• Medical Lasers
• /
• v.8 no.2
• /
• pp.43-49
• /
• 2019

The plume produced by vaporizing tissue with a laser contains a variety of contaminants called laser-generated air pollutants (LGACs). LGACs consist of a mixture of toxic gas components, biomicroparticles, dead and living cells, and viruses. Toxic odors and thick smoke from surgical incisions and the coagulation of tissues can irritate eyes and airways, as well as cause bronchial and pulmonary congestion. Because of the potential risk of the smoke, it is advisable to appropriately remove it from the surgical site. We recommend using a smoke evacuator to remove the smoke. Suction nozzles should be placed as close as possible to the surgical site in a range of 2 cm or less. In-line filters should be used between the inlet and outlet of the surgical site. All air filtration devices should be capable of removing particles below 0.1 microns in size. The filter pack should be handled according to infection control procedures in the operating room. The laser mask can be an auxiliary protective device if it is properly worn. Some smoke inhaled under the nose wrap or over the side of the mask will not be filtered. As in electrosurgical operations, a suitable mask should be worn while smoke is present.

• The Korean Journal of Mycology
• /
• v.46 no.3
• /
• pp.295-306
• /
• 2018

In the present study, we compared the effects of 50% ethanolic extracts of Chinese and Korean Wolfiporia cocos (CPE and KPE) on in vitro lipid accumulation in 3T3-L1 cells and their anticancer activities in Sarcoma 180 cells. We further compared the anticancer activities and the 50% inhibitory concentrations ($IC_{50}$) of CPE with KPE with cultivated for one and two years in a landfill and a facility (LPE and FPE), respectively. In addition, the single oral dose toxicities of CPE and KPE were evaluated in mice. Lipid accumulation was inhibited after 48 hours, in CPE and KPE treated 3T3-L1 cells; however, no significant difference was observed between CPE and KPE in their lipid accumulation inhibitory activities. The anticancer activity of KPE was higher than that of CPE at $300{\mu}g/mL$ (p<0.05), revealing the possibility of an auxiliary biological means for origin identification. The anticancer activities of LPE and FPE were significantly stronger than that of CPE (p<0.05) but there was no difference between extracts from one- and two-year-old W. cocos, irrespective of the cultivation method. In single oral dose toxicity tests, CPE and KPE did not induce mortality during the 14-day observation. Thus, the 50% of lethal dose ($LD_{50}$) of CPE and KPE were estimated to be higher than 2,000 mg/kg. Taken together, our results indicate that the anticancer assay could be an auxiliary means of identifying the origin of W. cocos. In addition, artificial cultivation could be an alternative way to reduce the import of W. cocos. Lastly, 50% ethanolic W. cocos extracts could be potential candidates for obesity and cancer managements.

• The Korean Journal of Physiology and Pharmacology
• /
• v.21 no.2
• /
• pp.241-249
• /
• 2017

Plasma membrane hyperpolarization associated with activation of $Ca^{2+}$-activated $K^+$ channels plays an important role in sperm capacitation during fertilization. Although Slo3 (slowpoke homologue 3), together with the auxiliary ${\gamma}^2$-subunit, LRRC52 (leucine-rich-repeat-containing 52), is known to mediate the pH-sensitive, sperm-specific $K^+$ current KSper in mice, the molecular identity of this channel in human sperm remains controversial. In this study, we tested the classical $BK_{Ca}$ activators, NS1619 and LDD175, on human Slo3, heterologously expressed in HEK293 cells together with its functional interacting ${\gamma}^2$ subunit, hLRRC52. As previously reported, Slo3 $K^+$ current was unaffected by iberiotoxin or 4-aminopyridine, but was inhibited by ~50% by 20 mM TEA. Extracellular alkalinization potentiated hSlo3 $K^+$ current, and internal alkalinization and $Ca^{2+}$ elevation induced a leftward shift its activation voltage. NS1619, which acts intracellularly to modulate hSlo1 gating, attenuated hSlo3 $K^+$ currents, whereas LDD175 increased this current and induced membrane potential hyperpolarization. LDD175-induced potentiation was not associated with a change in the half-activation voltage at different intracellular pHs (pH 7.3 and pH 8.0) in the absence of intracellular $Ca^{2+}$. In contrast, elevation of intracellular $Ca^{2+}$ dramatically enhanced the LDD175-induced leftward shift in the half-activation potential of hSlo3. Therefore, the mechanism of action does not involve pH-dependent modulation of hSlo3 gating; instead, LDD175 may modulate $Ca^{2+}$-dependent activation of hSlo3. Thus, LDD175 potentially activates native KSper and may induce membrane hyperpolarization-associated hyperactivation in human sperm.

• Transactions of the Korean hydrogen and new energy society
• /
• v.25 no.3
• /
• pp.271-279
• /
• 2014

A 25kW-class polymer electrolyte membrane (PEM) fuel cell system has been developed for the propulsion of a leisure boat. The fuel cell system was designed to satisfy various performance requirements, such as resistance to shock, stability under rolling and pitching oscillations, and durability under salinity condition, for its marine applications. Then, the major components including a 30kW-class PEM fuel cell stack, a DC-DC converter, a seawater cooling system, secondary battery packs, and balance of plants were developed for the fuel cell system. The PEM fuel cell stack employs a unique design structure called an anodic cascade-type stack design in which the anodic cells are divided into several blocks to maximize the fuel utilization without hydrogen recirculation devices. The performance evaluation results showed that the stack generated a maximum power of 31.0kW while maintaining a higher fuel utilization of 99.5% and an electrical efficiency of 56.1%. Combining the 30-kW stack with other components, the 25kW-class fuel cell system boat was fabricated for a leisure. As a result of testing, the fuel cell system reached an electrical efficiency of 48.0% at the maximum power of 25.6kW with stable operability. In the near future, two PEM fuel cell systems will be installed in a 20-m long leisure boat to supply electrical power up to 50kW for propelling the boat and for powering the auxiliary equipments.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.339-344
• /
• 2005

A PEMFC system model for FCEV was constructed and simulated numerically to examine the heat/water flow of the system and air/fuel humidification process for various operation conditions (ambient pressure /temperature/humidity, operating temperature, power load). We modeled PEMFC stack which can generate maximum electricity of about 80 kW. This stack consists of 400 unit cells and each unit cell has $250cm^2$ reacting area. Uniform current density and uniform operating voltage per each cell was assumed. The results show the flow characteristics of heat and water at each component of PEMFC system in macro-scale. The capacity shortage of the radiator occurred when the ambient was hot $(over\;40^{\circ}C)$ and power level was high (over 50 kW). In spite of some heat release by evaporation of water in stack, heat unbalance reached to 20kW approximately in such a severe operating condition. This heat unbalance could be recovered by auxiliary radiators or high speed cooling fan with additional cost. In cold environment, the capacity of radiator exceeded the net heat generation to be released, which may cause a problem to drop the operating temperature of stack. We dealt with this problem by regulating mass flow rate of coolant and radiator fan speed. Finally, water balance was not easily broken when we retrieved condensed and/or unused water.

• Transactions of the Korean hydrogen and new energy society
• /
• v.14 no.1
• /
• pp.35-45
• /
• 2003

Polymer electrolyte fuel cells(PEFC) have been considered to be a suitable candidate for residential, portable and mobile applications, due to their high efficiency and power density, even at low operating temperature. KIER developed a 5kW class PEFC system for residential application and operated the system for over 1,000 hours. To develop a 5kW PEFC system, performance of a cell was improved through successive tests of single cell of small and large area. Fabrication of three 2,5 kW class stacks, design and fabrication of natural gas reformer, design of auxiliary equipments such as DC/DC converter, DC/AC inverter and humidifying units were carried out along with integration of components, operation and evaluation of total system. During the development period from 1999 to 2001, MEA(membrane electrode assembly) fabrication technologies, design and fabrication technologies for separators, stacking technologies and so on were developed, thereby providing basis for developing stacks of higher efficiency and power density in the future. Experience of development of natural gas reformer opened possibilities to use various kinds of fuels. Main results obtained from the development of a 5kW class PEFC system for residential application are summarized.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.12
• /
• pp.6039-6045
• /
• 2012

This study was conducted to assess the predictive value of p-glycoprotein (p-gp) and p53 immunoexpression in human papillomavirus (HPV) infected cases of cervical dysplasia. Expression of both p-gp and p53 proteins was detected in cervical smears from 177 squamous intraepithelial lesions (SIL) cases along with 183 "atypical squamous cells of unknown significance" (ASCUS) and 150 normal cases. HPV 16 and 18 infection was detected by polymerase chain reaction using type-specific primers for HPV sub-types. There were no significant detectable p53 and p-gp expression in the normal cervix smears (p>0.05). In the ASCUS group 10 cases were positive for both p53 and p-gp immunoreactivity. In cervical dysplasia cases, p53 was positive in 86 (48.58%) while p-gp was positive in 93 (52.54%) and the two markers showed a highly significant correlation (r=0.92, p<0.001). Expression of p53 and p-gp was associated with grade of SIL (p<0.001). A positive correlation between the presence of HPV and expression of proteins p53 and p-gp in smears of patients with cervical lesions was also noted (p<0.001). Thus, p53 and p-gp immunostaining in cervical smears may act as an auxiliary biomarker for detection of HPV-associated cervical lesions. Additionally, a significant positive correlation between ascending grades of SIL and labeling indices of markers suggests that p53 and p-gp can be used as an adjunct to cytomorphological interpretation of conventional cervical Pap smears.

• Molecules and Cells
• /
• v.39 no.7
• /
• pp.550-556
• /
• 2016

During meiosis, exchange of DNA segments occurs between paired homologous chromosomes in order to produce recombinant chromosomes, helping to increase genetic diversity within a species. This genetic exchange process is tightly controlled by the eukaryotic RecA homologs Rad51 and Dmc1, which are involved in strand exchange of meiotic recombination, with Rad51 participating specifically in mitotic recombination. Meiotic recombination requires an interaction between homologous chromosomes to repair programmed double-strand breaks (DSBs). In this study, we investigated the budding yeast meiosis-specific proteins Hop2 and Sae3, which function in the Dmc1-dependent pathway. This pathway mediates the homology searching and strand invasion processes. Mek1 kinase participates in switching meiotic recombination from sister bias to homolog bias after DSB formation. In the absence of Hop2 and Sae3, DSBs were produced normally, but showed defects in the DSB-to-single-end invasion transition mediated by Dmc1 and auxiliary factors, and mutant strains failed to complete proper chromosome segregation. However, in the absence of Mek1 kinase activity, Rad51-dependent recombination progressed via sister bias in the $hop2{\Delta}$ or $sae3{\Delta}$ mutants, even in the presence of Dmc1. Thus, Hop2 and Sae3 actively modulate Dmc1-dependent recombination, effectively progressing homolog bias, a process requiring Mek1 kinase activation.

• Korean Journal of Food Science and Technology
• /
• v.34 no.6
• /
• pp.1115-1122
• /
• 2002

To evaluate the physiological properties of 22 varieties of legumes, antioxidative activity, antimutagenicity against Mitomycin C, genotoxicity, and mutagenicity were tested. Ethanolic extracts of legumes had significant antioxidative activities in the tests of electron-donating ability to DPPH radical, hydroxy radical-scavenging activity, and inhibitory effect on lipid auto-oxidation model system. Soy sprout bean (green), mung bean, and small black bean (green) had excitatory effects on the growth of E. coli PQ 37 cell. Black bean and green soy bean had inhibitory effects on the mutagenicities of the cells. Rice bean, pea, mung bean, and bonavista bean showed antimutagenic activities against chemical mutagen, Mitomycin C. Thus, rice bean and mung bean were found to be appropriate auxiliary ingredients of rice cake and rice processing food for the promotion of health and augmentation of rice and legume consumptions.

• Polymer(Korea)
• /
• v.32 no.5
• /
• pp.458-464
• /
• 2008

A successful scaffold should have a highly porous structure and good mechanical stability. High porosity and appropriate pore size provide structural matrix for initial cell attachment and proliferation enabling the exchange of nutrients between the scaffold and environment. In this paper the highly porous scaffold of poly(${\varepsilon}$-caprolactone) electrospun nanofibers could be manufactured with an auxiliary electrode and chemical blowing agent (BA) under several processing conditions, such as the concentration of PCL solution, weight percent of a chemical blowing agent, and decomposition time of a chemical blowing agent. To attain stable electrospinnability and blown nanofiber mats having high microporosity and large pore, a processing condition, 8wt% of PCL solution and 0.5wt% of a chemical blowing agent under $100^{\circ}C$ and decomposition time of $2{\sim}3\;s$, was used. The growth characteristic of human dermal fibroblasts cells cultured in the mats showed the good adhesion and proliferation on the blown mat compared to a normal electrospun mat.