• Journal of Power System Engineering
• /
• v.19 no.4
• /
• pp.69-75
• /
• 2015

In this study, the characteristics of heating performance of a high-performance air-cooled heat pump with vapor-injection(VI) cycle using re-heater was investigated experimentally. Devices used in the experiment is consist of a VI compressor, condenser, oil separator, refrigerant (economizer outlet refrigerant) re-heater, economizer, evaporator. And R410A was used as a working fluid. The experiment was conducted with two cycles(cycles A and B) for investigating heating performance. In case of cycle B, heat exchange was conducted by re-heater between outlet refrigerant of compressor and suction refrigerant of the VI system(Fig.1, re-heater). But the re-heater was not used in case of cycle A. As a result of this experiment, discharge temperature of refrigerator in compressor was shown higher value, when the cycle B was conducted, because of the heat exchange between suction refrigerant of VI cycle and outlet refrigerant of compressor in the re-heater than cycle A that was not use re-heater. it means that liquid hammer and the decrement of heating performance can be decreased by using re-heater. Also, Heating coefficient of performance(COPh) was shown about 2.98 in Cycle B which was 4% higher than Cycle A and from these results, It was confirmed that the improvement of the heating performance of heat pump with VI cycle can be achieved by applying re-heater.

• Journal of Korean society of Dental Hygiene
• /
• v.19 no.1
• /
• pp.141-149
• /
• 2019

Objectives: To investigate the real-world re-use of disposable dental supplies (DDS) in dental offices and assess the relationship between general characteristics of dental hygienists and reuse of DDS, with respect to infection control characteristics. Methods: A questionnaire was administered to 277 dental hygienists to assess their general characteristics, awareness of infection control/DDS management, and re-use of DDS. Nine DDS were categorized into the following categories based on their purpose: Critical, Semicritical, Noncritical, and Personal protective equipment (PPE). The association between general characteristics of dental hygienists and re-use of DDS, with respect to infection control characteristics, was assessed using the chi-squared test. Results: All 9 DDS were re-used to different extents. The highest reuse rate of supplies were for masks (64.6%), prophylaxis cups (61.0%) and plastic saliva ejectors (30.0%). Overall, 89.5% of the participants re-used DDS; subgroup analysis showed the following proportions of specific DDS re-use: PPE 66.4%; Semicritical DDS 63.9%; Noncritical DDS 19.5%; and Critical DDS 1.8%. Based on the type of clinic, the rate of re-use was higher in dental clinics than dental hospitals. Thus, the re-use of DDS may be caused by inappropriate or nonexistent guidelines or habitual practice, rather than the awareness or attitude of dental hygienists. Conclusions: In order to ensure a safe environment within the dental clinic, DDS classifications must be clearly outlined in the dental infection control guidelines; moreover, additional studies are needed regarding the regulations for DDS re-use and disposal.

• Journal of Korean Society of Forest Science
• /
• v.97 no.5
• /
• pp.547-551
• /
• 2008

The study aimed to develop a cryopreservation method for long-term storage using mature somatic embryo of Japanese larch. In this study, desiccation treatments significantly affected re-induction rates of embryogenic tissue (ET) from dried somatic embryos. In the effect of different dehydration temperature and duration on the re-initiation ET. the highest frequency was shown when somatic embryos were dehydrated at $25^{\circ}C$ for 2 (45.5%) or 1 day (43.3%), respectively. In addition, low temperatures [$4^{\circ}C$, 2 days (44.2%) or 3 days (43.5%)] were marked higher ET initiation. After that, the initiation value was declined with dehydration duration. For comparison of different relative humidity on re-induction frequency of ET, the best re-induction (43.5%) was obtained from somatic embryos pre-dried at $(NH_4)_2SO_4$ (RH 79%). Both $Na_2HPO_4$ (RH 97%) and $Na_2CO_3$ (RH 88%) treatments were showed the similar rate, 34.6, 34.2%, respectively. However the lowest rate (19.6%) was observed in distilled water (RH 100%). In comparison of the various storage temperatures and duration of the dried somatic embryos, the highest frequency (66.9%) of re-initiation was obtained when somatic embryos were cryopreserved for one day. However, the frequency was gradually decreased as the time length of storage increased regardless of types of storage. None of ET re-initiated when stored at $4^{\circ}C$ for 1, 2 and 84 days.

• Journal of architectural history
• /
• v.14 no.1 s.41
• /
• pp.107-122
• /
• 2005

The purpose of this study is to analyse Herzog & de Meuron's surface, which represents contemporary architectural trends toward surface. Semper's Bekleidung theory and the important architectural theories about surface were compared according to the conceptual opposition between representation and re-presentation, which is borrowed from Kastern Harris, and again Martin Heidegger. Representation means a sort of translation into a different medium. It doesn't preserve the material identity of what it represent. Re-presentation, however, celebrates the material employed. The tension between representation and re-presentation have activated the architectural history Contemporary architects have emphasized re-presentation at the expense of representation. This trends relate with digital technology, which demands surface or skin independent from depth or interior. Buildings that deserve to be called works of architecture invite us to attend to material in a different way Re-presenting its materials, the work of architecture reveals its being. Such revelation requires that materials work in a way that invites us to step back from our usual involvement with things. It's the poetics of re-presentation, which is emboded in the Herzog & de Meuron's architectural works.

• The Korean Journal of Nuclear Medicine
• /
• v.34 no.4
• /
• pp.344-352
• /
• 2000

Purpose: Re-188-Hydroxyethylidene diphosphonate (HEDP) is a new cost-effective agent for systemic radioisotope therapy of metastatic bone pain. We investigated the influence of carrier for labeling and biodistribution of Re-188-HEDP using HEDP kit with or without carrier ($KReO_4$). Materials and Methods: The kits (HEDP 15 mg, gentisic acid 4 mg and $SnCl_2.2H_2O_2$ 4.5 mg) with or without carrier ($KReO_4$ 0.1 mg) were labeled with Re-188 solution, made available from an in-house generator by boiling for 15 min. We compared the labeling efficiency and stability of carrier-added and carrier-free preparations of Re-188-HEDP Biodistribution and imaging studies of each preparation were performed in ICR mice ($1.85{\sim}3.7MBq/0.1ml$) and SD rats ($74.1{\sim}85.2MBq/0.5ml$). Results: The carrier-added preparation showed high labeling efficiency (95% at pH 5) and high stability in serum (88%, 3 hr). However, the carrier-free preparation showed low labeling efficiency (59% at pH 5) and low stability (43%, 3 hr). The carrier-added preparation showed high uptake in bone and low uptake in stomach and kidneys. However, the carrier-free preparation showed lower uptake in bone and higher uptake in both stomach and kidneys, which is supposed to be due to released perrhenate. The carrier-added preparation also showed better images with higher skeletal accumulation, lower uptake in other organs and lower soft tissue uptake than the carrier-free preparation. Conclusion: The results of these studies clearly demonstrate that addition of carrier perrhenate is required for high labeling efficiency, stability, bone uptake and good image quality of Re-188-HEDP.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.49 no.4
• /
• pp.218-222
• /
• 2023

Re-ankylosis is a common postoperative complication of temporomandibular joint (TMJ) ankylosis surgery. Various surgical options to prevent re-ankylosis, both with and without interpositional material, have been discussed in the literature. However, no standardized protocol has been suggested for management or prevention of TMJ ankylosis. This paper discusses the probable causes behind TMJ re-ankylosis and presents a case of unilateral TMJ re-ankylosis, which was managed by gap arthroplasty using an autologous abdominal dermal fat graft as an interpositional material and closely monitored for signs of relapse. Autologous fat graft acted as an effective barrier between the glenoid fossa and mandibular condyle, thus preventing dead space, hematoma and heterotrophic bone formation. A brief review of the literature and update on TMJ re-ankylosis are also presented.

• Journal of Information Technology Services
• /
• v.14 no.2
• /
• pp.1-14
• /
• 2015

As mobile distribution environment is changing rapidly and competition is more intensive in businesses today, technology based self service have been changed and developed. Among the change, financial institutes and consumers are interested in mobile banking services. This study attempted to investigate the impact of service convenience value on customer satisfaction and re-usage intention, and investigated the moderate effect of technology anxiety in the relationship between service convenience value and mobile banking service usage. For this study, data were gathered from respondents who have experience using mobile banking service and analyzed by structural equation model. A convenience value affected consumer satisfaction and re-usage intention toward mobile banking service. Also, this study found that the more technology anxiety, the less re-usage intention. The results show that management and investment to improve convenience value and to reduce technology anxiety make consumers' satisfaction and re-usage intention toward mobile banking service.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09b
• /
• pp.1198-1199
• /
• 2006

Type I clathrate $Ba_8Al_{16}Si_{30}$ was produced by arc melting and hot pressing and thermoelectric properties were investigated. Negative Seebeck coefficient at all temperatures measured, which means that the majority carriers are electrons. Electrical conductivity decreased by increasing temperature and thermal conductivity was 0.012 W/cmK at room temperature and dimensionless thermoelectric figure of merit (ZT) was 0.01 at 873K.

• Journal of Information Technology Services
• /
• v.8 no.1
• /
• pp.99-111
• /
• 2009

Rapid growth of Management Information System (MIS) and evolution of software system enlarge maintenance necessity and it needs a process to implement information system service in business. This paper proposes service-oriented maintenance process of component software based on service design and implementation provided by existing processes for maintenance, MaRMI-RE and ITIL. The proposed process derives activities and tasks of the process by identifying services according to service guidelines. Service-oriented maintenance process is produced by analyzing correlation between the derived activities and tasks and MaRMI-RE's and adding the tasks to MaRMI-RE. To verify availability of the proposed service-oriented maintenance process, correlation between artifacts is proved.

• Journal of the Korea Concrete Institute
• /
• v.24 no.2
• /
• pp.195-204
• /
• 2012

In the construction of high-rise buildings, bent re-bars are manually straightened to connect slabs to core-walls, which are usually cast before floor structures. During cold bending and straightening of re-bars, plastic deformation causing work hardening, Bauschinger effect and aging hardening is unavoidable. Tensile tests of coldly bent and straightened re-bars were conducted with test parameters of grade, diameter, and bend radius of re-bars as well as age between bending and straightening. Test results showed that proportional limits were lower and strain hardening occurred without yield plateaus. Inside and outside of re-bars with compression and tension deformations, respectively, during bending showed lower yield points due to Bauschinger effect and no yield plateaus due to work hardening, respectively. When re-bar grade was higher, yield point became significantly lower where Grade 400 re-bars had yield strengths lower than specified yield strength of 400 MPa. Because the surface of re-bar has higher strength than the core of re-bar, Bauschinger effect was more obvious for higher-grade re-bars. When age between bending and straightening was greater, yield strength increased and elongation decreased (i.e. embrittlement occurs). Using measured data, stress-strain relationship for straightened re-bars was developed based on Ramberg-Osgood model, which can be used to evaluate stiffness of joints when straightened re-bars are applied.