• 한국산업융합학회 논문집
• /
• 제24권6_2호
• /
• pp.827-839
• /
• 2021

Due to climate change and population growth, water scarcity is getting worse all over the world. Among various methods for desalination of seawater, the Multi-Effect Adsorptive Desalination method, which combines the existing Multi-Effect Desalination method and the Adsorptive Desalination method and can produce high-concentration-high-concentration freshwater, is emerging. Because the Multi-Effect Adsorptive Desalination method combines the two different methods, the system becomes complicated and the possibility of failure increases. Therefore, in this study, availability analysis was performed on the Multi-Effect Adsorptive Desalination process. A total of four types of reliability block diagrams were presented, and availability analysis was conducted based on them. The first form of a reliability block diagram is configured in series without any redundancy. The availability of the reliability block diagram composed of the serial system was found to be lower than the required availability. In order to increase availability, the redundancy to pumps and boiler are added to system. As a result of availability analysis, it was confirmed that designing desalination systems with redundancy to pump meets the 93% availability, which is typically required availability for various plants.

• 대한화학회지
• /
• 제57권5호
• /
• pp.568-573
• /
• 2013

A selective and sensitive method for simultaneous determination of copper in blood by adsorptive differential pulse cathodic stripping voltammetry is presented. The procedure involves an adsorptive accumulation of Cu(II)-ETSC (4- ethyl-3-thiosemicarbazide) on a hanging mercury drop electrode, followed by a stripping voltammetry measurement of reduction current of adsorbed complex at about -715 mV. The optimum conditions for the analysis of copper (II) ion are : pH 10.3, concentration of 4-ethyl-3-thiosemicarbazide $3.25{\times}10^{-6}$ M and an accumulation potential of -100 mV. The peak current is proportional to the concentration of copper over the range 0.003-125 ng/mL with a detection limit of 0.001 ng/mL and an accumulation time of 60 s. Moreover, with the use of the proposed method, there is a considerable improvement in the detection limit, the linear dynamic range and the deposition time, compared with the methods of adsorptive stripping voltammetry for the determination of copper. The developed method was validated by analysis of whole blood certified reference materials.

• 환경위생공학
• /
• 제10권1호
• /
• pp.132-141
• /
• 1995

The objectives of this study was to find the effect of zinc salt treated with coconut activated carbon and the effect of humic substance. The bottle- Point technique was used in determining the Freundlich isotherm equation. The adsorptive capacity of granular activated carbon was reduced when humic substance are present. Coconut activated carbon was coated with 0.0001 N zinc chloride decreased the BET surface area but increased the adsorptive capacity more than coconut activated carbon not coated with zinc chloride. The adsorptive capacity of TCE in coconut activated carbon coated with higher concentration of zinc chloride was reduced but increased in the solution containing humic substance when the coconut activated carbon was coated with 0.01 N- zinc chloride. The zinc salt coated with coconut activated carbon did not Increase the adsorptive velocity of coconut activated carbon.

• 한국환경과학회지
• /
• 제23권8호
• /
• pp.1419-1428
• /
• 2014

Electron beam-induced grafting polymerization was employed to prepare Acrylic acid-grafted bacterial cellulose (BC-g-AAc). BC-g-AAc as an adsorbent was applied to remove heavy metals (e.g., As, Pb, and Cd). This study examined followings; morphological change of surface, adsorptive behavior of BC-g-AAc, and interpretation of adsorptive kinetics. Specific surface areas of BC and BC-g-AAc were $0.9527m^2g^{-1}$ for BC and $0.2272m^2g^{-1}$ for BC-g-AAc, respectively as measured by BET nitrogen adsorption, revealing the morphological change of the surface of BC-g-AAc. Batch adsorption test was performed to investigate adsorptive behavior of BC-g-AAc in aqueous solution. The amounts of Pb and Cd adsorbed on BC-g-AAc were $69mg\;g^{-1}$ and $56mg\;g^{-1}$, respectively. However, As was not adsorbed on BC-g-AAc due to its neutral nature. Both the Benaissa model and the Kurniawan model were applied in the study to interpret adsorptive kinetics. From the value of correction coefficient ($R^2$), adsorptive kinetics of Pb and Cd were subjected to Kurniawan model referred to pseudo-second-order. Taken together, the results of this study show that BC-g-AAc has potential as a heavy metal (eg., Pb, Cd)-adsorbent made of an environmentally friendly material.

• Membrane and Water Treatment
• /
• 제10권4호
• /
• pp.259-264
• /
• 2019

Cost effective clay adsorptive microfiltration membranes were synthesized to remove Cr (III) from high polluted water. Raw and calcined bentonite were mixed in order to decrease the shrinkage and also increase the porosity; then, 20 wt% of carbonate was added and the samples, named B (without carbonate) and B-Ca20 (with 20 wt% calcium carbonate) were uniaxially pressed and after sufficient drying, fired at $1100^{\circ}C$ for 3 hours. Then, physical and mechanical properties of the samples, their phase analyses and microstructure and also their ability for Cr(III) removal from high polluted water (including 1000 ppm Cr (III) ions) were studied. Results showed that the addition of calcium carbonate lead the porosity to increase to 33.5% while contrary to organic pore formers like starch, due to the formation of wollastonite, the mechanical strength not only didn't collapse but also improved to 36.77 MPa. Besides, sample B-Ca20, due to the presence of wollastonite and anorthite, could remove 99.97% of Cr (III) ions. Hence, a very economic and cost effective combination of membrane filtration and adsorption technology was achieved for water treatment which made microfiltration membranes act even better than nanofiltration ones without using any adsorptive nano particles.

• 멤브레인
• /
• 제23권6호
• /
• pp.409-417
• /
• 2013

이산화탄소의 효과적인 분리 및 포집을 위해서 등방성 다공성 구조의 폴리프로필렌(pp) 격자의 내부에 제올라이트 입자들이 표면 덮임 없이 균일하게 분포되어 있는 흡착투과중공사막(APM: adsorptive permeation hollow fiber membrane)을 개발하였다. 본 연구에서는 이산화탄소/질소 혼합물을 모사 기체혼합물로 사용하였는데, 공급되는 기체혼합물 모두가 APM을 투과하면서 이산화탄소는 APM 내 분포되어 있는 흡착제에 흡착되고 질소는 투과하여 배출된다. APM이 장착된 모듈을 제조하여 이에 대한 흡착투과실험을 수행하여 흡착투과 성능을 분석하였고 또한 포화 흡착된 APM을 진공압에서 탈착 재생하여 그 결과를 재생효율과 에너지소모 관점에서 고찰하였다.

• 전기화학회지
• /
• 제13권1호
• /
• pp.63-69
• /
• 2010

플루오로퀴놀론 계 항생제들의 전기화학적 거동을 카본 페이스트 전극 (carbon paste electrode ; CPE)을 사용하여 순환 전압전류법 (cyclic voltammetry)과 네모파 흡착 벗김 전압전류법 (square wave adsorptive stripping voltammetry)으로 연구하였다. Enrofloxacin (ENR), Norfloxacin (NOR), Ciprofloxacin (CIP), Ofloxacin (OFL), Levofloxacin (LEV) 등 5가지 플루오로퀴놀론 계 항생제에 대한 전기화학적 분석을 수행하였다. pH 4.5인 아세트산 완충 용액 (acetate buffer) 에서 플루오로퀴놀론 계 항생제의 산화 전위는 Ag/AgCl 기준 전극에 대하여 각각 ENR : 0.952V, NOR : 1.052 V, CIP : 1.055 V, OFL : 0.983 V, LEV : 0.990 V 의 값을 나타내었으며, 네모파 흡착 벗김 전압전류법에 의한 산화 전류는 $0.2\;{\mu}M$에서 $1\;{\mu}M$ 사이의 농도영역에서 각 항생제의 농도와 선형을 나타내었다.

• 환경위생공학
• /
• 제14권2호
• /
• pp.18-24
• /
• 1999

The purpose of this study was carried out to estimate removal possibility of IBMP and IPMP causing odor in raw water. As a result of Freundlich isotherm. IBMP was superior to IPMP in adsorptive capacity. Adsorptive capacities of activated carbon were found to be in order of Lignite, Coconut shell, and Charcoal. These were well fitted with Freundlich isotherm. According to adsorption breakthrough tests for Lignite GAC, breakthrough time of IPMP and IBMP were 5.7hr and 5.5hr, respectively. Because adsorptive capacities of target material were very different with pore size distribution, it seemed that Lignite and Coconut shell based activated carbons were recommended in order to remove door compounds.

• Archives of Pharmacal Research
• /
• 제14권3호
• /
• pp.249-254
• /
• 1991

Activated carbons from rice-straw can be used as an adsorbents for the purification of water were prepared and evaluated. The adsorptive capacities of activated carbons were measured by iodine, potassium permangante, phenol and metals. It was observed by electron microscope (SEM) and IR spectrum that organic components in the rice-straw and its carbonization product were disappeared. Slit-shaped and porousstructures were formed by activation. There was no relationship between temperature and adsorption of iodine but adsorption of potassium permanganate increased as temperature rose. The adsorption of the phenol was greater than 99%. The adsorption data of phenol at $25^\circ{C}$ obeyed the Freundlich's isotherm. Various metals except sodium were not removed by activated carbon.

• 한국지하수토양환경학회:학술대회논문집
• /
• 한국지하수토양환경학회 2003년도 추계학술발표회
• /
• pp.123-127
• /
• 2003

Changes in pyrene partitioning due to mineral surface adsorptive fractionation processes of humic substances (HS) were examined in model environmental systems. For purified Aldrich humic acid(PAHA), carbon-normalized pyrene binding coefficients ( $K_{oc}$ ) for the residual (i.e., nonadsorbed and dissolved) PAHA components were different from the original dissolved PAHA $K_{oc}$ , value prior to contact with mineral suspensions. A positive correlation between the extent of pyrene binding and weight-average molecular weight (M $W_{w}$) of residual PAHA components was observed, which appeared to be unaffected by the specific mineral adsorbents use and fractionation mechanisms. A similar positive correlation was not observed with the adsorbed PAHA components, suggesting that conformational changes occurred for the mineral-associated components upon adsorption. Nonlinear pyrene sorption to mineral-associated PAHA was observed, and the degree of nonlinearity is hypothesized to be dependent on adsorptive fractionation effects and/or structural rearrangement of the adsorbed PAHA components.s.