• KSBB Journal
• /
• v.21 no.4
• /
• pp.312-316
• /
• 2006

A optimal condition for the Ginkgo biloba extraction in ethanol and water binary solvent system has been proposed based on concentration of bilobalide and ginkgolide known as having a antimicrobial components in the range 5% to 70% ethanol in water at $80^{\circ}C$. Concentration of bilobalide as a single component of Ginkgo biloba leaves extract is the highest at the 60% ethanol and ginkgolide A and B is highest at 50% ethanol. Antimicrobial effect of Ginkgo biloba leaves extracts on the S. aureus was also examined by disc diffusion test and optical density test. In case of the disc diffusion test, the clean zone diameter was increased from 0.95 cm to 1.70 cm as ethanol concentration increased from 5 to 70%. However, over the 40% of ethanol concentration the antimicrobial effect was almost flat. Based on these results, we propose that the 40% of ethanol and 60% water solvent is most desirable for Ginkgo biloba extract considering vapor pressure problem in concentrating process after extraction. We introduced SEM and TEM to figure out the morphological change on the surface and inside body of S. aureus when Ginkgo biloba leaves extract was treated. After mixed with Ginkgo biloba leaves extract blast like blebs appeared on the surface of S. aureus cells and cell wall was not observed. From the these results, it seems that the Ginkgo biloba leaves extract including bilobalide and ginkgolide A, B prevent cell wall synthesis.

• Journal of the Korean Geosynthetics Society
• /
• v.19 no.1
• /
• pp.103-110
• /
• 2020

The DMM (Deep mixing method) is a construction method in which an improved pile is installed in the soft ground by excavation ground using an auger and then mixing ground stabilizer with soil. Improved pile installed in the soft ground by the DMM may have different compressive strength depending on the properties and characteristics of the soil. In the previous study, laboratory tests were performed on the ground stabilizer for the DMM developed by using the ash of the circulating fluidized bed boiler as a stimulator for alkali activation of the blast furnace slag. And the test results were analyzed to derive the correlation between the unit weight of binder (γ_B) and the uniaxial compressive strength (q_u). In this study, comparative reviews were conducted on the correlations derived from the same laboratory tests on soil material collected from the Saemangeum area and the stability of the site was evaluated by analyzing the test results performed at the site. As a result, the clay collected from the Saemangeum area satisfies the correlation between the unit weight of binder (γ_B) and the uniaxial compressive strength (q_u) derived from the previous study. And the result of the test at the field showed a higher uniaxial compressive strength than the standard strength at the field, indicating excellent stability.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.7
• /
• pp.4960-4968
• /
• 2015

In this study to improve the chloride durability of the shotcrete structure depending on types and contents of mineral admixture chloride resistance was evaluated by NT BUILD 492 of european test standards. It was also evaluated with the mechanical properties such as static strength and chloride penetration resistance. For shotcrete mixed crushed stone aggregate of the maximum size 10mm of coarse aggregates was produced. Based on 28days compression strength the variable mixed with 15% silica fume showed the highest strength in 67.55MPa. As the content of fly ash and blast furnace slag increased, the strength lowered. In the chloride penetration resistance test, OPC showed "high grade" and In the case of admixture, the penetration resistance tended to increase in all variables except the fly ash. In order to evaluate the service life, the accelerated chloride penetration test was conducted by the standards of KCL, ACI, FIB. Test results were obtained with the lowest spreading factor in a variable mixed with silica fume of 15%. At the KCI standards, It was found to have a service life of about 65 years and at the FIB standards, It was found to have a service life of 131 years. Among standards, the service life of KCI standard in all of the variables was evaluated as the lowest.

• Journal of Animal Science and Technology
• /
• v.51 no.1
• /
• pp.1-8
• /
• 2009

We generated 57,598 expressed sequence tags (ESTs) from 3 cDNA libraries of Hanwooo (Korean Cattle), fat, loin, liver. Liver, intermuscular fat and longissimus dorsi tissues were obtained from a 24-month-old Hanwoo steer immediately after slaughter. cDNA library was constructed according to the oligocapped method. The EST data were clustered and assembled into unique sequences, 4,759 contigs and 7,587 singletons. To carry out functional analysis, Gene Ontology annotation and identification of significant leaf nodes were performed that were detected by searching significant p-values from $2^{nd}$ level GO terms to leaf nodes using Bonferroni correction. We found that 13, 26 and 8 significant leaf nodes are unique in the transcripts according to 3 GO categories, molecular function, biological process and cellular component. Also digital gene expression profiling using the Audic's test was performed and tissue specific genes were detected in the above 3 libraries.

• Journal of the Korea Concrete Institute
• /
• v.26 no.4
• /
• pp.507-515
• /
• 2014

Although the construction joints of a concrete structure are properly treated with some measures, leakage has frequently occurred. A series of tests on the bond characteristics between new and old concrete were carried out in this study, assuming that the leakage at the construction joints has certain relationship with the bond of concrete. To assess the bond characteristics under various conditions, a number of specimens were made that have an interface between new and old concrete and bond strength, flexural strength and splitting tensile strength were measured. Main test variables are type and amount of mineral admixtures, treatment method of the interface and type of waterstops. In addition, the effects of placing interval between the concrete and of the age of the strength tests were investigated. The test results showed a slightly increased bond strength when applying mineral admixtures, which can be attributed to the interface filled with the calcium silicate hydrate that is formed by pozzolanic reaction. On the other hand, the bond strength was higher when the interface was treated rough and dry, and the roughness of a waterstop affected the bond capacity of the waterstop. Also, an assessment is required that considers the type of strength test because the bond strength varied according to the test methods.

• Explosives and Blasting
• /
• v.39 no.1
• /
• pp.10-21
• /
• 2021

Brittle materials such as rocks and concretes exhibit large strain-rate dependency under dynamic loading conditions. This means that the mechanical properties of such materials can significantly be varied according to load velocity. Thus, the strain-rate dependency is recognized as one of the most important considerations in solving problems of blast engineering or rock dynamics. Unfortunately, however, studies for characterizing the dynamic properties of domestic rocks and other brittle materials are still insufficient in the country. In this study, dynamic tensile tests were conducted using the Hopkinson pressure bar apparatus to characterize the dynamic properties of Geochang granite and high-strength concrete specimens. The dynamic Brazilian disc test, which is suggested by ISRM, and the spalling method were applied. In general, the latter is believed to have some advantages in experiments under high-strain rate deformation. It was found from the tests that there were no significant difference between the dynamic tensile strengths obtained from the two different test methods for the two materials given. However, this was not the expected result before the tests. Actually, authors expected that there be some differences between them. Hence, it is thought that further investigations are needed to clarify this results.

• Korean Journal of Breeding Science
• /
• v.42 no.6
• /
• pp.615-622
• /
• 2010

A new rice cultivar, 'Joami', was developed by the rice breeding team of Sangju Substation, National Institute of Crop Science (NICS), Rural Development Administration. It was selected by a bulk and pedigree methods from a cross-combination among 'Sambaegbyeo', 'Yukara', and 'Tonggae112'. A promising line of YR20557-1-1-3-B-3 was designated as 'Sangju 36' in 2006. Local adaptability test of 'Sangju 36' was conducted at ten sites throughout the Korean peninsula during three years from 2006 to 2008. 'Sangju 36', thereafter, was registered as 'Joami' in 2008. The cultivar headed on July 30 in the test of local adaptability. Endosperm of 'Joami' is translucent with clear chalkiness and has 5.4% higher head rice ratio than that of 'Odaebyeo'. The yield potential of 'Joami' in milled rice is about 5.40 MT/ha under ordinary fertilizer level of local adaptability test, which was 6% higher than that of 'Odaebyeo'. In an alpine area of Korea, the rice variety needs a cold tolerance and a resistance to blast disease. 'Joami' showed a tolerance reaction at Chuncheon cold tolerance screening nursery and exhibited resistance reaction to blast disease in nation-wide disease screening nursery. Therefore, 'Joami' would be well adaptable to mid-mountainous area at central and southern part of Korean peninsula.

• Korean Journal of Breeding Science
• /
• v.42 no.3
• /
• pp.313-317
• /
• 2010

There are the farmer's needs to develop early-maturing cultivar adaptable to mid-northern inland plain and alpine area. Furthermore, it is required to develop a rice variety to produce new rice before concentrated marketing dates, even in the years of early Chuseok. 'Joun' is a new extremely early-maturing japonica rice cultivar developed in 2009 from the cross of SR14880-173-3-3-2-2-2/Unbong20 at Cheolwon Substation, National Institute of Crop Science (NICS), Rural Development Administration (RDA). The heading date of 'Joun' is July 23 in mid-northern alpine area, which is 7 days earlier than that of Odaebyeo. It has about 61 cm in culm length with semi-erect plant type. Panicle has a few awns and its exertion is good. The number of spikelets per panicle is smaller than that of Odaebyeo and 1,000 grain-weight of brown rice is 21.2 g which is less than 26.3 g of Odaebyeo, but the complete grain ratio is higher. Milled kernels are translucent with non-glutinous endosperm and palatability of cooked rice is good. It shows strong resistance to cold treatment, lodging, premature heading, wilting and viviparous germination during ripening stage. This cultivar shows resistance to leaf blast disease but susceptible to bacterial blight, virus disease and insect pests. The milled rice yield performance of 'Joun' is about 5.18 MT/ha by ordinary culture in local adaptability test for three years. This cultivar may be highly adaptable to the mid-northern inland plain and alpine area, north-eastern coastal area and middle plain area.

• Korean Journal of Breeding Science
• /
• v.41 no.2
• /
• pp.177-181
• /
• 2009

'Pyeongwon' is a new japonica rice cultivar which is developed from a cross between Jinbu19 and Samjiyeon4 from North Korea by the rice breeding team of National Institute of Crop Science, RDA. Pyeongwon has about 107 days duration from seeding to heading in mid-northen plain, alpine, north-eastern coastal and southern alpine areas. It has about 67 cm culm length and tolerance to lodging. Pyeongwon has 13 tillers per hill and 82 spikelets per panicle. It showed tolerance to heading delay and spikelet sterility due to cold treatment similar to Odaebyeo. It also showed slow leaf senescence and moderate tolerance to viviparous germination during the ripening stage. Pyeongwon has resistance to blast disease but susceptible to stripe virus and brown planthopper. Milled rice of Pyeongwon has translucent kernels, relatively clear non-glutinous endosperm and medium short grain. It is characterized as a low gelatinization temperature and slightly lower amylose content (17.1%) variety compared to Odaebyeo (19.5%) and has good palatability of cooked rice. The milled rice yield performance of this cultivar was about 5.28 MT/ha by ordinary culture in local adaptability test for three years. This cultivar may be highly adaptable to the mid-northen plain, alpine, north-eastern coastal and southern alpine areas of Korea.

• Journal of Periodontal and Implant Science
• /
• v.29 no.1
• /
• pp.51-63
• /
• 1999

Exposure of the root surface due to gingival recession after periodontal surgery, elicit pain response when exposed to mechanical, heat, chemical or osmotic irritation. Especially patients treated with periodontal surgery, show high frequency. There have been reports that the 1 out of 7 patients complains of dentinal hypersensitivity. There have been many studies on the clinical effects of various materials on the treatment of dentinal hypersensitivity. The purposes of this study were to evaluate the effect of sodium chloride and potassium oxalate and to observe the relationship between the dentinal hypersensitivity and surface characteristics such as dentinal tubule size and number. This study included 20 teeth which were scheduled for extraction and had no pulpal disease. These teeth were divided into Root planing group, EDTA group, NaCl group and Oxalate group. Dentinal hypersensitivity is measured by tactile, pressured air and cold water using NRS (Numerical Rating Scales). Teeth were extracted under local anesthesia and each specimen was sectioned to a size about 3 X 5 mm and was examined under the scanning electron microscope (X2,000) The results were as follows, 1. The EDTA group exhibited significantly increased dentinal hypersensitivity comparing with the other groups. 2. The NaCl and Oxalate groups showed significantly reduced dentinal hypersensitivity comparing with the EDTA group. 3. As a method for dentinal hypersensitivity measurement, it was presumed thet tactile sensitivity test was not sensitive method but air blast test and cold water test were adequate method. 4. In a SEM study, the root planing group exhibited amorphous smear layer and showed no dentinal tubule orifice, but the EDTA group showed the large number of dentinal tubules. On the other hand, the NaCl and Oxalate groups did not show exposed dentinal tubules. The NaCl group showed more rough root surface than the EDTA group, and the Oxalate group showed many participates to be presumed as calcium oxalate particle. As the results from this study, root planing couldn't expose the dentinal tubule and NaCl and potassium oxalate occluded exposed dentinal tubule effectively. Dentinal hypersensitivity has close relationship with the exposure of dentinal tubules, especially with it's size and number.