• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.11 no.4
• /
• pp.197-200
• /
• 1999

An extension of the modified leap-frog scheme is made to solve the nonlinear shallow-water equations. In the extended model. the physical dispersion of the Boussinesq equations is replaced by the numerical dispersion resulted from the leap-frog finite difference scheme. The model is used to simulate propagations of a solitary wave over a constant water depth and a linearly varying water depth. Obtained numerical results are compared with available analytical and other numerical solutions. A reasonable agreement is observed.

• Proceedings of the Korean Fiber Society Conference
• /
• 1994.10a
• /
• pp.137-138
• /
• 1994

Anionic water dispersible copolyesters were synthesized and characterized. Viscosity of the copolyester is lower than that of routine acrylic water dispersible polymers. Adhesive force of the copolyester was much higher than that of water dispersible acrylic polymers. Particle size of the copolyesters in water decreased with the increase of DMS or DEG feed ratio. With the conclusive study of the data of particle size and potential, it was found that the dispersion stability of copolyesters in water increased with the increase of DMS or DEG feed ratio. Judging from the results of potential and particle size of copolyesters, there seems to be competition between two dispersion stability factors, i.e. electrostatic stabilization and steric stabilization and as a result, morphological change of particles occurrs. Tg decreased with the increase of DEG molar feed ratio or oil contents.

• Journal of Environmental Science International
• /
• v.3 no.4
• /
• pp.317-332
• /
• 1994

Based on the Results of Marine Meteorological and Oceanographical Observations (1966 ~ 1987), oceanographic conditions of the Japan Sea in winter was studied in relation to the Japan Sea Proper Water (JSPW). The mean and dispersion of the deep water above 1000 m depth are 0.26$\pm$0.2$^{\circ}C$ in temperature and 5.1$\pm$0.25 ml/h in oxygen. The mean and dispersion of the bottom water below 1000m depth are 0.07$\pm$$0.04^{\circ}C$ in temperature and 5.1$\pm$0.15ml/1 in oxygen. The distributions of the temperature and dissolved oxygen in the deep water above 1000m depth are ranged wider than 각one of the bottom water below 1000m depth in T-S and T-$ extrm{O}_2$ diagrams. The bottom water are showed more homogeneous and smaller variations than the deep water in the characteristics of water mass. The deep water above 1000m depth is active in contact with the atmosphere. The JSPW similar to the above characteristics is showed in the open ocean of the north of $40^{\circ}$30""N, west of $138^{\circ}$E. Therefore, the deep water is formed probably by the open-ocean convection.tion.

• Journal of Korean Society of Water and Wastewater
• /
• v.10 no.3
• /
• pp.64-72
• /
• 1996

The one of the most important factors we shoud consider in designing the processes using porous media such as activated carbon adsorber is the prediction of the breakthrough curve. In this study, the breakthrough curve of BAC process for the treatment of refractory pollutants was evaluated by simplified engineering analysis. Through the experiments, the slope of the breakthrough curve can be determined by retardation factor, R and apparent dispersion coefficient, $D_{app}$ which is determined by hydrodynamic dispersion, mass transfer effects and isotherm. Estimated concentration of effluent was agreed with the experimental values. Also, it is possible to use this method for predicting the breakthrough curve of the pollutants removal and tranport of pollutants in porous media.

• Proceedings of the International Microelectronics And Packaging Society Conference
• /
• 2003.11a
• /
• pp.278-281
• /
• 2003

A new type of ultrasonic spray nozzle was fabricated with piezoelectric devices. The spray nozzle was designed for the chemicals dispersion in the water purification bath. The piezoelectric properties in ultrasonic spray nozzles were optimized for the better dispersion of chemicals for purification process. Ultrasonic spray nozzle was packaged in metal case with silicone resin for the water proof application.

• Journal of the Korean Society of Safety
• /
• v.10 no.2
• /
• pp.56-63
• /
• 1995

A simulation of contaminant dispersion in a water reservoir has been done using 2-D finite difference method(FDM). The steady state velocity field of the reservoir was computed using stream function-vorticity formulation of Wavier-Stokes equation and continuity equation. Based on the computed steady state velocity field, the transient convective diffusion equation of the contaminant dispersion was computed. For the 1m$\times$1m reservoir model with inlet and outlet attached, it was shown that the center of circulation located toward right. For the numerical values of v =0.01($\textrm{cm}^2$/s) and D=0.6($\textrm{cm}^2$/s) and the flow of 50($\textrm{cm}^3$/s ), it was determined that the outflow had to be shut down in 18 seconds to prevent from severe pollution. Also the required time was computed to be 6 seconds for the inflow of 100 ($\textrm{cm}^3$/s). The result of this study is considered, hopefully, to be useful for the design of the water reservoir systems that are the subjects to various contamination.

• 한국방재학회:학술대회논문집
• /
• 2008.02a
• /
• pp.431-434
• /
• 2008

Pratical dispersion-correction scheme is applicated to simulate the distant propagation of tsunami. This scheme is based on the leap-frog finite difference scheme for the linear shallow-water equations. The new scheme has the advantage of using the constant spatial grid size and time step size even in area of variable depths. And this new model constructed by using the 2nd upwind scheme, dynamic linking method, and staggered grid system. This model is simulated to near Sokcho harbor about The Central East Sea Tsunami in 1983. And this result is compared to tide gage and result of former model.

• Journal of the Microelectronics and Packaging Society
• /
• v.10 no.4
• /
• pp.65-71
• /
• 2003

A new type of ultrasonic spray nozzle was fabricated employing a piezoelectric device. The spray nozzle was designed to disperse chemicals in a water treatment mixing tank. The piezoelectric properties in ultrasonic spray nozzles were optimized to improve the dispersion of chemicals. The piezoelectrics were packaged in an aluminum case with silicone resin for the aqueous solution proof packaging. Chemicals were dispersed with high efficiency and the chemicals consumption was reduced by the ultrasonic fine particle spraying. The concentration of Escherichia coli in mixing tank was decreased remarkably using ultrasonic spray nozzle dispersion compared to the conventional methods.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.10 no.2
• /
• pp.73-82
• /
• 1998

In order to simulate surface discharged heat dispersion in costal area, a 2-dimensional Eulerian-Lagrangian model for far field and semi-active particle tracking random walk model in near field has been combined. The mass of discharged heat water in near field has treated as particles with buoyancy and this is eventually converted to horizontal additive dispersion in random walk equations. This model is applied to both a simplified coastal geometry and a real site. In simple application it can simulate plume-like characteristics around discharging point than a near field-model, CORMIX/3. Actual application in the Chonsu Bay shows farther spreading of heat water in near field comparing the observed data, and this shows that the developed model might be applied with satisfaction.

• Water for future
• /
• v.29 no.4
• /
• pp.187-198
• /
• 1996

A numerical model for unsteady dispersion of horizontal line source in turbulent shear flow is developed. A fractional step finite difference method is used which splits the unsteady two-dimensional advective diffusion equation into the longitudinal advection and the vertical diffusion equations, and solves them alternately for half time intervals by the Holly-Preissmann scheme and the Crank-Nicholson scheme, respectively. The developed numerical model is verified using a semi-analytic solution for steady dispersion in turbulent shear flow. Dispersion of an instantaneous plane source in turbulent shear flow is analyzed using the model. The degree of mixing at the same dimensionless time is almost the same regardless of the friction factor, and the travel distance required to reach a certain degree of mixing is inversely proportional to the square root of the friction factor.