• Journal of Biosystems Engineering
• /
• v.27 no.4
• /
• pp.327-334
• /
• 2002

In this study, energy conversion from thermal energy to mechanical power by using n-pentane was tested and exergy variation, cycle number, water quantity pumped and thermal efficiency were analyzed. The energy conversion was done and the water head could be ten meters on the experimental conditions. The operating temperature range of cycle was recommended to be around the liquid-vapour saturation temperature of the working fluid on the viewpoint of the maximum work. The cycle diagram was analyzed by the exergy analysis. For the constant water head, the cycle number was decreased and the water quantity per day was increased and thermal efficiency become higher when the water quantity per cycle become increasing. For the constant pumping water quantity per cycle, cycle number and the water quantity per day was decreased and the thermal efficiency become higher because the saturation temperature become higher when the water head become higher.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.29-32
• /
• 2004

Gaseous partitioning tracer test has been used for determining the volume and spatial distribution of residual non-aqueous phase liquid (NAPL) in the unsaturated soils. In this study, an experimental method for measuring the content of gas-exposed NAPL as well as that of total NAPL in a sand during air sparging was developed. Two different gaseous phase NAPL-partitioning tracers were used; n-pentane, with very low water solubility, was used as the tracer that partitions into NAPL that is only in contact with the mobile gas, and chloroform, with fairly good water solubility, was selected for detecting total NAPL content in the sand. Helium and difluromethanewere used as the non- reactive tracer and water-partitioning tracers, respectively. Using n-decane as a model NAPL (NAPL saturation of 0.018), 25.6% of total NAPL was detected by n-pentane at the water saturation of 0.68. Oniy 9.1% of total NAPL was detected by n-pentane at the water saturation of 0.84. This result implies that the quantity of gas-exposed NAPL increased about three times when the water saturation decreased from 0.84 to 0.68. At the water saturation of 0.68, more than 90% of total NAPL was detected by chloroform while 65.8% of total NAPL was detected by chloroform at the water saturation of 0.84. Considering that the removal rate of NAPL during air sparging for NAPL-contaminated aquifer is expected to be greatly dependent upon the spatial arrangement of NAPL phase with respect to the mobile gas, this new approach may provide useful information for investigating the mass transfer process during air-driven remedial processes fer NAPL-contaminated subsurface environment.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.195-195
• /
• 2017

The water in the crop cultivation shows difference according to the variety of crop, cultivations period and climatic condition. The growth and development, quantity and fruit enlargements are affected by soil water conditions. In previous study, leaf area and photosynthesis are decreased by lower soil moisture. Other research reported that excess moisture condition at vegetative and reproductive growth period in cultivation of soybean caused highest reduction in crop growth rate (CGR) and dry weights of plant parts. In particular, the damage was bigger during vegetative growth stage than reproductive growth period. Soybean (Glycine max (L.) Merill) is useful and popular crop throughout the world. It is very popular crop in Korea, China, Japan and other Asian countries. Soybeans used in various way including soybean sprouts, paste, soymilk, oil and tofu. Two soybean cultivars grown in four different irrigation conditions were determined for physiological responses. In this study, we examined leaf area (LA), leaf dry weight (LDW), specific leaf area (SLA), root dry weight (RDW) and shoot height (SH) in different water conditions. 50mL/9day irrigation periods showed the lowest contents in LA, LDW, RDW, SH. Water deficit caused increase of leaf Water saturation deficits (WSD), Cheongjakong 3 and Taekwangkong showed increase of leaf water saturation deficits (WSD) in drought conditions and leaf water potential and stomatal conductance were decreased. Photochemical efficiency was decreased in 50mL/1day irrigation condition while, there was decrease of growth and development in 50mL/9day with drought.

• Textile Coloration and Finishing
• /
• v.11 no.3
• /
• pp.1-8
• /
• 1999

Polyester ultrarmcrofiber(UMF, fiber fineness : 0.05d) and the other three kinds of polyester fibers(0.52, 1.04 and 2.08d) were dyed with two disperse dyes, C.1. Disperse Red 60 and Blue 56. Dyeing rates and absorption isotherms of these dyes have been measured at 100, 115 and $130^\circ{C}$ in water system. The dye bath was maintained at pH 5.0 with acetic acid(0.1mo1/1) /sodium acetate(0.1mo1/1) buffers and a liquor ratio of 1000：1. The absorption isotherms from two disperse dyes are nearly linear up to the saturation values, which increase with the temperature of dyeing. Dye uptake decreased with the fiber fineness in lower temperature $100^\circ{C})$, whereas increased in higher temperature$(130^\circ{C})$. A comparatively greater quantity of dye is necessary to dye ultrarmcrofiber fabrics than conventional fabrics. Disperse Blue 56 having a good build-up property is agreed to Fothergill's equation, which is inversely varied with the fiber fineness by the quantity of dye necessary to obtain a given shade.

• Journal of Mechanical Science and Technology
• /
• v.17 no.5
• /
• pp.740-750
• /
• 2003

It has been observed that the cooling capacity of an impinging water jet is affected by the seasonal conditions in large-scale steel manufacturing processes. To confirm this phenomenon, cooling experiments utilizing a hot steel plate cooled by a laminar jet were conducted for two initial ambient air temperatures (10$^{\circ}C$ and 40$^{\circ}C$) in a closed chamber, performing an inverse heat conduction method for quantitative comparison. This study reveals that the cooling capacity at an air temperature of 10$^{\circ}C$ is lower than the heat extracted at 40$^{\circ}C$. The amount of total extracted heat at 10$^{\circ}C$ is 15% less than at 40$^{\circ}C$ , These results Indicate the quantity of water vapor, absorbed until saturation, affects the mechanism of boiling heat transfer.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.19-24
• /
• 2003

This paper is to research the heat transfer characteristic in copper-water variable conductance heat pipes(VCHP) with a non-condensable gas and gas reservoir. The heat transfer characteristics in the VCHP have not yet been studied much researches. VCHP are used in many applications. These applications range from thermal control of components and systems on satellites, to precise temperature calibration duties, conventional electronics temperature control and thermal diodes. The practical use of VCHP is a simple way to control the temperature of satellites. As the quantity of NCG was increased, there was an increase in the saturation vapor temperatures. As the input heat has loaded from 90 W to 110 W, the difference of the evaporator surface is lower than $10^{\circ}C$.

• Proceedings of the KOSOMBE Conference
• /
• v.1997 no.11
• /
• pp.517-527
• /
• 1997

Magnetic Resonance Spectroscopic Imaging is a methodology combining the imaging and spectroscopy. It can provide the spectrum of each areas of image so that one can easily compare the spectrum of one position to another position of the image. In this study, we developed pulse sequence or the spectroscopic imaging method, RF wave forms or the saturation of water signal, computer simulations to validate our method, and confirmed the methodology with phantom experiment. Then we applied the spectroscopic method to human subject and identified a few important metabolites in in vivo. To develope a water saturating RF waveform, we used Shinnar-Le-Roux algorithm and obtained maximum phase RF waveform. With this RF pulse, it could suppress the water signal to 1:1000. The magnet is shimmed to under 1.0ppm with auto-shimming technique. The saturation bandwidth is 80Hz(2ppm). The water and fat seperation is 3.3ppm(about 140Hz at 1 Tesla magnet), the bandwidth is enough to resolve the difference. But we are more concerned about the narrow window in between the two peaks, in which the small quantity of metabolites reside. We performed the computer simulation and phantom experiments in 8*8 matrix form and showed good agreement in the image and spectrum. Finally we applied spectroscopic imaging to the brain of human subject. Only the lipid signal was shown in the periphery region which agrees with the at distribution in human head surface area. The spectrum inside the brain shows the important metabolites such as NAA, Cr/PCr, Choline. We here have shown the spectroscopic imaging which is normally done above 1.5 Tesla machine can be performed in the 1 Tesla Magnetic Resonance Imaging Unit.

• Journal of the Korean Solar Energy Society
• /
• v.30 no.1
• /
• pp.34-41
• /
• 2010

Gas hydrates are solid solutions when water molecules are linked through hydrogen bonding and create host lattice cavities that can enclose many kinds of guest(gas) molecules. There are plenty of methane(gas) hydrate in the earth and distributed widely at offshore and permafrost. Several schemes, to produce methane hydrates, have been studied. In this study, depressurization method has been utilized for the numerical model due to it's simplicity and effectiveness. IMPES method has been used for numerical analysis to get the saturation and velocity profile of each phase and pressure profile, velocity of dissociation front progress and the quantity of produced gas. The values calculated for the sample length of 10m, show that methane hydrates has been dissolved completely in approximately 223 minutes and the velocity of dissociation front progress is 3.95㎝ per minute. The volume ratio of the produced gas in the porous media is found to be about 50%. Analysing the saturation profile and the velocity profile from the numerical results, the permeability of each phase in porous media is considered to be the most important factor in the two phase flow propagation. Consequently, permeability strongly influences the productivity of gas in porous media for methane hydrates.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.1
• /
• pp.29-38
• /
• 2000

It is observed that the cooling capacity of impinging water jet is affected by the seasonal conditions in steel manufacturing process with large scale. To confirm this phenomena, the cooling experiments of a hot steel plate by a laminar jet were conducted for two different initial ambient air temperature($10^{\circ}C$ and $40^{\circ}C$) in a closed chamber, and an inverse heat conduction method is applied for the quantitative comparison. It is found that the cooling capacity under $10^{\circ}C$ air temperature is lower than that under $40^{\circ}C$, as is the saturated water vapor is more easily observed, and the amount of total extracted heat in the case of $10^{\circ}C$ is smaller by nearly 15% than that of $40^{\circ}C$ case. From these results, it is thought that the quantity of water vapor, which could be absorbed until saturation, effects on the mechanism of boiling heat transfer.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.4 no.6
• /
• pp.187-195
• /
• 1996

Because an alternative refrigerant(HFC-134a) is being used instead of CFC-12 for automotive air-conditioning system, newly designed air-conditioning components are necessary due to changes in characteristics. Optimum design scheme for receiver dryer in an automotive air-conditioning system is described with emphases upon the volume of desiccant and container. The volume of the container, that is manufactured based on the study, is reduced down to one half of the existing receiver dryers.