• Journal of Advanced Marine Engineering and Technology
• /
• 제33권1호
• /
• pp.37-43
• /
• 2009

This paper is performed to develop a tripple-tube exchanger which can improve the system efficiency. Three different tube diameters are compacted by one body(tripple-tube) to recover waste heat from heat exchanging among the fluids. With this, the tripple-tube shows higher cooling capacity than the double-tube after comparing between those two systems. The results of this paper are basic data to design the optimum tripple-tube heat exchanger.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2003년도 학술.기술논문 발표회
• /
• pp.77-82
• /
• 2003

The purpose of this study is development of technique to use cementitious powder as recycle cement produced from deteriorated Concrete waste which has a large quantity of calcium carbonate. Therefore, after having theoretical consideration based on the properties of high-heated concrete and concerning about neutralization of Concrete, we analysis chemical properties of ingredients of cementitious powder. After making origin cement paste, then processing the accelarated carbonation, we consider the properties of hydration and chemical properties of cementitious powder under various temperature conditions. As a result of the thermal analysis, the CaCo3 content of cementitious powder would affect decision of heat temperature to recover its hydrated ability because CaCo3 content is increased when neutralization is progressed. And as a result of XRD analysis, in case of origin powder of non-neutralized paste, CaO peak is found at 700℃. but, heat temperature to generate CaO would increase when the content of neutralized ingredients is increased. Finally, recycle cement heated at 700℃ shows the best compressive strength when the content of neutralized ingredients in recycle cement is less then 50%. However, it would be quite difficult to manage quality of recycle cement according to recycling points of various concrete waste.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2003년도 학술.기술논문발표회
• /
• pp.77-82
• /
• 2003

The purpose of this study is development of technique to use cementitious powder as recycle cement produced from deteriorated Concrete waste which has a large quantity of calcium carbonate. Therefore, after having theoretical consideration based on the properties of hish-heated concrete and concerning about neutralization of Concrete, we analysis chemical properties of ingredients of cementitious powder After making origin cement paste, then processing the accelerated carbonation, we consider the properties of hydration and chemical properties of cementitious powder under various temperature conditions As a result of the thermal analysis, the CacO3 content of cementitious powder would affect decision of heat temperature to recover its hydrated ability because CacO3 content is increased when neutraliTation is preBlessed. And as a result of XRD analysis. in case of origin powder of non-neutralized paste, CaO peak is found at $700^{\circ}C$. but, heat temperature to generate CaO would increase when the content of neutralized ingredients is increased. Finally, recycle cement heated at $700^{\circ}C$ shows the best compressive strength when the content of neutralized ingredients in recycle cement is less then 50%. However, it would be quite difficult to manage quality of recycle cement according to recycling points of various concrete waste.

• 설비공학논문집
• /
• 제30권2호
• /
• pp.100-106
• /
• 2018

Recently, the development of a heat pump technology to recover process waste heat and to generate steam of $120^{\circ}C$ or higher required for industrial processes, has attracted attention. The research of conventional heat pump utilizing the available energy is used primarily for air conditioning, and the production temperature is about $60^{\circ}C$, so it is difficult to utilize it for industrial use. Therefore, in this study, we developed a steam heat pump (SGHP) which recovers the waste heat of process and generates steam at $120^{\circ}C$. The low-pressure refrigerant R245fa, considered to be an eco-friendly refrigerant, has been selected as the refrigerant for SGHP in this study since its Ozone Depletion Potential (ODP) is zero and the Global Warming Potential (GWP) is relatively low. A flash tank functioning as a phase separator was installed in the rear stage of the condenser, and the saturated water of high temperature was decompressed to generate steam. It was started at the initial temperature of $70^{\circ}C$, and it was confirmed that $120^{\circ}C$ steam was produced after the system stabilized. We have conducted experiments by modifying the system, and ultimately achieved a heating capacity of 101.4 kW and a COP of 3.05.

• 한국자동차공학회논문집
• /
• 제21권6호
• /
• pp.81-91
• /
• 2013

A novel design process of a parallel multi-flow type air-cooled condenser of a dual-loop waste heat recovery system with Rankine steam cycles for improving the fuel efficiency of gasoline automobiles has been investigated focusing on reduction of the pressure drop inside the micro-tubes. The low temperature condenser plays a role to dissipate heat from the system by condensing the low temperature loop working fluid sufficiently. However, the refrigerant has low evaporation temperature enough to recover the waste from engine coolant of about $100^{\circ}C$ but has small saturation enthalpy so that excessive mass flow rate of the LT working fluid, e.g., over 150 g/s, causes enormously large pressure drop of the working fluid to maintain the heat dissipation performance of more than 20 kW. This paper has dealt with the scheme to design the low temperature condenser that has reduced pressure drop while ensuring the required thermal performance. The number of pass, the arrangement of the tubes of each pass, and the positions of the inlet and outlet ports on the header are most critical parameters affecting the flow uniformity through all the tubes of the condenser. For the purpose of the performance predictions and the parametric study for the LT condenser, we have developed a 1-dimensional user-friendly performance prediction program that calculates feasibly the phase change of the working fluid in the tubes. An example is presented through the proposed design process and compared with an experiment.

• 대한기계학회논문집B
• /
• 제36권9호
• /
• pp.937-944
• /
• 2012

선박의 주 추진용 디젤엔진에서 배출되는 배기가스의 폐열을 회수하는 발전시스템에 대하여, 작동유체로서 물이 적용된 3 변 사이클에 대한 열역학적 특성을 이론적으로 조사하였다. 그 결과로, 하나의 열원이 주어지면, 에너지 및 엑서지 효율은 터빈입구에서 작동유체에 대한 압력 및 온도의 특정한 조건에 의하여 최대화될 수 있었다. 그러한 조건에 대하여 응축온도의 증가에 따라, 터빈의 체적 팽창비를 적절하게 감소시킬 수 있었는데, 열원의 엑서지 손실률 및 응축기에서 엑서지 파괴율이 크게 증가되었다. 따라서, 상부 사이클에서 버려지는 엑서지를 회수하기 위하여, 저온 열원에 적합한 유기랭킨사이클을 하부 사이클로 적용하는 복합 사이클이 유용할 수 있다.

• 생물환경조절학회지
• /
• 제21권4호
• /
• pp.372-378
• /
• 2012

본 연구에서는 화력발전소에서 온배수의 형태로 배출되는 폐열을 히트펌프의 열원으로 이용하여 온실의 난방에 활용할 수 있는 히트펌프 시스템을 설계 제작하였으며, 난방 성능을 분석하여 PE 파이프 열교환기의 설계기준을 제시하고자 하였다. PE 파이프 열교환기의 내경은 20mm, 두께는 2mm였으며, Roll의 직경은 1,000mm로 하였다. 연구결과 PE파이프 열교환기의 적정 길이는 1.0RT당 75m로 설계하는 것이 바람직할 것으로 판단되었으며, 이때 히트펌프시스템의 난방성능계수(COPh)는 3.8로 나타났다.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제9권4호
• /
• pp.17-26
• /
• 2001

Simulation was conducted using TRNSYS to evaluate the thermal performance of a facility. This facility has a condensing-type heat exchanger which is able to recover the latent energy for the purpose of reducing the heating energy in winter. The boiler and chiller are selected based on the annual peak loads and controlled to maintain the facility at the set temperature of 14~$17^\circ{C}$. Supplied energy by the boiler and recovered energy by the heat exchanger were calculated as a function of number of pass through heat exchanger, kind of fuel and hot water velocity. Simulation results show that about 20% of the total heating load can be recovered by the heat exchanger and the amount of latent heat is increasing with the number of pass. This means that the efficiency of the waste energy recovery system can be increased by using a condensing-type heat exchanger rather than a traditional sensible heat exchanger.

• 자원리싸이클링
• /
• 제33권3호
• /
• pp.21-29
• /
• 2024

전 세계적으로 탄소 중립 전략에 따른 탈탄소화와 관련하여 전기자동차의 수요가 급증하고 있다. 전기자동차의 주요 부품인 리튬이온 배터리의 수요 또한 급증하게 되었고, 이는 폐배터리의 발생으로 이어진다. 이에 폐배터리를 재활용하여 유가 금속을 회수하기 위한 연구가 수행되고 있으며, 본 연구에서는 폐LFP 배터리의 양극재로부터 리튬을 선택적으로 선침출 및 회수하고자 하였다. 양극재 분말 내 포함된 바인더를 제거하여 반응 표면적 증대 및 반응성을 높이기 위하여 대기 및 질소 분위기 그리고 다양한 온도 범위에서 열처리하였고, 이후 기계화학적(Mechanochemical) 공정을 통하여 수침출 하였다. 먼저, 열처리 후 분말을 과황산나트륨(Na₂S₂O₈)과 기계화학적 반응을 이용하여 가용성 리튬화합물로 전환하였고, 이후 증류수를 이용하여 수침출 하였다. 본 연구에서 열처리를 통한 양극재 분말의 특성 변화를 확인하였고, 최종 질소 분위기에서 열처리하여 모든 온도 범위에서 리튬의 침출율은 약 100%로 선침출할 수 있었다.

• 한국산학기술학회논문지
• /
• 제22권4호
• /
• pp.56-66
• /
• 2021

본 연구에서는 가축분뇨 처리시설의 호기성 액비화 과정에서 발생하는 열을 회수하기 위한 폐열회수 시스템을 고안하여 시스템을 구성하는 요소 장치의 성능을 분석하였다. 또한, 회수된 열의 활용 가능성을 확인하였다. 실험 설정을 위해 가축분뇨 처리시설의 액비 발효조에서 발생하는 발효열을 확인하였다. 호기성 액비화를 위한 발효조의 온도가 균일성을 나타낸 특성과 34.5 ~ 43.9 ℃의 범위에서 운영되는 점을 고려하여 실험 온도 수준을 35, 40, 45 ℃로 설정하였다. PE 및 STS 파이프로 구성된 복합열교환기는 53.5, 65.6, 74.4 MJ/h 열에너지를 회수하고, 5 RT 용량의 히트펌프는 95.6, 96.1, 98.9 MJ/h 열에너지를 축열 하였으며, 이때 히트펌프의 난방성능계수는 4.53, 4.62, 4.65이었다. 발효조의 온도를 45 ℃로 가정한 열교환기의 최대 온수 생산능력을 급탕량 산정 방법으로 비교했을 때 56 360 kcal/day의 에너지 공급량을 확인하였다. 축열조와 연계된 FCU의 온풍 난방능력은 20.8 MJ/h, 에너지 이용효율은 96.1 %였다. FCU의 온풍으로 퇴비를 건조하였을 때 초기함수율 50.5 %에서 건조 후 함수율 45.8 %로 4.7 % 감소함을 확인할 수 있었다.