에 설치하는, 두가지의 형태를 취하고 있다. 고상식의 경우 건물밑으로 바람을 통하게 함으로써 적설현상을 피하는데 효과적이기는 하나 남극의 거센 바람에 대응하기 위하여 구조적인 문제를 해결해야 하는 취약점을 지니고 있다. 본 연구는 경계층난류풍하를 이용하여 고상식 남극건물에 가해지는 풍하중을 파악함으로서 남극건물의 design guide line을 제시하였다.

• Wind and Structures
• /
• 제17권5호
• /
• pp.465-477
• /
• 2013

In this paper, the effects of parapets on the mean and fluctuating wind pressures which are acting on a flat top of a finite cylinder vertically placed on a flat plate have experimentally been investigated. The aspect ratio (AR) of cylinder is 1 and the Reynolds number (Re) based on cylinder diameter and free stream velocity is 150000. The pressure distributions on the flat top and the side wall of the finite cylinder immersed in a simulated atmospheric boundary layer have been obtained for different parapet heights. The large magnitudes of mean and minimum suction pressures occurring near the leading edge were measured for the cases with and without parapet. They shift to the further downstream on the circular top with increasing parapet height. It is seen that the parapets reduce the local high suction on the top up to 24%.

• Wind and Structures
• /
• 제9권1호
• /
• pp.37-58
• /
• 2006

The paper describes a study about effects of upstream hills on design wind loads using two mathematical approaches: Computational Fluid Dynamics (CFD) and Artificial Neural Network (NN for short). For this purpose CFD and NN tools have been developed using an object-oriented approach and C++ programming language. The CFD tool consists of solving the Reynolds time-averaged Navier-Stokes equations and $k-{\varepsilon}$ turbulence model using body-fitted nearly-orthogonal coordinate system. Subsequently, design wind load parameters such as speed-up ratio values have been generated for a wide spectrum of two-dimensional hill geometries that includes isolated and multiple steep and shallow hills. Ground roughness effect has also been considered. Such CFD solutions, however, normally require among other things ample computational time, background knowledge and high-capacity hardware. To assist the enduser, an easier, faster and more inexpensive NN model trained with the CFD-generated data is proposed in this paper. Prior to using the CFD data for training purposes, extensive validation work has been carried out by comparing with boundary layer wind tunnel (BLWT) data. The CFD trained NN (CFD-NN) has produced speed-up ratio values for cases such as multiple hills that are not covered by wind design standards such as the Commentaries of the National Building Code of Canada (1995). The CFD-NN results compare well with BLWT data available in literature and the proposed approach requires fewer resources compared to running BLWT experiments.

• 한국군사과학기술학회지
• /
• 제12권6호
• /
• pp.704-710
• /
• 2009

In this study, a comparison study of flutter analysis for the AGARD 445.6 wing with wind turnnel test data has been conducted in the subsonic, transonic and supersonic flow regions. Nonlinear aeroelastic using FSIPRO3D which is a generalized user-friendly fluid-structure analyses have been conducted for a 3D wing configuration considering shockwave and turbulent viscosity effects. The developed fluid-structure coupled analysis system is applied for aeroelastic computations combining computational structure dynamics(CSD), finite element method(FEM) and computations fluid dynamics(CFD) in the time domain. MSC/NASTRAN is used for the vibration analysis of a wing model, and then the result is applied to the FSIPRO3D module. the results for dynamic aeroelastic response using different turbulent models are presented for several Mach numbers. Calculated flutter boundary are compared with the wind-tunnel experimental and the results show very good agreements.

• 한국공간구조학회:학술대회논문집
• /
• 한국공간구조학회 2008년도 춘계 학술발표회 논문집
• /
• pp.15-18
• /
• 2008

대공간 구조는 3차원적인 힘의 흐름과 면내력에 의해 외부하중에 대한 저항능력을 확보하는 형태 저항형 구조로서, 구조물 자체의 곡률을 이용하여 면외방향으로 작용하는 외력을 주로 면내력으로 저항할 수 있게한 구조시스템이다. 그러므로, 연성구조물의 일종인 막구조물은 대공간 구조물을 보다 효과적으로 구축할 수 있다. 이러한 막구조물은 지진이나 고정하중에 의한 영향보다 바람의 의한 영향이 매우 중요하다고 볼 수 있다. 또한, 풍하중은 주변 환경 및 구조물의 형태에 따라 그 크기가 매우 다르게 나타난다. 본 논문에서는, 우리나라에서 풍하중의 영향을 가장 많이 받은 지역들 중에 건설된, 2개 경기장의 설계 풍하중과 풍동실험 결과값들을 비교 검토해 보고자 한다.