• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.13 no.3
• /
• pp.96-106
• /
• 2014

Necessarily traffic policies have been biased in car than pedestrian, so pedestrian's environment is getting worse. Result of this situation our accident rate is high as 36.4%, compared to OECD member countries with average rate of 17.8%(in 2009). Increasing interest for pedestrians environment improvement, and it make an effort to build environment to guarantee walk and safety of pedestrians. Analysis on the binary logistic regression(BLR) was used. The dependent variable is occurring from the road width of less than 9m accident, and independent variable extracted can be obtained from the traffic accident data. Traffic accident on roads having width of less than 9 meters affecting variables is when the driver is straight, when the driver is female, when the pedestrian is walk driveway, and so on. To prevent it, efforts is demanded to protect handicapped, to build safe pedestrians environment using C-ITS and to decrease speed of going straight vehicle on roads having width of less than 9 meters.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.12
• /
• pp.127-134
• /
• 2005

Lost packet robustness is an most important quality measure for voice over IP networks(VoIP). Recovery of the lost packet from the received information is crucial to realize this robustness. So, this paper proposes the lost packet recovery method from the received information for real-time communication for CELP coder. The proposed BS-PLC (Both Side Packet Loss Concealment) based WSOLA(Waveform Shift OverLab Add) allow the lost packet to be recovered from both the 'previous' and 'next' good packet as the LP parameter and the excitation signal are respectively recovered. The burst of packet loss is modeled by Gilbert model. The proposed scheme is applied to G.729 most used in VoIP and is evaluated through the SNR(signal to noise) and the MOS(Mean Opinion Score) test. As a simulation result, The proposed scheme provide 0.3 higher in Mean Opinion Score and 2 dB higher in terms of SNR than an error concealment procedure in the decoder of G.729 at $20\%$ average packet loss rate.

• Korean Journal of Health Education and Promotion
• /
• v.18 no.1
• /
• pp.61-78
• /
• 2001

The purpose of this research was to find out plans to promote the fulfillment of the breast self-examination and breast cancer screening, which is preventive health behavior about women's having breast cancer exam in some part of our country with searching for the primary causes which have an effect on their fulfillment. The subjects of the study were 540 literate volunteers who were of age from 20 to 69 and who visited 8 health centers in Taegu. The survey research was made through questionares in the 8 health centers in Taegu from the 15th to the 30th of September, 1998. Based on Becker's health belief model asking medical staff's opinions with bibliographies, the major findings from the survey was as follow. The fulfillment rate of the breast self-examination and the breast cancer screening was 37.8％(204 subjects), 27.6％ (149 subjects) each. Getting breast self-exam varied significantly depending on subject's age, income of family, religion, occupation and the number of children. As far as the breast cancer screening was concerned, there was remarkably significant difference in accordance with their age, marital status, religion, occupation, income of family, the number of children, ways of nursing and parturition age of the first baby. The subjects in their forties accounted for the highest rate. Based on the fulfillment of the breast self-examination and the breast cancer screening, the average points of all the variables presented from the health belief as well as the points of the susceptibility, seriousness, benefits, knowledge and level of health concern of interest in health were significantly higher than the points of non-fulfillment of them in the statistical analysis whereas the barriers was lower than them. In consequence of the multiple-logistic regression analysis putting the breast self-examination and the breast cancer screening in dependent variables, occupation, knowledge, seriousness, benefits, barriers and cues to action had significant effects on breast self-examination against breast cancer. Looking more attainments, thinking diseases more seriously, feeling more usefulness and there being any patient around with breast cancer led to the higher rate of the breast self-examination against it. On the other hand, feeling more impedition as well as housewives caused the lower rate of it. The breast cancer screening was significantly affected by age, sensitivity, usefulness, impedition and behavior momentum as well. The cases who are older, feeling more sensitivity against breast cancer, more usefulness of the examination and where any patient around, the fulfillment rate was higher. Contrarily the more impedition they felt, the lower the fulfillment rate was. Accordingly, the study of the causes, which have significant effects on the fulfillment of the self-examination and the breast cancer screening in order to find it in an early stage, and the development of health education programs as well as proper education for public health through carrying on campaigns and stepping up public relations must be indispensable.

• Journal of the Korea Convergence Society
• /
• v.8 no.6
• /
• pp.139-145
• /
• 2017

The aim of this study was to measure the remineralization effect of APF gel and fluride varnish on artificial enamel caries using CLSM in vitro. The samples were divided into 3 groups: control, 1.23% APF gel, 5% NaF varnish. The specimen surfaces were observed by CLSM and measured average fluorescence of the lesion(AFL). The results were analyzed using one-way ANOVA and Pearson's correlation analysis at a significance level off 0.05(PSWA 18.0, SPSS Inc., USA). There were significant differences between AFL at baseline and 1 day after fluoride application(p<0.05) but there are no significant differences between ${\Delta}$ AFL of all groups (p=0.222). Result of Pearson's correlation analysis, there are no significant correlation between VHN and AFL, but there were significant correlation between AFL at baseline and 1 day after fluoride application(r=0.811, p<0.001). Although AFL decreased after fluoride application, but there was no difference between the groups. In the future, it is necessary to test the oral environment model or in situ experiment supplemented the limitations of this study.

• The Journal of Korean Academy of Prosthodontics
• /
• v.35 no.3
• /
• pp.517-534
• /
• 1997

It has been held that excessive mechanical forces to the osseous and soft tissues of the TMJ result in joint dysfunction. Understanding the stress pattern on TMJ is very important in TMJ research. But, it is very difficult to measure directly the biomechanical stress distribution in the TMJ when the mandible is loaded. Therefore, stress distribution in the TMJ during functional movement was studied through animal experiment or mathematical model. It was observed and compared the stress distribution occuring in the working and balancing condyle when lower right canine, lower right first molar and lower right second molar were clenched by the three dimensional finite element analysis. Also, stress distribution in the working and balancing condyles were observed and compared when $20^{\circ}$ forward and buccal bite forces were applied to the first molar. The results were as follows : 1. Stress distribution in the condyles during unilateral clenching of the first molar, second molar, canine showed no difference. In the working condyle, tensile force was concentrated on the lateral aspect of the condylar articular surface and condylar neck. And compressive force was concentrated on the anteromedial and lateral aspect of condyle. In the balancing condyle, tensile and compressive forces were concentrated on the lateral aspect of the condylar articular surface and stress transmission to the temporal bone was not observed. 2. When lateral forces were applied to the first molar, tensile forces were concentrated on the medial aspect of the condylar neck and condylar posterior surface in working and balancing condyle. Compressive force was concentrated on the anteromedial and lateral surface of the condyle and stress transmission to the temporal bone was not observed. 3. During unilateral clenching, stress in the working condyle decreased as the occlusal load moved posteriorly while the stress in the balancing condyle increased. when lateral force was applied to first molar, the incremental amount of stress was greater than vertical load. 4. During unilateral clenching, the average balancing/working condyle stress ratio was 2.52. There was a greater concentration of stress in the balancing condyle. The ratio increased as the occlusal load moved posteriorly and decreased considerably when lateral forces were applied to the first molar.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.11
• /
• pp.7990-8000
• /
• 2015

Plant factories are plant cultivation systems which produce farm products uniformly under the controlled environmental condition regardless of seasons and places. Thermal flow in the plant factory is an important parameter in cultivating plants. In this research, we study thermal flow characteristics for a hybrid plant factory with multi-layer cultivation shelves using computer simulation techniques. In order to obtain numerical solutions for thermal flow characteristics, a finite volume method was applied. We consider a low-Reynolds-number ${\kappa}-{\epsilon}$ turbulence model, incompressible viscous flows, and pressure boundary conditions for numerical simulation. Commercial software Solid Works Flow Simulation is then used to investigate characteristics of thermal flows in the plant factory applying several different inflow air velocities and arrangements of cultivation shelves. From numerical analysis results, we found that temperatures in cultivation shelves were uniformly distributed for Case 3 when the inflow air velocity was 1.6 m/s by using a blower in the plant factory. However in Case 1 lower temperature distributions were observed in test beds, TB2 and TB3, which indicated that additional temperature control efforts would be required. Average shelf temperature increased by $3^{\circ}C$ using artificial light source (DYLED47) with 50% blue and 50% red LED ratios. Korea Academia-Industrial cooperation Society.

• The Transactions of the Korea Information Processing Society
• /
• v.4 no.7
• /
• pp.1804-1820
• /
• 1997

In this paper, an efficient call control procedure is presented for next generation wireless ATM networks and its performance is mathematically analyzed using the open queueing network. This procedure is based on a new scheme called as the cell clustering. When we use the cell clustering scheme, at the time that a mobile connection is admitted to the network, a virtual cell is constructed by choosing a group of neighboring base stations to which the call may probabilistically hand over and by assigning to the call a collection of virtual paths between the base stations. Within a microcell/picocell environment, it is seen that the cell clustering can support effectively a very high rate of handovers, provides very high system capacity, and guarantees a high degree of frequency reuse over the same geographical region without requiring the intervention of the network call control processor each time a handover occurs. But since mobiles, once admitted, are free to roam within the virtual cell, overload condition occurs in which the number of calls to be handled by one base station to exceed that cell site's capacity of radio channel. When an overload condition happens, the quality of service is abruptly degraded. We refer to this as the overload state and in order to quantify the degree of degradation we define two metrics, the probability of overload and the normalized average time spent in the overload state. By using the open network queueing model, we derive closed form expressions for the maximum number of calls that can be admitted into the virtual cell such that the two defined metrics are used as the acceptance criteria for call admission control.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.1
• /
• pp.121-132
• /
• 2000

This study is to investigate the performance of a new BNR process using predenitrification scheme focusing on nitrogen removal and the possibility of adapting a computer simulation scheme in BNR process development. By using a pre-denitrification basin, higher $COD/NO_3-N$ ratio could be sustained in this BNR process. The results of the investigation showed a SDNR value of 9.04mg/gMv/hr. In the anoxic tank, the average value of SPRR of 6.25mgP/gMv/hr was observed to be very sensitive to SCOD load of influents. By calibrating internal parameters (stoichiometric and kinetic parameters) of the simulation model, the results of simulation for various BNR processes gave good agreement with observed data. The major adjustment was given with three parameters, maximum specific growth rate of heterotrophic biomass, short chain fatty acid (SCFA) limit, and phosphorous release rate. With the series of simulations on varying operational conditions, the simulation by computer program can be a useful tool for process selection, and design and operation of municipal wastewater treatment plant.

• Economic and Environmental Geology
• /
• v.47 no.6
• /
• pp.635-643
• /
• 2014

Sustaiable development yield of groundwater in Korea has been determined according to 10 year drought frequency of groundwater recharge in the standard mid-sized watershed or relatively large area of district. Therefore, the evaluation of groundwater impact in a small watershed is hard to apply. Fot this purpose, a novel approach to estimate cell based sustainable development yield of groundwater (SDYG) is suggested and applied to Gyeongju region. Cell based groundwater recharge is computed using hydrological component analysis using the SWAT-MODFLOW which is an integrated surface water-groundwater model. To estimate the potential amount of groundwater development, the existing method which uses 10 year drought frequency rainfall multiplied by recharge coefficient is adopted. Cell based SDYGs are computed and summed for 143 sub-watersheds and administrative districts. When these SDYGs are combined with groundwater usage data, the groundwater usage rate (total usage / SDYG) shows wide local variations (7.1~108.8%) which are unseen when average rate (24%) is only evaluated. Also, it is expected that additional SDYGs in any small district could be estimated.

• 대한공업교육학회지
• /
• v.33 no.1
• /
• pp.265-281
• /
• 2008

The objective of this study is to show practice example let student experience about concurrent servers based multi-processes and multi-thread among the principles of data communication in ICT(information and communications technology). For this, we first implement multi-process server(fork server) and multi-thread server(thread server), and multi-thread client(thread client), Secondly, for experimental environment, we developed small ethernet networks and measure data transfer time with relation to the number of users. Experimental results show that mean transfer time of thread server is less than that of fork server by 20~61 % on average. Furthermore, it is found that the difference of data transfer time between fork server and thread server is proportional to that of the number of users. Main reason of performance difference dues to the difference between process forking time and thread creation time. We can also find that context switching for process and thread affects the load of web server. Our presentation and experimental results can be applied to used as the educational practice materials with which student can experience data communication principles.