• Korean Journal of Optics and Photonics
• /
• v.13 no.1
• /
• pp.32-37
• /
• 2002

Passive polarization mode splitters at λ= 1.55 ${\mu}{\textrm}{m}$ were designed and fabricated based on Ti:x-cut LiNbO$_3$ single-mode optical waveguide and two-mode interference theory. The splitting ratio with waveguide width 8 ${\mu}{\textrm}{m}$, branching angle 0.55$^{\circ}$ and interfering length 470 ${\mu}{\textrm}{m}$ showed 16.18 dB, 21.25 dB for TE and TM input polarization modes, respectively. Polarization cross-talk of -16.28 dB and -21.28 dB for TE and TM modes was achieved. Total insertion losses of 2.24 dB/cm (TE) and 2.41 dB/cm (TM) were also measured. The devices operated nearly wavelength independently over a range or 30 nm.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.2 no.3
• /
• pp.32-40
• /
• 1991

A modified transmission line model is proposed for input impedance analysis of a square microstip antenna with single-circularly-polarized. Alog-periodic arrangement with microstrip antenna (LPMA) which consists of 3 resonant element ($3\times1$) is designed for broadband operation ranging from 11.2 GHz to 12.4 GHz, based on this pro- posed model from transmission line model. Aplanar array ($3\times4$array), in which 4sets of the above LPMA are in the same plane, is fabricated for high gain X-band satellite communication antennas. The optimum spacing between each LPMA is determined using computer simulation for the minimum bariation of far field pattern and null. This $3\times4$array has a measured values of gain greater than 8dBi, VSWR les then 2.3, and bandwidth greater than 7% respectively.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.46 no.10
• /
• pp.856-867
• /
• 2018

This paper presents the applicability of MIMO joint decoding to dual-contact satellite systems in which two LEO satellites using X-band frequency band are transmitting each image data to two ground station antennas, simultaneously. When two satellites are closely positioned within the looking angle of the two antennas, each satellite interferes with each other by the relative antenna gain corresponding to an offset angle and this might cause the performance degradation without interference mitigation. To mitigate the performance degradation, SM MIMO techniques for joint decoding are applied. Especially, the relative antenna gain of ground station depending on the angle difference between two satellites in ground station antenna plays an important role in modelling the dual-contact satellite systems. The condition number of MIMO channel including the antenna gain calculated from the mathematical gain pattern model was primarily analyzed. Simulation results showed that the SM MIMO techniques using detection schemes such as ZF-SIC, MMSE-SIC, and ML can be applicable to dual-contact satellite systems.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.4
• /
• pp.747-752
• /
• 2009

In this paper, the MIMO(Multi-Input Multi-Output) channel characteristics for Rx antenna spacing are described in the real environment, which has LOS(Ling of Sight) and NLOS (Won-Line of Sight). We developed $2\times2$ MIMO channel measurement system at 2.3GHz Wibro Band. MIMO antenna evaluation parameters such as received power, channel capacity and spatial correlation are evaluated for standard dipole antenna with 0.25, 0.5, 0.75 and 1.0 wavelength spacing at 2-position for LOS and 4-position for NLOS. The spatial correlation is distributed more than 0.9 in most LOS case which might be intricate to operate MIMO communication. MIMO antenna design need to be focused on getting spatial diversity and reducing spatial correlation in LOS case.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.3
• /
• pp.519-526
• /
• 2016

As marine accidents happen frequently, it is required to establish a marine traffic monitoring system, which is designed to improve the safety and efficiency of navigation in VTS (Vessel Traffic Service). For this aim, recently, X-band marine radar is used for extracting the sea surface information and, it is necessary to retrieve wave information correctly and provide for the safe and efficient movement of vessel traffic within the VTS area. In this paper, three different current estimation algorithms including the classical least-squares (LS) fitting, a modified iterative least-square fitting routine and a normalized scalar product of variable current velocities are compared with buoy data and then, the iterative least-square method is modified to estimate wave information by improving the initial current velocity. Through several simulations with radar signals, it is shown that the proposed method is effective in retrieving the wave information compared to the conventional methods.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.9A
• /
• pp.694-701
• /
• 2003

In this paper, we present a hardware structure and new features of a smart antenna BTS (Base Transceiver Station) for CDMA2000 1X system. The proposed smart antenna BTS is a composite system consisting of many subsystems, i.e., array antenna element, frequency up/down converters, AD (Analog-to-Digital) and DA (Digital-to-Analog) converters, spreading/despreading units, convolutional encoder/Viterbi decoder, searcher, tracker, beamformer, calibration unit etc. Through the experimental tests, we found that the desired beam-pattern in both uplink and downlink communications is provided through the calibration procedure. Also it has been confirmed that the adaptive beamforming algorithm adopted to our smart antenna BTS is fast and accurate enough to support 4 fingers to each user. In our experiments, commercial mobile terminals operating PCS (Personal Communication System) band have been used. It has been confirmed that the smart antenna BTS tremendously improves the FER (Frame Error Rate) performance compared to the conventional 2-antenna diversity system.

• Composites Research
• /
• v.26 no.5
• /
• pp.279-288
• /
• 2013

In this paper, the delamination and deformed FSS caused by residual stresses in the Loop type FSS embedded composites and the transmission characteristic changes due to deformation of FSS by residual stresses were studied. FSS may have different electromagnetic characteristics depending on the type of element, design variables, and array. Therefore, design variables of square loop FSS embedded composites structures were determined to obtain the transmission characteristic for X-band (8~12 GHz). Then the design variables of other types of loops (triangular loop and circular loop) were determined based on the dimensions of square loop. Thereafter, the residual stresses and transmission characteristics of FSS embedded composite structures with various single and double loop FSS's, and stacking sequence of composite laminates were compared.

• Aerospace Engineering and Technology
• /
• v.11 no.2
• /
• pp.1-11
• /
• 2012

This paper describes the transmit/receive(T/R) module for the space based X-band active phased array radar. T/R module is the integrated module which is assembled by the transmitting and receiving RF semiconductor devices to enable the electronically beam steering of the phased array antenna and the key component of the SAR payload. T/R module can selectively receive the polarization signals by the switch according to the established technology but now the technological trend of the T/R module is to receive the horizontal and vertical polarization signal simultaneously. Therefore the research and development of the dual polarization receiving channel T/R module is actively in progress. In this study, as the prior research for the next generation SAR payload, the technological trend of the active phased array radar T/R module and the result of the preliminary design of the dual receiving channel T/R module were described.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.5
• /
• pp.1-5
• /
• 2010

This paper deals with a method to measure the thickness of scale-layer, iron oxide formed on the surface of the rolling steel, using a dielectric lens antenna. The dielectric lens antenna has an independent characteristic with the frequency in the X-band and changes the spherical wave radiated from a horn antenna into a plane wave at the focusing point. Using this concept, we regard a scale-layer on the rolling steel as a dielectric-PEC(Perfect Electric Conductor) layer and apply a theoretical analysis of the normal-incident plane wave. To reduce the phase error arising from the use of the dielectric lens antenna, this paper utilizes a regression process algorithm. In comparison with the conventional iteration algorithm, the present algorithm led to a unique solution for the thickness of the scale-layer.

• The Journal of the Acoustical Society of Korea
• /
• v.23 no.5
• /
• pp.420-427
• /
• 2004

This paper presents real time implementation of 4kbps EHSX (Enhanced Harmonic Stochastic Excitation) speech coder that combines the harmonic vector excitation coding with time-separated transition coding. The harmonic vector excitation coding uses the harmonic excitation coding for voiced frames and used the vector excitation coding with the structure of analysis-by-synthesis for unvoiced frames, respectively. For transition frames mixed with voiced and unvoiced signal, we use the time-separated transition coding. In this paper. we present the optimization methods of implementation speech coder on the EMS320C6701/sup (R)/ DSP. To reduce the complex for real-time implementation. we perform the optimization method in algorithm by replacing the complex sinusoidal synthesis method with IFFT. and we apply fully pipelines hand assembly coding after converting it from floating source to fixed source. To generate a more efficient code. we also make use or the available EMS320C6701/sup (R)/ resources such as Fastest67x library and memory organization.