• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.12
• /
• pp.17-27
• /
• 2011

Most of the previous mobility management protocols such as IETF MIPv4/6 and its variants standardized by the IETF do not support global seamless handover because they require partially changes of the existing network infrastructure. In this article, we propose a simple mobility management protocol (SMMP) which can support global seamless handover between homogeneous or heterogeneous wireless networks. To do this, the SMMP employs separate location management function as DMMS to support global user and service mobility and the bidirectional tunnels are dynamically constructed to support seamless IP mobility by using the IEEE MIH extension server, which is extended the IEEE 802.21 MIH standards. The detailed architecture and functions of the SMMP have been designed. Finally, the mathematical analysis and the simulation have been done. The performance results show the proposed SMMP outperforms the existing MIPv6 and HMIPv6 in terms of handover latency, packet loss, pear signal noise ratio (PSNR).

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.1
• /
• pp.179-187
• /
• 2014

The underlay protocol is a cognitive radio method in which secondary or cognitive users use the same frequency without affecting the quality of service (QoS) for the primary users. In addition, because of the broadcast characteristics of the wireless environment, some nodes, which are called eavesdropper nodes, want to illegally receive information that is intended for other communication links. Hence, Physical Layer Security is applied considering the achievable secrecy rate (ASR) to prevent this from happening. In this paper, a performance analysis of the amplify-and-forward scheme under an interference constraint and Physical Layer Security is investigated in the cooperative communication mode. In this model, the relays use an amplify-and- forward method to help transmit signals from a source to a destination. The best relay is chosen using an opportunistic relay selection method, which is based on the end-to-end ASR. The system performance is evaluated in terms of the outage probability of the ASR. The lower and upper bounds of this probability, based on the global statistical channel state information (CSI), are derived in closed form. Our simulation results show that the system performance improves when the distances from the relays to the eavesdropper are larger than the distances from the relays to the destination, and the cognitive network is far enough from the primary user.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.5
• /
• pp.159-166
• /
• 2008

Recently, according to the rapid development of location positioning technology and wireless communications technology and increasement of usage of moving object data, many researches and developments on the real-time locating systems which provides real time service of moving object data stream are under proceeding. However, MO (Moving Object) DBMS used based system in the in these systems is the inefficient management of moving object data streams, and the existing DSMS (Data Stream Management System) has problems that spatio-temporal data are not handled efficiently. Therefore, in this thesis, we designed and implemented spatio-temporal DSMS for efficient real-time management of moving object data stream. This thesis implemented spatio-temporal DSMS based STREAM (STanford stREam dAta Manager) of Stanford University is supporting real-time management of moving object data stream and spatio-temproal query processing and filtering for reduce the input loading. Specifically, spatio-temporal operators of the spatio-temporal DSMS support standard interface of SQL form which extended "Simple Feature Specification for SQL" standard specifications presented by OGC for compatibility. Finally, implemented spatio-temporal DSMS in this thesis, proved the effectiveness of the system that as applied real-time monitoring areas that require real-time locating of object data stream DSMS.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.5
• /
• pp.85-90
• /
• 2017

Indoor location-based services have been developed based on the Internet of Things technologies which measure and analyze users who are moving in their daily lives. These various indoor positioning technologies require separate hardware and have several disadvantages, such as a communication protocol which becomes complicated. Based on the fact that a reduction in signal strength occurs according to the distance due to the physical characteristics of the transmitted signal, RSSI technology that uses the received signal strength of the wireless signal used in this paper measures the strength of the transmitted signal and the intensity of the attenuated received signal and then calculates the distance between a transmitter and a receiver, which requires no separate costs and makes to implement simple measurements. It was applied calculating the value for the average RSSI and the RSSI filtering feedback. Filtering is used to reduce the error of the RSSI values that are measured at long distance.It was confirmed that the RSSI values through the average filtering and the RSSI values measured by setting the coefficient value of the feedback filtering to 0.5 were ranged from -61 dBm to - 52.5 dBm, which shows irregular and high values decrease slightly as much as about -2 dBm to -6 dBm as compared to general measurements.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.1
• /
• pp.101-107
• /
• 2012

When wireless devises for MICS(Medical Implant Communication Service) or ISM(Industrial Scientific and Medical) bands are designed, it is necessary to verify the performance by using a human body flat phantom. However, most of studies on the phantom are limited to the biological effects of mobile-phone EMF. In this paper, semi-solid phantoms having the electric properties suggested by FCC at MICS and ISM bands are fabricated. The manufactured phantoms satisfy the electric properties($\varepsilon_r=56.7$ and $\sigma=0.94$ at MICS band, $\varepsilon_r=52.7$ and $\sigma=1.95$ at ISM band) at each band. All the composing materials for phantoms are commercially available in domestic market. Two methods using both polyethylene powder and TX-151 and glycerin at each band are proposed for diverse purpose. The electrical properties of the fabricated phantoms are measured by a dielectric probe kit and network analyzer after the lapse of one day (24 hours).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.5
• /
• pp.908-915
• /
• 2001

In this paper, it is analyzed theoretically that the performance degradation, caused by carrier frequency offset, in an OFDM/M-ary PSK system. Then, when Turbo coding is adopted to an OFDM/M-ary PSK system, the degree of performance enhancement is evaluated. Finally, the maximum frequency offset is calculated to satisfy the BER performance required in a Turbo coded OFDM/M-ary PSK system. As results of analysis, it is shown that the more the number of M-ary is, the worse the BER performance is. Moreover, 7dB, 9dB, and 17dB of $E_b/N_o$ are required in QPSK, 8PSK and 16PSK systems, respectively in order to satisfy the error performance, $BER=10^{-3}$ for voice communication. If $E_b/N_o$ are 10㏈ and 15㏈, the frequency offset should be below 0.05 and 0.075, respectively, for voice communication. When Turbo coding is adopted to an OFDM/M-ary PSK system, the less the number of M-ary is, the greater the performance enhancement of Turbo coding is. If the number of a M-ary system of the system is below 16, it is found that required $E_b/N_o$ is about 8dB to satisfy $BER=10^{-5}$ Moreover, in the system the Turbo coding scheme, voice communication is available with greatly low$E_b/N_o$, and 8dB of $E_b/N_o$ is enough for data communication regardless of the permission range of frequency offset.

• Journal of Broadcast Engineering
• /
• v.18 no.2
• /
• pp.215-224
• /
• 2013

With the rising popularity of smart-phones, the supply of Internet protocol television is largely increased and it causes the wireless communication network load to be increased. To overcome such an overloading problem, 3GPP is now working on the standardization of MBMS since LTE Release 6 specification. MBMS has good performance in bandwidth efficiency by sharing the same bandwidth with the mulitple MBMS users having the same content. According to the proposed algorithm, in heterogeneous networks having a dispersed Single-cell MBMS where 3GPP network and Wi-Fi network are mixed, if the number of MBMS users, who are belonging to cells supporting a dispersed Single-cell MBMS, is more than a specified threshold, the MBMS priority policy is operated. Otherwise, the Wi-Fi priority policy is executed. As the simulation results show both the increase of total available bandwidth ratio and the decrease of network usage cost, it is confirmed that the proposed scheme allows the network efficiency to be maximized.

• Journal of KIISE:Databases
• /
• v.27 no.1
• /
• pp.53-63
• /
• 2000

The mobile computing service market is increasing rapidly due to the development of low-cost wireless network technology and the high-performance mobile computing devices. In recent years, several methods have been proposed to effectively deal with restrictions of the mobile computing environment such as limited bandwidth, frequent disconnection and short-lived batteries. Amongst those methods, much study is being done on the caching method - among the data transmitted from a mobile support station, it selects those that are likely to be accessed in the near future and stores them in the local cache of a mobile host. Existing cache replacement methods have some limitations in efficiency because they do not take into consideration the characteristics of user mobility and spatial attributes of geographical data. In this paper, we show that the value and the semantic of the data, which are stored in the cache of a mobile host, changes according to the movement of the mobile host. We argue it is because data that are geographically near are better suited to provide an answer to a users query in the mobile environment. Also, we define spatial location of geographical data has effect on, using the spatial attributes of data. Finally, we propose two new cache replacement methods that efficiently support user mobility and spatial attributes of data. One is based on the location of data and the other on the meaningful region of data. From the comparative analysis of the previous methods and that they improve the cache hit ratio. Also we show that performance varies according to data density using this, we argue different cache replacement methods are required for regions with varying density of data.

• The KIPS Transactions:PartD
• /
• v.18D no.6
• /
• pp.481-492
• /
• 2011

Recently, various mobile services are provided by the spread of wireless network infrastructures and smart devices. The improvement of cloud computing technologies increases the interests for enterprise mobile cloud services in various IT companies as well. By increasing the interests for enterprise mobile cloud services, it is necessary to evaluate the use of enterprise mobile cloud services. Therefore, the factors which affect the user acceptance of enterprise mobile cloud services are analyzed on the basis of Davis' technology acceptance model in this research. As analysis results, four external variables have significant effects on perceived ease of use of mobile cloud services. Also, these variables indirectly affect attitude toward using cloud services. The results show that the security is the most important factor for attitude toward using enterprise mobile cloud services. The service users also consider the interoperability as an important factor for the user acceptance of cloud services. The perceived ease of use has more contribution than the perceive usefulness on attitude toward using enterprise mobile cloud services. This research has both industrial and academic contributions because it provides the guideline to companies for introducing the enterprise mobile cloud services and apply the technology acceptance model on new IT services.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.36 no.10
• /
• pp.1189-1193
• /
• 2012

The Miniaturized Fingerprint Imager (MFI) is a slim optical mouse that can be used as an input device for application to wireless portable personnel communication devices such as smartphones. In this study, we have fabricated key optical components of an MFI, including the illumination optical components and imaging lens. An LED beam-shaping lens consisting of an aspheric lens and a Fresnel facet was successfully machined using a diamond turning machine (DTM). A customized V-shaped groove for beam path banding was fabricated by the bulk micromachining of silicon that was coated with aluminum using the shadow effect in thermal evaporation. The imaging lens and arrayed multilevel Fresnel lenses were fabricated by electron beam lithography and FAB etching, respectively. The proposed optical components are extremely compact and have high optical efficiency; therefore, they are applicable to ultraslim optical systems.