• Journal of information and communication convergence engineering
• /
• 제8권1호
• /
• pp.29-34
• /
• 2010

Wind speed and wind direction are usually taken using two parameters: wind speed and wind direction. This paper studies the average wind speed and direction calculation methods. The paper first introduces to basic wind's knowledge, and then presents several methods in calculating average wind speed and direction. Lastly some graphs are plotted base on these computational methods and the implementation of these methods in an actual buoy system.

• 한국환경과학회지
• /
• 제10권2호
• /
• pp.135-142
• /
• 2001

In order to investigate horizontal wind field in the boundary layer around Pusan area, wind speed and wind direction measured at 14 AWS(Automatic Weather Station), 1997, was used. The wind direction at PRM(Pusan Regional Meterological Office) was showed that southwest and northeast wind dominated for spring and summer, northeast wind for fall and northwest for winter. Anticline flow was showed at \`Gaekumm\` which is located between Mt. Backyang(641m) and Mt. Yumkwang(503m) and affected on wind field at \`Pusanjin\`. The low wind speed and various wind direction was represented at the basin topography, \`Buckgu\`, \`Jeasong\`, \`Ilkwang\` and \`Kijang\`. The annual mean wind speed at 14 sites, 2.5ms(sup)-1, was lower than that measured at PRMO, 3.9ms(sup)-1. The wind direction analysis showed that the case of same direction in compare with that measured at PRMO is about 54% and case of opposite direction is about 12%. Annual and seasonal mean windrose showed wind direction is affected by not only synoptic weather state but also topography.

• 생물환경조절학회지
• /
• 제1권2호
• /
• pp.142-147
• /
• 1992

The wind pressure distributions were analyzed to provide fundamental criteria for the structural design on the two-span arched house according to the wind directions through the wind tunnel experiment. In order to investigate the wind force distributions, the variation of the wind force coefficients, the mean wind force coefficients, the drag force coefficients and the lift force coefficients were estimated using the experimental data. The results obtained are as follows : 1. The variation of the wind force with wind directions on the side walls was the greatest at the upwind edge of the walls. 2. The maximum negative wind force along the length of the roof appeared at the upwind edge at the wind direction of 60$^{\circ}$. 3. The maximum negative wind force along the width of the roof appeared at the width ratio and wind direction of 0$^{\circ}$ and 0.4 in the first house and 0.6 and 30$^{\circ}$ in the second house, respectively. 4. The mean negative wind force on the side walls of the first house at the wind direction of 0$^{\circ}$ was far greater than that of the second house, and the maximum negative wind force on the roof occurred at the wind direction of 30$^{\circ}$. 5. The maximum lift force appeared on the second house at the wind direction of 30$^{\circ}$, but the lift force on the first house was far greater than that on the second house at the wind direction of 0$^{\circ}$. 6. The parts to be considered for the local wind forces were the edges of the walls, and the edges of the x-direction and the width ratio, 0.4 of the y-direction in the roofs.

• 한국환경과학회지
• /
• 제16권4호
• /
• pp.467-477
• /
• 2007

A numerical study with Envi-met model is experimented to investigate the characteristics of wind pattern in apartment complex. In all case, most conditions such as wind speed, temperature, and surface features are considered as the same, but wind direction is the only different factor. The wind directions considered in this study have a meaning of prevailing wind direction. When the prevailing wind with the direction of $170^{\circ}$ blows into the complex, the ventilation passage toward the outside of complex is formed and the stagnation of air is not expressed. In case of having the direction of $300^{\circ}$, most evident ventilation passages are composed. When the inflow wind direction is the northeast, $30^{\circ}$, there is some possibility of stagnation phenomenon. This is because the arrangement of buildings makes a right angle with the inflow wind direction.

• 한국항공운항학회지
• /
• 제17권1호
• /
• pp.39-45
• /
• 2009

An Analysis of wind is essential for planning runway direction. As a general rule, the principal traffic runway at an airport should be oriented as closely as practicable in the direction of the prevailing wind. Aircraft are able to maneuver on a runway as long as the wind component at right angles to the direction of landing and taking-off, the cross wind component, is not excessive. ICAO recommends that runway be oriented so that aircraft may be landed at least 95% of the time with allowable cross wind components not exceeding specified limits based upon the airport reference field length. Based on the recommendation, the direction of the runway or runways at an airport can be determined through graphical vector analysis on wind rose. This study is to develop the wind-rose software for planning the optimum runway direction at an airport with the raw wind data based on reliable wind distribution statistics that extend over as long as a period as possible, preferably of not less than 5 years.

• 한국공간구조학회논문집
• /
• 제21권1호
• /
• pp.51-59
• /
• 2021

In this paper, the effect of the turbulence intensity in across-wind direction on the wind load in CFD(Computational fluid dynamics) simulation was analyzed. 'Ansys fluent' software was used for CFD simulation. And the fluctuating wind speed applied to the simulation was generated according to Korean Design Standard and Von Karman wind turbulence model. The turbulence intensity in across-wind direction for simulation was applied from 0 to 100% of the turbulence intensity in along-wind direction. The analysis results showed that the turbulence intensity in across-wind direction had a particularly great effect on the wind load in across-wind direction.

• Wind and Structures
• /
• 제30권3호
• /
• pp.275-288
• /
• 2020

High-rise buildings are very slender and flexible. Their low stiffness values make them vulnerable to horizontal loads, such as those associated with wind or earthquakes. For high-rise buildings, the threat to serviceability caused by wind-induced vibration is an important problem. To estimate the serviceability under wind action, the response acceleration of a building at the roof height is used. The response acceleration is estimated by the same wind speed at all wind directions. In general, the effect of wind direction is not considered. Therefore, the response accelerations obtained are conservative. If buildings have typical plans and strong winds blow from relatively constant wind directions, it is necessary to account for the wind direction to estimate the response accelerations. This paper presents three methods of evaluating the response accelerations while considering the effects of wind direction. These three serviceability evaluation methods were estimated by combining the wind directional frequency data obtained from a weather station with the results of a response analysis using wind tunnel tests. Finally, the decrease in the efficiencies of the response acceleration for each serviceability evaluation method was investigated by comparing the response acceleration for the three methods accounting for wind direction with the response acceleration in which wind direction was not considered.

• Smart Structures and Systems
• /
• 제21권5호
• /
• pp.591-600
• /
• 2018

The probabilistic characterization of wind field characteristics is a significant task for fatigue reliability assessment of long-span railway bridges in wind-prone regions. In consideration of the effect of wind direction, the stochastic properties of wind field should be represented by a bivariate statistical model of wind speed and direction. This paper presents the construction of the bivariate model of wind speed and direction at the site of a railway arch bridge by use of the long-term structural health monitoring (SHM) data. The wind characteristics are derived by analyzing the real-time wind monitoring data, such as the mean wind speed and direction, turbulence intensity, turbulence integral scale, and power spectral density. A sequential quadratic programming (SQP) algorithm-based finite mixture modeling method is proposed to formulate the joint distribution model of wind speed and direction. For the probability density function (PDF) of wind speed, a double-parameter Weibull distribution function is utilized, and a von Mises distribution function is applied to represent the PDF of wind direction. The SQP algorithm with multi-start points is used to estimate the parameters in the bivariate model, namely Weibull-von Mises mixture model. One-year wind monitoring data are selected to validate the effectiveness of the proposed modeling method. The optimal model is jointly evaluated by the Bayesian information criterion (BIC) and coefficient of determination, $R^2$. The obtained results indicate that the proposed SQP algorithm-based finite mixture modeling method can effectively establish the bivariate model of wind speed and direction. The established bivariate model of wind speed and direction will facilitate the wind-induced fatigue reliability assessment of long-span bridges.

• 환경영향평가
• /
• 제20권2호
• /
• pp.133-140
• /
• 2011

A numerical study with Envi-met model is experimented to investigate the characteristics of wind pattern in Gangwon innovation city. In all case, most conditions such as wind speed, temperature, and surface are considered as the same, but wind direction is the only different factor. The wind directions considered in this study have a meaning of prevailing wind direction. When the prevailing wind with the direction of $247^{\circ}$ blows into the city, the ventilation passage toward the outside of city is formed and the stagnation of air is not expressed. In case of having the direction of $270^{\circ}$, most evident ventilation passages are composed. When the inflow wind direction is the north, $0^{\circ}$, there is some possibility of stagnation phenomenon. The case where the representative wind direction of three kind will flow with development, in compliance with the building is caused by with screening effect of some and shows a true stagnation phenomenon, wishes in the park and flowing water and the greens area to be for a long time formed and the wind direction is maintained.

• 방사선산업학회지
• /
• 제17권3호
• /
• pp.299-307
• /
• 2023

Given that toxic substances are diffused by the various movements of the atmosphere, it is very important to evaluate the risks associated with this phenomenon. When analyzing the behavioral characteristics of these atmospheric diffusion models, the main input data are the wind speed and wind direction among the meteorological data. In particular, it is known that a certain wind direction occurs in summer and winter in Korea under the influence of westerlies and monsoons. In this study, synoptic meteorological observation data provided by the Korea Meteorological Administration were analyzed from January 1, 2012 to the end of August of 2022 to understand the regional wind characteristics of nuclear power plants and surrounding areas. The selected target areas consisted of 16 weather stations around the Hanbit, Kori, Wolsong, Hanul, and Saeul nuclear power plants that are currently in operation. The analysis was based on the temperature, wind direction, and wind speed data at those locations. Average, maximum, minimum, median, and mode values were analyzed using long-term annual temperature, wind speed, and wind direction data. Correlation coefficient values were also analyzed to determine the linear relationships among the temperature, wind direction, and wind speed. Among the 16 districts, Uljin had the highest wind speed. The median wind speed values for each region were lower than the average wind speed values. For regions where the average wind speed exceeds the median wind speed, Yeongju, Gochang, Gyeongju, Yeonggwang, and Gimhae were calculated as 0.69 m s^-1, 0.54m s^-1, 0.45m s^-1, 0.4m s^-1, and 0.36m s^-1, respectively. The average temperature in the 16 regions was 13.52 degrees Celsius; the median temperature was 14.31 degrees and the mode temperature was 20.69 degrees. The average regional temperature standard deviation was calculated and found to be 9.83 degrees. The maximum summer temperatures were 39.7, 39.5, and 39.3 in Yeongdeok, Pohang, and Yeongcheon, respectively. The wind directions and speeds in the 16 regions were plotted as a wind rose graph, and the characteristics of the wind direction and speed of each region were investigated. It was found that there is a dominant wind direction correlated with the topographical characteristics in each region. However, the linear relationship between the wind speed and direction by region varied from 0.53 to 0.07. Through this study, by evaluating meteorological observation data on a long-term synoptic scale of ten years, regional characteristics were found.