• New & Renewable Energy
• /
• v.16 no.1
• /
• pp.15-24
• /
• 2020

For mechanical load testing of wind turbines, capture matrix is constructed for various range of wind speeds according to the international standard IEC 61400-13. The conventional method wastes considerable amount of data by its invalid data policy -segment data into 10 minutes then remove invalid ones. Previously, we have suggested an alternative way to save the total amount of data to build a capture matrix, but the efficient selection of data has been still under question. The paper introduces optimization algorithms to construct capture matrix with less data. Heuristic algorithm (simple stacking and lowest frequency first), population method (particle swarm optimization) and Q-Learning accompanied with epsilon-greedy exploration are compared. All algorithms show better performance than the conventional way, where the distribution of enhancement was quite diverse. Among the algorithms, the best performance was achieved by heuristic method (lowest frequency first), and similarly by particle swarm optimization: Approximately 28% of data reduction in average and more than 40% in maximum. On the other hand, unexpectedly, the worst performance was achieved by Q-Learning, which was a promising candidate at the beginning. This study is helpful for not only wind turbine evaluation particularly the viewpoint of cost, but also understanding nature of wind speed data.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.8
• /
• pp.4012-4018
• /
• 2013

This paper proposes an energy conservation scheme when apartment remodeling is provided, which analyzes the energy conservation techniques that are suitable for overseas passive houses. Subsequently, a passive solution that is more suitable for our country is derived. In order to examine the energy saving rate applying to passive solution, it evaluates the energy saving rate of 5 specific cases by taking advantage of internal building energy efficiency rating certification system, classifies them and analyzes them. Finally, a rational alternative is devised, and then which is implemented in the internal apartment housing remodeling project. This scheme can save 40% of the energy in comparison with typical apartment building.

• Journal of the Korean Solar Energy Society
• /
• v.30 no.5
• /
• pp.32-37
• /
• 2010

In order to handle the crisis about energy-environment problem, it is necessary to develop the future-oriented and innovative energy technology in architecture area. So the development of new technology for energy saving and alternative energy use has been spurred in this area. Double skin window system, which is an active covering to respond to the exterior change of the environment, is the skill that can reduce the indoor cooling and heating load and the environmental architecture can be realized. This study works out U-value of windows using the window-simulation program with the development and study of the double skin. In addition, the effect of the double skin insulation on the efficiency rating has been analyzed, applying to the certification system of the building energy efficiency rating which has implemented.

• Journal of the Korean housing association
• /
• v.27 no.3
• /
• pp.1-9
• /
• 2016

It is essential to maximize the advantages of long-life housing in consideration of the occupants' demands in order to promote the construction of long-life housing. The diverse plan types with flexibility should be developed based on those demands. Therefore, this study aims to review the level of awareness of long-life housing, and identify the customer needs by conducting the survey for the preference to pre-defined plan types. The results of survey are as follows: 1) Despite the enforcement of the Long-life Housing Certification System in 2014, the recognition among the customers about the long-life housing is still on the low level as shown in that 79.9% of respondents were not aware of the long-life housing; 2) For three alternative plan types, 78.5% on the integration type in front, 63.1% on the moving kitchen type, 47.0% on the Divided Housing type had intention to change; 3) 68.9% of the total are willingly ready to purchase the long-life housing under the condition of no difference in price between normal apartment and long-life housing. The less the number of family members is, the bigger this ratio of positive purchase intention is. Reflecting these results into the designs is expected to contribute to the enhancement of customer satisfaction as well as the diffusion of long-life housing.

• Journal of Information Processing Systems
• /
• v.16 no.2
• /
• pp.301-317
• /
• 2020

An enterprise patch-management system (PMS) typically supplies a single point of failure (SPOF) of centralization structure. However, a Blockchain system offers features of decentralization, transaction integrity, user certification, and a smart chaincode. This study proposes a Hyperledger Fabric Blockchain-based distributed patch-management system and verifies its technological feasibility through prototyping, so that all participating users can be protected from various threats. In particular, by adopting a private chain for patch file set management, it is designed as a Blockchain system that can enhance security, log management, latest status supervision and monitoring functions. In addition, it uses a Hyperledger Fabric that owns a practical Byzantine fault tolerant consensus algorithm, and implements the functions of upload patch file set, download patch file set, and audit patch file history, which are major features of PMS, as a smart contract (chaincode), and verified this operation. The distributed ledger structure of Blockchain-based PMS can be a solution for distributor and client authentication and forgery problems, SPOF problem, and distribution record reliability problem. It not only presents an alternative to dealing with central management server loads and failures, but it also provides a higher level of security and availability.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.15 no.3
• /
• pp.277-281
• /
• 2005

Air-line mask is an important personal protective equipment for workers working under hazardous surroundings in which a fixed ventilation system is difficult to be installed. If the air-line mask make loud noise, works wearing the mask may be faced with health problems such as noise induced hearing loss(NIHL). The purpose of this study is to introduce a low noisy technology for workers using air-line mask. A traditional type air-line has been improved to an advanced air-line mask with lesser noise. In the mask, air suppling conduits consists of multi tubes are placed inside of the front of the safety helmet. The noise level reduced from 80dB(A) to less than 80dB(A) when measured by KS A 0701 method at Center for Safety Inspection, Testing and Certification for KOSHA. It is suitable for related regulation[Article 35 of the Industrial Safety and Health Act(Test of Personal Protective Equipment)]. While workers working in noise level of over 90dB(A), they may expose to 82dB(A) or less when they wear the advanced masks. This type masks can be an alternative for works suffering from loud noise generated by traditional air-line masks.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.2B
• /
• pp.203-211
• /
• 2009

In the area of the telecommunication industry, a few products have been developed before related technical regulation has been made. Government agency is forced to make a final decision on whether a requested product is sellable in the market only after the structure and function of requested product is tested. The introduction of a 'SDoC', and 'privatization of technical regulation' to our legal system could be a solution for minimizing the situation mentioned above. Both 'SDoC' and 'privatization of technical regulation' are systems which are capable of minimizing the appearance of products without technical regulations. Furthermore, 'Temporary approval system' would provide a government agency with administrative procedure for new product without technical regulation.

• KIEAE Journal
• /
• v.10 no.1
• /
• pp.91-96
• /
• 2010

Incheon Free Economic Zone's Songdo Area is a newly constructed city built on land reclaimed from the seaside and the surrounding area. Yeongjong Area is made after Land reclamation between Yeongjong Island and Yongyou Island began in November 1992. The first phase linking these islands to create the Incheon International Airport (phase 1) and the Airport Town Square community was finished in March 2001. However, if we take a look at the overall status of the project as it is carried on at present, it is hard to deny that the project is trapped inside the same legal restrictions as are all other existing cities, which permits Songdo Area and Yeongjong Area to meet only very minimum standards. This study intends to analyze and assess the Incheon Free Economic Zone's Songdo Area and Yeongjong Area of environmentally friendly construction and to rate its current development status, exposing any problems and offering alternative solutions. In this paper, the current state of constructions in Songdo Area and Yeongjong Area were reviewed. Then a quantitative analysis and assessment for the Songdo Area and Yeongjong Area constructions of apartments, complex buildings, office buildings, school facilities, store and hotel facilities were conducted by using green building certification criteria. Finally the synthetic results of environmental performance evaluation for Incheon Free Economic Zone's Songdo Area and Yeongjong Area constructions and follow-up suggestions were described.

• The Plant Pathology Journal
• /
• v.34 no.6
• /
• pp.575-579
• /
• 2018

Apple stem grooving virus (ASGV) is considered to cause the most economically important viral disease in pears in Korea. The current PCR-based methods used to diagnose ASGV are time-consuming in terms of target detection. In this study, a novel assay for specific ASGV detection that is based on reverse transcription-recombinase polymerase amplification is described. This assay has been shown to be reproducible and able to detect as little as $4.7ng/{\mu}l$ of purified RNA obtained from an ASGV-infected plant. The major advantage of this assay is that the reaction for the target virus is completed in 1 min, and amplification only requires an incubation temperature of $42^{\circ}C$. This assay is a promising alternative method for pear breeding programs or virus-free certification laboratories.

• Journal of Information Technology Services
• /
• v.22 no.6
• /
• pp.71-86
• /
• 2023

The rapid change in industry and the technological gap give rise to social demand for upskilling and reskilling and spread of alternative education. Against this backdrop, digital certification and career management tools can be used to manage various types of learning activities comprehensively. Digital badges provide various kinds of history information related to individual learning, and the reliability and transparency of the issued information can be strengthened by applying blockchain technology. There have been various discussions about digital badges for a long time, but due to the lack of standards to support the issuance and distribution of digital badges, they have been partially used in some areas. However, interest in digital badges is increasing due to the development of related technologies, establishment of standards, paradigm changes in higher education, and government policies related to nurturing digital talent. This paper deals with the use of digital badges for efficient and transparent learning management and career management in an online learning environment. The researcher analyzes the technical characteristics and use cases of digital badges, and proposes a plan for use in online higher education based on them.