• Computers and Concrete
• /
• v.15 no.4
• /
• pp.503-514
• /
• 2015

Fibre-added concretes are frequently used in large site applications such as slab and airports as well as in bearing system elements or prefabricated elements. It is very difficult to determine the mechanical properties of the fibre-added concretes by experimental methods in situ. The purpose of this study is to develop an artificial neural network (ANN) model in order to predict the compressive and bending strengths of hybrid fibre-added and non-added concretes. The strengths have been predicted by means of the data that has been obtained from destructive (DT) and non-destructive tests (NDT) on the samples. NDTs are ultrasonic pulse velocity (UPV) and Rebound Hammer Tests (RH). 105 pieces of cylinder samples with a dimension of $150{\times}300mm$, 105 pieces of bending samples with a dimension of $100{\times}100{\times}400mm$ have been manufactured. The first set has been manufactured without fibre addition, the second set with the addition of %0.5 polypropylene and %0.5 steel fibre in terms of volume, and the third set with the addition of %0.5 polypropylene, %1 steel fibre. The water/cement (w/c) ratio of samples parametrically varies between 0.3-0.9. The experimentally measured compressive and bending strengths have been compared with predicted results by use of ANN method.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.2B
• /
• pp.207-212
• /
• 2009

Surfactants were used as representative anionic and non ionic surfactants to investigate the effect of mass transfer on the mineral-catalyzed Fenton-like oxidation of sorbed phenanthrene. Mass transfer of phenanthrene on the oxide surface or interlayer between aqueous and solid phases was generated by surfactant addition. Apparent solubility of phenanthrene was increased as surfactant concentration increasesd. In tests using Tween 80, oxidation of phenanthrene decreased as apparent solubility increased. High apparent solubility was not responsible for oxidation of sorbed phenanthrene in the sand due to the surfactant acted as a scavenger of degradation. In tests with SDS, $H_{2}O_{2}$ decomposition rate in Fenton-like oxidation was decreased by complexation between goethite and SDS. However, in tests using 32 mM of SDS, efficiency of phenanthrene treatment increased compared to the test without SDS addition. Therefore, suitable amount of SDS addition could provide optimum condition for phenanthrene oxidation on the oxide surface or interlayer between aqueous and solid phase, and decrease $H_{2}O_{2}$ decomposition, and as a result, phenanthrene removal efficiency can be improved.

• Clinical and Experimental Pediatrics
• /
• v.49 no.11
• /
• pp.1140-1151
• /
• 2006

Inherited metabolic disorders are individually rare but as a whole, they are nor rare. Since Archibald Garrod introduced a concept of "inborn error of metabolism" or "chemical individuality", more than 500 diseases are currently known, affecting approximately one in 500 newborns cumulatively. They frequently manifest with acute, life-threatening crisis that require immediate specific intervention or they present with insidious diverse symptoms and signs involving multiple visceral organs or tissues as well as central nervous system, hampering a correct diagnosis. In addition, many pediatricians are not familiar with all diagnostic and therapeutic strategies for diverse inherited metabolic disorders. However, the prognosis of affected children are heavily dependent on rapid and effective treatment. In this lecture, practical guidelines for the specific diagnosis based on diverse clinical features of inherited metabolic disorders will be described. Many sophisticated laboratory tests are available for confirmatory diagnosis of each disease, which challenge to general pediatricians with respect to knowledge about biochemical metabolite assay test, enzymatic test and DNA diagnostic tests. Sample collections, indications, methods and interpretation of results in varying laboratory tests will be listed as well.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.137-144
• /
• 2005

Recently a pressurized grouting soil nail is demanded due to problems beyond of economical and engineering purpose. In this study, a newly modified soil nailing technology named as the PGSN (Pressurized Grouting Soil Nailing) system is respected to reduced displacements of nails and increase of global slope stability. And effects of various factors related to the design of the PGSN system, such as the length of the soil nail, injected pressure and W/C ratio of cement grout in the pressurized grouting soil nail are examined throughout a series of the displacement-controlled field pull-out tests. Displacement-controlled field pull-out tests are performed in the present study and the volume of grouting are also evaluated based on the measurements. In addition, both short-term and long-term characteristics of pull-out deformations of the newly proposed PGSN system are analyzed and compared with those of the general soil nailing system by carrying out the stress-controlled field pull-out tests. From the pull-out characteristics of pressurized grouting soil nails, it is found that the effect of the length of the soil nail, injected pressure and W/C ratio of cement grout are important parameters.

• Smart Structures and Systems
• /
• v.25 no.5
• /
• pp.543-557
• /
• 2020

This paper presents a series of experimental and numerical investigations on a vertical isolation system with quasi-zero stiffness (QZS) property. The isolation system comprises a linear helical spring and disk spring. The disk spring is designed to provide variable stiffness to the system. Orthogonal static tests with different design parameters are conducted to verify the mathematical and mechanical models of the isolation system. The deviations between theoretical and test results influenced by the design parameters are summarized. Then, the dynamic tests for the systems with different under-load degrees are performed, including the fast sweeping tests, harmonic excitation tests, and half-sine impact tests. The displacement transmissibility, vibration reduction rate, and free vibration response are calculated. Based on the test results, the variation of the transmission rule is evaluated and the damping magnitudes and types are identified. In addition, the relevant numerical time history responses are calculated considering the nonlinear behavior of the system. The results indicate that the QZS isolation system has a satisfactory isolation effect, while a higher damping level can potentially promote the isolation performance in the low-frequency range. It is also proved that the numerical calculation method accurately predicts the transmission character of the isolation system.

• Proceedings of the KSR Conference
• /
• 2000.11a
• /
• pp.557-570
• /
• 2000

It is necessary to perform a study on the interrace between a G7 pantograph and a KTX catenary system prior to G7 on-line tests in the Korea High Speed Test Track in order to predict how high current collection quality can be obtained during the on-line tests and check if safety problems shall be caused b)Y the tests or not. According to the simulation results, current collection quality of the G7 pantograph at 350km/h is lower than that of a GPU pantograph at 300km/h, but the contact wire uplifts and average contact forces are within the safe-zone. In addition, the ratio of running speed (350km/h) to safe running. Therefore, the G7 on-line tests at 350km/h in the Korea High Speed Test Track is expected not to cause the safety problem.

• Korean Journal of Pharmacognosy
• /
• v.22 no.2
• /
• pp.124-127
• /
• 1991

In the preceding paper, it was reported that total 63 traditional Korean herbal medicines listed in the Korean Pharmacopoeia and Korean Natural Drug Standards were found to be different plants in terms of systematic botany when those were compared with other two countries' drug compendia, Chinese Pharmacopoeia, Japanese Pharmacopoeia and Japanese Natural Drug Standards. Among 63 traditional Korean herbal drugs, 28 items were subject to the chemical identification test by using official methods that are described in the Korean Pharmacopoeia and the Korean Natural Drug Standards. In addition, 5 items were also tested by using the official methods described in Chinese and Japanese drug compendia, since there are no official chemical tests available in the Korean drug compendia. It was found that most of chemical tests appeared to be suitable. It was noted that the chemical test for Atractylodis Rhizoma(蒼朮) was incorrect and unapplicable. Those chemical tests for Clematidis Radix(威靈仙), Rubi Fructus(覆盆子) and Viticis Fructus(蔓荊子) are desirable to be revised for more accurate identification.

• Journal of The Korean Society of Inherited Metabolic disease
• /
• v.13 no.1
• /
• pp.1-19
• /
• 2013

Inherited metabolic disorders are individually rare but as a whole, they are nor rare. Since Archibald Garrod introduced a concept of "inborn error of metabolism" or "chemical individuality", more than 600 diseases are currently known, affecting approximately one in 500 newborns cumulatively. They frequently manifest with acute, life-threatening crisis that requires immediate specific intervention or they present with insidious diverse symptoms and signs involving multiple visceral organs or tissues as well as central nervous system, hampering a correct diagnosis. In addition, many pediatricians are not familiar with all diagnostic and therapeutic strategies for diverse inherited metabolic disorders. However, the prognosis of affected children are heavily dependent on rapid and effective treatment. In this lecture, practical guidelines for the specific diagnosis based on diverse clinical features of inherited metabolic disorders will be described. Many sophisticated laboratory tests are available for the confirmatory diagnosis of each disease, which is challenging to general pediatricians with respect to knowledge about biochemical metabolite assay test, enzymatic test and DNA diagnostic tests. Sample collections, indications, methods and interpretation of results in varying laboratory tests will be listed as well.

• Geomechanics and Engineering
• /
• v.10 no.5
• /
• pp.689-707
• /
• 2016

Soil stabilization is one of the useful method of ground improvement for soil with low bearing capacity and high settlement and unrequired swelling potential. Generally, the stabilization is carried out by adding some solid materials. The main objective of this research was to investigate the feasibility of stabilization of organic soils and sewage sludge to obtain low cost alternative embankment material by the addition of two different slags. Slags were used as a replacement for weak soil at ratios of 0%, 25%, 50%, 75% and 100%, where sewage sludge and organic soil were blended with slags separately. The maximum dry unit weights and the optimum water contents for all soil mixtures were determined. In order to investigate the influence of the slags on the strength of sewage sludge and organic soil, and to obtain the optimal mix design; compaction tests, the California bearing ratio (CBR) test, unconfined compressive strength (UCS) test, hydraulic conductivity test (HCT) and pH tests were carried out on slag-soil specimens. Unconfined compressive tests were performed on non-cured samples and those cured at 7 days. The test results obtained from untreated specimens were compared to tests results obtained from soil samples treated with slag. Laboratory tests results indicated that blending slags with organic soil or sewage sludge improved the engineering properties of organic or sewage sludge. Therefore, it is concluded that slag can be potentially used as a stabilizer to improve the properties of organic soils and sewage sludge.

• Nuclear Engineering and Technology
• /
• v.41 no.6
• /
• pp.797-806
• /
• 2009

The Multichannel Analyzer for Transient and steady-state in Rod Array - Liquid Metal Reactor for Flow Blockage analysis (MATRA-LMR-FB) code for the analysis of a subchannel blockage has been developed and evaluated through several experiments. The current version of the code is improved here by the implementation of a distributed resistance model which accurately considers the effect of flow resistance on wire spacers, by the addition of a turbulent mixing model, and by the application of a hybrid scheme for low flow regions. Validation calculations for the MATRA-LMR-FB code were performed for Oak Ridge National Laboratory (ORNL) 19-pin tests with wire spacers and Karlsruhe 169-pin tests with grid spacers. The analysis of the ORNL 19-pin tests conducted using the code reveals that the code has sufficient predictive accuracy, within a range of 5 $^{\circ}C$, for the experimental data with a blockage. As for the results of the analyses, the standard deviation for the Karlsruhe 169-pin tests, 0.316, was larger than the standard deviation for the ORNL 19-pin tests, 0.047.