• Proceedings of the KSME Conference
• /
• 2007.05a
• /
• pp.399-402
• /
• 2007

In the previous research, it has been found that water strider's legs are strongly water repellent due to hierarchical structure of hydrophobic setae on the legs. Here we propose an answer why they should be so hydrophobic by showing that the work required to remove a floating hydrophobic cylinder from an interface depends very sensitively on the contact angle of the cylinder: superhydrophobic cylinders require relatively little work to remove them from an interface. Also we experimentally study the work required to lift a leg out of water with different contact angles and compare our experimental results with a theoretical prediction.

• Journal of Sensor Science and Technology
• /
• v.28 no.6
• /
• pp.407-413
• /
• 2019

Using 3D printing technology, we created a biomimetic water strider robot that can monitor environments. We found ways to increase the bearing capacity of the fluid-driven water strider robot by conducting experiments then comparing with more stable robots. The controller of the robot is based on Arduino, and can be controlled wirelessly with a Bluetooth module. The speed of the robot is 7.37 cm/s, and the bearing capacity is 29 g. A lithium polymer battery that can be charged with a solar cell was used as a power source, and both the charging and driving times were also explored.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.365-365
• /
• 2010

Similar to the superhydrophobic surfaces of lotus leaf, water strider leg is attributed to hierarchical structure of micro pillar and nano-hair coated with low surface energy materials, by which water strider can run and even jump on the water surface. In order to mimick its leg, many effort, especially, on the fabrication of nanohairs has been made using several methods such as a capillarity-driven molding and lithography using poly(urethane acrylate)(PUA). However most of those effort was not so effective to create the similar structure due to its difficulty in the fabrication of nanoscale hairy structures with hydrophobic surface. In this study, we have selected a low surface energy polymeric material of polytetrafluoroethylene (PTFE, or Teflon) assisted with surface modification of CF4 plasma treatment followed by hydrophobic surface coating with pre-cursor of hexamethyldisiloxane (HMDSO) using a plasma enhanced chemical vapor deposition (PE-CVD). It was found that the plasma energy and duration of CF4 treatment on PTFE polymer could control the aspect ratio of nano-hairy structure, which varying with high aspect ratio of more than 20 to 1, or height of over 1000nm but width of 50nm in average. The water contact angle on pristine PTFE surface was measured as approximately $115^{\circ}$. With nanostructures by CF4 plasma treatment and hydrophobic coating of HMDSO film, we made a superhydrophobic nano-hair structure with the wetting angle of over $160^{\circ}C$. This novel fabrication method of nanohairy structures has been applied not only on 2-D flat substrate but also on 3-D substrates like wire and cylinder, which is similarly mimicked the water strider's leg.

• The Korean Journal of Ecology
• /
• v.14 no.4
• /
• pp.449-455
• /
• 1991

The water striders, gerris paludum insularis larvae which were fed with the drosophila melanogaster cultured on the appli diet and artificial diet, were reared in the growth cabinet controlled as the two constant temperature regimes of 25 c and 30 c under the condition of photoperiod 16l : 8d, light intensity 510 240 lux, relative humidity 65 3%, and in the natural state. The effects of temperature and diet on the devolopment of g. paludum insularis were analyzed and the results were summarized as follows. 1. The total developmental period of the water strider larvae fed with the d. melanogaster reared on the apple diet at the natural stste was the longest 40 days, and the total devopmental periods at 25 c and 30 c were 35 days and 27 days respectively. The tolal developmental period of larvae fed with d. melanogaster reared on the artifical diet at 25 c was the longest 42 dats, and the total developmental periods at natural stste and 30 c were 32 days and 27 days, respectively. 2. In the larval developmental stages, the fifth stage was longer than that of any stage. The duration of egg stage which was not influenced by diet at 25 c was the longest. 3. The water strider larvae fed which the d. melanogaster reared on the artificial diet at 25 c did not complete their devolopment. 4. No significant difference was odserved in the developmentperiod for diet at 30 c. but, there were significant differences in developmental periods for diet at 25 c and natural state. 5. The rate of adult emergence on the apple diet was higher than that of the artificial diet was higher than of the artificial diet. 6. The shapes of the survivorship curve were convex-curve. 7. The development periods of the larval stages of water striders might be affected to temperature and diet dependently.

• The Korean Journal of Ecology
• /
• v.27 no.6 s.122
• /
• pp.369-373
• /
• 2004

The water strider, Gerris paludum insularis, was reared in a growth cabinet at two constant temperatures and ${\approx}20^{\circ}C$ under a 16:8 (L:D) photoperiod. Differences in head width among three temperatures of ${\approx}20^{\circ}C,\;25^{\circ}C\;and\;30^{\circ}C$ in G. paludum insularis, were compared. Temperature affected growth of head width of G. paludum insularis. There were highly significant differences among head width for three temperature regimes and the immature stages. It was found that head width is greater in $30^{\circ}C$ than $25^{\circ}C\;and\;{\approx}20^{\circ}C$. The growth quantity of the head width in ${\approx}20^{\circ}C$ shows the slowest increase, and $25^{\circ}C\;and\;30^{\circ}C$ were gradually increased in that order. The maximum ratio of growth quantity by each stage is in the first instar in all regimes. The growth rates of all regimes show an increase pattern.

• Proceedings of the KSME Conference
• /
• 2008.11a
• /
• pp.1427-1432
• /
• 2008

This paper describes the locomotion of a water jumping robot which attempts to emulate the fishing spider’s ability to jump on the water surface. While previous studies of the robots mimicking arthropods living on water were focused on recreating their horizontal skating motions, here we aim to achieve a vertical jumping motion. The robot jumps by pushing the water surface with rapidly released legs which were initially bent. The motion is triggered with a latch driven by the shape memory alloy actuator. The robot is capable of jumping to the maximum height of 26mm. Jumping efficiency, defined the maximum jumping height on water over the maximum jumping height on rigid ground, is 0.26 This work represents a first step toward robots that can locomote on water with superior versatility including skating and jumping.

• Journal of Ecology and Environment
• /
• v.31 no.1
• /
• pp.1-7
• /
• 2008

In this minireview we focus on how males may exploit female's sensitivity to predation risk in the context of mating. It has been shown in studies on guppies and jumping spiders that in response to altered female behaviors, which are adaptations to the unfavorable environment and a consequence of females' higher sensitivity to predator's presence as well as females' higher predation risk, males can adopt condition-dependent mating tactics. It appears that in such cases males do not modify their reproductive behavior directly in response to their own perception of predation risk, but indirectly in response to changes in female behavior induced by predator presence. It has also been recently shown in crabs that males can exploit female behavior by creating safer habitat spots, which increases the male mating success. Hence all the evidence suggests that males not only respond to female sensitivity to the natural variation in predation risk, but that males can also exploit female behavior by altering the environment. As a logical extension of these findings, we present a hypothesis that in certain conditions males can manipulate the environment in order to increase the predation risk and to induce female behaviors that enhance the male's mating success with the increased predation risk. We propose that such a manipulation to increase predation risk is expected to evolve in males of species with a strong sexual conflict and female-biased predation risk. Although empirical evidence has not been yet shown, initial observations in a water strider species in Korea, Gerris gracilicornis, seem to support this hypothesis.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.33 no.2 s.109
• /
• pp.100-110
• /
• 2005

The Korea South-East Power Co., Ltd.(KOSEP) held a design competition for Energy Theme Park at Yeong-Heung power plant in October, 2004. The site is located in 980-1 Oe-ri, Yeong-Heung myun, OngJin gun, Incheon City and has an area of $54,450m^2$. Design objectives of KOSEP were to make environmentally sustainable space, to build a symbolic and gathering place for community members and visitors, to make a tourist spot of Yeong-Heung Island linked with adjacent sight spots in OngJin gun, and to elevate an identity and status of the KOSEP by creating a landscape correspondent to the concept of the building design. The spatial concept of this project was developed by expressing a circular course of energy, named 'energy circle' and accounting for principles of energy generation. By interpreting 'energy circle' and principles of energy generation, and applying it to the site, the design met the various desires of the KOSEP. This design consists of seven theme spaces; the future energy plaza, the wind plaza, the light plaza, the thermal power plaza, a water strider dam, a ecological pond and the stratum plaza. These theme spaces are consecutively placed along the circular path which surrounds the public information building and to represent how power plants generate energy in each space and diverse design techniques and special effects are used.