• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.2A
• /
• pp.51-60
• /
• 2005

In this paper, we propose an enhanced SIR measurement algorithm for WCDMA mobile station modem. The proposed algorithm minimizes processing delay by applying velocity estimation-based channel estimator with IIR filter and reduces measured SIR offset by compensating attenuated signal power by using pilot channel(CPICH) in fading channel environment. To improve stability of SIR measurement, we also adopt an IIR filter which can properly reflect variation of fading channel in signal and interference power measurement. We prove that the proposed algorithm outperforms conventional SIR measurement algorithm in mean and jitter of measured SIR. Computer simulation shows that performance results using the proposed algorithm have improvement of approximately 8dB for measured mean and 2dB for measured jitter in the wireless mobile channel, especially in fast mobile speed environment.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.10A
• /
• pp.1473-1479
• /
• 2000

This paper presents the performance evaluation of an adaptive QAM scheme under flat and frequency selective fading channels for indoor wireless communication systems. The QAM modulation is combined with differential encoding and the demodulation process is carried out noncoherently. The adaptation is performed by varying the modulation level of QAM, depending upon received signal strength. The adaptation mechanism allows a 2- or 3-bit increase or decrease at a time, if the channel condition is considered to be significantly good or bad. Simulation results show that the average number of bits per symbol (ABPS) for each symbol block transmitted over a flat fading channel is higher than 5.0 and the BER performance is better than 10^-4 for a SNR value higher than 30 dB. For frequency selective fading channels, an oversampling technique in the receiver was employed. The BER performance obtained for frequency selective fading channels is better than 10^-4 with a SNR value of 40 dB and ABPS is found to be approximately 5.5. Therefore, this scheme is very useful in that it provides both very high bandwidth efficiency and acceptable performance with moderate SNR values over flat and frequency selective fading channels. In addition, this scheme provides reduced receiver complexity by way of noncoherent detection.

• Journal of electromagnetic engineering and science
• /
• v.7 no.1
• /
• pp.35-41
• /
• 2007

An alternative solution to the problem of obtaining acceptable performances on a fading channel is the diversity technique, which is widely used to combat the fading effects of time-variant channels. The symbol error probability of M-ary DPSK (MDPSK), PSK (MPSK) and QAM (MQAM) systems using 2 branches from the branch with the largest signal-to-noise ratio(SNR) at the output of L-branch selection combining(SC), i.e., SC2 in frequency-nonselective slow Nakagami fading channels with an additive white Gaussian noise(AWGN) is derived theoretically. These performance evaluations allow designers to determine M-ary modulation methods against Nakagami fading channels.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.4A
• /
• pp.370-377
• /
• 2004

In this paper, we present an adaptive modulation technique for orthogonal frequency division multiplexing (OFDM) for broadband wireless communications. Also, using improved channel prediction, we enhance the performance of adaptive OFDM in high mobility environments. Adaptive modulation technique has been shown to achieve reliable high-rate data transmission over frequency-selective fading channel when OFDM is employed. This scheme requires the accurate channel information between two stations for a better performance. In an outdoor high mobility environment, most of adaptive OFDM systems have to be given the channel information transmitted from the receiver. Even if it is possible, there is some delay. Moreover, the channel impulse response between two stations is very rapidly varied. If the channel information is obsolete at the time of transmission, then poor system performance will result. In order to solve this problem, we propose adaptive OFDM with improved channel predictor. The proposed bit allocation algorithm has a lower complexity and the proposed scheme mitigates the effect of channel delay. Robust approach is less sensitive to outdated channel information. Performance results show that the proposed scheme can achieve considerable performance enhancement.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.5A
• /
• pp.355-362
• /
• 2009

In real-time communication services, delay constraints are among the most important QoS (Quality of Service) factors. In particular, it is difficult to guarantee the delay requirement over wireless channels, since they exhibit dynamic time-varying behavior and even severe burst-errors during periods of deep fading. Channel throughput may be increased, but at the cost of the additional delays when ARQ (Automatic Repeat Request) schemes are used. For real-time communication services, it is very essential to predict data deliverability. This paper derives the delay distribution and the successful delivery probability within a given delay budget using a priori channel model and a posteriori information from the perspective of queueing theory. The Gilbert-Elliot burst-noise channel is employed as an a Priori channel model, where a two-state Markov-modulated Bernoulli process $(MMBP_2)$ is used. for a posteriori information, the channel parameters, the queue-length and the initial channel state are assumed to be given. The numerical derivation is verified and analyzed via Monte Carlo simulations. This numerical derivation is then applied to a rate control scheme for real-time video transmission, where an optimal encoding rate is determined based on the future channel capacity and the distortion of the reconstructed pictures.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.6
• /
• pp.1050-1055
• /
• 2001

In this paper we analyze the performance of 2-D PSAM for wireless OFDM systems. We apply the analysis of single-carrier PSAM to the 2-D time-frequency lattice of OFDM. To estimate channel fading, we use interpolation filter which minimizes the average power of error as compensation method and analyze the affects on the system performance of the pilot symbol pattern on the 2-D time-frequency lattice. Finally according to the CP and the Doppler frequency, we analyze the performance of 2-D PSA-16QAM for OFDM systems over frequency selective Rayleigh fading channel model.

• Journal of Advanced Navigation Technology
• /
• v.12 no.1
• /
• pp.54-60
• /
• 2008

The reliability of conventional wireless communication systems are diminished by multi-path fading, shadowing, propagation delay, pathloss, AWGN and an interference of the symbols. Therefore, we need more reliable system which can stably transmit multimedia datas over the poor communication environments, so, in this paper, we used STBC system based on STTC that allows a maximum space diversity gain of STBC scheme and channel efficiency, coding gain and diversity gain of STTC scheme at the same time. We did then analyzed the performance over the correlated slow fading channel between transmitter and receiver channels.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.10a
• /
• pp.336-340
• /
• 2001

In this paper we analyze the performance of 2-D PSAM for wireless OFDM systems. We apply the analysis of single-carrier PSAM to the 2-D time-frequency lattice of OFDM. To estimate channel fading, we use interpolation filter which minimizes the average power of error as compensation method and analyze the affects on the system performance of the pilot symbol pattern on the 2-D tine-frequency lattice. Finally according to the CP and the Doppler frequency, we analyze the performance of 2-D PSA-16QAM for OFDM systems over frequency selective Rayleigh fading channel model.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.10a
• /
• pp.154-158
• /
• 2003

In this paper, Error rate performance of BCH coded DS-CDMA 16 QAM signal is analyzed using selective combining Diversity reception techniques in the environments of Rician fading. First in the performance of DS-CDMA 16 QAM signal in Rician fading channel, Second using SC diversity recepting techniques, and third using both diversity and BCH coding error rate performance is evaluated. from the results of Numerical analyzed it is found that a synergistic performance improvement is shown due to both diversity reception and coding techniques overcoming mobile wireless data communication channel environments.

• Journal of Information Processing Systems
• /
• v.11 no.1
• /
• pp.57-75
• /
• 2015

In evaluating the performance of a dual-hop wireless link, the effects of large and small scale fading has to be considered. To overcome this fading effect, several schemes, such as multiple-input multiple-output (MIMO) with orthogonal space time block codes (OSTBC), different combining schemes at the relay and receiving end, and orthogonal frequency division multiplexing (OFDM) are used in both the transmitting and the relay links. In this paper, we first make compare the performance of a two-hop wireless link under a different combination of space diversity in the first and second hop of the amplify-and-forward (AF) case. Our second task in this paper is to incorporate the weak signal of a direct link and then by applying the channel model of two random variables (one for a direct link and another for a relayed link) we get very impressive result at a low signal-to-noise ratio (SNR) that is comparable with other models at a higher SNR. Our third task is to bring other three schemes under a two-hop wireless link: use of transmit antenna selection (TAS) on both link with weak direct link, distributed Alamouti scheme in two-hop link and single relay antenna with OFDM subcarrier. Finally, all of the schemes mentioned above are compared to select the best possible model. The main finding of the paper is as follows: the use of MIMO on both hops but application TAS on both links with weak direct link and the full rate OFDM with the sub-carrier for an individual link provide a better result as compared to other models.