• Asian-Australasian Journal of Animal Sciences
• /
• v.8 no.3
• /
• pp.267-273
• /
• 1995

The differences in rumen particle pool size, passage rate and rumen degradability in sheep receiving three varieties of orchardgrass hay harvested at pre-heading (H1), early-bloom (H2) and late-bloom (H3) were investigated using four ruminal-cannulated wethers (68 kg) fed 1,300 g of the hay once a day. Representative samples of whole rumen contents were collected at different times after feeding and the quantities of rumen particle pools [large particle pool (LPP), retained on a $1,180{\mu}m$ sieve; small particle pool (SPP), retained on a 47 but passed a $1,180{\mu}m$ sieve; and soluble fraction (SOL), passed a $47{\mu}m$ sieve (SOL)] were determined by a wet-sieving technique. The fullowing results were obtained: 1) The dry weight of whole rumen contents were significantly lower (p < 0.05) for HI than for H2 or H3. The reduction rate of whole rumen contents was slightly but significantly greater for HI that, the other hay varieties. 2) The LPP disappearance rates were 26.2, 25.3 and 21.7 g DM/h for H1, H2 and H3, respectively, and no statistical differences were found among the hay varieties. Appreciable changes were not observed with SPP and SOL throughout measurements for all hay varieties; however the SPP was markedly greater (p <0.05) for H2 and ill than for HI, while SOL did not differ among hay varieties. 3) The SPP passage rate (g DM/h) and effective rumen degradability (%) for HI, H2 and ill were, respectively, 9.7, 56.6; 16.9, 42.3; and 18.0, 28.9. The ruminal tum-over rate for SPP appeared to be higher for HI than for the other hay varieties.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.11
• /
• pp.1610-1616
• /
• 2006

Influence of different levels of corn steep liquor (CSL) on chemical composition of urea treated wheat straw (UTWS), ruminal characteristics, digestion kinetics, nitrogen (N) utilization, and nutrient digestibility by ruminally-cannulated buffalo bulls was studied in a $4{\times}4$ Latin Square Design. The CSL was used to ensile 5% UTWS at the rate of 0, 3, 6, and 9% on a dry matter (DM) basis. Total N and neutral detergent fibre (NDF) were increased with increasing level of CSL. Increased NDF content was attributable to increased neutral detergent insoluble nitrogen. Four diets were formulated to contain 20% concentrate and 80% UTWS ensiled with 0, (control), 3 (CSL3), 6 (CSL6), and 9% CSL (CSL9). All diets were mixed daily and fed at 1.5% of body weight twice daily. Ruminal NH3 concentration decreased with level of CSL used to ensile UTWS at 3 and 6 h post prandial, however, at 9 h post parandial it was similar across all diets and at 12 h post prandial was higher with diets containing UTWS ensiled with CSL. Concentrations of total ruminal volatile fatty acid and acetate were increased with the CSL level used to ensile UTWS. Increased rate of disappearance and reduction in lag time of DM and NDF was recorded with diets containing UTWS ensiled with CSL. Dry matter and NDF digestibilities were higher with CSL diets than on the control diet. Buffalo bulls retained more N with diets containing UTWS ensiled with CSL. The present results indicated that UTWS could be ensiled with CSL to improve its nutritive value and N utilization by ruminants.

• IMMUNE NETWORK
• /
• v.12 no.1
• /
• pp.18-26
• /
• 2012

Background: Vitamin C is an essential nutrient for maintaining human life. Vitamin C insufficiency in the plasma is closely related with the development of scurvy. However, in vivo kinetics of vitamin C regarding its storage and consumption is still largely unknown. Methods: We used $Gulo^{-/-}$ mice, which cannot synthesize vitamin C like human. Vitamin C level in plasma and organs from $Gulo^{-/-}$ mice was examined, and it compared with the level of wild-type mice during 5 weeks. Results: The significant weight loss of $Gulo^{-/-}$ mice was shown at 3 weeks after vitamin C withdrawal. However, there was no differences between wild-type and vitamin C-supplemented $Gulo^{-/-}$ mice (3.3 g/L in drinking water). The concentration of vitamin C in plasma and organs was significantly decreased at 1 week after vitamin C withdrawal. Vitamin C is preferentially deposited in adrenal gland, lymph node, lung, and brain. There were no significant changes in the numbers and CD4/CD8 ratio of splenocytes in $Gulo^{-/-}$ mice with vitamin C withdrawal for 4 weeks. And the architecture of spleen in $Gulo^{-/-}$ mice was disrupted at 5 weeks after vitamin C withdrawal. Conclusion: The vitamin C level of $Gulo^{-/-}$ mice was considerably decreased from 1 week after vitamin C withdrawal. Vitamin C is preferentially stored in some organs such as brain, adrenal gland and lung.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.7
• /
• pp.1221-1225
• /
• 2007

A ${\beta}$-ionone-resistant mutant strain isolated from the red yeast Xanthophyllomyces dendrorhous KCTC 7704 was used for batch and continuous fermentation kinetic studies with glucose media in a 2.5-1 jar fermentor at $22^{\circ}C$ and pH 4.5. The kinetic pattern of growth and carotenoid concentration in the batch fermentations exhibited a so-called mixed-growth-associated product formation, possibly due to the fact that the content of intracellular carotenoids depends on the degree of physical maturation toward adulthood. To determine the maximum specific growth rate constant (${\mu}_m$) and Monod constant ($K_s$) for the mutant, glucose-limited continuous culture studies were performed at different dilution rates within a range of $0.02-0.10\;h^{-1}$. A reciprocal plot of the steady-state data (viz., reciprocal of glucose concentration versus residence time) obtained from continuous culture experiments was used to estimate a ${\mu}_m$ of $0.15\;h^{-1}$ and $k_s$ of 1.19 g/l. The carotenoid content related to the residence time appeared to assume a typical form of saturation kinetics. The maximum carotenoid content ($X_m$) for the mutant was estimated to be $1.04\;{\mu}g/mg$ dry cell weight, and the Lee constant ($k_m$), which was tentatively defined in this work, was found to be 3.0 h.

• Elastomers and Composites
• /
• v.35 no.4
• /
• pp.272-280
• /
• 2000

The experimental kinetics was analyzed for commercial rubbers such as NR, IR, BR, SBR 1500, and SBR 1700. Kinetic analysis for the commercial rubbers was performed using a thermogravimetric method, which the activation energies of NR obtained by Kissinger, Friedman, ana Ozawa's method were 195.0, 198.3, and 186.3 kJ/mol, respectively. whereas that of SBR 1500 were 246.4, 247.5, and 254.8 kJ/mol, respectively. It was shown that the yield of pyrolytic oil was generally increased with increasing the final temperature. Considering the effect of heating rate. it was found that the yield of pyrolytic oil was not consistent for each sample. The number average molecular weight of pyrolitic oil of SBR 1500 was in the range of 740-2486. The calorific value of SBR 1500 was 39-40 kJ/g, and it might be a considerable energy potential although it was lower than the conventional fuel such as kerosene, diesel, light fuel, and heavy fuel.

• Journal of Environmental Science International
• /
• v.6 no.1
• /
• pp.75-88
• /
• 1997

The rates of photodegradation, reactivities, and mechanisms of photooxidation for the aqueous solution containing with halogen derivatives of aliphatic hydrocarbons have been discussed with respect to the kinds of photocatalysts, concentration of photocatalytlc suspensions, strength of radiant power, time of illumination, changes of pH of substrate solution, wavelength of radiation, and pressure of oxygen gas saturated In the solution. These aqueous solutions suspended with 0.5 $gL^{-1}$ $TiO_2$ powder have been photodecomposed in the range of 100 and 93.8% per 1 hour if it is illuminated with wavelength (λ $\geq$ 300nm) produced from Xe-lamp(450W). The photocatalytic abilities have been increased In the order of $Fe_2O_3$ < CdS < $CeO_2$ < Y_2O_3$ <$TiO_2$, and rates of photodegradation for the solution have maldmum values in the condition of pH 6 ~ 8 and 3 psi-$O_2$ gL^{-1}$. These rates for the Photoolddation Per 1 hour were dependent on the size of molecular weight and chemical bonding for organic halogen compounds and the rates of photodegadation were increased in the order of $C_2H_5Br$ < CH_2Br_2$ < C_5H_11Cl C_2H_4Cl_2$ < tracts-$C_2H_2Cl_2$ < cis-C_2H_2Cl_2$ The T_{1/2}$ and t99% for these solutions were 5~21 and 40~90 minutes. respectively, and these values were coincided with Initial reaction kinetics(ro). It was found that reaction of photodegradation has the pseudo first-order kinetics controlled by the amount of $h^+_{VB}$ diffused from a surface of photocatalysts.

• Journal of Microbiology and Biotechnology
• /
• v.18 no.1
• /
• pp.128-134
• /
• 2008

The kinetics of cell growth and Cyclosporin A (Cyc A) production by Tolypocladium inflatum were studied in shake flasks and bioreactors under controlled and uncontrolled pH conditions. In the case of the shake flask, the production time was extended to 226 h and the maximal antibiotic concentration was 76 mg/l. When scaling up the cultivation process to a bioreactor level, the production time was reduced to only 70h with a significant increase in both the cell growth and the antibiotic production. The maximal dry cell weights in the case of the controlled pH and uncontrolled pH cultures in the bioreactor were 22.4g/l and 14.2g/l, respectively. The corresponding maximal dry cell weight values did not exceed 7.25g/l with the shake flask cultures. The maximal values for Cyc A production were 144.72 and 131.4 mg/l for the controlled and uncontrolled pH cultures, respectively. It is also worth noting that a significant reduction was observed in both the dry cell mass and the antibiotic concentration after the Cyc A production phase, whereas the highest rate of antibiotic degradation was observed in the stirred tank bioreactor with an uncontrolled pH. Morphological characterization of the micromorphological cell growth (mycelial/pellet forms) was also performed during cultivation in the bioreactor.

• International Journal of Advanced Culture Technology
• /
• v.3 no.2
• /
• pp.100-109
• /
• 2015

Environmental problems from petroleum-based plastic wastes have been rapidly increasing in recent years. The alternative solution is focus on the development of environmental friendly plastic derived from renewable resource. Poly(lactic acid) (PLA) is a biodegradable polymer synthesized from biomass having potential to replace the petroleum-based non-degradable polymers utilizations. PLA can be synthesized by two methods: (1) ring-opening of lactide intermediate and (2) direct polycondensation of lactic acid processes. The latter process has advantages on high yields and high purity of polymer products, materials handling and ease of process treatments. The polymerization process of PLA synthesis has been widely studied in a laboratory scale. However, the mass scale production using direct polycondensation of lactic acid has not been reported. We have investigated the kinetics and scale-up process of direct polycondensation method to produce PLA in a pilot scale. The order of reaction is 2 and activation energy of lactic acid to lactic acid oligomers is 61.58 kJ/mol. The pre-polymer was further polymerized in a solid state polymerization (SSP) process. The synthesized PLA from both the laboratory and pilot scales show the comparable properties such as melting temperature and molecular weight. The appearance of synthesized PLA is yellow-white solid powder.

• Corrosion Science and Technology
• /
• v.20 no.6
• /
• pp.373-383
• /
• 2021

The effect of Cr addition to high Mn steel on flow-accelerated corrosion (FAC) behavior in a neutral aqueous environment was evaluated. For comparison, two types of conventional ferritic steels (API X70 steel and 9% Ni steel) were used. A range of experiments (electrochemical polarization and impedance tests, weight loss measurement, and metallographic observation of corrosion scale) were conducted. This study showed that high Mn steel with 3% Cr exhibited the highest resistance to FAC presumably due to the formation of a bi-layer scale structure composed of an inner Cr enriched Fe oxide and an outer Mn substituted partially with Fe oxide on the surface. Although the high Mn steels had the lowest corrosion resistance at the initial corrosion stage due to rapid dissolution kinetics of Mn elements on their surface, the kinetics of inner scale (i.e. Cr enriched Fe oxide) formation on Cr-bearing high Mn steel was faster in dynamic flowing condition compared to stagnant condition. On the other hand, the corrosion scales formed on API X70 and 9% Ni steels did not provide sufficient anti-corrosion function during the prolonged exposure to dynamic flowing conditions.

• Transactions of the Korean hydrogen and new energy society
• /
• v.33 no.1
• /
• pp.8-18
• /
• 2022

With rapid industrialization and population growth, fossil fuel use has increased, which has a significant impact on the environment. Hydrogen does not cause contamination in the energy production process, so it seems to be a solution, but it is essential to find an appropriate storage method due to its low efficiency. In this study, Mg-based alloys capable of ensuring safety and high volume and hydrogen storage density per weight was studied, and Mg₂NiH_x synthesized with Ni capable of improving hydrogenation kinetics. In addition, in order to improve thermal stability, a hydrogen storage composite material synthesized with CaO was synthesized to analyze the change in hydrogenation reaction. In order to analyze the changes in the metallurgical properties of the materials through the process, XRD, SEM, BET, etc. were conducted, and hydrogenation behavior was confirmed by TGA and hydrogenation kinetics analysis. In addition, in order to evaluate the impact of the process on the environment, the environmental impact was evaluated through "Material Life Cycle Assessments" based on CML 2001 and EI99' methodologies, and compared and analyzed with previous studies. As a result, the synthesis of CaO caused additional power consumption, which had a significant impact on global warming, and further research is required to improve this.