• Environmental Engineering Research
• /
• 제25권2호
• /
• pp.171-177
• /
• 2020

Removal through adsorption is the most widely used and effective treatment method for volatile organic compounds (VOCs) in exhaust gases. However, at high temperatures and humidity, adsorption is competitive due to the presence of moisture and unsmooth physical adsorption thereby deteriorating adsorption performance. Therefore, water adsorption honeycomb (WAH) and VOCs adsorption honeycomb (VAH) were prepared to improve VOCs adsorption at high temperatures and humidity. Adsorbed toluene amounts on single honeycomb (SH), containing only VAH, and combined honeycomb (CH), containing WAH and VAH, were determined. Further, the toluene adsorption rates of honeycomb adsorbents mounted on rotary systems, VAH-single rotor (SR) and WAH/VAH-dual rotor (DR) were determined. Toluene adsorption by WAH/VAH-CH (inlet temperature: 40-50℃; absolute humidity: 28-83 gH₂O/kg-dry air) was 1.6 times that by VAH-SH, and the water adsorption efficiency of WAH/VAH-CH was 1.7 times that of VAH-SH. The adsorption/removal efficiency of the WAH/VAH-DR (inlet temperature: 45℃; absolute humidity: 37.5 gH₂O/kg-dry air) was 3% higher than that of VAH-SR. This indicates that the WAH at the rotor inlet selectively removed water, thereby improving the adsorption efficiency of the VAH at the outlet.

• 환경위생공학
• /
• 제19권1호
• /
• pp.37-41
• /
• 2004

The removal efficiency of cadmium by chitosan complex isolated from Aspersillus oryzae was investigated through laboratory experiments. The results of the study are as follows. The adsorption kinetics of cadmium was reached the adsorption equilibrium in approximately 20 minutes and the removal efficiency was showed 95.8%. The effect of temperature on cadmium adsorption by chitosan complex shows that as the temperature increased, the amount of cadmium adsorption per unit weight of chitosan complex increased. The correlation between amount of cadmium adsorption per unit weight of chitosan complex and temperature was obtained through the coefficient of determination($R^2$). $R^2$ values was 0.854(p<0.05). A linearized Freundlich equation was used to fit the acquired experimental data. As a result, Freundlich constant, the adsorption intensity(1/n) was 0.550, and the measure of adsorption(k) was 2.181. So, it was concluded that adsorption of cadmium by chitosan complex is effective.

• 한국수소및신에너지학회논문집
• /
• 제30권5호
• /
• pp.411-417
• /
• 2019

An adsorption chiller is connected to the fuel processing/fuel cell system to increase the energy efficiency of the system. Since, the minimum temperature of $70^{\circ}C$ is needed to operate the adsorption chiller, HT-PEMFC is used as a heating source and $80^{\circ}C$ hot water in the water tank at the system is supplied to the chiller. Experimentally measured COP of the adsorption chiller was between 0.4-0.5 and the total calcuated efficiency of the connected system was between 60% and 70% comparing to 47% without adsorption chilling system.

• 한국환경과학회지
• /
• 제2권4호
• /
• pp.357-365
• /
• 1993

This study was conducted for the efficient utilization of biomaterials such as starch residue, tangerine skin, and green tea residue, which are agricultral by-products discarded in Cheju Province annually, as adsorbents and biomaterials were examined for their removal ability of heavy metal ions in waste water by batch adsorption experiments. The removal efficiency of biomaterials for heavy metal ions was above 80-90% and almost similar to activated carbon and the adsorption ability of those treated with 포르말린 was improved in the green tea residue only for $Pb^{2+}$, $Cu^{2+}$, and $Zn^{2+}$. In the conditions of pH, the removal efficiency of heavy metal ions was high in the range of 5-7. In the solutions which heavy metal ions were mixed, the removal efficiency was similar at $Ag^+$, $Pb^{+2}$ and reduced to about 10% at the other ions, as compared with the solutions they were not mixed. Adsorption isotherm of biomaterials was generally obeyed to Freundlich formular than Langmuir formular and Freundlich constant, 1/n were obtained in the range of 0.1-0.5.

• 설비공학논문집
• /
• 제14권8호
• /
• pp.671-675
• /
• 2002

The gas adsorption efficiency for various surfaces with three different characteristics has been reviewed. The dimethyl disulfide gas has been used to investigate characteristics of gas adsorption for different surface characteristics such as plasma treated, lacquer coated and untreated. Three different surfaces were evaluated in dry conditions initially and tested at wet surface conditions with spraying water to evaluate the gas adsorption efficiency which usually occurred at defrost cycles. The results show that the gas adsorption of the plasma treated sample has better performance than others. The lacquer coated and untreated samples showed the similar result, but the lacquer coated sample showed a slightly better performance.

• 한국연초학회지
• /
• 제14권1호
• /
• pp.87-93
• /
• 1992

The adsorption efficiency of some adsorbents for the organic solvents and gas phase of smoke was investigated. 1. Specific surface area of activated carbon increased to 1900 mfg with increased activation time. 2. Adsorption efficiency of benzene and acetone increased with increasing total surface area. Adsorption capacity for gas phase such as hydrogen cyanide, aldehyde was proportional to the micro pore surface area under 20A. 3. The removal efficiency of particulate matter of smoke was higher with the adsorbents of relatively higher pore size compared to that of micro pore.

• 미생물학회지
• /
• 제26권3호
• /
• pp.237-246
• /
• 1988

The higher bacterial numbers on clay than on sand were caused by different environmental factors. Such factors affecting the adsorption of E. coli ATCC 11775 in the sediment as follows; optimal pH range for the adsorption of E. coli ATCC 11775 was pH 7.5-pH 9.5. E. coli ATCC 11775 were shown maxima in the salinity of 18.$75%_{o}$ on sand type sediment and $12.5%_{o}$ on clay type sediment. Bacteria attached better to clay typed sediment than to sand typed sediment when organic substance was eliminated. Beef extract of 0.5%-1% concentration was found to promote the attachment of E. coli ATCC 11775 effectively. Peptone of 0.5% was enganced the attachment on the clay, and peptone of 1.3%-5%, on the sand. E. coli ATCC 11775 was found to adsorb onto benthonite with the highest efficiency and on celite with the lowest efficiency. Efficiency of adsorption by inorganic ions was shown due to higher values of ion. Adsorption was achieved in the order of $Al^{3+}, Ca^{2+}, Na^{+}$.

• 환경위생공학
• /
• 제17권3호
• /
• pp.7-13
• /
• 2002

The removal efficiency of heavy metals by chitosan complex isolated from biological industrial waste was investigated through laboratory experiments. The results of the study are as follows. The adsorption kinetics of heavy metals were reached the equilibrium adsorption in approximately 30 minutes and the removal efficiency were showed 70.7～97.4%. The effect of temperature on heavy metals adsorption by chitosan complex shows that as the temperature increased, the amount of heavy metals adsorption per unit weight of chitosan complex increased. The correlation between amount of heavy metals adsorption per unit weight of chitosan complex and temperature were obtained through the coefficient of determination($R^2$). $R^2$ values were 0.75(p<0.05), 0.99(p<0.05) and 0.98(p<0.05) in Hg, Mn, and Zn, respectively. The injected chitosan complex in which 0.1 g was adsorpted highly and the removal of heavy metals was found to have the best removal efficiency A linearized Freundlich equation was used to fit the acquired experimental data. As a result, Freundlich constants, the adsorption intensity(I/n) was 0.5564, 0.4074, 0.5244 on the Hg, Mn, Zn, respectively And the measure of adsorption(k) was 2.2144, 1.6963, 2.0792 on the Hg, Mn, Zn, respectively. So, it was concluded that adsorption of heavy metals by chitosan complex is effective.

• 대한화학회지
• /
• 제41권5호
• /
• pp.239-245
• /
• 1997

광유로부터 polychlorinated biphenyls(PCBs)를 제거할 수 있는 가능성을 평가하기 위해 활성탄을 이용한 흡착반응을 연구하였다. 염소원자의 치환이 비교적 적은 PCBs로 구성되어 있는 Aroclor 1242의 흡착 효율은 95% 이상이었으나, 많은 염소원자들로 치환된 Aroclor 1260은 상당히 낮은 75%의 효율을 나타내었다. 관찰된 차이점은 평면이나 비평면 구조를 갖고 있는 PCBs의 기하학적인 구조에 기인한다. 실제로 평면구조 PCBs의 농도는 Aroclor 1260에서보다도 Aroclor 1242에서 훨씬 높다. PCBs의 독성은 주로 평면 구조와 관련되어 있기 때문에, 활성탄에 의한 평면구조 PCBs의 우선적인 흡착은 활성탄의 처리를 통해 독성의 감소가 성취될 수 있다는 것을 보여준다. 독성 감소의 효율은 Toxicity Equivalence Factor(TEF)를 써서 평가하였다.

• 한국환경과학회지
• /
• 제21권5호
• /
• pp.623-631
• /
• 2012

The adsorption behavior of Eosin Y on activated carbon (AC) in batch system was investigated. The adsorption isotherm could be well fitted by the Langmuir adsorption equation. The kinetics of adsorption followed the pseudo-second-order model. The temperature variation was used to evaluate the values of free energy (${\Delta}G^{\circ}$), enthalpy (${\Delta}H^{\circ}$) and entropy (${\Delta}S^{\circ}$). The positive value of enthalpy change ${\Delta}H^{\circ}$ for the process confirms the endothermic nature of the process and more favourable at higher temperature, the positive entropy of adsorption ${\Delta}S^{\circ}$ reflects the affinity of the AC material toward Eosin Y and the negative free energy values ${\Delta}G^{\circ}$ indicate that the adsorption process is spontaneous. With the increase of the amount of AC, removal efficiency of Eosin Y was increased, but adsorption capacity was decreased. And adsorption capacity was increased with the decrease of particle size. With the increase of the amount of AC, removal efficiency of Eosin Y was increased, but adsorption capacity was decreased. And adsorption capacity was increased with the decrease of particle size.