• Journal of the Korea Institute of Military Science and Technology
• /
• v.4 no.2
• /
• pp.179-188
• /
• 2001

The objective of this paper is to design and implement sliding mode control scheme for an actuation system using BLDC motor. Since the dynamic characteristics of this system with unknown disturbance and parameter variations are very complicated and highly nonlinear, the conventional linear control approaches may not guarantee satisfactory control performances. In order to improve the dynamic performances of this system, a model following sliding mode control(MFSMC) with perturbation estimation approach is designed and implemented. It eliminates the conventional requirements for the knowledge of uncertainty upper boundary. The effectiveness of this control approach is verified by comparison with a PID control through a series of simulation and experimental studies.

• Journal of the Korean Society of Combustion
• /
• v.16 no.4
• /
• pp.8-15
• /
• 2011

The present study investigates the combustion phenomena in a sludge incinerator using experimental and numerical method. The temperature and gas concentration were measured at 33 points during operation of the incinerator in order to assess the mixing and combustion characteristics. Numerical simulation was also carried out using a commercial CFD code. Simplified inlet conditions were introduced in oder to predict the bulk solid combustion and the diffusion of the volatile matter released by pyrolysis of sludge. The experimental results showed that the combustion process is extremely inhomogeneous. Large variations were observed in the temperature and gas concentrations in the freeboard of the incinerator due to poor mixing performance between the air and the combustibles, which is caused by massive and bulk generation of volatile matter by fast pyrolysis of sludge particles. The boundary condition of the CFD simulation was found effective in predicting the poor mixing and combustion performance of the reactor.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.6
• /
• pp.1259-1265
• /
• 2013

In wireless environment such as wireless LAN, proper location of wireless LAN AP allows us to take an effective coverage to provide good wireless communication service. To simulate wireless environment, FDTD formulation is introduced and Gaussian pulse injection in grid space is considered to be replaced wireless LAN AP. So structural effect corresponding to location of arbitrary obstacle must be considered, and its received gain is estimated. An obstacle in scattering field should be modeled to be conductor and concrete wall and its diffraction effect for some cross wall is evaluated between transmitter and receiver point.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.5
• /
• pp.482-494
• /
• 1992

In this paper, the neuro-fuzzy inferene system for the effective object recognition is studied. The proposed neuro-fuzzy inference system combines learning capability of neural network with inference process of fuzzy theory, and the system executes the fuzzy inference by neural network automatically. The proposed system consists of the antecedence neural network, the consequent neural network, and the fuzzy operational part, For dissolving the ambiguity of recognition due to input variance in the neuro-fuzzy inference system, the antecedence’s fuzzy proposition of the inference rules are automatically produced by error back propagation learining rule. Therefore, when the fuzzy inference is made, the shape of membership functions os adaptively modified according to the variation. The antecedence neural netwerk constructs a separated MNN(Model Classification Neural Network)and LNN(Line segment Classification Neural Networks)for dissolving the degradation of recognition rate. The antecedence neural network can overcome the limitation of boundary decisoion characteristics of nrural network due to the similarity of extracted features. The increased recognition rate is gained by the consequent neural network which is designed to learn inference rules for the effective system output.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.955-958
• /
• 2001

The structure characteristics of varistor of Zn oxide to depend on the breakdown voltage has been investigated to annealing condition by additive material of Sb$_2$O$_3$ system. The breakdown voltage that has not doping Sb$_2$O$_3$ was 235[V]. ZnO varistors was shown ohmic properties when it's applied voltage was below critical voltage. It was shown non-ohmic properties over critical voltage, because current was increased with decreasing resistance. High voltage ZnO varistors had high breakdown voltage, but it had bad electrical stability with various surge. Sb$_2$O$_3$was increased non-linear coefficient in ZnO varistors grain boundary.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1995.11a
• /
• pp.74-76
• /
• 1995

ZnO varistor with composition of ZnO(90wt%)-Bi$_2$O$_3$(3wt%)-Sb$_2$O$_3$(3.6wt%)-CO$_2$O$_3$(1.16wt%)-NiO(0.88wt%)-MnO$_2$(0.71wt%)-Cr$_2$O$_3$(0.93wt%) according to Al$_2$O$_3$addtive was fabricated by sintering methods. The effects of Al$_2$O$_3$dopant on the I-V characteristics of ZnO varistors were investigated. These changes of electric properties were found to be caused by the variation of grains and grain boundary related to Al$_2$O$_3$dopting. And the conductive mechanism of ZnO varistor in prebreakdown region were investigated with defect model.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1995.11a
• /
• pp.163-166
• /
• 1995

It was investigated the properties of TSC (Thermally Stimulated Current) to understand carriers behavior from long ago. Activation Energy of their properties is very important to verify electrical characteristics. So, for many years, many researchers were worked to get the activation energy, more compeletely. But, if boundary conditions were not satisfied, the values of activation energy contained several errors. In this work, to obtain the activation energy related to charged particles, the peak temperature Tp and the slope of tangential line on any coordinates of Arrhenius plot are applied. The calculation process can be denied with by computer, and the result of observation shows that the cures of calculation data and simulation data coincide very compeletely.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07b
• /
• pp.785-787
• /
• 2002

Conductivity and transmittancy of ZnO is very excellent and the price is low. So the study of transparent electrode materials and electromagnetic wave shielding wall is actively in progress. We add $Al_2O_3$(0.0, 2.0, 3.0, 5.0wt%) to ZnO and observe microscopic structure and conductivity. For XRD observation, Al peak of AZO is increased by increasing the amount of $Al_2O_3$. We observe that the size of grain is reduced by increasing the liquid phase of grain boundary to SEM observation. Conductivity of AZO is increased by increasing the amount of $Al_2O_3$. We confirm the application possibility of the materials for electromagnetic wave reflection materials.

• Proceedings of the KSR Conference
• /
• 2003.10b
• /
• pp.531-537
• /
• 2003

Recently, various and new special methods of construction about steel bridges have been tried, and the study about local buckling about this have been performed too. But becuase of various cases, structural analysis is performed to check safety for each step of construction, and this is not efficient and economical method for time and manpower. So, for solution of this problems, general method about checking safety needs to be developed. In this study, in preparation for development about this, we look into elastic buckling characteristics of plates for each case as load, boundary condition, aspect ratio, and so on.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.680-683
• /
• 2006

A one-dimensional planar model is considered of the atmosphere with multi-layer clouds illuminated by a mono-directional parallel flux of solar radiation. A new approach is proposed to radiation transfer modeling and daylight background formation for the atmosphere with such clouds that is represented as a heterogeneous multi-layer system each layer of which is described by different optical characteristics. The influence functions of each layer are determined by solutions of the radiation transfer boundary problem with an external monodirectional wide flux while the contribution of multiple scattering and absorption in the layer is taking into account.