• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.34 no.6
• /
• pp.705-712
• /
• 2001

It is of great importance to represent the directional ocean waves in a laboratory basin for hydraulic model tests. The directional ocean waves can be expressed as a linear superposition of a large number of component waves with different frequencies and propagating directions. The aim of the study is to check the wave generating characteristics by serpent-type wave generating system in PKNU (Pukyong National University) which is composed of 10 piston-type wave generators. In the experiment, spatial variation of irregular wave heights and propagating angles are measured in the multi-directional wave maker basin. Target wave directional spectrum is reproduced in the area of multi-directional wave maker basin. The directional spreading of the generated waves varied spacially in the basin. They differed from target spectrum as the measurement point becomes far from the center line normal to the generator face, The effective generation area where that target can be reproduced is limited to the triangular area attached the generator face. According to the results, it is emphasized that the effective experiment area in the basin considered wave generator characteristics should be determined in consideration of experimental conditions including structural shapes, water depth, wave directionality etc.

• Journal of Ship and Ocean Technology
• /
• v.7 no.1
• /
• pp.13-18
• /
• 2003

The control performances for active re-reflecting wave control suggested in the previous paper have been verified in cases of regular and irregular waves in a real two dimensional wave basin. For regular waves, the control performances are investigated in terms of reflection coefficients, expected amplitudes of propagating waves and wave absorbing capabilities after cessation of wave generation, compared with those of no-control cases. For irregular waves similar verification procedures were adopted. Though there are certain constraints due to the geometrical non-linearity of wave maker and certain nonlinear characteristics due to the near field and gravity waves these experiments show that the control logic could be useful in realizing re-reflecting wave control in conditions of real wave basin.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.34 no.4
• /
• pp.93-99
• /
• 2022

Analytical solutions for regular waves generated by bottom wave makers in a 3-dimensional wave basin were derived in this study. Bottom wave makers which have triangular, rectangular and combination of two shapes were adopted. The 3-dimensional velocity potential was derived based on the linear wave theory with the bottom moving boundary condition, kinematic and dynamic free surface boundary conditions in a wave basin. Then, analytical solutions of 3-dimensional particle velocities and free surface displacement were derived from the velocity potential. The solutions showed physically valid results for regular waves generated by bottom wave makers in a wave basin. The analytical solution for obliquely propagating wave generation from bottom wave maker which works like a snake was also derived. Numerical results of the solution agree well with theoretically predicted results.

• Journal of Ocean Engineering and Technology
• /
• v.16 no.5
• /
• pp.1-6
• /
• 2002

Extreme waves are generated in a model basin based on directional wave focusing. The targeted wave field is described by double summation method and it is applied to serpent-type wavemaker system. The extreme crest amplitude at a designed location is obtained by syncronizing the phases and focusing the directions of wave components. Two distinguished spectrums of constant wave amplitude and constant wave steepness are adapted to describe the frequency distribution of component waves. The surface profile of generated wave packets is measured by wave guage array and the effects of dominant spectral parameters governing extreme wave characteristics are investigated. It is found that frequency bandwidth, center frequency, shape of frequency spectrum and directional range play a significant role in the wave focusing. In particular, the directional effect significantly enhances the wave focusing efficiency.

• Journal of Ship and Ocean Technology
• /
• v.6 no.4
• /
• pp.13-18
• /
• 2002

Active control has been partly applied to suppress the re-reflecting waves in wave basin with plunger-type wave maker to obtain desirable waves. This limitation comes from the non-confirmable theoretical background to the control algorithm. This paper proposes control logic to overcome this drawback, based on the impulse response function for propagating waves between control input and the wave height. The performances have been verified as reasonable in practical application by comparing with the propagating wave components in numerical wave basin, using wave decomposition method. Moreover, the control logic can also give useful wave-absorbing performance after cessation of wave generation.

• Economic and Environmental Geology
• /
• v.52 no.6
• /
• pp.555-560
• /
• 2019

One-dimensional shear wave velocity structure of North Korea is constrained using short (2-sec) to long period (30-sec) Rayleigh waves generated from four seismic events in China. Rayleigh waves are well recorded at the five broadband seismic stations (BRD, SNU, CHNB, YKB, KSA) which are located near to the border between North and South Korea. Group velocities of fundamental-mode Rayleigh waves are estimated with the Multiple Filter Analysis and refined by using the Phase Matched Filter. Average group velocity dispersion curve ranging from 2.9 to 3.2 km/s, is inverted to constrain the shear wave velocity structures. Relatively low group velocity dispersion curves along the path between the events to BRD at period from 4 to 6 seconds may correspond to the sedimentary sequence of the West Korea Bay Basin (WKBB) in the Yellow Sea. The low velocity zone in deep layers (14-20 km) may be related to the deep sedimentary structure in Pyongnam basin. The fast shear wave velocity structure from the surface to the depth of 14 km is consistent with the existence of metamorphic rocks and igneous bodies in Nangrim massif and Pyongnam basin.

• Journal of Ship and Ocean Technology
• /
• v.11 no.3
• /
• pp.1-13
• /
• 2007

A semi-submersible drilling rig is regarded as one of the typical offshore structures operated in the field with moderate environments such as the Gulf of Mexico, Brazil, and West Africa. Its typical roll and pitch natural periods are around 30 seconds, which avoids prevailing regions of the wave energy spectrum, and their responses in waves are quite acceptable for common operation conditions. But large roll and pitch motions can be induced by wave difference frequency energy spectrum if the metacentric heights of a semi-submersible decrease to small values in some loading conditions, and it is because the roll and pitch natural periods increase and approach to the region where the spectral density of the low frequency wave drift moment has significant value. This paper describes the low frequency roll motion of a semi-submersible that are excited by the wave 2nd order difference frequency energy by a series of model experiments. From the model tests with several different initial metacentric heights (GM), it was observed that a semi-submersible can experience large roll motion due to the wave group spectrum.

• Journal of the Society of Naval Architects of Korea
• /
• v.39 no.1
• /
• pp.38-48
• /
• 2002

Theoretical development to generate the directional extreme waves in model basin is established based on wave focusing method. The effects of associated parameters, such as the directional range, frequency width, and center frequency, are investigated in terms of wave focusing efficiency. The two different spectral models of constant wave amplitude and constant wave slope are applied to control the wave characteristics. The wave packets simulated by theory are compared with numerical results based on Boussinesq equation and FEM. Both controls of direction and frequency spectrum are essential to focus directional waves effectively. It is noticed that wave focusing ability depends on the frequency bandwidth of spectrum rather than center frequency, and both spectral models with same parameters result in the equivalent efficiency of wave focusing.

• Journal of the Society of Naval Architects of Korea
• /
• v.59 no.2
• /
• pp.89-95
• /
• 2022

The stability of the existing ships has been evaluated through numerical calculations in the steady-state, but recently the IMO proposed a new stability assessment criteria that the stability is evaluated in the state in which environmental loads from such as waves and wind act like the loads under actual ship operating conditions. In this study, IMO 2nd generation stability assessment method and procedure were summarized for the dead ship condition, and Direct Stability Assessment (DSA) was performed on 13K chemical tanker through basin model test. The model test is performed in the ocean engineering basin to implement wave and wind loads, and environmental conditions for waves were set height and period of the incident wave, considering the regular wave and wind generation range reproducible in the ocean engineering basin. In addition, to consider the effect of wind speed, the Beaufort Scale for wind speed was applied in the model test.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.05a
• /
• pp.363-368
• /
• 2001

Because of rapid damping of light and electromagnetic wave, acoustic wave has been widely used for underwater communication. However, the propagation of the acoustic wave is highly dependent on the environment such as water properties(temperature, pressure, salinity), bottom and surface conditions, etc.. This paper deals with the surface reflection effect on the wave propagation in the underwater anechoic basin in KRISO. Both theortical and experimental approaches are performed and the results are compared.