• Food Science of Animal Resources
• /
• v.37 no.4
• /
• pp.518-528
• /
• 2017

Quality characteristics of frozen cylindrical pork loin were evaluated following different tempering methods: 27.12 MHz curved-electrode radio frequency (RF) at 1000 and 1500 W, and forced-air convection (FC) or water immersion (WI) at $4^{\circ}C$ and $20^{\circ}C$. The developed RF tempering system with the newly designed curved-electrode achieved relatively uniform tempering compared to a parallel-plate RF system. FC tempering at $4^{\circ}C$ was the most time-consuming process, whereas 1500 W RF was the shortest. Pork sample drip loss, water holding capacity, color, and microbiological quality declined after WI tempering at $20^{\circ}C$. Conversely, RF tempering yielded minimal sample changes in drip loss, microstructure, color, and total aerobic bacteria counts, along with relatively uniform internal sample temperature distributions compared to those of the other tempering treatments. These results indicate that curved-electrode RF tempering could be used to provide rapid defrosting with minimal quality deterioration of cylindrical frozen meat block products.

• Food Science of Animal Resources
• /
• v.34 no.6
• /
• pp.852-857
• /
• 2014

This study was carried out to develop a simple, convenient, and reproducible testing device to determine wettability and dispersibility of dairy powders. The testing device consists of a sieve ($150{\mu}m$) attached to a sample chamber, sensors mounted on a supporting body and a main control unit containing a display panel. The sensors detect the difference in electrical resistance between air and water. A timer is automatically triggered by the sensor when the bottom of sample-loaded chamber contacts water in the petri dish. Wettability and dispersibility of commercial skim milk powders (SMPs) produced at different heating strengths (low-, medium-, and high-heat SMP) are compared using the new testing device. Wettability of the SMPs were correlated with particle size and are found to increase in the order of medium-, low-, and high-heat SMP regardless of the amount of sample tested. Dispersibility of SMPs showed the same trend and high heat-SMP which has the smallest particle size resulted in the lowest dispersibility. Unlike existing methods, the new testing device can determine both wettability and dispersibility of powders and successfully detected differences among the samples.

• Journal of Korean Society of Water and Wastewater
• /
• v.11 no.4
• /
• pp.133-141
• /
• 1997

In order to treat the landfill leachate, $UV/TiO_2/H_2O_2$ system connected with biological treatment was investigated, and proper pretreatment methods were examined to reduce the load on the system considering economical and technical efficiency. It was more profitable to put $H_2O_2$ into the system in the early stage for the sample which was treated with $H_2SO_4$ to decrease alkalinity and with $FeCl_3-6H_2O$ flocculation. Because the required reaction time run up by increasing $H_2O_2$ input amount, though the COD was reduced slightly, the optimal $H_2O_2$ input amount should be determined for the desired COD and the economical efficiency. The appropriate way to get the lowest COD in the shortest time was the method to treat the sample which was controlled to pH 3.5 after adjusting to pH 12 and put 500 ppm $H_2O_2$ into the system. In that case, to increase $H_2O_2$ input amount was not profitable for the system efficiency. The sufficient photocatalytic excited time was required to reduce the photocatalytic decomposition time for the sample which was gone through the alkali state.

• Journal of the Korean Society of Tobacco Science
• /
• v.23 no.1
• /
• pp.45-52
• /
• 2001

This study was carried out to evaluate the uncertainty in the analysis of total alkaloids and reducing sugar content in flue-cured tobacco. The sources of uncertainty associated with the analysis of total alkaloids and reducing sugar were the weighing of sample, the preparation of extracting solution, the addition of extracting solution into the sample, the preparation of standard solution, the precision of calibration curve for standard solution, the reproducibility of analysis, and the determination of water content in tobacco, etc. For the calculating uncertainties, Type A of uncertainty was evaluated by the statistical analysis of a series of observation, and Type B by the information based on supplier’s catalogue and/or certificated of calibration. It was shown that the main source of uncertainty was caused by the calibration curve of standard solution, the reproducibility of analysis, the volume measurement of 1$m\ell$, and the purity of nicotine reference material in the preparation of standard solution. The uncertainty in the addition of extracting solution, the sample weighing, the volume measurement of 100$m\ell$, and the determination of water content of tobacco contributed relatively little to the overall uncertainty. The expanded uncertainty of total alkaloids and reducing sugar in flue-cured tobacco at 95% level of confidence was $\pm$0.12% and $\pm$0.54%, respectively.

• Geomechanics and Engineering
• /
• v.37 no.4
• /
• pp.359-370
• /
• 2024

The primary goal of this study is to evaluate the migration of fine granular materials into overlying layers under cyclic loading using a modified large-scale triaxial system as a physical model test. Samples prepared for the modified large-scale triaxial system comprised a 60 mm thick gravel layer overlying a 120 mm thick subgrade layer, which could be either tailings or railway sand. A quantitative analysis of the migration of fine granular materials was based on the mass percentage and grain size of migrated materials collected in the gravel. In addition, the cyclic characteristics, i.e., accumulated axial strain and excess pore water pressure, were evaluated. As a result, the total migration rate of the railway sand sample was found to be small. However, the total migration rate of the sample containing tailings in the subgrade layer was much higher than that of the railway sand sample. In addition, the migration analysis revealed that finer tailings particles tended to be migrated into the upper gravel layer easier than coarser tailings particles under cyclic loading. This could be involved in significant increases in excess pore water pressure at the last cycles of the physical model test.

• Proceedings of the KSME Conference
• /
• 2007.05a
• /
• pp.102-107
• /
• 2007

The steel impeller placed in a water pump has been studied with the aim to understand corrosion phenomena on the surface responsible for reducing the pumping efficiency of water inside cooling system. This preliminary experiment includes a period (around 1 month) observation with a powered microscope and weight measurements. The experiments are carried out at different conditions of water and mixtures of water and coolants, based on the water contents of 25%, 50%, 75%, and 100% water (pure tap water). From the visual results of microscopy, most of the steel surface is fitted and clear rusty or corrosion phenomena are noticeable as time goes. In addition, the weight loss of the sample specimen submerged in the water is linearly increased, whereas those in the mixtures of water initially gain weight and become almost constant.

• Journal of the Korean Chemical Society
• /
• v.35 no.4
• /
• pp.355-361
• /
• 1991

The separative preconcentration of trace mercury[Hg(II)] in a water sample was studied by a coprecipitation flotation technique. The trace Hg(II) was precipitated together with Ce(OH)$_3$ by adding 3.0 ml of 0.1M Ce$^{3+}$ solution to 1,000 ml of water sample and adjusting pH to 11.0 with 1.0M NaOH solution. The hydrophobic precipitate[Ce(OH)$_3$-Hg(OH)$_2$], which was formed by adding 2.0 ml of 0.1${\%}$ ethanolic sodium oleate solution, were floated on the surface with an aid of tiny nitrogen gas bubbles. The floated materials were quatitatively collected in a suction flask and dissolved with 5.0 ml of 2.0M HNO$_3$. The solution was marked to 25.00 ml with a deionized water. The content of Hg(II) was determined by cold vapor atomic absorption spectrophotometry. Any interferences of concomitants such as Ag$^+$, Br$^-$, I$^- $, etc. were not observed on the whole procedure. The analytical result showed that Hg(II) found in the wastewater of Seochang Campus, Korea University was 1.98 ng/ml with the relative standard deviation of 3.6${\%}$. And recoveries of Hg(II) in the wastewater into which 1.0 ng/ml and 2.0 ng/ml were added were 95${\%}$ and 91${\%}$, respectively. From such results, this procedure could be concluded to be tolerably accurate and reproducible for the determination of trace mercury in a water sample.

• Journal of Environmental Science International
• /
• v.11 no.4
• /
• pp.399-403
• /
• 2002

This study was designed to analyse the odor from Nam river. The characteristic odor in the water occurred from geosmin and phenol, p-cresol and indol were detected from sediment/water samples. The others were detected as alcohols and fat acid compounds. Algae causing odor and taste were identified as Oscillatoria sp. and Synedra acus. 15 species of phytoplankton, a zooplankton, an eelworm and chironomus were identified in water/sediment sample.

• Journal of Korea Water Resources Association
• /
• v.32 no.3
• /
• pp.281-289
• /
• 1999

Small-scale hydropower projects at existing agricultural reservoirs can contribute to produce electric energy by maximizing the use of releases from the reservoirs. The irrigation water duration, the reservoir hydropower simulation, and the nonlinear programming model are employed to estimate potential hydroelectric energy at an existing reservoir. The nonlinear programming model consists of finding a maximum hydroelectric energy subject to irrigation water demand constraints. The sample reservoir given a set of inflow and irrigation water is considered. The optimal solutions by the optimization model yield the most hydroelectric energy for the analysis period in the three methods. Consequently, the nonlinear programming model uses the most water for hydropower generation with respect to the total inflow of the sample reservoir. It is also found that additional storage by increasing the normal water level of the sample reservoir does not significantly increase the annual hydroelectric energy for the given reservoir. It is expected that the optimization model and the proposed procedure for estimating potential hydroelectric energy can be applied to evaluate feasibility analysis for small scale hydropower additions at existing agricultural dams.

• Journal of the Korean Magnetic Resonance Society
• /
• v.6 no.1
• /
• pp.1-11
• /
• 2002

Physical properties of PVB [Poly(vinyl butyral)] polymer are strongly correlated with water contents in the polymer. Thus dynamics of PVB containing 10~50(w/w) ％ of water were studied by $^{13}$ C CP/MAS/DD over the temperature range 293K -348K. From the Peak area, line width, chemical shift, and relaxation times ( $T_{1}$ $T_{1p}$) measured at 9.4 T, it was deduced that water facilitates molecular dynamics of the PVB molecules overall including conformational exchange of the racemic and meso butyaldehyde rings in the PVB. However, the influence of water was not linear to the amount of water in the PVB samples. It is suggested that water up to 30 w/w ％ of the sample is closely bound to the PVB polymer and water relatively free from the PVB polymer starts to appear when water is added more than 30 w/w ％.％.