• Textile Coloration and Finishing
• /
• v.14 no.2
• /
• pp.33-39
• /
• 2002

A study has been made of the dry-jet-wet spinning of PAN copolymer fibers using 60% aqueous zinc chloride solution as solvent and 25∼40% aqueous zinc chloride solution as non-solvent. The technological characteristics of this method were that small streams of dope were extruded from the die and allowed to pass through a short distance of air gap(about 10mm) before entering the spinning bath for full coagulation. This work showed the importances which coagulation condition, stretch ratio and fiber tenacity up to 10.5 g/d could be obtained with elongation of 11∼16%. Individual fibers were evaluated on the basis of density and mechanical properties such as tenacity and elongation etc.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.45 no.2
• /
• pp.70-77
• /
• 2022

Wet-spun regenerated silk fibroin (RSF) fibers have been extensively studied owing to their 1) useful properties as biomaterials, including good blood compatibility and cyto-compatibility; 2) the various methods available to control the structural characteristics and morphology of the fiber, and 3) the possibility of fabricating blended fibers and new material-embedded fibers. In this study, silk nanofibrils prepared using a new method were embedded in RSF to fabricate wet-spun silk nanofibril/RSF composite fibers. Up to 2% addition of silk nanofibril, the silk nanofibril/RSF dope solution showed slight shear thinning, and the G' and G" of the dope solution were similar. However, above 3% silk nanofibril content, the viscosity of the dope solution significantly increased. In addition, shear thinning was remarkably evident, and the G' of the dope solution was much higher than the G", indicating a very elastic state. As the silk nanofibril content was increased, the wet-spun silk nanofibril/RSF composite fiber became uneven, with a rough surface, and more beaded fibers were produced. Scanning electron microscopy observations revealed that the beaded fibers were attributed to the inhomogeneous dispersion and presence of agglomerates of the silk nanofibrils. As the silk nanofibril content and RSF concentration increased, the maximum draw ratio decreased, indicating the deterioration of the wet spinnability and post-drawing performance of silk nanofibril/RSF.

• Proceedings of the Korean Fiber Society Conference
• /
• 1999.10a
• /
• pp.447-450
• /
• 1999

• Proceedings of the Korean Fiber Society Conference
• /
• 1994.10a
• /
• pp.95-95
• /
• 1994

• Proceedings of the Korean Fiber Society Conference
• /
• 1994.10a
• /
• pp.96-96
• /
• 1994

• Proceedings of the Korean Fiber Society Conference
• /
• 1994.04a
• /
• pp.77-77
• /
• 1994

• Fibers and Polymers
• /
• v.1 no.2
• /
• pp.92-96
• /
• 2000

A high molecular weight polyhydroxyamide (PHA) solution in N, N-dimethyl acetamide (DMAc) was prepared from 3, 3'-dihydroxybenzidine and isophthalic chloride (IPC), which was used for spinning PHA fiber. Before spinning, the diffusion property of DMAc into various coagulants was examined. The fiber was well formed in coagulants such as water/ethanol with a composition of 5/5, ethanol, and ethanol/isopropanol with a composition of 7/3 and 5/5. However, the PHA fiber spun in the water/ethanol mixture contained voids. After the fiber spun in ethanol was annealed at over $350^{\circ}C$, the ultimate stress and initial modulus of the fiber increased from 75.5 MPa and 3.22 GPa to 369 MPa and 29.5 GPa, respectively. These properties of the PHA fiber spun by the dry spinning method were also enhanced, attaining 154 MPa and 5.56 Gpa, respectivel.

• Proceedings of the Korean Fiber Society Conference
• /
• 2000.04a
• /
• pp.125-128
• /
• 2000

Chemical cellulose from an ascidian tunic is isolated by extraction, digestion and bleaching steps. The content of $\alpha$-cellulose was above 98 wt%, and it's DPw was about 918. A new regenerated cellulose fiber from the chemical cellulose obtained in this study was made using NMMO/water(87/13 wt%) as a solvent by dry jet-wet spinning. The effects of spinning speed and cellulose content of spinning dope on the properties were investigated.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.11a
• /
• pp.471-473
• /
• 2006

An object of the present study is to provide a hollow fiber membrane humidifier capable of improving the humidification efficiency while lowering the pressure loss, and is suitably usable for PEMFC(Polymer Electrolyte Membrane Fuel Cell). The performance of PEMFC is decisively dependent on the humidity of the electrolyte membrane(fluorinated membrane) and a humidifier plays an important role in moisturizing electrolyte membrane. Especially this humidifier is adaptable for lower price to promote the commercialization of fuel cell vehicles and is passive type to be power free and to be volumetrically optimized. In this research, we propose the substitutes for the expensive fluorinated materials and the optimum dry-jet wet spinning conditions of hollow fiber membrane to get the fuel cell humidifier. In addition to that we established the standard method of evaluating the moisturizing performance of the humidifier of various materials.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.11a
• /
• pp.177-179
• /
• 2007

An object of the present study is to provide a hollow fiber membrane humidifier capable of improving the humidification efficiency while lowering the pressure loss, and is suitably usable for PEMFC(Polymer Electrolyte Membrane Fuel Cell). The performance of PEMFC is decisively dependent on the humidity of the electrolyte membrane(fluorinated membrane) and a humidifier plays an important role in moisturizing electrolyte membrane. Especially, this humidifier is a passive type(power-free) item and is volumetrically optimized. In this research, we propose the substitutes for the expensive fluorinated humidifier materials and the optimum dry-jet wet spinning conditions of hollow fiber membrane. In addition to that, This study will present an performance of an humidifier and compare computational results with the experimental data.