• Journal of the korean academy of Pediatric Dentistry
• /
• v.34 no.1
• /
• pp.122-129
• /
• 2007

The purpose of this study was to evaluate the effects of a various light curing time on the residual monomers released from light-cured dental sealant, and to examine the effectiveness of surface treatment in reducing the oxygen-inhibited layer of light-cured dental sealant($Helioseal^{(R)}$ F, Vivadent, Liechtenstein). Specimens were cured with a halogen light curing unit(XL 3000, 3M, USA) for 20, 40, 60s. Surface treatment of a light-cured dental sealant included no treatment(control group), a 10-seconds exposure to distilled water(Group I), 10-seconds manual application using a cotton pellet wetted with 75% alcohol(Group II), and 10-seconds application of a water/pumice slurry using a rubber cup on a slow-speed handpiece The specimens were eluted in distilled water for 10 minutes. All elutes were analyzed by HPLC for identification and quantitive analysis of monomers. The results of this study can be summarized as follows. 1. None of the chromatograms of the tested sealant displayed peaks with the same retention time as that of the standard solution, except for TEGDMA. 2. The release of TEGDMA decreased with increasing curing time in conventional halogen light. 3. All surface treatment group had a decrease of monomer release in comparison with no treatment group. 4. Treatment that Group III eliminated the greatest amount of any type of residual monomers. 5. The elution of unreacted monomers from curing with halogen curing unit for 60s and Group III was less than other groups.

• Korean Journal of Ecology and Environment
• /
• v.44 no.1
• /
• pp.95-101
• /
• 2011

Present study aimed to investigate morphological change and gene expression in the gill of Cyprinus carpio after exposure against muddy water caused by riverbed disturbance with various rearing condition. The gill of C. carpio showed abnormal shapes in its secondary lamellae and a rough surface with impure debris after exposed to muddy water for 80 days. In addition, the gills showed the edema, the exfoliation of epithelial cell, and the fusion of the secondary lamellae. Using 20 ACPs, 24 differentially expressed genes (DEGs) exposed to muddy water for 80 days were identified. 17 genes among them were up-regulated, while 7 genes were down-regulated in preterm deliveries. A BLAST searches revealed that 3 genes were revealed known genes as calcium transporter 1 (TRPV6) mRNA, macha mRNA for putative puroindoline b protein, and Efnb3 protein-like. Therefore, it is considered that Efnb3 gene from gill would be a useful indicator for neurobehavioral changes in fish influenced by muddy water.

• Textile Coloration and Finishing
• /
• v.17 no.5 s.84
• /
• pp.26-36
• /
• 2005

This study was carried to evaluate mechanical characteristics of Poly(ethylene terephthalate) fabrics (by Kawabata evaluation system(KES)) which was systematically treated with $O_2$ low temperature plasma and chitosan acetate solution. Furthermore, surface structure was investigated by SEM, AFM, air permeability and wettability. Tensile energy(WT), shear rigidity(G) and surface roughness(MIU) properties calculated by KES-FB have increased with increasing plasma treatment time, while bending rigidity(G) and energy of compression(WC) value were decreased compared with those of the untreated. SEM photographs showed the identification of chitosan coating but did not confirm the plasma etching structure. Air permeability was decreased according to plasma treatment time with increasing concentrations of chitosan. The water absorption rate made rapid progress by chitosan treatment.

• Journal of Advanced Marine Engineering and Technology
• /
• v.23 no.3
• /
• pp.360-368
• /
• 1999

The paper describes spectroscopic characteristics of plasma induced in the pulsed YAG laser welding of alloys containing a large amount of volatile elements. The authors have conducted the spectroscopic analyses of laser induced Al-Mg alloys plasma in the air and argon atmosphere. In the air environment the identified spectra were atomic lines of Al, Mg, Cr, Mn, Cu, Fe and Zn and singly ionized Mg lines as well as the intense molecular spectra of ALO and MgO formed by chemi-cal reactions of evaporated Al and Mg atoms from the pool surface with oxygen in the air. In argon atmosphere MgO and AlO spectra vanished but AlH spectrum was detected. the hydrogen source was presumable hydrogen dissolved in the base metals water absorbed on the surface oxide layer or $H_2$ and $H_2O$ in the shielding gas. The resonant lines of Al and Mg were strongly self-absorbed in particular self-absorption of the Mg line was predominant. These results show that the laser induced plasma was made of metallic vapor with relatively low temperature and high density.

• ALGAE
• /
• v.20 no.4
• /
• pp.305-314
• /
• 2005

5 Haptophyta 2 Chrysophyta and 1 Prasinophyta species of scale-bearing nanoflagellates were collected in coastal water of Korea and identified by examination of their scales with Field Emission Scanning Electron Microscope (JSM-6700F). These included Chrysochromulina ahrengoti, C. simplex, C. spinifera, Prymnesium parvum, P. patelliferum, Mamiella gilva, Paraphysomonas imperforata and Pa. vestita. The surface of cells covered with unmineralised scales (5 Haptophyte and 1 Prasinophyta species) or silica scales (2 Chrysophyta species). Scale-covered flagella are found in the 1 Prasinophyta species. One of the main structural characteristics of Haptophyte is the haptonema, a filiform organelle which occurs together with the two flagella. It may be long and coiling upon irritation as in Chrysochromulina, or short and noncoiling as in Prymnesium.

• Advances in materials Research
• /
• v.1 no.4
• /
• pp.349-359
• /
• 2012

To reveal localized plastic deformation zones in a tough pitch copper, the etching characteristics of a copper sample have been examined. The etching was carried out on a sample surface using an etchant consisting of 25 ml nitric acid solution and 75 ml water. To clarify the plastic deformation zone, the sample deformed plastically was heated to between $250^{\circ}C$ and $300^{\circ}C$ before the etching process. This is due to a change of the microstructure and crystal orientation in the plastic deformation zone producing recrystallized small grains. In this case, the plastically deformed zone is severely etched, whereas the undeformed zone is only slightly etched. Identification of the details of the deformation zone from the etching is further discussed.

• Journal of Environmental Health Sciences
• /
• v.35 no.3
• /
• pp.187-190
• /
• 2009

Cryptosporidium spp. were detected in 17 of 135 swine lagoon samples from five farms by 18S ribosomal DNA locus and PCR. Seventeen positive samples identified were included two distinctive genotypes C. suis and Cryptosporidium sp. based on a small-subunit rRNA gene-based PCR-restriction fragment length polymorphism analysis. Cryptosporidium spp. were detected out of farrowing, farrowing and nursery (mix), and finishing. Prevalence rate was 12.6% with infection rates between 3.7 and 18.5%. We concluded that Cryptosporidium oocysts can persist in treated lagoon and potentially contaminate surface water through improper discharge. This study was undertaken for the evaluation of the infection status of the genotypes of Cryptosporidium spp. in swine lagoon.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.43 no.4
• /
• pp.120-128
• /
• 2001

Pollution sources and their environmental contributions were investigated to select the best management practices for the effective control of water quality. The nitrogen isotope mass ratio was determined to estimate the nitrate sources and their contribution. Sampling sites were chosen by calculating effluent loads at each watershed. Two liters each of the surface water samples were collected from four sites at Bokha river and two sites and Gwanri river. They were sequentially prepared through distillation method and analyzed using an isotope ratio mass spectrometer(IsoPrime EA). As revealed by the experimental values obtained the mass ratio values ($\delta$$^{5}$ N) of watersheds with a large amount of nonpoint sources were less than +5 an indication that the samples were influenced by chemical fertilizers. However watersheds with large amount of point sources were influenced not only by chemical fertilizers but also by animal and municipal wastes. The mass ratio values of samples generally decreased during rainy days. But during dry days the mass ratio values well-reflected the nitrate sources and the condition of watersheds. Through this study the nitrogen isotope mass ratio has been found to be useful for estimating nitrate sources and their contribution to the rural watersheds.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.34 no.4
• /
• pp.209-214
• /
• 2020

The association of cold-heat (CH) pattern and anthropometry/body composition has been suggested in that they are related to thermoregulation. We aimed to study the association of CH pattern and anthropometry/body composition. A total of 1479 individuals aged 50-80 years were included in the study, and their CH pattern were evaluated by a self-administered questionnaire. After adjustment for age and sex, the CH score were significantly correlated with weight, BMI (body mass index), body surface area, waist-hip ratio, fat free mass, body fat mass, body cell mass, intracellular water, extracellular water, and basal metabolic rate; however, the correlation coefficients were mostly low (0.15-0.24). The selected variables for predicting CH score were various according to the methods used for variable selection; however, the adjusted R-squared of the final models were all around 0.12. Thus the most parsimonious model could be the one that includes sex and BMI. In conclusion, various anthropometry and body composition indices were associated with CH pattern. Future studies are necessary to improve the performance of the prediction model.

• Journal of Multimedia Information System
• /
• v.4 no.4
• /
• pp.195-204
• /
• 2017

Mobile robots are used for years as a valuable research and educational tool in form of available open-platform designs and Do-It-Yourself kits. Rapid development and costs reduction of Unmanned Air Vehicles (UAV) and ground based mobile robots in recent years allowed researchers to utilize them as an affordable research platform. Despite of recent developments in the area of ground and airborne robotics, only few examples of Unmanned Surface Vehicle (USV) platforms targeted for research purposes can be found. Aim of this paper is to present the development of open-design USV drone with integrated multi-level control hardware architecture. Proposed catamaran - type water surface drone enables direct control over wireless radio link, separate development of algorithms for optimal propulsion control, navigation and communication with the ground-based control station. Whole design is highly modular, where each component can be replaced or modified according to desired task, payload or environmental conditions. Developed USV is planned to be utilized as a part of the system for detection and identification of marine and lake waste. Cameras mounted to the USV would record sea or lake surfaces, and recorded video sequences and images would be processed by state-of-the-art computer vision and machine learning algorithms in order to identify and classify marine and lake waste.