• Korean Journal of Crystallography
• /
• v.8 no.2
• /
• pp.149-153
• /
• 1997

ZnO varistor based on ZnO-Bi2O3-Co3O4-MnCO3-Cr2-O3-Sb2O3 system with Sb2O3 contents were studied for grain size variation and microstructure properties. The composition of pure ZnO varistor was observed composition was inhibited owing to formation of Zn7Sb2O12 spinel phase and did not observed abnrmal grain growth. With Sb2O3 contents, the grain sizes of ZnO varistor were remarkably decreased and the microstructure had the distribution of dense and homogeneous grains.

• Journal of the Korean Ceramic Society
• /
• v.31 no.2
• /
• pp.213-219
• /
• 1994

The formations of spinel and colors of ZnO-Fe2O3-TiO2-SnO2 system have been researched on the basis of ZnO-Fe2O3 system. Specimens were prepared by substituting Fe3+, with Ti4+ or Sn4+ when mole ratios between Fe3+ and Ti4+ or between Fe3+ and Sn4+ were 0.2 mole. The reflectance measurement and X-ray diffraction analysis of the formation of spinel and the colors of there specimens were carried out. ZnO-Fe2O3 system in which Fe2O3 was substituted with SnO2 and TiO2 was formed the spinel structure of 2ZnO.TiO2, 2ZnO.SnO2, ZnO.Fe2O3. The stable stains which were colored with yellow and brown could be manufactured.

• Journal of the Korean Ceramic Society
• /
• v.30 no.9
• /
• pp.723-730
• /
• 1993

The mechanism of formation of perovskite phase and the dielectric properties of PZMN[Pb(Zn, Mg)1/3Nb2/3O3] ceramics were examined using two different types of the columbite precursors, (Mg, Zn)Nb2O6 (MZN) and MgNb2O6＋ZnNb2O6 (MN＋ZN). The formatin of perovskite phase in PbO＋MN＋ZN system is characterized by an initial rapid formation of Mg-rich perovskite phase, followed by a sluggish formation of Zn-rich perovskite phase. On the other hand, thepyrochlore/perovskite transformation in the PbO＋MZN system proceeded uniformly with a spatial homogeneity. The degree of diffuseness of the rhombohedral/cubic phase transitionis higher in the PbO＋MN＋ZN system than in the PbO＋MZN specimen, indicating a broadened compositional distributjion of the B-site catons (Nb+5, Zn+2, Mg+2) in the PbO＋MN＋ZN system.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.31 no.6
• /
• pp.270-275
• /
• 2021

ZnO was synthesized according to the transformation behavior and crystallization conditions of Zn-intermediate obtained by zinc sulfate as a precursor and NaOH, Na₂CO₃ as a alkali agents. For ZnO crystallization, Zn₄(OH)₆SO₄·H₂O and Zn₅(OH)₆(CO₃)₂·H₂O as a Zn-intermediate were calcined at 400℃ and 800℃ for 1 h, respectively, based on decomposition temperature from TGA. Zn₄(OH)₆SO₄·H₂O was confirmed to have mixed Zn₄(OH)₆SO₄·H₂O and ZnO at 400℃, and was completely thermally decomposed at 800℃ to form ZnO phase. The prepared Zn₅(OH)₆(CO₃)₂·H₂O as a Zn-intermediate by the reaction with Na₂CO₃ was transformed to a complete ZnO crystallization over 400℃. Nano-sized ZnO can be synthesized at a relatively lower calcination temperature through the reaction with Na₂CO₃.

• Korean Journal of Materials Research
• /
• v.1 no.2
• /
• pp.65-70
• /
• 1991

The effect of inclusion particles on the microstructure development and electrical characteristics in the systems $ZnO-Bi_2O_3-CoO-Sb_2O_3\;and\;ZnO-Bi_2O_3-CoO-Sb_2O_3-Cr_2O_3 were investigated. The growth of ZnO grains, which was controlled by the spinel particles during sintering, decreased with increasing amount of spinel particles. Addition of $Cr_2O_3(0.5mol\%) increased the breakdown voltage without affecting the non-linear characteristics. The calculated barrier voltage of the $ZnO-Bi_2O_3-CoO-Sb_2O_3\;-and\;ZnO-Bi_2O_3-CoO-Sb_2O_3-Cr_2O_3$ systems were about 3.1V and 2.9V, respectively.

• Journal of the Korean Ceramic Society
• /
• v.40 no.11
• /
• pp.1113-1119
• /
• 2003

We used isopropanol which has low boiling point to prepare thin films at low temperature and changed mole concentration of zinc acetate from 0.3 to 1.3 mol/l. The structural, optical and electrical properties of ZnO thin films with Zn content were investigated. ZnO thin films highly oriented along the c-axis were obtained at Zn concentration of 0.7 mol/l. ZnO thin films with Zn concentration of 0.7 mol/l showed a homogeneous surface layer of nano structure. The transmittance of ZnO thin films by UV-vis. measurement was about 87% under the Zn concentration of 0.7 mol/l, but rapidly decreased over the 1.0 mol/l. The optical band gap energy was obtained from 3.07 to 3.22 eV which is very close to the band gap of bulk ZnO (3.2 eV). The electrical resistivity of ZnO thin films was about 150 $\Omega$-cm that shows little difference with Zn concentration. I-V curves of ZnO thin films exhibited typical ohmic contact properties.

• Journal of the Korean Ceramic Society
• /
• v.28 no.4
• /
• pp.305-314
• /
• 1991

This study was conducted to research the formation and the color development of NiO-ZnO-Fe2O3-TiO2-SnO2 system for the purpose of synthesizing the spinel pigments which are stable at high temperature. After preparing ZnO-Fe2O3 as a basic composition, {{{{ chi }}NiO.(l-{{{{ chi }})ZnO.Fe2O3 system, {{{{ chi }}NiO.(l-{{{{ chi }})ZnO.TiO2 system, and {{{{ chi }}NiO.(l-{{{{ chi }})ZnO.SnO2 system were prepared with {{{{ chi }}=0, 0.2, 0.5, 0.7, 1 mole ratio respectively. The manufacturing was carried out at 128$0^{\circ}C$ for 30 minutes. The reflectance measurement and the X-ray analysis of these specimens were carried out and the results were summarized as follows. 1. In the specimens which included NiO, it was difficult for the spinel structure to be formed. 2. As increasing the contents of NiO and Fe2O3, all the groups which were yellow or green colored changed to brown. 3. NiO-ZnO-Fe2O3 system and NiO-ZnO-TiO2 system formed the spinel structure and the illmenite structure appeared in NiO-TiO2 system.

• Journal of the Korean Ceramic Society
• /
• v.29 no.2
• /
• pp.101-106
• /
• 1992

Sintering behavior, distribution of dopant oxides and electrical properties in the ZnO-Bi2O3-CoO-Sb2O3 and ZnO-Bi2O3-CoO-Sb2O3-Cr2O3 systems were studied. The linear shrinkage of ZnO varistors from 850 to 950$^{\circ}C$ was related to the decomposition reaction (py\longrightarrowsp+Bi2O3) of the pyrochlore phase. In the distribution of the dopant oxides (CoO, Sb2O3, Cr2O3), Co distribute uniformly throughout the sample, the distribution of Sb coincided with small particles (spinel phase, Zn7Sb2O12), and Cr distributed very consistently with Sb. The increase in breakdown voltage, due to the addition of Cr2O3, was not only attributed to the decrease in the ZnO grain size but also to the solution of Cr2O3 in the spinel phase. The leakage current (80% V60 ${\mu}\textrm{A}$) was increased by the addition of Cr2O3.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07a
• /
• pp.37-40
• /
• 2003

Amorphous $Al_2O_3$ nanotubes have been fabricated by utilizing the ZnO nanowires as template with wet etching method. ZnO nanowires synthesized by thermal evaporation are conformally coated with $Al_2O_3$ by atomic-layer deposition(ALD) method. The $Al_2O_3$-coated ZnO nanowires are of core-shell structure; ZnO core nanowires and $Al_2O_3$ shells. When the $ZnO/Al_2O_3$ core-shell structure is dipped in $H_3PO_4$ solution at $25^{\circ}C$ for a 6 min, the core ZnO materials are completely etched, and only $Al_2O_3$ nanotubes are remained. This nanotube fabrication is technically easier than others, and simply approachable. Transmission electron microscopy shows that the $Al_2O_3$ nanotubes have various thicknesses that can be controlled.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.10
• /
• pp.834-839
• /
• 2000

The structural properties that SEM photograph of ZnO varistors surface studied by fractal mathematics program were investigated to verify the relations of electrical characteristics. The SEM photograph of ZnO varistors surface were changed by binary code and the grain shape of that were analyzed by fractal dimension. The void of ZnO varistors surface was found by fractal program. The relation between grain density and electrical properties depend on fractal dimension. The grain size in ZnO varistors surface was decreased by increasing of Sb$_2$O$_3$ addition. The spinel structure was formed by Sb$_2$O$_3$addition and it was depressed the ZnO grain formation. The grain size of ZnO by Sb$_2$O$_3$addition were from 5 to 10[${\mu}{\textrm}{m}$]. Among of ZnO varistors, fractal dimension of ZnO4 was very high as a 1.764. The density of grain boundary in ZnO2 and ZnO3 varistors surface was 15[%] by formed spinal structure. The breakdown electric field of ZnO2 that fractal dimension has 1.752 was very high to be 8.5[kV/cm]. When the fractal dimensin was high, the grain shape of ZnO varistors was complex and the serial layers of ZnO grain was increased.