• Journal of the Society of Naval Architects of Korea
• /
• v.61 no.2
• /
• pp.68-76
• /
• 2024

The rotor sail is one of the representative devices in eco-friendly wind-assisted propulsion systems that have been practically applied to commercial ships. The present study proposes an asymmetric vertical folding rotor sail (AFRS) designed for small ships, featuring asymmetric geometry along the vertical direction and the function of vertical folding. To evaluate the aerodynamic performance of rotor sail, the drag, lift and lift-to-drag ratio were derived using computational fluid dynamics. The aerodynamic performance of AFRS was compared with that of normal rotor sail with different aspect ratios and spin ratios. The effect of geometric parameters on the aerodynamic performance of AFRS was assessed by varying the asymmetric diameter ratio. The maximum improvement in lift-to-drag ratio for AFRS was approximately 12% in the considered case. Additionally, the resistance is decreased when AFRS is vertically folded without rotating. Throughout the present study, improved aerodynamic and resistance performances for AFRS were confirmed, which will successfully provide additional propulsion to small ships.

• Journal of electromagnetic engineering and science
• /
• v.12 no.4
• /
• pp.287-289
• /
• 2012

This paper proposes an alternate time-switched space-frequency block coding transmission technique for orthogonal frequency division modulation systems. There are two antennas in the transmitter but it still has only a baseband and RF and a switch that alternates between the antennas at every symbol timing. Alternating transmit symbols result in zeros that make maximal ratio receive combining possible in the receiver. Simulation results show that it provides better performance than the traditional algorithm at the expense of one additional antenna.

• Journal of Korean Institute of Industrial Engineers
• /
• v.31 no.3
• /
• pp.194-200
• /
• 2005

A stochastic dynamic lot sizing problem for multi-item is suggested in the case that the distribution of the cumulative demand is known over finite planning horizons and all unsatisfied demand is fully backlogged. Each item is produced simultaneously at a variable ratio of input resources employed whenever setup is incurred. A dynamic programming algorithm is proposed to find the optimal production policy, which resembles the Wagner-Whitin algorithm for the deterministic case problem but with some additional feasibility constraints.

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.320-321
• /
• 2018

A non-isolated high voltage gain bidirectional DC-DC converter for battery storage system has been presented in this paper. The topology is composed of boost converter and traditional SEPIC converter. The proposed converter can achieve higher voltage conversion ratio with reduced voltage and current stresses in the switches. In additional, a reduced number of components are included in this topology. The PSIM simulation is carried to validate the analysis and operation of the converter.

• Communications for Statistical Applications and Methods
• /
• v.20 no.5
• /
• pp.417-425
• /
• 2013

We consider an extended version of a logarithmic series distribution and discuss the estimation of its parameters by the method of moments and the method of maximum likelihood. Test procedures are suggested to test the significance of the additional parameter of this distribution and all procedures are illustrated with the help of real life data sets. In addition, a simulation study is conducted to assess the performance of the estimators.

• ETRI Journal
• /
• v.33 no.3
• /
• pp.401-406
• /
• 2011

This paper presents a fast block-matching algorithm based on the normalized cross-correlation, where the elimination order is determined based on the gradient magnitudes of subblocks in the current macroblock. Multilevel Cauchy-Schwartz inequality is derived to skip unnecessary block-matching calculations in the proposed algorithm. Also, additional complexity reduction is achieved re-using the normalized cross correlation values for the spatially neighboring macroblock because the search areas of adjacent macroblocks are overlapped. Simulation results show that the proposed algorithm can improve the speed-up ratio up to about 3 times in comparison with the existing algorithm.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 2003.03a
• /
• pp.259-266
• /
• 2003

This paper begins with the seismic performance evaluation of an existing building, which exhibits the need of additional damping to reduce its response. Required damping ratio is found by capacity spectrum method to satisfy a target response. It is expressed with the design parameter of active mass damper by adopting Linear Quadratic Regulator, Optimal gains are obtained and then weighting matrices are found. Finally the seismic performance by added active mass damper is demonstrated, which satisfies the target response.

• Journal of the Korea Concrete Institute
• /
• v.21 no.2
• /
• pp.169-178
• /
• 2009

An equation for calculating confining reinforcement amount of RC bridge columns, specified in the current bridge design codes, has been made to provide additional load-carrying strength for concentrically loaded columns. The additional load-carrying strength will be equal to or slightly greater than the resistant strength of a column against axial load, which is lost because the cover concrete spalls off. The equation considers concrete compressive strength, yield strength of transverse reinforcement, and the section area ratio as major variables. Among those variables, the section area ratio between the gross section and the core section, varying by cover thickness, is a variable which considers the strength in the compression-controlled region. Therefore, the cross section ratio does not have a large effect in the aspect of ductile behavior of the tension-controlled region, which is governed by bending moment rather than axial force. However, the equation of the design codes for calculating confining reinforcement amount does not directly consider ductile behavior, which is an important factor for the seismic behavior of bridge columns. Consequently, if the size of section is relatively small or if the section area ratio becomes excessively large due to the cover thickness increased for durability, too large an amount of confining reinforcement will be required possibly deteriorating the constructability and economy. Against this backdrop, in this study, comparison and analysis were performed to understand how the cover thickness influences the equation for calculating the amount of confining reinforcement. An equation for calculating the amount of confining reinforcement was also modified for reasonable seismic design and the safety. In addition, appropriateness of the modified equation was examined based on the results of various test results performed at home and abroad.

• Journal of the Korean Society for Railway
• /
• v.14 no.5
• /
• pp.404-410
• /
• 2011

In AC feeding system, the fault location is calculated by using ratio of current absorbed in the neutral point of AT(Automatic Transformer) or by measuring reactance. In this way, however, an estimation error can be happened due to the many reasons. In addition, for measuring currents in the neutral point of AT, other measuring devices and communication equipments are additionally required. In order to solve the disadvantages, this paper suggests a novel technique using the distribution ratio of catenary current. The proposed technique uses existing protective relays and measures catenary current. With the measured data, we can calculate the distribution ratio of catenary current and determine fault location. Through the simulated results, we derived the correlation between current ratio and fault location. Using this technique, additional equipments and expenses can be reduced. Besides, fault location can be determined more correctly.

• Asia-Pacific Journal of Business
• /
• v.12 no.3
• /
• pp.329-342
• /
• 2021

Purpose - The purpose of this study is to analyze the effect of investment by the National Pension Service, which has a high share as a single fund, on the dividend payout ratio. Design/methodology/approach - This study secured a share through DART of the Financial Supervisory Service and disclosure of the National Pension Service. We also used a fixed-effects model and 2SLS to analyze the data. Findings - First, it was found that there was a possibility of conflicting interests among shareholders concerning the company's dividend payment policy. Second, in the range of 3% to 4.9% of the National Pension Service shareholding, an additional increase in the holding ratio was found to have a positive (+) effect on the dividend rate. Third, after the introduction of the Stewardship Code, it was found that the increase in ownership of the fund had a positive (+) effect on the company's dividend payout ratio, regardless of the share ratio range. Moreover, the relationship between the fund ownership and the dividend payout ratio showed a clear positive relationship when free cash flow was high along investment opportunities were low. Research implications or Originality - First, This study included less than 5% of the share in the analysis. Second, We used the recent changes in fund shareholder activities. Third, We tested an instrumental variable to confirm the relationship between the National Pension Service share and the dividend ratio.