• Journal of the Korean Society of Laryngology, Phoniatrics and Logopedics
• /
• v.9 no.1
• /
• pp.71-78
• /
• 1998

Type Ⅰ thyuroplasty in conjunction with arytenoid adduction is one of the excellent techniques in the treatment of unilateral vocal fold paralysis. But perioperative objective evaluation of the patients is difficult. With the development of the videostroboscopy and image analysis program, we could quantify the Glottal Area Waveform(GAW) in patients with unilateral vocal fold paralysis and investigated the relationship between the glottal area and aerodynamic and acoustic parameters. Eight female patients who were performed type Ⅰ thyroplasty in conjunction with arytenoid adduction and 5 females with normal vocal function were involved in this study. Preoperative and postoperative videostroboscopy and vocal function study wire performed. GAW was analysed quantitatively with image analysis program (Kay Stroboscope Image analysis, KSIP) Peak Glottal Area(PGA), Baseline Offset(BO), and Closing Phase(CP) were increased in patients with unilateral vocal fold paralysis and they were reduced after the operation. Mean flow Rate (MFR) was well correlated with the PGA in normal control group and unilateral vocal fold paralysis patients. Noise to harmonic ratio(NHR) was correlated with PGA only in preoperative unilateral vocal fold paralysis patients. In conclusion quantitative measurement of the GAW is useful method in evaluation of unilateral vocal f31d paralysis patients.

• Journal of electromagnetic engineering and science
• /
• v.2 no.1
• /
• pp.1-4
• /
• 2002

Performance improvement of the DS-CDMA system by the spectrum-overlap is important for better service quality or more system capacity. In this paper, an analysis thor capacity improvement is newly considered when the Lanczos chip waveform is used for the spectrum-overlapped DS-CDMA system. RC(relative capacity) is the ratio of the capacity of overlapping system to that of non-overlapping system, which is used for the expression of the capacity improvement. The optimal overlapping ratio is numerically found to make the maximum capacity improvement When the rectangular chip waveform is used far the overlapping system, maximum capacity improvement is increased by about 10% at the required BER=$10^{-3}$TEX> and the optimal overlapping ratio is 1.23. When the 95 % power bandwidth is considered for the Lanczos chip waveform, maximum capacity improvement is increased by 34.4% at overlapping ratio of 1.55 when the required BER is $10^{-3}$TEX>. The lower required BER far the better communication quality makes gradually smaller capacity improvement.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.2 no.1
• /
• pp.120-126
• /
• 2013

The main aim of this paper is to expound high-efficiency operation of Switched Reluctance Generator (SRG) based on the current waveform. For this purpose, theoretical analysis of the copper loss and iron loss of the system is done first. Then, necessary simulation is done to find the variation trend of the copper loss and iron loss with the variation of the current waveform at the same output power. Finally, the best current waveform which can make the system operate with high efficiency is obtained by considering the influence of these two kinds of loss. In order to verity the simulation results, the experimental platform of DC motor-SRG is built and the modified angle position control (APC) method which can specify the current shape optionally is presented. By comparing the system efficiency at the three kinds of typical current waveform, the correctness and feasibility of the theory is verified. The proposed method is simple, reliable, and easy to achieve.

• Journal of the Korean Society of Safety
• /
• v.28 no.3
• /
• pp.63-68
• /
• 2013

This paper is aimed to make an analysis on characteristics of the parallel arc waveform and RMS of current at the electrical tracking state by conductive powder. In order to achieve the goal in this paper, field state investigation at metal processing companies in Chung-Nam province area was conducted. With the field state investigation, conductive powder were collected from metal processing companies. By experiment on electrical connector(breaker, connector) over which the conductive powder were scattered, arc waveform and RMS of current were measured. The measured waveform and RMS(root-mean-square) of current were analyzed to describe characteristics and patterns of electrical arc by the conductive powder. It was proved that conductive powder on electrical connector can flow electrical current enough to make electrical fire with high thermal energy. Also the change of sine waveform and RMS of current can be used to find out relationship between electrical fire and fault signal by conductive powder. The results obtained in this paper will be very helpful for the prevention of electrical fires occurred at the metal processing companies.

• Journal of the Korean Society of Mechanical Technology
• /
• v.20 no.6
• /
• pp.783-789
• /
• 2018

This paper investigates the relationship of voltage and current waveform between normal piezo injector and deterioration abnormal piezo injector. The experimental methods using Pico oscilloscope and GDS scan tool are employed to measure current and voltage waveform and fuel pressure of piezo injector. The experiment is carried out during no-load condition. A summary of the important results are as follows. 1) In case of normal injector, the fluctuation of duration time of piezo injector was linearly and regularly decreased with increasing engine speed, but the that of deterioration piezo injector was irregularly decreased with increasing engine speed. 2) In main injection, the peak value of the current waveform of abnormal injector was larger than that of normal injector, the duration time of deteriorated abnormal injector was less than that of normal injector at 800rpm and 1500rpm, but the duration time of deteriorated abnormal injector was larger than that of normal injector at 2000rpm and 3000rpm. This irregularity appears to be caused by the deterioration of the injector.

• Journal of Ocean Engineering and Technology
• /
• v.15 no.4
• /
• pp.60-65
• /
• 2001

Thermal spray coating is formed by a process in which melted particles flying with high speed towards substrate, then crash and spread on the substrate surface cooled and solidified in a very short time, Stacking of the particles makes coating. In this study, the exfoliation of $Al_2$O$_3$ and Ni-4.5wt.%Al thermally sprayed coating which were deposited by an atmospheric plasma spray apparatus are investigated using an AE method. A tensile test is conducted on notch specimens in a stress range below the elastic limit of substrate. The wave forms of AE generated from the three coating specimens can be classified by FFT analysis into two types which low frequency(type I waveform is considered to corresponds exfoliation of coating layers and type II waveform corresponds the plastic deformation of notch tip or the resultant fracture of coating. The fracture of the coating layers can estimate by AE event and amplitude, because AE features increase when the deformation generates.

• The Journal of the Acoustical Society of Korea
• /
• v.13 no.6
• /
• pp.91-97
• /
• 1994

In speech processing, the waveform codings are concerned with simply preserving the waveform of signal through a redundancy reduction process. In the case of speech synthesis, the waveform codings with high quality are mainly used to the synthesis by analysis. Because the parameters of this coding are not classified as both excitation and vocal tract, it is difficult to apply the waveform coding to the synthesis by rule. Thus, in order to apply the waveform coding to synthesis by rule, it is necessary to alter the pitches. In this paper, we proposed a new pitch alteration method that can change the pitch period in waveform coding by dividing the speech signals into the vocal tract and excitation parameters. This method is a time-frequency domain method preserving the phase component of the waveform in time domain and the magnitude component in frequency domain. Thus, it is possible that the waveform coding is carried out the synthesis by rule in speech processing. In case of using the algorithm, we can obtain spectrum distortion with $2.94\%$. That is, the spectrum distortion is decreased more $5.06\%$ than that of the pitch alteration method in time domain.

• Journal of Biomedical Engineering Research
• /
• v.18 no.1
• /
• pp.25-36
• /
• 1997

To regulate cardiac output of the Total Artificial Heart(TAH) physiologically, the hemodynamic information must be toed back to the controller. So far, our group has developed an automatic cardiac output control algorithm using the motor current waveform, It is, however difficult to detect the preload level such as a filling status of ventricular inflow and the variation of atrial pressures within normal physiologic range(0-15 mmHg) by analyzing the motor current which simultaneously reflects the afterload effect. On the other hin4 the interventricular volume pressure(IVP) which is not influenced by arterload but by preload is a good information source for the estimation of preload states. In order to find the relationship between preload and IVP waveform, we set up the artificial heart system on the Donovan type mock circulatory system and measured the IVP waveform, right and left atrial pressures, inflow and outflow waveforms and the signals represented the information of moving actuator's position. We shows the feasibility of estimating the hemodynamic changes of inflow by using IVP waveform. fife found that the negative peak value of IVP waveform is linearly related to atrial pressures. And we also found that we could use the time to reach the negative peak in IVP waveform, the time to open outflow valve, the area enclosed IVP waveform as unfu parameters to estimate blood filling volume of diastole ventricle. The suggested method has advantages of avoiding thrombogenesis, bacterial niche formation and increasing longterm reliability of sensor by avoiding direct contact to blood.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2006.05a
• /
• pp.120-124
• /
• 2006

In this study, psychological assessment was carried out to investigate the driver's psychological characteristics by the change of the headlight. The participants were 20 men and 20 women in their 20s and thirty-two different conditions in combinations of waveform of light, voltage, and alteration time were used. The questionnaire for the assessment was evaluated by 8 subjective items and 5-point SD criteria of 19 pair's adjective. The results were as follows. 1. The assessment results from SD method indicated 3 factors by factor analysis, and it was shown that A waveform had significances in a sense of security and impetus and B waveform had a significance in a sense of security The levels of the limitations for the voltage change were 12V in the factor of a sense of security and 11V in the factor of a sense of impetus for A waveform, 12.6V in the factor of a sense of security for B waveform. 2. The results of the subjective assessment showed that the limitation of A waveform's brightness change was 12V. Moreover, the limitations of voltage changes were 12.6V for B waveform brightness change, 12V for discomfort, 12.6V for darkness. And the limitation of C waveform's brightness change was 12V.

• Tunnel and Underground Space
• /
• v.28 no.5
• /
• pp.457-475
• /
• 2018

For increase of reality in numerical analysis, a blasting vibration waveform obtained from field blast operations has been directly used for input parameters of dynamic analysis in the form of vibration velocity. A numerical model was built considering the geological characteristics of underground limestone opening as well as the mining stages in this opening, and the effect of blast operations on stability of underground limestone opening was investigated by dynamic numerical analysis. The adequacy of applying the real vibration waveform to dynamic analysis has been approved from the preliminary analysis, and the dynamic numerical analysis results show that the continuous mining operation can cause the collapse of roof in openings and the active yield zone around openings. Therefore, the additional reinforcements should be applied for ensuring the stability of underground limestone openings.