• Nuclear Engineering and Technology
• /
• 제15권3호
• /
• pp.179-187
• /
• 1983

국내원자력 발전소중 고리 1호기 및 5,6호기의 LOCA 사고시 격납용기 살수용액과 썸프 용액의 pH값이 US NRC에서 요구하는 설계기준치를 만족하는가를 알아보기 위해 전산프로그램 “LOCAPH”를 개발하여 최대 pH경우와 최소 pH경우로 나누어 분석하였다. 고리 5,6호기의 경우, 썸프 용액의 pH는 설계기준(최소 8.5이상)을 잘 만족하고 있으며, 살수 용액의 pH는 설계기준(8.5에서 11.0사이)을 약간 벗어나고 있음을 볼 수 있었다. 그러나 고리 1호기의 경우를 보면 썸프 용액의 pH는 역시 설계기준을 잘 만족하고 있으나 살수 용액의 pH는 최대 pH 경우에 있어서 현재 설계에 반영되고 있는 설계기준을 상당히 벗어나고 있음을 알 수 있었다.(고리 1호기 설계시 살수 용액의 pH에 대한 설계 기준치는 없었음) 설계 기준을 만족시키기 위해 고리 1호기의 설계변수를 바꾸어가며 계산해 본 결과 격납용기 살수 용액의 공급원인 핵연료 재장전수 저장탱크(RWST)의 붕소 농도를 2750ppm에서 2850ppm 사이로 유지하거나, 격납용기 살수 용액에 첨가되는 NaOH의 유량을 10gpm에서 24gpm사이로 유지해야 함을 알 수 있었다.

• 한국건축시공학회지
• /
• 제4권1호
• /
• pp.97-103
• /
• 2004

In case of a fire in road or railway tunnel it is always necessary to keep the escape condition as good as possible. Most of the victims of major fires in tunnels are because they couldn't leave the tunnel in time and were trapped by smoke, or rescue teams couldn't reach the place of the accident due to low visibility and high temperature. In spring 2003 a comprehensive field experiment was undertaken in a large scaled tunnel in Youngin City to test the effectiveness of a new water spray curtain system, designed to the air qualify inside of a tunnel in case of fire during passenger's escape to safe routes, In order to control the smoke propagation, fixed water sprayed nozzles were used to make water curtain system, which can be installed or hanging water piping line below ceiling. The experiment was accompanied by an extensive measurement campaign in order to measure temperature dropping effect and flow conditions as well as CO concentration for various water sprayed curtains produced by sprinkler heads or water spray nozzle. Eventually comparison analysis were undertaken to investigate the performance of water curtains under fixed water pressure. Therefore most effective water curtain system was presented on the basis of water droplet size in long tunnel.

• 한국태양에너지학회 논문집
• /
• 제30권3호
• /
• pp.108-115
• /
• 2010

Global warming and heat island make the outdoor air temperature ascend. Tall office buildings are covered with glass window facades as a design aspect and the portion of window area to facade area is increasing. Hence, cooling load for solar radiation passing through glass window is rising. Cooling air to a certain room is supplied equally despite the face of the room in most office buildings. Especially, the west part of the office cannot maintain the required temperature that occupant needs because of the solar heat coming through windows.?In this study, we projected the water spray system to reduce the solar heat transfer and to reflect the solar ray through windows. We perform the experiments to evaluate the performance of the solar heat protection devices. We measured the room temperature of two separated office rooms for solar heat control devices. The investigation's results show that the water spray system is sufficient to the coated glass and the venetian blinds for the decrease of the solar heat inflow.

• 수산해양교육연구
• /
• 제22권4호
• /
• pp.604-610
• /
• 2010

Busan subway transportation system has been established a key role in the society last 20 years. However many people are suffering from hot and humid environment at subway station and platform due to deteriorated ventilation system as well as insufficient air conditioning system in existing stations and platforms. As a result, these systems require revitalization. There is about 5400tons of low temperature underground water is generated from subway stations every day. By using this method and air washer we are trying to lower the temperature. Air washer is commonly used for removing humidity but in this experiment it will be used as air precooling. This research offers result of experiment using air washer system to lower the temperature in large spaces like subway station. The experiment result has shown when L/G was the same, at condition which water spray temperature at $18^{\circ}C$ resulting inlet and outlet temperature difference larger. Also, in the same water spray temperature conditions, larger L/G condition showed a greater temperature difference. LCC evaluation of both system were shown that air washer system of using underground water will save 53% of the initial cost than refrigeration system, and save 75% of operating cost.

• 펄프종이기술
• /
• 제37권4호통권112호
• /
• pp.38-43
• /
• 2005

Natural Com Starch(NCS) spray system has been widely used In multiply board mill for the better bonding strength between board layers. However the unsuitable NCS spray system could lead to a drop in plybond efficiency of multiply board. It could also result in the accumulation of unretained-starch in the white water system, which could not only rise in BOD and COD level but also reduce the effects of rosin-alum sizing system and other additives. In this study, the simple and rapid method by UV-spectroscopy for measuring the starch contents in the white water was proposed, and the quantitative analysis for dissolved starch content in white water was carried out in two kinds of board production process. It could be confirmed that about 150 ppm of oxidized starch was retained in white water dewatered from undertop ply of multiply board process, and about 470 ppm of natural starch was dissolved in white water originated from unsuitable spraying system in the multiply board production lines for cup base paper.

• 한국분무공학회지
• /
• 제28권1호
• /
• pp.43-48
• /
• 2023

The waste-heat-recovery boiler with water spray (HR-B/WS) applies the heat exchange between the inlet air and exhaust gas with the water spray into the inlet air. The evaporation of water in the inlet air promotes heat recovery from the exhaust gas so that thermal efficiency can be improved by the enhanced condensing effect. The NOx emission can also be reduced by lowering the flame temperature due to the dilution effect of the water. In this study, the validity of this concept is examined by the practical boiler test performed with a 24 kW condensing boiler under the full load condition according to the water injection amount. The theoretical amount of water injection is calculated under the assumption of full evaporation of the sprayed water, which is calculated as 50 g/min. Since the injected water cannot evaporate fully in the actual system, the maximum water spray amount is set as 100 g/min. The results showed that the water injection can increase the thermal efficiency up to 95.59% and reduce NOx and CO emissions simultaneously to 8.9 ppm and 35 ppm at 0% of O₂. Although the heat energy loss increased due to the unevaporated water, the increase in water injection amount caused higher thermal efficiency due to the increased amount of the evaporated water.

• 한국화재소방학회논문지
• /
• 제22권3호
• /
• pp.216-220
• /
• 2008

물분무소화설비는 화원의 냉각, 주변공기의 희석, 미세한 물방울의 증발에 의한 열차단과 같은 소화특성을 이용한다. 미분무수의 운동량은 입자가 큰 물방울에 비해 상대적으로 낮으며 화원의 침투능력도 효과적이지 못하다. 증발된 수증기에 의한 기여는 무게가 가볍고 밀도가 희박하여 화원에 일부분으로 제한되는 경향이 있다. 반면, 사이클식 미분무 패턴은 성층화된 분무 특성에 의해 공기 추출능력과 침투력이 개선될 것으로 예상된다. 이 논문에서는 유체공학적 화재모델인 FDS를 사용하여 교번식 미분무 패턴에 대해 분석된 소화능력을 다룬다. 저자는 이 분석이 미분무 노즐의 표본을 개발하기 위한 기본 개념을 제공할 수 있기를 기대한다.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2008년도 하계학술발표대회 논문집
• /
• pp.334-339
• /
• 2008

An closed cooling tower is a device similar to a general cooling tower, but with cooling tower replaced by a heat exchanger. The purpose of this study is to evaluate thermal performance of heat exchanger at various conditions and to provide design datebase. The experimental study regarding heat exchanger for closed cooling tower was conducted. Experimental apparatus consists of constant temperature bath, water pump, spray nozzle, heat exchanger, fan, and date acquisition system. Heat transfer rates at various air velocitys, water flow rates, two different spray modes were measured and heat transfer coefficient were calculated to compare the thermal performances. This study provides that the heat transfer coefficient increases with increasing spray water flow rate and with increasing air velocity. The wet mode was more effective than dry mode for closed cooling tower to this study.

• Journal of Biosystems Engineering
• /
• 제29권3호
• /
• pp.217-224
• /
• 2004

This research was conducted to test the feasibility of utilizing high-pressure water jets of over 1.0㎫ as a means of breaking and peeling garlic bulbs. High-pressure plunger pumps and flat-spray nozzles of varying orifice diameters and spray angles were utilized to supply water jets into a prototype peeling chamber made of transparent acrylic plates. Water jets were discharged from a total of six nozzles installed in such a way that three parallel nozzles face the other three. The cross-sectional area of the peeling chamber and the installation angle of the nozzles had critical effects on peeling performance. Small cross-sectional area was required so that total impact force of water jets on garlic could be increased. The optimum installation angles were around 4, 8, and 16$^{\circ}$ for the nozzles having 15, 40, and 65$^{\circ}$ spray angles, respectively. Best performance with 61.4% of completely-peeled garlics was obtained at a pressure of 1.94㎫ and a flow rate of 9.07 $\ell$/min for each nozzle. The peeling efficiency of the system was generally unsatisfactory due to the limited flow rate of the plunger pumps utilized. For better performance, it is recommended to increase flow rate while reducing operating pressure by utilizing other type of pumps.

• 마이크로전자및패키징학회지
• /
• 제10권4호
• /
• pp.65-71
• /
• 2003

압전 세라믹스를 이용하여 약품 분사용 초음파분사 노즐을 제작하였다. 정수장의 혼화 공정에 사용되는 약품(응집제)의 고효율 분산을 위해 분사 노즐을 설계하였으며 압전세라믹을 최적화하였다. 제작된 초음파 약품 분사 노즐을 패키징하여 정수장의 약품 혼화 과정에 적용하여 약품사용의 고 효율화와 사용량 저감을 위한 연구를 진행하였다. 압전체는 실리콘으로 마감처리를 하였으며 Al으로 패키징하였다. 본 초음파 분사 노즐 시스템을 적용하여 혼화지에 실험한 결과 약품의 순간 혼화를 촉진시키는 기술로 투입 약품량을 저감시킬 수 있을 것으로 판단된다. 초음파 발진 약품 분사시, 무발진과 비교하여 대장균 제거 효율에서 현저하게 높아졌다.