• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.6
• /
• pp.2711-2733
• /
• 2018

Minimizing power consumption in bandwidth limited optical traffic grooming networks is presented as a two-objective optimization problem. Since the main objective is to route a connection, the network throughput is maximized first, and then the minimum power consumption solution is found for this maximized throughput. Both transparent IP over WDM (Tp-IPoWDM) and translucent IP over WDM (Tl-IPoWDM) network may be applied to examine such bi-objective algorithms. Simulations show that the bi-objective algorithms are more energy-efficient than the single objective algorithms where only the throughput is optimized. For a Tp-IPoWDM network, both link based ILP (LB-ILP) and path based ILP (PB-ILP) methods are formulated and solved. Simulation results show that PB-ILP can save more power than LB-ILP because PB-ILP has more path selections when lightpath lengths are limited. For a Tl-IPoWDM network, only PB-ILP is formulated and we show that the Tl-IPoWDM network consumes less energy than the Tp-IPoWDM network, especially under a sparse network topology. For both kinds of networks, it is shown that network energy efficiency can be improved by over-provisioning wavelengths, which gives the network more path choices.

• Journal of Communications and Networks
• /
• v.12 no.1
• /
• pp.30-42
• /
• 2010

In this work we consider the problem of downlink resource allocation for proportional fairness of long term received rates of data users and quality of service for real time sessions in an OFDMA-based wireless system. The base station allocates available power and subchannels to individual users based on long term average received rates, quality of service (QoS) based rate constraints and channel conditions. We formulate and solve a joint bandwidth and power optimization problem, solving which provides a performance improvement with respect to existing resource allocation algorithms. We propose schemes for flat as well as frequency selective fading cases. Numerical evaluation results show that the proposed method provides better QoS to voice and video sessions while providing more and fair rates to data users in comparison with existing schemes.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39B no.2
• /
• pp.61-74
• /
• 2014

In recent years, development of femtocells are receiving considerable attention towards increasing the network coverage, capacity, and improvement in the quality of service for users. In 3GPP LTE-Advanced (LTE-A) system, to efficiently utilize the bandwidth, femtocell and macro cell uses the same frequency band, but this deployment poses a technical challenge of cross-tier interference to macro users. In this paper, the novel quality of service based fractional power control (QoS-FPC) scheme under the heterogeneous networks environment is proposed, which considers the users priority and QoS-requirements during the power allocation. The proposed QoS-FPC scheme has two focal points: firs, it protects the macrocell users uplink communication by limiting the cross-tier interference at eNB below a given threshold, and second, it ensures the optimization of femtocell users power allocation at each power adjustment phase. Performance gain is demonstrated with extensive system-level simulations to show that the proposed QoS-FPC scheme significantly decreases the cross-tier intereference and improves the overall users throughput.

• Journal of electromagnetic engineering and science
• /
• v.15 no.1
• /
• pp.53-58
• /
• 2015

For the testing of nonlinear power amplifiers, this paper suggests an approach to design optimized multisine signals that could be substituted for the original modulated signal. In the design of multisines, complex coefficients should be determined to mimic the target signal as much as possible, but very few methods have been adopted as general solutions to the coefficients. Furthermore, no solid method for the phase of coefficients has been proven to show the best resemblance to the original. Therefore, in order to determine the phase of multisine coefficients, a time-domain nonlinear optimization method is suggested. A frequency-domain-method based on the spectral response of the target signal is also suggested for the magnitude of the coefficients. For the verification, multisine signals are designed to emulate the LTE downlink signal of 10 MHz bandwidth and are used to test a nonlinear amplifier at 1.9 GHz. The suggested phase-optimized multisine had a lower normalized error by 0.163 dB when N = 100, and the measurement results showed that the suggested multisine achieved more accurate adjacent-channel leakage ratio (ACLR) estimation by as much as 12 dB compared to that of the conventional iterative method.

• Journal of Power Electronics
• /
• v.18 no.5
• /
• pp.1523-1535
• /
• 2018

High-performance Phase-Locked Loops (PLLs) are critical for grid synchronization in grid-tied power electronic applications. In this paper, a new single-phase All Digital Phase-Locked Loop (ADPLL) is proposed. It features fast transient response and good robustness under distorted grid conditions. It is designed for Field Programmable Gate Array (FPGA) implementation. As a result, a high sampling frequency of 1MHz can be obtained. In addition, a new OSG is adopted to track the power frequency, improve the harmonic rejection and remove the dc offset. Unlike previous methods, it avoids extra feedback loop, which results in an enlarged system bandwidth, enhanced stability and improved dynamic performance. In this case, a new parameter optimization method with consideration of loop delay is employed to achieve a fast dynamic response and guarantee accuracy. The Phase Detector (PD) and Voltage Controlled Oscillator (VCO) are realized by a Coordinate Rotation Digital Computer (CORDIC) algorithm and a Direct Digital Synthesis (DDS) block, respectively. The whole PLL system is finally produced on a FPGA. A theoretical analysis and experiments under various distorted grid conditions, including voltage sag, phase jump, frequency step, harmonics distortion, dc offset and combined disturbances, are also presented to verify the fast dynamic response and good robustness of the ADPLL.

• Journal of electromagnetic engineering and science
• /
• v.12 no.4
• /
• pp.290-292
• /
• 2012

This paper proposes a setup for a best multisine design method that uses a time-domain optimization. The method is based on minimization of the time-domain error, so its resulting multisine has a very accurate ACLR estimation. This is because its probability distribution and sample-to-sample correlation are close to those of the original signal, which are crucial for the testing of nonlinear power amplifiers. In addition, a hyperbolic-tangent function is introduced to control the ripple of tone magnitudes within signal bandwidth. For the verification, multisines were generated and compared for many aspects such as normalized error, in-band ripple, and ACLR estimation. Test results with different numbers of tones provide supporting evidence that the suggested multisine design has better ripple suppression, by up to 7 dB, and better accuracy, by up to 0.2 dB, when compared to the conventional method. The accuracy of the ACLR was improved by about 5 dB when the number of tones was 4. The suggested method improves the ACLR estimation performance of multisine testing due to its closer resemblance to the target modulation signal.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.4
• /
• pp.811-816
• /
• 2011

In this paper, we propose a optimal design using the Evolution Strategy of a high gain $4\times4$ array antenna that have the resonant frequency of a 19.05GHz with 18.86GHz~19.26GHz bandwidth. The proposed array antenna structure is designed to be allocated equally electric power by microstrip patch power splitter. Thus the optimal array antenna with power splitter are determined by using an optimal design program based on the evolution strategy. To achieve this, an interface program between a commercial EM analysis tool and the optimal design program is constructed for implementing the evolution strategy technique that seeks a global optimum of the objective function through the iterative design process consisting of variation and reproduction. The simulation result of $4\times4$ array antenna is confirmed that the Gain is 19.36 dBi at resonance frequency 19.05GHz.

• Journal of the Korean Society for Precision Engineering
• /
• v.19 no.1
• /
• pp.158-164
• /
• 2002

This paper proposes the optimization of ultrasonic signal recognition in ferrite carbon steel weld zone using neural networks. For these purposes, the ultrasonic signals for defects as porosity, incomplete penetration and slag inclusion in the weld zone are acquired in the type of time series data. And then their applications evaluated feature extraction based on the time-frequency-attractor domain(peak to peak, rise time, rise slope, fall time, fall slope, pulse duration, power spectrum, and bandwidth) and attractor characteristics (fractal dimension and attractor quadrant) etc. The proposed neural networks system in this study can enhances performance of ultrasonic signal recognition.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2022.05a
• /
• pp.272-275
• /
• 2022

The federated learning can be utilized in conjunction with the blockchain technology to provide good privacy protection and reward distribution mechanism in the field of intelligent IOT in edge computing scenarios. Nonetheless, the synchronous federated learning ignores the waiting delay due to the heterogeneity of edge devices (different computing power, communication bandwidth, and dataset size). Moreover, the potential of smart contracts was not fully explored to do some flexible design. This paper investigates the fusion application based on the FLchain, which is the combination of asynchronous federated learning and blockchain, discusses the communication optimization, and explores the feasible design of smart contract to solve some problems.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.18 no.7
• /
• pp.1749-1773
• /
• 2024

Recent advances in deep neural networks (DNNs) have greatly improved the accuracy and universality of various intelligent applications, at the expense of increasing model size and computational demand. Since the resources of end devices are often too limited to deploy a complete DNN model, offloading DNN inference tasks to cloud servers is a common approach to meet this gap. However, due to the limited bandwidth of WAN and the long distance between end devices and cloud servers, this approach may lead to significant data transmission latency. Therefore, device-edge collaborative inference has emerged as a promising paradigm to accelerate the execution of DNN inference tasks where DNN models are partitioned to be sequentially executed in both end devices and edge servers. Nevertheless, collaborative inference in heterogeneous edge environments with multiple edge servers, end devices and DNN tasks has been overlooked in previous research. To fill this gap, we investigate the optimization problem of collaborative inference in a heterogeneous system and propose a scheme CIS, i.e., collaborative inference scheme, which jointly combines DNN partition, task offloading and scheduling to reduce the average weighted inference latency. CIS decomposes the problem into three parts to achieve the optimal average weighted inference latency. In addition, we build a prototype that implements CIS and conducts extensive experiments to demonstrate the scheme's effectiveness and efficiency. Experiments show that CIS reduces 29% to 71% on the average weighted inference latency compared to the other four existing schemes.