• Food Science of Animal Resources
• /
• v.38 no.2
• /
• pp.273-281
• /
• 2018

Preheating conditions (low-, medium-, and high heat-) did not significantly affect the buffering capacity (BC) of skim milk powder (SMP), whereas the level of demineralization significantly affected the BC of whey powders (WP). Heat treatment ($85^{\circ}C$ for 30 min) of both SMP and WP (90% demineralized) mixtures (88:12, 76:24, 64:36 and 52:48; SMP:WP) resulted in a reduced BC, and the extent of this reduction increased with the proportion of WP increased in the samples. High-buffering milk prepared by the addition of phosphate salts (40 mM $NaH_2PO_4$ and 60 mM $Na_2HPO_4$) delayed the rate of pH decline during yoghurt fermentation. The high-buffering yoghurt showed a significantly higher water holding capacity (WHC) than that of control yoghurt (p<0.05), as well as a more uniform and interconnected microstructure with small pore sizes than those of control yoghurt. No significant differences were found between high-buffering and control yoghurt regarding the viable bacterial counts of starter. The manipulation BC can potentially improve the quality characteristics of yoghurts, such as WHC and texture.

• Journal of the Korean Wood Science and Technology
• /
• v.35 no.5
• /
• pp.38-45
• /
• 2007

Flakeboards made from ring- and drum-cut flakes of Douglas-fir, hemlock, red lauan and kapur using two kinds of resin levels were evaluated for the selected properties according to flake thickness. The pH and buffering capacity of four species were determined. Those of kapur were extremely different from the other three species. These pH and buffering capacity values result in the poor internal bond strength of kapur flakeboard. The internal bond strength was affected significantly by flake thickness, resin content and species. MOR and MOE in bending strength were maximized at medium drum-cut flake thickness. Screw holding strength was not consistent for flake thickness, but it was influenced by species. Thickness swelling and water absorption of Douglas-fir and hemlock flakeboard were minimized at medium drum-cut flake thickness.

• Journal of the Korean Chemical Society
• /
• v.43 no.2
• /
• pp.172-181
• /
• 1999

To develop the manufacturing technique for the powder builder of amorphous solid types, the water glass mixed with caustic soda dispersed into the methanol. Thus soluble sodium silicate was made a form of amorphous solid powder. In order to examine characteristics of water soluble sodium silicate $SiO_2/Na_2O$ mol ratio, we investigated solubility, thermogram, SEM, and BET analysis. pH buffering capacity, calcium-ion binding capacity as temperature change, and surfactant loading capacity were examined for characteristics as laundry detergent builder. $SiO_2/Na_2O$ molar ratio of soluble sodium silicate was 1.0, 2.4, 2.8, and zeolite was used in order to investigate basic characteristics of laundry detergent builder. Silicate used with laundry detergent was good for pH buffering capacity and solubility. But calcium-ion binding capacity and surfactant adsorption ability were lower. $SiO_2/Na_2O$ mol ratio became higher, pH buffering capacity and ion exchange ability were lower and surfactant adsorption ability was a little higher.

• Journal of Korea Soil Environment Society
• /
• v.2 no.1
• /
• pp.35-44
• /
• 1997

A column study using artificial acid rain was conducted to evaluate the buffering capacities in soil layer and host rock. In an effort to compare the effect of composition of host root two valleys of which compositions of host rock are different were chosen within the study area and the pHs of the water flowing in the valleys were measured from May, 1996 to October, 1996. The pHs of the artificial acid rain prepared by adding appropriate amounts of both sulfuric and nitric acids to distilled water were 3, 4, and 5, and the column effluents were analyzed for major cations and anions. The cation exchange capacities(CECs) of A Horizon and the B Horizon were 9.68 and 6.16 meq/100g, respectively, Compared to the B Horizon, the pH in the column effluent of A Horizon with larger CEC was higher. The sums of $Ca^{2+}$, $Mg^{2+}$, $Na^{+}$in the column effluents gradually decreased, indicating the loss of CEC by acid rain. The field study showed that pHs of the surface water in the valleys increased as the water flows downwards. The magnitude of this buffering capacity was greater for the valley in which smectite in addition to kaolinite and illite was a weathered product of host rocks. This also indicates that host rock as well as soil layer retains the buffering capacity.

• Korean Journal of Environmental Agriculture
• /
• v.25 no.2
• /
• pp.157-163
• /
• 2006

Investigation of Cd and Zn availability in four different soils as affected by the interactions of these two heavy metals was conducted using the metal desorption quantity-intensity (Q/I) isotherms. The soils were artificially contaminated with proper concentrations of Cd and Zn as $CdSO_4\;and\;ZnSO_4$ solutions. DTPA (diethylene triamine pentaacetic acid) - extractable and water-extiactable Cd or Zn from the soils were used as $Q_{Cd}\;or\;Q_{Zn}\;and\;I_{Cd}\;or\;I_{Zn}$ factors, respectively. The coefficient of determination for Cd and Zn desorption Q/I linear regression in the soils ranged from 0.947 to 0.999, which indicated that Q and I factors were closely correlated. The buffering capacity of Cd, $BC_{Cd}$, in the soils decreased with increasing Zn treatments, and the $BC_{Cd}$ values were ranged between 205.8 and 2255.6. The decreases of $BC_{Cd}$ values were mainly dependent upon the increases of $I_{Cd}$ factors. However, Zn buffering capacity. $BC_{Zn}$ decreased with increasing Cd treatments in acidic soils, and increased in neutral and calcareous alkaline soils. The $BC_{Cd}$ values were ranged from 143.2 to 6158.0. The values of $BC_{Zn}$ as influenced by the treatments of Cd were also controlled by the solubility of water-extractable Zn, $I_{Zn}$ factor. The solubility of water-extractable Cd and Zn was significantly dependent upon the changes of soil pH that were impacted by the treatment of Zn and Cd, respectively. Also, the availability of Cd was higher than Zn availability in the acidic and neutral soils, but Zn was higher than Cd in the calcareous alkaline soil.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.20 no.1
• /
• pp.228-238
• /
• 1996

The purpose of this study was to evaluate the effect of chacteristics of knit fabrics on the microclimate of the skin simulating system. To determine the effect of characteristics of knit fabrics, vapor state of sweat pulse was simulated in the closed system. Different contents of fibers such as cotton, wool and polyester with different yarn size and knit types were chosen for specimens. The changes of humidity and temperature of air layer in the simulated systems were measured. Buffering indices, $K_d$ and $\beta_r$, were determined by considering $\alpha_p, \DeltaP_{max}, t_{max}, and tan\beta$. Physical properties of knit fabrics such as thickness, porosity, air resistance and moisture vapor transport were measured. Results showed that vapor pressure of wool was lower than cotton or polyester This was attributed to the hydrophilicity of wool which absorbed moisture rather quickly and retained in the knit fabric. The time to decrease vapor pressure was faster for polyester than cotton or wool. As a result, $K_d$ was in the order of wool> polye, item> cotton. $\beta_r$ of wool was rower than cotton or polyester due to its lowers porosity and slower desorption rate. For the yarn size, $K_d$ was in the order of 80's> 60's> 30's; thinner and lighter yarn showed better water vapor transport property. For knit type, buffering capacity of single jersey was better than interlock knit fabric. Statistical analysis showed that the air permeability was the most influential factor far the water vapor transport properties.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.1A
• /
• pp.75-84
• /
• 2009

The present study assesses the chloride threshold level for corrosion of steel in concrete by examining the properties of four different binders used for blended concrete in terms of chloride binding, buffering of cement matrix to a pH fall and the corrosion behaviour. As binders, ordinary Portland cement (OPC), 30% pulverised fuel ash (PFA), 60% ground granulated blast furnace slag (GGBS) and 10% silica fume (SF) were used in a concrete mix. Testing for chloride binding was carried out using the water extraction method, the buffering of cement matrix was assessed by measuring the resistance to an artificial acidification of nitric acid, and the corrosion rate of steel in mortar with chlorides in cast was measured at 28 days using an anodic polarisation technique. Results show that the chloride binding capacity was much affected by $C_{3}A$ content and physical adsorption, and its order was 60% GGBS>30% PFA>OPC>10% SF. The buffering of cement matrix to a pH fall was varied with binder type and given values of the pH. From the result of corrosion test, it was found that the chloride threshold ranged 1.03, 0.65, 0.45 and 0.98% by weight of cement for OPC, 30% PFA, 60% GGBS and 10% SF respectively, assuming that corrosion starts at the corrosion rate of $0.1-0.2{\mu}A/cm^{2}$. The mole ratio of [$Cl^{-}$]:[$H^{+}$], as a new presentation of the chloride threshold, indicated the value of 0.008-0.009, irrespective of binder, which would be indicative of the inhibitive characteristic of binder.

• The Korean Journal of Ecology
• /
• v.16 no.2
• /
• pp.169-180
• /
• 1993

Soils of four combinations, sand with high content of organic matter(SL), sand with low content of OM(SS), siltyl loam with high content of OM(LL) and silty loam with low content OM (LS), were filled on column and then percolated with simulated sulfuric acid rain with pH 5.6, 4.0, 3.5, 3.0 and 2.5. From soil leachates, pH and concentrations of basic cations and Al were determined. Cation concentrations in the leachates increased as pH of the rain decreased. The orders of buffering capacity of soil, leachability of cation from soil, leaching sensitivity of ion andbase saturation sensitivity of soil to acidity of the rain water were SS$\leq$K <$\leq$LL

• Journal of Environmental Science International
• /
• v.7 no.2
• /
• pp.149-156
• /
• 1998

Enoronmental problems caused by certain geologic conditions Include pollution of soil by heavy metal, acidization of souls , acid mine drainage, Pound-water pollution, and natural radioactivity, as well as zoo-logical hazards such as landslide and subsidence. The acrid mine drainage contains large amount of heavy metals nO, therefore. cause serious pollution onto the nearby drainage systems and soils. In spite of this prospective environmental danger, few studies have been done on the acid mine drainage derived from non-metallic ore deposits such as pyrophyllitefNapseok) deposits. The sudo-bearing pyrophyllite ores, alteration zones, and mine talllngs of pyrophylllte deposits produce acrid mine drainage by the okidation of weathering. Compared to the fresh host rocks, the ores and altered rocks of pyrophyllite deposits produce acidic solution which contain higher amount of heavy metals because of OeP lower buffering capacity to acrid solution. The pus of urine water and nearby stream water of pyrophyllite deposits are 2.1~3.7, which are strong- ly acidic and much lower than that (6.2~7.2) of upstream water and than that (6.8~7.6) of the stream water derived from the non-mineralized area. This study reveals that this acrid mine drainage can affect the downstream area which is 8km far from the pyrophyllite deposits, even though the drain Is diluted with abundant non-contaminated river water This suggmists that not only acid mine drainage but also the sulfide-bearing sediments originated from the pyrophyllite deposits move downstream and form acidic water through continuous oxidation reaction. The heavy metals such as Pb, Zn, Cu, Cd, Nl, Mn and Fe are enriched In the mine water of low pH, and their contents decrease as the pH of mine water Increases because of the Influx of fresh stream wainer. SoUs of the Pyrophyulte deposits are characterized by high contents of heavy metals. The stream sediments containing the yellowish brown precipitates formed by neutralization of acid mine drainage occur in all parts of the stream derived from the pyrophyllite deposits, and the sediments also contain high amounts of heavy metals. In summary, the acid mine drainage of the pyrophyllite deposits is located in the upstream part of Hoidong water reservoir in Pusan contains large amounts of heavy metals and flows into the Holdong water reservoir without any purification process. To protect the water of Holdong reservoir, the acid mine drainage should be treated with a proper purification process.

• Korean Journal of Soil Science and Fertilizer
• /
• v.30 no.1
• /
• pp.56-61
• /
• 1997

A study was carried out to find out the basic information in physical properties for selection and manufacturing the good seedling media through the analysis of the physical properties, such as particle size, water retention and three phases of the major horticultural substrates. Easily available water(EAW), the water contents between 1kPa and 5kPa water potental, was highest in peatmoss with 39%, and perlite 34.0%, vermiculite 16.9%, but the values of osmunda and bark were lower than 4.8%. Water buffering capacity(WBC), the water content between 5kPa and 10kPa, was 6.1% in peatmoss and 2.3% in vermiculite but it was lower than 1.0% in other substrates. To adjust the suitable range of water potential at crossing point of water and air curves to 1.5~2.5kPa, more finer materials were needed in osmunda and bark, and more coarser materials must be added to peatmoss, perlite and vermiculite. Water potentials of substrates in saturated pot condition were equivalent to 2.2kPa in peatmoss and others were ranged in 1.0kPa to 4.3kPa of water potential in pressure chamber.