• 한국재료학회지
• /
• 제30권8호
• /
• pp.399-405
• /
• 2020

In the present investigation we show the effect of Al doping on the length, size, shape, morphology, and sensing property of ZnO nanorods. Effect of Al doping ultimately leads to tuning of electrical and optical properties of ZnO nanorods. Undoped and Al-doped well aligned ZnO nanorods are grown on sputtered ZnO/SiO₂/Si (100) pre-grown seed layer substrates by hydrothermal method. The molar ratio of dopant (aluminium nitrate) in the solution, [Al/Zn], is varied from 0.1 % to 3 %. To extract structural and microstructural information we employ field emission scanning electron microscopy and X-ray diffraction techniques. The prepared ZnO nanorods show preferred orientation of ZnO <0001> and are well aligned vertically. The effects of Al doping on the electrical and optical properties are observed by Hall measurement and photoluminescence spectroscopy, respectively, at room temperature. We observe that the diameter and resistivity of the nanorods reach their lowest levels, the carrier concentration becomes high, and emission peak tends to approach the band edge emission of ZnO around 0.5% of Al doping. Sensing behavior of the grown ZnO nanorod samples is tested for H₂ gas. The 0.5 mol% Al-doped sample shows highest sensitivity values of ~ 60 % at 250 ℃ and ~ 50 % at 220 ℃.

• 한국세라믹학회지
• /
• 제35권1호
• /
• pp.17-22
• /
• 1998

B-doped ZnO thin films on glass substrates were prepared by sputtering the ceramic targets which had been prepared by sintering disks consisting of ZnO and various amounts of B2O3 While pure ZnO films show-ed a c-axis oriented growth the B-doping retarded the prefered orientation and grain growth of the film. Electron concentrations for undoped and B-doped ZnO films were on the order of 7.8${\times}$1018 cm-3 and 5${\times}${{{{ {10 }^{20 } }} c{{{{ {m }^{-3 } }} respectively. The electron mobility however decreased with the B-doping concentration. Optical meas-urements on the films showed that the average transmittance in the visible range was higher than 85% The measurements also indicated a blueshift of the absorption edge with doping.

• 한국전기전자재료학회논문지
• /
• 제27권10호
• /
• pp.642-647
• /
• 2014

For feasible study of opto-electrical application regarding to oxide semiconductor, we implemented the N doped ZnO growth using a atomic layer deposition technique. The p-type ZnO deposition, necessary for ZnO-based optoelectronics, has considered to be very difficulty due to sufficiently deep acceptor location and self-compensating process on doping. Various sources of N such as $N_2$, $NH_3$, NO, and $NO_2$ and deposition techniques have been used to fabricate p-type ZnO. Hall measurement showed that p-type ZnO was prepared in condition with low deposition temperature and dopant concentration. From the evaluation of photoluminescence spectroscopy, we could observe defect formation formed by N dopant. In this paper, we exhibited the electrical and optical properties of N-doped ZnO thin films grown by atomic layer deposition with $NH_3OH$ doping source.

• 한국재료학회지
• /
• 제19권11호
• /
• pp.607-612
• /
• 2009

We investigated the effects of Co doping on the NO gas sensing characteristics of ZnO-carbon nanotube (ZnO-CNT) layered composites fabricated by coaxial coating of single-walled CNTs with ZnO using pulsed laser deposition. Structural examinations clearly confirmed a distinct nanostructure of the CNTs coated with ZnO nanoparticles of an average diameter as small as 10 nm and showed little influence of doping 1 at.% Co into ZnO on the morphology of the ZnO-CNT composites. It was found from the gas sensing measurements that 1 at.% Co doping into ZnO gave rise to a significant improvement in the response of the ZnO-CNT composite sensor to NO gas exposure. In particular, the Co-doped ZnO-CNT composite sensor shows a highly sensitive and fast response to NO gas at relatively low temperatures and even at low NO concentrations. The observed significant improvement of the NO gas sensing properties is attributed to an increase in the specific surface area and the role as a catalyst of the doped Co elements. These results suggest that Co-doped ZnOCNT composites are suitable for use as practical high-performance NO gas sensors.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제45회 하계 정기학술대회 초록집
• /
• pp.145.1-145.1
• /
• 2013

A prerequisite for the development of graphene-based field effect transistors (FETs) is reliable control of the type and concentration of carriers in graphene. These parameters can be manipulated via the deposition of atoms, molecules, and polymers onto graphene as a result of charge transfer that takes place between the graphene and adsorbates. In this work, we demonstrate a unique and facile methodology for the homogenous and stable p-type doping of graphene by hybridization with ZnO thin films fabricated by MeV electron beam irradiation (MEBI) under ambient conditions. The formation of the ZnO/graphene hybrid nanostructure was attributed to MEBI-stimulated dissociation of zinc acetate dihydrate and a subsequent oxidation process. A ZnO thin film with an ultra-flat surface and uniform thickness was formed on graphene. We found that homogeneous and stable p-type doping was achieved by charge transfer from the graphene to the ZnO film.

• 한국세라믹학회지
• /
• 제33권5호
• /
• pp.531-535
• /
• 1996

ZnGa2O4 and Mn-doped ZnGa2O4 were synthesized using the state reaction method to investigate their photoluminescence characteristics depending on Mn concentration. Under 254nm excitation, ZnGa2O4 exhibited a broad-band emission extending from 330 nm to 610 nm peaking at 450nm. On the other hand Mn-doped ZnGa2O4 showed a new strong narrow-band emission peaking at 504 nm and maximum intensity at the doping concentration of 0.006 mole Mn.

• 한국재료학회지
• /
• 제29권10호
• /
• pp.586-591
• /
• 2019

This study describes the doping effect of $Yb_2O_3$ on microstructure, electrical and dielectric properties of $ZnO-V_2O_5-MnO_2-Nb_2O_5$ (ZVMN) ceramic semiconductors sintered at a temperature as low as $900^{\circ}C$. As the doping content of $Yb_2O_3$ increases, the ceramic density slightly increases from 5.50 to $5.54g/cm^3$; also, the average ZnO grain size is in the range of $5.3-5.6{\mu}m$. The switching voltage increases from 4,874 to 5,494 V/cm when the doping content of $Yb_2O_3$ is less than 0.1 mol%, whereas further doping decreases this value. The ZVMN ceramic semiconductors doped with 0.1 mol% $Yb_2O_3$ reveal an excellent nonohmic coefficient as high as 70. The donor density of ZnO gain increases in the range of $2.46-7.41{\times}10^{17}cm^{-3}$ with increasing doping content of $Yb_2O_3$ and the potential barrier height and surface state density at the grain boundaries exhibits a maximum value (1.25 eV) at 0.1 mol%. The dielectric constant (at 1 kHz) decreases from 592.7 to 501.4 until the doping content of $Yb_2O_3$ reaches 0.1 mol%, whereas further doping increases it. The value of $tan{\delta}$ increases from 0.209 to 0.268 with the doping content of $Yb_2O_3$.

• Transactions on Electrical and Electronic Materials
• /
• 제14권3호
• /
• pp.148-151
• /
• 2013

The control of Ga doping in ZnO nanowires (NWs) by physical vapor deposition has been implemented and characterized. Various Ga-doped ZnO NWs were grown using the vapor-liquid-solid (VLS) method, with Au catalyst on c-plane sapphire substrate by hot-walled pulsed laser deposition (HW-PLD), one of the physical vapor deposition methods. The structural, optical and electrical properties of Ga-doped ZnO NWs have been systematically analyzed, by changing Ga concentration in ZnO NWs. We observed stacking faults and different crystalline directions caused by increasing Ga concentration in ZnO NWs, using SEM and HR-TEM. A $D^0X$ peak in the PL spectra of Ga doped ZnO NWs that is sharper than that of pure ZnO NWs has been clearly observed, which indicated the substitution of Ga for Zn. The electrical properties of controlled Ga-doped ZnO NWs have been measured, and show that the conductance of ZnO NWs increased up to 3 wt% Ga doping. However, the conductance of 5 wt% Ga doped ZnO NWs decreased, because the mean free path was decreased, according to the increase of carrier concentration. This control of the structural, optical and electrical properties of ZnO NWs by doping, could provide the possibility of the fabrication of various nanowire based electronic devices, such as nano-FETs, nano-inverters, nano-logic circuits and customized nano-sensors.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.421-422
• /
• 2013

Recently, ZnO has received attentionbecause of its applications in optoelectronics and spintronics. In order to investigate deep level defects in ZnO, we used N-doped ZnO with various of the N-doping concentration. which are reference samples (undoped ZnO), 27%, 49%, and 88%-doped ZnO. Photoinduced current transient spectroscopy (PICTS) measurement was carried out to find deep level traps in high resistive ZnO:N. In reference ZnO sample, a deep trap was found to located at 0.31 (as denoted as the CO trap) eV below conduction band edge. And the CN1 and CN2 traps were located at 0.09, at 0.17 eV below conduction band edge, respectively. In the case of both annealed samples at 200 and $300^{\circ}C$, the defect density of the CO trap increases and then decreases with an increase of N-doping concentration. On the other hands, the density of CN traps has little change according to an increase of N-doping concentration in the annealed sample at $300^{\circ}C$. According to the result of PICTS measurement for different N-doping concentration, we suggest that the CO trap could be controled by N-doping and the CN traps be stabilized by thermal annealing at $300^{\circ}C$.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.337-337
• /
• 2013

ZnO seed layers were deposited on a quartz substrate using the sol-gel method, and B-doped ZnO (BZO) nanorods with different B concentrations ranging from 0 to 2.5 at.% were grown on the ZnO seed layers by the hydrothermal method. The structural, optical, electrical propertiesof the ZnO and BZO nanorods were investigated using field-emission scanning electron microscopy, X-ray diffraction (XRD), photoluminescence (PL), ultraviolet-visible spectroscopy, and hall effect. The ZnO and BZO nanorods grew well aligned on the surface of the quartz substrates. From the XRD data, it can be seen that the B doping is responsible for the distortion of the ZnO lattice. The PL spectra show near-band-edge emission and deep-level emission, and they also show that B doping significantly affects the PL properties of ZnO nanorods. The optical band gaps are changed by B doping, and thus the Urbach energy value changed with the optical band gap of the ZnO nanorods. From the hall measurements, it can be observed that the values of electrical resistivity, carrier concentration, and mobility are changed by B doping.