• Journal of the Korean Wood Science and Technology
• /
• v.35 no.1
• /
• pp.64-72
• /
• 2007

The biodeterioration behaviors of square post to support the wooden printing blocks Shelves in the Janggeongpanjeon were investigated according to the positions and parts of square post, and environmental conditions. It was found that a high differences of deterioration in the progressing levels of wood decay, according to the positions and parts of square post, and environmental conditions. The decay levels were very high and still progressing in the contacted areas with stone foundation which are about up to 50 cm above it. In the decay type, white rot fungi was mainly affected in the inside of building which mainly made of softwood. The decay in the square posts to support the wooden printing block shelves inside of building was worse in the rear side, compared to front side. The insects was not found in most of square posts excluding the post which was neighboring at the infected round column by insect.

• 보존과학연구
• /
• s.16
• /
• pp.129-138
• /
• 1995

For the study of the pigments on lacquer with wooden for comparing a characteristics and chemical structures have been selected samples from tombs at Tanwol-dong, Ch′ungch′ong-do, Hwang-namtaech′ong, Anapchi Lake in Kyongju-shi and Miruksa Site. Analysis showed that red pigments on the lacquer with wooden from Anapchi Lake and Tomb at Tanwol-dong was found to Cinnabar, and those sample sexcavated from Hwang-namtaech′ong have been analyzed to calcite, maghematite and kornelite. In general, red pigments have two components like cinnabar and hematite. Hematite was found that red lacquer at Hwang-namtaech′ong was to beidentified Maghematite caused by their environment air pollution. Cinnabar was handled more valuable than hematite for unchanging characteristics for their colour under same condition since old times.

• Journal of Conservation Science
• /
• v.35 no.6
• /
• pp.670-680
• /
• 2019

This study attempts to identify whether there were preferred wood species or any required properties depending on the use of wooden objects by comparing wood species analysis results of wooden objects, which are classified specifically by their uses like comb, wooden tablets, containers, etc., excavated from Haman Seongsansansung mountain fortress, which is the archaeological site of the Three Kingdoms era and those excavated from archaeological sites in Gyeongsang province considered to be the similar era of Haman Seongsansansung mountain fortress site. Wooden tablets and combs show the preferred species clearly and containers preferred wood species with the mid-ranged strength and the resistance against moisture migration.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.8
• /
• pp.790-796
• /
• 2002

In our country, historically beautiful and significant wooden architectures are preserved as the cultural properties. For a long time, however, the architectures are often exposed to rough environmental conditions, such as weathering, insect attack, etc. This may lead to deterioration of structural integrity of the architectures. Therefore, it is necessary to diagnose wooden architectures in advance. In this paper, the possibility of a subsurface-penetrating radar(SPR) fur non-destructive testing(NDT) of wooden architectures is investigated by using the three-dimensional finite-difference time-domain(FDTD) simulation and actual laboratory measurement.

• Journal of Conservation Science
• /
• v.26 no.3
• /
• pp.247-258
• /
• 2010

We conducted optical microscopy, infra-red spectroscopy and SEM-EDS analysis of the lacquer layers on the wooden coffins excavated from King Muryeong's Tomb. We found four varnishing methods according to the sub-materials of lacquer layers: The lacquer of wooden coffins with black paint layer on the surface were classified with two groups; single layer and three layers. The lacquer of wooden coffins without black paint layer on the surface were classified with two groups; single layer and two layers. IR spectra of the laquer were same as those of the oriental laquer. The SEM-EDS analysis showed that the lacquer layers were mixed with iron, copper and calcium.

• Fire Science and Engineering
• /
• v.26 no.3
• /
• pp.8-13
• /
• 2012

This study suggests the water curtain nozzles as the way to protect important wooden cultural properties from an adjacent building fire or a forest fire. They are designed to block off the pyrolysis of timbers which occurs at $200{\sim}250^{\circ}C$ by forming a water curtain with the flow of water that spouts over a certain pressure from the bottom. The existing water curtain nozzles installed at the following sites were examined: NakSan-sa (Temple) in Gangwon-do (Province) and in Muwisa (Temple) in Jeollanam-do (South Province). As a way to improve and complement the system, this study designed nozzles with covers in order not to disrupt the landscape. Connected pipes are elevated and jet water when they are in use. Possible ways to install the connected elevating pipes to jet water effectively were investigated.

• Conservation Science in Museum
• /
• v.14
• /
• pp.7-12
• /
• 2013

The conservation has been conducted for the fragments of an wooden boat in the Neolithic Age, excavated from Bibong-ri, Changnyeong, Korea. The vacuum-freeze drying have been applied to mostly to the small relics, such as wooden lacquerwares or small wooden goods etc.. Therefore, the large objects like a wooden boats have been treated almost by air-drying after impregnation with aqueous PEG solution. The air-drying is needed to impregnate with PEG aqueous solution during long period and run the risk of the fault generation. This report explain an example adapted for the fragments of the wooden boat by humidity-controlled drying(HCD) with slow adjusting moisture content. We did the chemical pre-treatment, PEG aqueous solution. The concentration of the aqueous solution was increased gradually from 10% to 80%. After the impregnation, the objects were dried by the HCD. The dimensional stability of the fragments after treatment was good.

• Journal of the Korean Wood Science and Technology
• /
• v.43 no.1
• /
• pp.104-111
• /
• 2015

The three-year inspection of 20 tree stumps in the fire prevention area around the wooden building confirmed that termite colonies had been rapidly spread. In particular, four buildings among thirty one wooden buildings of Songgwang-sa temple were infected by the termite, indicating that the habitate of termite has been spread across the fire prevention area over the temple area. However, a non-destructive microwave diagnosis showed that internal damages have been progressed until now, suggesting a high risk to the building. These results suggest that the fire prevention area should be properly maintained to have harmful element controlled. Therefore, effective methods are required to eliminate tree stumps or wood materials used to establish fire prevention area near wooden buildings.

• Journal of architectural history
• /
• v.14 no.3 s.43
• /
• pp.103-118
• /
• 2005

This study is about the meaning of wooden brackets that are distinctive elements of wooden architecture in Korea, Japan, and China. Existing studies about wooden brackets have been limited to the boundary of formalism, so the object of this study is to make a breakthrough in the field of those studies. The Wooden brackets in this study are considered to be decorative elements, and the principles of their design are examined. The specific subject of the study is wooden architecture with Jusimpo-styled brackets that have brackets only on pillars. The definition of Jusimpo is reexamined first, and ChulMok-Ikkong which has not been regarded as a Jusimpo-styled wooden bracket is interpreted as Jusimpo-styled one in this study. Categorized into three types, Jusimpo is examined how it is expressed according to the type of the roof in a building. In view of the results, the wooden bracket system is an effective technique to express the formality, and two designing principles can be seen in Jusimpo; one that wooden brackets observed externally are standardized and regarded as the same ones, and the other that the style of wooden brackets used in the most formal building is Yi-ChulMok. These designing principles mean that the carpenter who was in charge of building the architecture had certain principles when expressing wooden brackets as well as the roofs according to the class of the architecture. In addition, although the styles of wooden brackets that were used in the most formal architecture during the Chosun period were mostly Dapo, Jusimpo in the form of Yi-ChulMok was also adopted in some temples depending on their scale, and that means Jusimpo-styled wooden brackets were never considered to be inferior to Dapo-styled ones. And this point leaves the argument that the reexamination of Jusimpo-styled wooden brackets which have been regarded as the style used in the attached building or small structures since the Choun dynasty should be conducted.

• Journal of the Korean Wood Science and Technology
• /
• v.31 no.6
• /
• pp.45-54
• /
• 2003

The density and strength of wood is affected by degradations and defects, such as voids and knots. Old wooden structures such as traditional cultural properties have been deteriorated by these types of defects. They were evaluated by a visual observation that is difficult to evaluate the inner deterioration in structures. In this study, three nondestructive testing techniques were investigated to detect the wooden structural members. Ultrasonic stress wave tests, drilling resistance tests and visual inspections were used to examine the structural wood members. Patterns of Resistograph using by drilling resistance tests could indicate the features of internal wood such as voids, knots, decay, fungi, and so on. The technique just like as ultrasonic stress wave tests, however, difficult to detect exactly area where small amounts of internal deterioration in logs are. In spite of results of ultrasonic stress wave test, the internal deterioration of wooden structural members could be evaluated by the relationship between ultrasonic stress wave tests and drilling resistance tests.