• Journal of Communications and Networks
• /
• v.11 no.1
• /
• pp.26-35
• /
• 2009

In this paper, we investigate how to do resource allocation to guarantee a minimum user data rate at low signaling overhead in multi-cell orthogonal frequency division multiple access (OFDMA) wireless systems. We devise dynamic resource allocation (DRA) algorithms that can minimize the QoS violation ratio (i.e., the ratio of the number of users who fail to get the requested data rate to the total number of users in the overall network). We assume an OFDMA system that allows dynamic control of frequency reuse factor (FRF) of each sub-carrier. The proposed DRA algorithms determine the FRFs of the sub-carriers and allocate them to the users adaptively based on inter-cell interference and load distribution. In order to reduce the signaling overhead, we adopt a hierarchical resource allocation architecture which divides the resource allocation decision into the inter-cell coordinator (ICC) and the base station (BS) levels. We limit the information available at the ICC only to the load of each cell, that is, the total number of sub-carriers required for supporting the data rate requirement of all the users. We then present the DRA with limited coordination (DRA-LC) algorithm where the ICC performs load-adaptive inter-cell resource allocation with the limited information while the BS performs intra-cell resource allocation with full information about its own cell. For performance comparison, we design a centralized algorithm called DRA with full coordination (DRA-FC). Simulation results reveal that the DRA-LC algorithm can perform close to the DRA-FC algorithm at very low signaling overhead. In addition, it turns out to improve the QoS performance of the cell-boundary users, and achieve a better fairness among neighboring cells under non-uniform load distribution.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.4
• /
• pp.285-296
• /
• 2005

Reduced pressure chemical vapor deposition technology has been used to study SiGe heterostructure epitaxy and device issues, including SiGe relaxed buffers, proper control of Ge component and crystalline defects, two dimensional delta doping, and their influence on electrical properties of devices. From experiments, 2D profiles of B and P presented FWHM of 5 nm and 20 nm, respectively, and doses in 5×10/sup 11/ ∼ 3×10/sup 14/ ㎝/sup -2/ range. The results could be employed to fabricate SiGe/Si heterostructure field effect transistors with both Schottky contact and MOS structure for gate electrodes. I-V characteristics of 2D P-doped HFETs revealed normal behavior except the detrimental effect of crystalline defects created at SiGe/Si interfaces due to stress relaxation. On the contrary, sharp B-doping technology resulted in significant improvement in DC performance by 20-30 ％ in transconductance and short channel effect of SiGe HMOS. High peak concentration and mobility in 2D-doped SiGe heterostructures accompanied by remarkable improvements of electrical property illustrate feasible use for nano-sale FETs and integrated circuits for radio frequency wireless communication in particular.

• Smart Structures and Systems
• /
• v.13 no.6
• /
• pp.993-1014
• /
• 2014

In civil engineering, revolving structures (RS) are a unique structural form applied in innovative architecture design. Such structures are able to revolve around themselves or along a certain track. However, few studies are dedicated to safety design or health monitoring of RS. In this paper, a wireless dynamic sensing system is developed for RS, and field tests toward a large revolving auditorium are conducted accordingly. At first, a wheel-rail problem is proposed: The internal force redistributes in RS, which is due to wheel-rail irregularity. Then the development of the sensing system for RS is presented. It includes system architecture, network organization, vibrating wire sensor (VWS) nodes and online remote control. To keep the sensor network identifiable during revolving, the addresses of sensor nodes are reassigned dynamically when RS position changes. At last, the system is mounted on a huge outdoor revolving auditorium. Considering the influence of the proposed problem, the RS of the auditorium has been designed conservatively. Two field tests are conducted via the sensing system. In the first test, 2000 people are invited to act as the live load. During the revolving process, data is collected from RS in three different load cases. The other test is the online monitoring for the auditorium during the official performances. In the end, the field-testing result verifies the existence of the wheel-rail problem. The result also indicates the dynamic sensing system is applicable and durable even while RS is rotating.

• Journal of Korea Port Economic Association
• /
• v.29 no.2
• /
• pp.211-238
• /
• 2013

The Port Logistics Information System (Port-MIS) is the system that processes all of port management such as entry and departure of ships, using facilities within ports, port traffic control, cargo entering and carrying and tax collection in 31 trade ports over the whole country. Lately, The Port Logistics Information System (Port-MIS) has been reformed as a WEB-based system and established basis to provide real time information support structure, diversification of civil complaint system, and optimized civil complaint service by using wire and wireless internet. The typical study on the Port Logistics Information System was C/S program and EDI-centered. But it has significance to study on service quality measurement of WEB Port-MIS that has been served as a new web-based platform since April 2010, for there was no such a study until now.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.2
• /
• pp.40-49
• /
• 2015

PicoCast is a recently proposed short-range wireless communications technology that supports both low rate sensor/control data and high speed data such as voice and video traffic in the personal space, defined by the user-centric space of radius tens of meters, with one unified protocol. When the users are in the same area, personal spaces defined by each user may overlap. Since these PicoCast piconets may simultaneously operate, mutual interference is unavoidable. It is necessary to investigate the effect of mutual interference on data transmission and to conduct research on minimizing the interference among PicoCast devices. In this paper we analyze the effect of mutual interference between PicoCast piconets based on data throughput using OPNET network simulator. We have implemented the PicoCast protocol and measured the average throughput and packet loss rate.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.5
• /
• pp.542-549
• /
• 2016

This paper presents a SoC (System-on-a-Chip) dedicated for a single-chip smart capsule which can be used to continuously monitor human alimentary canal pH and temperature values. The SoC is composed of the pH and temperature sensor interface circuit, a wireless transceiver, the power management circuit and the flow control logic. Fabricated in $0.18{\mu}m$ standard CMOS technology, the SoC occupies a die area of ${\sim}9 mm^2$. The SoC consumes 6.15 mW from a 3 V power supply, guaranteeing the smart capsule battery life is no less than 24 hours when using 50 mAh coin batteries. The experimental results show that measurement accuracy of the smart capsule is ${\pm}0.1$ pH and ${\pm}0.2^{\circ}C$ for pH and temperature sensing, respectively, which meets the requirement of in-body pH and temperature monitoring in clinical practice.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.2
• /
• pp.161-170
• /
• 2017

The balise is a device for the railroad signal control systems, which is installed between both rail. The balise sends fixed or variable data, named telegram, to the train with wireless method. The telegram includes the position information, the movable distance under the signal status, the gradient, the speed, the temporary speed limit, etc. This research is on a design of the DBPL encoder for the balise. Normally the DBPL encoder for the balise is with the ASIC or FPGA technology. In this research, the DBPL encoder is designed with commercial low power operable micro-controller. The firmware(logic level encode) and the SPI Bus function block(physical level output) of the micro-controller are used for the DBPL encode. Under the european standard, the required working speed of the DBPL encoder is 564.48Kbps. The DBPL encoder of this research is tested under the speed of 564.48Kbps, and it worked properly.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.4
• /
• pp.2058-2074
• /
• 2017

Dense Heterogeneous Cellular Networks(HCNs) offer a promising approach to meet the target of 1000x increase in aggregate data rates in 5G wireless communication systems. However how to best utilize the available radio resources at densely deployed small cells remains an open problem as those small cells are typically unplanned. In this paper we focus on balancing loads across macro cells and small cells by offloading users to small cells, as well as dynamically switching off underutilized small cells. We propose a joint user association and base station(BS) sleep mangement(UA-BSM) scheme that proactively offloads users to a fraction of the densely deployed small cells. We propose a heuristic algorithm that iteratively solves the user association problem and puts BSs with low loads into sleep. An interference relation matrix(IRM) is constructed to help us identify the candidate BSs that can be put into sleep. User associations are then aggregated to selected small cells that remain active. Simulation results show that our proposed approach achieves load balancing across macro and small cells and reduces the number of active BSs. Numerical results show user signal to interference ratio(SINR) can be improved by small cell sleep control.

• Aerospace Engineering and Technology
• /
• v.11 no.2
• /
• pp.49-56
• /
• 2012

LEO Satellite performs the operations and missions by FSW(Flight Software) after separation from a launch vehicle. Many of the operations by FSW are automatically conducted by the algorithms of FSW. In the case of the IAC(Initial Activation and Checkout) operations, a mission scheduling, an orbit transition, etc, however, a decision and a control of the satellite operators or manufacturers are required in order to operate the satellite safely. For this, the wireless communication channel between a satellite and a ground station should be prepared to receive telemetries and to transmit tele-commands for controlling FSW properly. Therefore, the verification of the interface between KOMPSAT-3 and a ground station is essential. This verification test is named the satellite end-to-end test. In this paper, we show the design process of the satellite end-to-end test and test results.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.3
• /
• pp.179-186
• /
• 2012

Nowadays, the multihomed host equipped with multiple network interfaces has been interested research in next generation wireless network, because the mobile users expect that they can be able to access services not only anywhere, at any time and from any network but also simultaneously. This paper addresses the mobility simulation model of the multihomed node for supporting MIPv4 and MIPv6 function in an interworking of Worldwide Interoperability for Microwave Access (WiMAX) and IEEE 802.11 WLAN. The multihomed node with two air interfaces has been developed based on WiMAX and WLAN workstation node model in simulation software. The main point of the developed model is to support both MIPv4 and MIPv6 function, and provide network selection policy for the multihomed node between WiMAX and WLAN network. Based on the received Router Advertisement along with the interface number, we can manage the access interfaces in ordered list to make handover decision while the multihomed node is moving. In the end of this paper, the simulation scenarios and results are shown for testing MIPv4 and MIPv6 function.