• Journal of Sericultural and Entomological Science
• /
• v.29 no.2
• /
• pp.7-14
• /
• 1987

Extensive studies were undertaken to analyze the genetic basis of economically important quantitative characters in the silkworm by diallel crosses of four inbred lines differing widely in silk yielding ability. Some differences between the reciprocal corsses were detected in cocoon weight, cocoon shell weight, cocoon filament length and cocoon filament weight in case the parental lines were greatly differenent each other in silk yielding ability. The general combining ability (GCA) varied with the inbred lines and M242, a Chieese sexlimited larval marking variety showed high GCA value in the economic characters, such as cocoon yield, cocoon weight, cocoon filament length and weight, and raw silk percentage. The highest heterosis effect, about 13% to 14% was seen in cocoon and raw silk yield and it was low in cocoon reelability and raw silk percentage with less than 1%. It is advisable to improve highly heritable quantitative characters such as larval duration, cocoon shell weight, cocoon filament length and raw silk percentage by means of selection, and to select single crosses with high heterosis effect for cocoon weight and cocoon yield which show overdominance. Genetic correlation should be considered when more than two characters are targets for improvement and selecting high cocoon shell weight is effective to breed high silk yielding varieties. It is difficult to improve cocoon reelability because of low heritability (0.11) and its negative correlation with cocoon-silk quality.

• Food Science and Preservation
• /
• v.15 no.6
• /
• pp.840-846
• /
• 2008

Microwave-assisted extraction (MAE) of grape seeds was performed under the different conditions based on a central composite design for independent variables of microwave power ($0{\sim}120\;W$), ethanol concentration ($0{\sim}100%$) and extraction time ($1{\sim}5\;min$). Response surface methodology (RSM) was used to predict the optimum extraction conditions for three dependent variables in grape seed extracts: total yield, total catechin and electron donating ability. Determination coefficients ($R^2$) of regression equations for the three dependent variables were higher than 0.9 (p < 0.01). The optimal MAE conditions to yield the maximum value of total catechin (434.16 mg%) were 122.76 W microwave power, 42.88% ethanol and 4.67 min extraction time. The superimposed contour maps for maximizing the three dependent variables indicated that the MAE condition ranges were 75150 W, 4060% ethanol and 3.55.0 min. The predicted values at the optimized conditions (6.72% total yield, 408.65 mg% total catechin, and 83.33% electron donation ability) were similar to the experimental values. The optimized MAE (112.5 W, 50% EtOH, 4.2 min) was more efficient than the conventional solvent extraction using 80% EtOH, $60^{\circ}C$ for 3h and 150 rpm.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.44 no.3
• /
• pp.464-469
• /
• 2015

Response surface methodology (RSM) was used to monitor extraction characteristics of extracts from Sarcodon aspratus. Based on a central composite design, independent variables were microwave power (30~150 W), ethanol concentration (0~100%), and extraction time (1~9 min). Dependent variables were yield, electron-donating ability, total phenol contents, and SOD-like activity. Coefficients of determination ($R^2$) for dependent variables ranged from 0.80 at 0.97. The maximum extraction yield was 50.28% under conditions of 125.1 W microwave power, 18.67% ethanolic concentration, and 7.06 min extraction time. The maximum extraction electron-donating ability was 22.14% under conditions of 31.09 W, 45.76%, and 4.32 min. The maximum extraction total polyphenol content was 30.54 mg tannic acid equivalent/g at 122.54 W, 48.05%, and 8.36 min. The maximum extraction SOD-like activity was 33.44% at 121.17 W, 47.42%, and 8.41 min. Based on superimposition of four dimensional RSM with respect to extraction yield, electron-donating ability, total polyphenol content, and SOD-like activity obtained under various extraction conditions, optimum ranges of extraction conditions were found to be microwave power of 78~88 W, ethanol concentration of 39~57%, and extraction time of 3.5~9 min.

• Journal of the korean society of oceanography
• /
• v.37 no.1
• /
• pp.45-50
• /
• 2002

New production (NP) values in well-mixed waters of the Yellow Sea were estimated using two different methods and were compared with each other; one is from the quantum yield model of nitrate uptake and chlorophyll ${\alpha}$-specific light absorption coefficient, and the other is from a traditional $^{15}N$-labelled stable isotope uptake technique. The quantum yields of nitrate uptake were highly variable, ranging from 0.0001 to 0.04 mol $NO_3Ein^{-1}$, and the small values in this study might have resulted from either the partitioning into nitrate uptake of little portions of light energy absorbed by phytoplankton or that phytoplankton may predominantly utilize other N sources (E. G. ammonium and/or urea) than nitrate. The estimates (0.54-8.47 nM $h^{-1}$) of NP from the quantum yield model correlated well ($r^2$=0.67, p<0.1) with those (0.01-4.93 nM $h^{-1}$) obtained using the $^{15}NO_3$ uptake technique. To improve the ability of estimating NP values using this model in the Yellow Sea, more data need to be accumulated in the future over a variety of time and space scales.

• Journal of the Korean Wood Science and Technology
• /
• v.28 no.4
• /
• pp.72-82
• /
• 2000

Attempts were made to analyze the behavior of single and multiple-bolted connections through theoretical methods such as European yield theory, empirical approaching method, and semi-rigid theory instead of many experimental methods that have been actually inefficient and non-economical. In the case of a single-bolted connection, if accurate characteristic values of a material could be guaranteed, it would be more convenient and economical to perform the behavior analysis using a model based on the semi-rigid theory, instead of the existing complex yield model, or the empirical formula which produces errors, giving different results from the actual ones. If the variables of equation determining the load and deformation could be appropriately controlled, the analytical method in conjunction with a semi-rigid theory could be effectively applied to obtain the desirably predicted value, considering that the appropriate solution could be derived through a simpler equation using a less difficult method compared to the existing yield model. It is concluded that analytical method with semi-rigid theory can be used in the behavior analysis of bolted connection because our developed method showed excellent analysis ability of behavior until number of bolt is two. Although our analytical method has the disadvantage that the number of bolt is limited to two, it is concluded that it has the advantage than numerical method which complicated and time-consuming.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.39 no.2
• /
• pp.75-80
• /
• 2019

Oilseed rape is known to crop having low nitrogen use efficiency (NUE) but requires high levels of N fertilizer. NUE is associated with N remobilization from source to sink organ, consequently affects seed yield. Remobilization of leaf N is also related to transport of C/N metabolites in phloem. However, interaction between seed yield and phloem transport was not fully documented. In response to seed yield, N and C metabolites and their transport into seed from bolting to pod filling stage investigated in two contrasting genotypes (Capitol and Pollen) cultivated under ample (HN) or limiting nitrate (LN) supply. Seed yield was significantly reduced in N limitation and its reduction rate was much lower in Capitol than in Pollen compared to HN treated plants. Amino acid and protein content was higher in Capitol than in Pollen at bolting stage. They gradually decreased during plant development but not significant between two cultivars and/or two treatments. Glucose, fructose and sucrose content were 1.8-,1.6- or 1.25-fold higher in LN condition than in HN condition, respectively. Amino acid and sucrose content in phloem were largely higher in Capitol than in Pollen under LN condition. These results indicate that the higher seed yield might be related to greater transport ability of amino acid and sucrose in phloem under LN condition.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.4 no.1
• /
• pp.23-30
• /
• 2002

The general and specific combining abilities and hybrid vigour of seven polyvoltine breeds [BL24, BL62, BL6S, BL67, BL68, BL69, and Pure Mysore (PM)] with five bivoltine breeds (NB4D2, CSR2, CSR5, CSR18 and CSR19) were evaluated in a line ${times}$ tester design by analysing six quantitative traits viz., fecundity, yield 110,000 larvae both by number and weight, cocoon weight, shell weight and cocoon shell ratio. ANOVA estimates showed significant effects for all the traits indicating the role of both additive and non- additive gene actions. Estimation of GCA revealed that the breed BL67 exhibited significant positive effects toy all the six traits followed by BL68 for four important economic traits viz., fecundity, cocoon weight, shell weight and cocoon shell ratio. Among testers, CSR5 showed significant GCA effects for five traits whereas CSR2 exhibited for shell weight and shell ratio. Three hybrids viz., BL67${times}$ NB4D2, BL67 ${times}$CSR5 and BL67${times}$ CSR19 excelled in four quantitative traits for SCA. Majority of the hybrids expressed positive hybrid vigour for cocoon yield/10,000 larvae by weight, cocoon weight and shell weight. Four hybrids namely PM ${times}$ NB4D2, BL67 ${times}$NB4D2, BL67${times}$ CSR5 and BL67${times}$ CSR19 manifesting positive hybrid vigour for five economic traits were adjudicated as best Heterotic hybrids and recommended for commercial exploitation to increase the silk yield.

• Fibers and Polymers
• /
• v.7 no.2
• /
• pp.129-138
• /
• 2006

Using a strain-controlled rheometer, the steady shear flow properties of aqueous xanthan gum solutions of different concentrations were measured over a wide range of shear rates. In this article, both the shear rate and concentration dependencies of steady shear flow behavior are reported from the experimentally obtained data. The viscous behavior is quantitatively discussed using a well-known power law type flow equation with a special emphasis on its importance in industrial processing and actual usage. In addition, several inelastic-viscoplastic flow models including a yield stress parameter are employed to make a quantitative evaluation of the steady shear flow behavior, and then the applicability of these models is also examined in detail. Finally, the elastic nature is explained with a brief comment on its practical significance. Main results obtained from this study can be summarized as follows: (1) Concentrated xanthan gum solutions exhibit a finite magnitude of yield stress. This may come from the fact that a large number of hydrogen bonds in the helix structure result in a stable configuration that can show a resistance to flow. (2) Concentrated xanthan gum solutions show a marked non-Newtonian shear-thinning behavior which is well described by a power law flow equation and may be interpreted in terms of the conformational status of the polymer molecules under the influence of shear flow. This rheological feature enhances sensory qualities in food, pharmaceutical, and cosmetic products and guarantees a high degree of mix ability, pumpability, and pourability during their processing and/or actual use. (3) The Herschel-Bulkley, Mizrahi-Berk, and Heinz-Casson models are all applicable and have equivalent ability to describe the steady shear flow behavior of concentrated xanthan gum solutions, whereas both the Bingham and Casson models do not give a good applicability. (4) Concentrated xanthan gum solutions exhibit a quite important elastic flow behavior which acts as a significant factor for many industrial applications such as food, pharmaceutical, and cosmetic manufacturing processes.

• Journal of Korean Society of Forest Science
• /
• v.79 no.3
• /
• pp.260-268
• /
• 1990

Two types of ridge regression estimators were compared with the ordinary least squares (OLS) estimator in order to select the "best" estimator when multicollinearitc existed. The ridge estimators were Mallows's (1973) $C_P$-like statistic, and Allen's (1974) PRESS-like statistic. The evaluation was conducted based on the predictive ability of a yield model developed by Matney et al. (1988). A total of 522 plots from the data of the Southwide Loblolly Pine Seed Source study was used in this study. All of ridge estimators were better in predictive ability than the OLS estimator. The ridge estimator obtained by using Mallows's statistic performed the best. Thus, ridge estimators can be recommended as an alternative estimator when multicollinearity exists among independent variables.

• Journal of Sericultural and Entomological Science
• /
• v.32 no.1
• /
• pp.17-30
• /
• 1990

A 6${\times}$4 top-cross set was made from the ten silkworm parental lines selected by the first principal component scores. They were also analysed for the relationship between the combining ability and the first principal component score. The highest general combining ability effects were detected in the parental lines of Japanese, N39 and chinese, C46, for the most quantitative characters in the study. The first principal component score of factors related to silk productivity in the parents was significantly and positively correlated to the general combining ability of the twelve characters such as cocoon yield, cocoon weight, cocoon shell weight, cocoon shell percentage, duration of the 5th instar larvae, total larval period, length of a bave, weight of a have, non-breaking length of a bave, non-breaking weight of a have, raw silk percentage, and neatness. Similarity distance (D$^2$) was related to the specific combining ability of the characters such as cocoon yield, non-breaking length of a bave, non-breaking weight of a have, non-breaking ratio of a bave, raw silk percentage, neatness. From the results, it is possible to predict the general combining ability effects by the principal component scores for the 12 characters of the parents related to silk productivity.