• Journal of the Korean Society of Tobacco Science
• /
• v.9 no.1
• /
• pp.35-43
• /
• 1987

This survey was been conducted to classify the distribution of morphological and chemical characteristics of soils in the major districts cultivating flue-cured tobacco plant. The results obtained are summarized as follows; 1. Tobacco was mainly grown in local valley, 7-15% slopes, loam and sandyloam containing gravels, and productivity classes of soil were corresponded to 3-4 degree for upland crops. 2. most soils were acidic (below pH 5.5) and contained low organic matters. (below 2%) 3. Dominant soil series were SANGJU, JIGOG, SEOCTO, SAMGAG ANRYONG, SUAM, and YESAN.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.821-826
• /
• 2003

Laboratory experiments were peformed to understand physical properties of soil-cement column under the influence of acidic flow including metal contaminants and its retaining capacity against metal migration. The contaminant used in this study was nitric acid with Cu and Cd. The Permeability of soil-cement column decreased when pH of the column began to drop below 12. Decreases in pH led to significant reduction of compressive strength of clayey soil-cement specimen, while relatively marginal reduction for sandy soil-cement specimen. The metal contaminants did not leachate from soil-cement column until pH of soil-cement dropped below 7∼8 for Cu and 9∼10 for Cd. Metal contaminants were precipitated and trapped inside the soil-cement column at pHs higher than those mentioned as verified with metal analysis and visual inspection. This indicated that soil-cement column not only performs well as a cut-off wall, but also helps alleviating the level of contamination of the surrounding environment.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 2000.06a
• /
• pp.159-165
• /
• 2000

In this paper the residual stresses on lubricated sliding surfaces were measured during break-in procedure and up to scuffing by the X-ray diffraction method. The cylinder-on-disk type tribometer was used with the line-contact geometry. Scuffing tests were done using a constant load. In the break-in procedure the loads were increased from very low values in several steps. It was found that the sliding surfaces with break-in represented relatively higher values of residual compressive stresses than those without break-in. The residual stresses below the surfaces showed the small amount of stress increases. The results of scuffing tests with and without break-in showed the same trends as break-in tests did. However, in case of tests with break-in procedure the stresses below the surfaces showed very large increases in the residual compressive stresses. From the tests of break-in and scuffing, it was found that the increases in scuffing lives were related with the increases of residual stresses on the lubricated sliding surfaces with break-in.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.4 no.3
• /
• pp.49-54
• /
• 2001

It is common that the soil layer is a few meters below the earth's surface and the rock mass is below the soil layer in the view of geological characteristics in Korea. And the boundary between rock and soil is clearly divided. When dealing with the stability of rock masses, as in the case of rock slopes or dam foundations, the majority of the collapses is not within the soil layer, but within the soil-rock boundary. Therefore it is important to identify the shear strength characteristics between soil-rock boundary. And then in the method of reinforcement on landslide this chose a cut slope near Daemo elementary school in Seoul, surveyed shear strength between soil-rock contacts and considered a large scale collapse using a limit equilibrium method.

• Asian-Australasian Journal of Animal Sciences
• /
• v.8 no.3
• /
• pp.263-265
• /
• 1995

Blood plasma minerals and their effects towards the fertility in 136 cows randomly selected from 26 dairy farms in central Thailand were studied. An average of 8.60 mg% Ca, 5.97 mg% P, 2.45 mg% Mg, $85.9{\mu}g%$ Cu, and $160.9{\mu}g%$ Zn in plasma was observed. Compared to the critical deficient values, 24.3, 10.3, 11.8, 28.7 and 0.0% of the surveyed cows obtained the respective elements in plasma below the standard levels. No significant difference (p >.05) in plasma concentrations of Ca, P, Mg and Zn for the low fertile (conception rate > 3) and fertile (conception rate < 3) cows was found. However, plasma Cu of the low fertile cows (averaged $77.2{\mu}g%$) was lower (p <.01) than that of the fertile ones (averaged $91.12{\mu}g%$). Additionally, it is observed that 47.1% of the cows with the low fertility problem obtained plasma Cu below the 65.0 pg% critical deficient value.

• Proceedings of the IEEK Conference
• /
• 2000.06d
• /
• pp.54-57
• /
• 2000

In this paper, we propose a new interpolation method by using the motion between two moving image frames. In the proposed method, the movement is detected by using neighborhood pixels of target pixel in the past frame and the present frame. Then, H-shaped pseudomedian filter (below HPMED) is used for the still part of the image and Delta-shaped interpolation filter (below $\Delta$-shaped) for used in the moving part of the image. We detect the movement by comparing the differences between pixels in 4${\times}$5 window of the past frame and the present frame; the difference has a critical value. We simultaneously accomplish checking PSNR(peak signal noise ratio) and subjective assessment that is placed the focus on edge characteristic for assessment of result in computer simulation. The results show that the proposed adaptive method is better than the conventional methods.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.3
• /
• pp.182-188
• /
• 2004

We demonstrate a $2.1\;{\times}\;1.0\;{\times}\;0.1cm^3$ sized compact transmitter using LTCC System-in-Package (SiP) technology for 60GHz-band wireless communication applications. For low-attenuation characteristics and resonance suppression of the SiP, we have proposed and demonstrated a coplanar double wire-bond transition and novel CPW-to-stripline transition integrating air-cavities as well as novel air-cavities embedded CPW line. The fabricated transmitter achieves an output of 13dBm at a RF frequency of 62GHz, an IF frequency of 2.4GHz, and a LO frequency of 59.6GHz. The up-conversion gain is 11dB, while the LO signal is suppressed with the image rejection mixer below -21.4dBc, and the image and spurious signals are also suppressed below -31dBc.

• Journal of the Korean Society for Heat Treatment
• /
• v.21 no.2
• /
• pp.69-78
• /
• 2008

Differences in hardness and microstructure between surface and area at 0.3 mm below the surface after quenching and tempering of ductile cast iron for rear planet carrier of automotive transmission have been investigated. Microstructure of ductile cast iron consisted of ferrite, pearlite, and nodular graphite. The amount of pearlite increased with going down to the half-thickness area. It was found that Cr and Mo segregated to the pearlite and the pearlite transformed to the harder martensite during quenching. The martensite was more resistant to the decomposition to ferrite and cementite during tempering because of segregation of Cr and Mo, resulting in the harder tempered martensite. Consequently, the hardness of the surface with less amount of pearlite, corresponding to the harder martensite in the quenched and tempered microstructure, was lower than that of the area at 0.3 mm below the surface.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.7 no.2
• /
• pp.287-297
• /
• 1995

In this study, the geometry consists of a two-dimensional rectangular enclosure with localized heating from below. The size and the location of the heater on the floor has been varied, and one of the vertical walls remains at a low temperature simulating a cold window. The governing equations for momentum, energy and continuity, which are coupled with turbulent equations have been solved using a finite volume method. A low Reynolds number $k-{\varepsilon}$ model has been incorporated to solve the turbulent kinetic energy and the dissipation rate. The heat transfer characteristics and the thermal environmental characteristics of the room have been obtained for various system parameters in a room with a partially heated floor.

• Proceedings of the KIPE Conference
• /
• 2011.11a
• /
• pp.219-220
• /
• 2011

In this paper, 300[W] class boost type single phase inverter system which can compensate voltage sag was designed. If the voltage sag has appeared in input voltage, the boost converter would be operated to compensate it. The system is designed for that the THD of ouput voltage is below 5[%] and steady state error of output voltage is below 1[%]. The system was verified through experiments.