• Korean Journal of Organic Agriculture
• /
• v.28 no.1
• /
• pp.31-57
• /
• 2020

Korea-US FTA amendment became effective January 1, 2019 through several trade negotiations between the two countries. These amendments did not include changes in the agricultural sector. However, given the policy direction of the Trump administration, it is difficult to be certain that the existing Korea-US FTA on the agricultural sector will remain unchanged. This study examines the potential impact of changes in the US beef import tariff rates under the Korea-US FTA, which is progressively eliminated until 2026 using a dynamic partial equilibrium model. The modelling system is simulated with 100% decreases of tariff rates over 2020~2026 period and then compared to the baseline which is developed based on the current Korea-US FTA tariff rates. According to the scenario analyses results, 100% decreases of US beef tariff rate lowered Korean beef cattle production value up to 4.23%. Looking at this change in terms of absolute value rather than percentage, the total production value over 2020~2026 is expected to decrease by 815 billion won compared to Baseline. This reduction in production value in dynamic analysis is 67 billion won higher than the comparative static analysis.

• Korean Journal of Materials Research
• /
• v.21 no.10
• /
• pp.542-545
• /
• 2011

Half-Heusler alloys are a potential thermoelectric material for use in high-temperature applications. In an attempt to produce half-Heusler thermoelectric materials with fine microstructures, TiCoSb was synthesized by the mechanical alloying of stoichiometric elemental powder compositions and then consolidated by vacuum hot pressing. The phase transformations during the mechanical alloying and hot consolidation process were investigated using XRD and SEM. A single-phase, half- Heusler allow was successfully produced by the mechanical alloying process, but a minor portion of the second phase of the CoSb formation was observed after the vacuum hot pressing. The thermoelectric properties as a function of the temperature were evaluated for the hot-pressed specimens. The Seebeck coefficients in the test range showed negative values, representing n-type conductivity, and the absolute value was found to be relatively low due to the existence of the second phase. It is shown that the electrical conductivity is relatively high and that the thermal conductivities are compatibly low in MA TiCoSb. The maximum ZT value was found to be relatively low in the test temperature range, possibly due to the lower Seebeck coefficient. The Hall mobility value appeared to be quite low, leading to the lower value of Seebeck coefficient. Thus, it is likely that the single phase produced by mechanical alloying process will show much higher ZT values after an excess Ti addition. It is also believed that further property enhancement can be obtained if appropriate dopants are selectively introduced into this MA TiCoSb System.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.77-78
• /
• 2006

This paper presents a signal quality estimation technique for QAM modulation systems. By making a LUT(Look-up table) putting the number of N enough, we can derive estimated SNR from LUT even though N is small. That is so called MOTM algorithm. In 16-QAM, the distance $d_a$, between adjacent symbols is always invariable, so absolute value of R(the amplitude of signal) minus $d_a$ has a always same signal distribution value. This value does not form a Gaussian shape but, by making a little bit correction, we can make this symmetrical. So, from the received symbol value, by using LUT we can easily derive the estimated SNR. By considering this, we introduce a signal quality estimation technique for QAM schemes. This proposed method can be applicable to high order modulation schemes and wide range of signal to noise ratio.

• Management & Information Systems Review
• /
• v.17
• /
• pp.161-189
• /
• 2005

As the importance of intellectual assets has been brought into relief, this study aims at positively verifying where the intellectual workers' overall level of their knowledge conversion preference and their job character has reached, and how much the knowledge conversion preference, the job character and the fitness of both factors affects the job effectiveness respectively. For this purpose 3 types of research hypotheses were set up and the result of the verification of the hypotheses is summarized as follows: First, the verification of the relation between the knowledge conversion preference and the job effectiveness revealed that the workers who have the higher synthetic ability in knowledge conversion preference show the higher job satisfaction and job product. Secondly, the verification of the relation between the MPS representing the job character by measured index and the job satisfaction revealed that the absolute value of relative coefficient between the 4 factors excluding the public welfare factor and the MPS is 4, interpreted as medium correlation. Thirdly, the analysis on the degree of relation between the job product measured by the quality of job result and the input effort and the MPS showed that the absolute value of person relative coefficient is 5, interpreted not only as medium correlation but also very meaningful. Accordingly, the main purpose of this study was to give a guideline which can be utilized as an indicator for educating, training and placing the workers. As results, the main effect that the variable of knowledge conversion preference and job character chosen as the independent variable influences on the dependent variable of job satisfaction and job product is very meaningful except the public welfare factor.

• Journal of the Korean Data and Information Science Society
• /
• v.26 no.4
• /
• pp.857-864
• /
• 2015

By Wikipedia, data mining is the computational process of discovering patterns in huge data sets involving methods at the intersection of association rule, decision tree, clustering, artificial intelligence, machine learning. Clustering or cluster analysis is the task of grouping a set of objects in such a way that objects in the same group are more similar to each other than to those in other groups. The similarity measures being used in the clustering may be classified into various types depending on the characteristics of data. In this paper, we computed bounds for similarity measures based on the probabilistic interestingness measure with partially marginal probability such as Peirce I, Peirce II, Cole I, Cole II, Loevinger, Park I, and Park II measure. We confirmed the absolute value of Loevinger measure wasthe upper limit of the absolute value of any other existing measures. Ordering of other measures is determined by the size of concurrence proportion, non-simultaneous occurrence proportion, and mismatch proportion.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.5 s.335
• /
• pp.39-46
• /
• 2005

It is well known the fact that turbo codes has better performance as the number of iteration and the interleaver size increases in the AWGN channel environment. However, as the number of iteration and the interleaver size are increased, it is required much delay and computation for iterative decoding. Therefore, it is important to devise an efficient criterion to stop the iteration process and prevent unnecessary computations and decoding delay. In this paper, it proposes the efficient iterative decoding stop criterion using the absolute mean value of LLR difference. It is verifying that the proposal iterative decoding stop criterion can be reduced the average iterative decoding number compared to conventional schemes with a negligible degradation of the error performance.

• Journal of Korean Society of Disaster and Security
• /
• v.6 no.3
• /
• pp.1-8
• /
• 2013

Based on random vibration theory, a procedure for calculating the dynamic response of the tall building to time-dependent random excitation is developed. In this paper, the fluctuating along- wind load is assumed as time-dependent random process described by the time-independent random process with deterministic function during a short duration of time. By deterministic function A(t)=1-exp($-{\beta}t$), the absolute value square of oscillatory function is represented from author's studies. The time-dependent random response spectral density is represented by using the absolute value square of oscillatory function and equivalent wind load spectrum of Solari. Especially, dynamic mean square response of the tall building subjected to fluctuating wind loads was derived as analysis function by the Cauchy's Integral Formula and Residue Theorem. As analysis examples, there were compared the numerical integral analytic results with the analysis fun. results by dynamic properties of the tall uilding.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.9A
• /
• pp.1392-1400
• /
• 1999

In this paper, we propose a two-stage fast full search algorithm for block motion estimation that produces the same performance to that of full search algorithm (FSA) but with remarkable computation reduction. The proposed algorithm uses the search region subsampling and the difference of adjacent pixels in the current block. In the first stage, we subsample the search region by a factor of 9, and then calculate mean absolute error (MAE) at the subsampled search points. And in the second stage, we reduce the search points that need block matching process by using the lower bound of MAE value at each search Point. We Set the lower bound of MAE value for each search point from the MAE values which are calculated at the first stage and the difference of adjacent pixels in the current block. The experimental results show that we can reduce the computational complexity considerably without any degradation of picture quality.

• Journal of the Korea Society of Computer and Information
• /
• v.17 no.10
• /
• pp.137-143
• /
• 2012

The learners using learning content through the smart devices can access to the Internet from anytime and anywhere. However, with the rapid increase of learning content on the Web, it will be time-consuming for learners to find contents they really want to and need to study. Therefore, e-learning systems should not only provide flexible content delivery, but support adaptive harmonizing fusion content. The harmonizing fusion content it is a very important in fusion e-learning service. The representative method to provide synchronization between fusion content is a provide absolute time value between of the contents. However, this method is occurs a problem transferring time delay. Also, to enter an absolute time value for the duration of the each content is several problems arise. In this paper introduces a new smart e-smart service support the harmonizing media based technology to create synchronized learning presentation.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.39 no.1
• /
• pp.64-72
• /
• 2016

In this paper, we utilize a Gaussian process to predict the power consumption in the air-conditioning system. As the power consumption in the air-conditioning system takes a form of a time-series and the prediction of the power consumption becomes very important from the perspective of the efficient energy management, it is worth to investigate the time-series model for the prediction of the power consumption. To this end, we apply the Gaussian process to predict the power consumption, in which the Gaussian process provides a prior probability to every possible function and higher probabilities are given to functions that are more likely consistent with the empirical data. We also discuss how to estimate the hyper-parameters, which are parameters in the covariance function of the Gaussian process model. We estimated the hyper-parameters with two different methods (marginal likelihood and leave-one-out cross validation) and obtained a model that pertinently describes the data and the results are more or less independent of the estimation method of hyper-parameters. We validated the prediction results by the error analysis of the mean relative error and the mean absolute error. The mean relative error analysis showed that about 3.4% of the predicted value came from the error, and the mean absolute error analysis confirmed that the error in within the standard deviation of the predicted value. We also adopt the non-parametric Wilcoxon's sign-rank test to assess the fitness of the proposed model and found that the null hypothesis of uniformity was accepted under the significance level of 5%. These results can be applied to a more elaborate control of the power consumption in the air-conditioning system.