• Geotechnical Engineering
• /
• v.4 no.2
• /
• pp.25-32
• /
• 1988

This paper first presents the distributions of static lateral earth pressure in case of translational o.all movement (ATRA) , obtained respectively by the Dubrova method and by the method where Chang's idea is applied to the former, acting on the rigid retaining vertical wall with horizontal sand backfill. Total active resultant forces and the points of application of those forces, calculated results by the two methods, are compared with the experimental results recently published by Fang Y.S. and Ishibashi I. A comparative study about the distribution of static lateral earth pressurein each case of rotation about top(AT) and base (AB), on which the writer studied previously, is also conducted along with the above experimental results. The following results are obtained 1) In case of AT and ATRA, the experimental results are in good agreement with the calculated results by the Dubrova's method. 2) In case of AB, the results of the Dubrova's method are very inconsistent with those of model test, where as th method 9.here Chang's idea is applied, corresponds well, even though there is a small deviation.

• Radiation Oncology Journal
• /
• v.31 no.3
• /
• pp.171-174
• /
• 2013

Sorafenib is a multi-targeted kinase inhibitor, which is the current standard treatment for advanced hepatocellular carcinoma (HCC). Only one case of radiation recall dermatitis (RRD) associated with sorafenib has been reported so far. Our patient with recurrent HCC was treated with palliative radiotherapy (RT) for the chest wall mass. Sorafenib at 400 mg twice daily was begun on the day following RT. On the 14th day post-RT, an erythematous patch was observed on right chest wall which matched area previously irradiated. It was consistent with RRD. Ten days later, a disseminated exanthematous rash and severe pruritus occurred. Sorafenib was stopped and an oral antihistamine was prescribed to relieve symptoms. At the 1-week follow-up after the cessation of sorafenib, all symptoms were resolved. Physicians should be alert to this recall phenomenon as it can occur both in the skin and elsewhere and the occurrence of RRD may be unpredictable.

• KIEAE Journal
• /
• v.8 no.1
• /
• pp.99-104
• /
• 2008

This study surveys the types of form works used for constructing composite basement walls found in domestic construction sites. Based on expert surveys, the research provides criteria for selecting a form work type and cost-benefit analysis for different types of form works. In selecting a form work type, safety was considered the most important factor. It is induced from the survey that a successful construction requires a form work type that could solidly bear the lateral pressure of concrete rather than other types that cut back the cost and shorten the construction period. In the cost-benefit analysis, the benefit was the highest in 'euro-form+soldier system', and the cost was most competent in 'rib-lath+soldier system'. In considering benefit and cost together, 'euro-form+soldier system' was judged to be the best option. This is likely to be attributed to the following reasons: site workers are familiar with euro-forms because it is the most widely used; and, soldier system is more reliable in bearing lateral pressure compared to steel pipes.

• Journal of the Korean Wood Science and Technology
• /
• v.11 no.1
• /
• pp.5-11
• /
• 1983

This paper aims at gaining the informations atout the fibril angle at secondary walls of tracheids. The test specimens were taken from disks on stem wood of "Pinus koraiensis Sieb. et zucc". The method of measuring the fibirl angle was selected so-called "iodine method" that crystalline aggregates of iodine may be induced to form within the elongated interstices of the cellulose matrix of the secondary wall and that these elongated crystals are oriented parallel to the long axies of the fibrills of cellulose. The following conclusions may be drawn from the results of this investigation. 1) Gross average fibril angle was about $17.6^{\circ}$ on stem wood. 2) Its values seem to be greater for earlywood (avg.$19.8^{\circ}$) than for latewood tracheids (avg.$15.3^{\circ}$) in normal wood. 3) According to the increase of annual ring from pith to barks the orientation of fibril angle seems to be decrease gradually in normal wood. 4) In the case of height variation in trees the sample trees have a tendency to increase the orientation fibril angle to the increase of tree height in stem.

• Progress in Medical Physics
• /
• v.3 no.2
• /
• pp.59-65
• /
• 1992

Carcimoma of the breast are first frequency malignancy in women in the world. third frequency in Korea. Radiation therapy in breast cancer were treated through opposed tangential fields with photon beam or electron beam. Density within the field and thickness to tumor are very importent factors determining dose distribution in radiation therapy of electron beam. Radiotherapy traetment planning using computed tomography in Breast cancer are able to ideal dose distribution. Authors concluded as following. 6MeV energy of electron beam propered below 1.5cm in chest wall's thickness or internal mammary lymphnode's depth. 9MeV energy of electron beam from 1.5cm to 2.0cm. 12 MeV energy of electron beam from 2.0cm to 2.5cm.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.9 no.1
• /
• pp.77-99
• /
• 2017

Offshore oscillating water columns (OWC) represent one of the most promising forms of wave energy converters. The hydrodynamic performance of such converters heavily depends on their interactions with ocean waves; therefore, understanding these interactions is essential. In this paper, a fully nonlinear 2D computational fluid dynamics (CFD) model based on RANS equations and VOF surface capturing scheme is implemented to carry out wave energy balance analyses for an offshore OWC. The numerical model is well validated against published physical measurements including; chamber differential air pressure, chamber water level oscillation and vertical velocity, overall wave energy extraction efficiency, reflected and transmitted waves, velocity and vorticity fields (PIV measurements). Following the successful validation work, an extensive campaign of numerical tests is performed to quantify the relevance of three design parameters, namely incoming wavelength, wave height and turbine damping to the device hydrodynamic performance and wave energy conversion process. All of the three investigated parameters show important effects on the wave-pneumatic energy conversion chain. In addition, the flow field around the chamber's front wall indicates areas of energy losses by stronger vortices generation than the rear wall.

• Restorative Dentistry and Endodontics
• /
• v.26 no.1
• /
• pp.64-76
• /
• 2001

Despite the improvements in bond strengths of dentin adhesives and resin-modified glass ionomers, the marginal seal of cervical restorations remains a concern. Microleakage at poorly sealed margins can result in staining, post-operative sensitivity, pulpal irritation, and recurrent caries. The objective of this study was to evaluate the effect of surface penetrating sealant(SPS) on the microleakage of cervical restorations. 45 extracted human teeth were selected, and Class V preparations were prepared on the both buccal and lingual surface of the teeth to the following dimensions : 1.5mm axially, 3mm mesiodistally, and 3mm incisogingivally. After cervical restoration with composite resin, compomer, glass ionomer each restoration was treated as three methods: No Tx., Scotchbond Multipurpose Adhesive$^{\circledR}$, Fortify$^{\circledR}$. The sections were examined with a stereomicroscope to determine the extent of microleakage at enamel and dentin margins. The results of this study were as follows. 1. All groups showed some microleakage. 2. Gingival cavity wall with cementum margin showed significantly higher leakage value than occlusal cavity wall with enamel margin. 3. The group treated with SPS showed significantly lower leakage value than no treated group(p<0.05). But there is no difference between Fortify$^{\circledR}$ and Scotchbond Multipurpose adhesive$^{\circledR}$. The results of this study suggest that SPS are effective in reducing microleakage of class V restorations. But it is certain that some microleakage still occurred despite the application of SPS.

• Nuclear Engineering and Technology
• /
• v.45 no.4
• /
• pp.469-476
• /
• 2013

In a postulated severe core damage accident in a PHWR, multiple failures of core cooling systems may lead to the collapse of pressure tubes and calandria tubes, which may ultimately relocate inside the calandria vessel forming a terminal debris bed. The debris bed, which may reach high temperatures due to the decay heat, is cooled by the moderator in the calandria. With time, the moderator is evaporated and after some time, a hot dry debris bed is formed. The debris bed transfers heat to the calandria vault water which acts as the ultimate heat sink. However, the questions remain: how long would the vault water be an ultimate heat sink, and what would be the failure mode of the calandria vessel if the heat sink capability of the reactor vault water is lost? In the present study, a numerical analysis is performed to evaluate the thermal loads and the stresses in the calandria vessel following the above accident scenario. The heat transfer from the molten corium pool to the surrounding is assumed to be by a combination of radiation, conduction, and convection from the calandria vessel wall to the vault water. From the temperature distribution in the vessel wall, the transient thermal loads have been evaluated. The strain rate and the vessel failure have been evaluated for the above scenario.

• Journal of the Architectural Institute of Korea Planning & Design
• /
• v.35 no.10
• /
• pp.53-62
• /
• 2019

The purpose of this study is to analyze the way historical heritage was dealt with during the massive urban development period of the 1960s through the case of Deoksugung Palace. The wall of Deoksugung Palace was rebuilt and relocated in 1961. Later, it was rebuilt and relocated again in 1968, and Daehanmun Gate was soon moved back too. I analyzed the opinions of the Seoul Metropolitan Government, the Cultural Heritage Committee, experts and citizens that occurred during this process and reached the following conclusion. First, in 1961, the existing stone walls of Deoksugung Palace were rebuilt rather than restored and conserved for the urbanscape at the time. Second, in the 1960s, the Cultural Heritage Committee focused on the conservation of the origin of Daehanmun Gate, while citizens valued the overall harmony and function of Deoksugung Palace. Third, unlike the 1970s project led by the president to renovate national security and national defense sites, there was a call from citizens to realize the preservation of Deoksugung Palace.

• Journal of the Architectural Institute of Korea Planning & Design
• /
• v.35 no.11
• /
• pp.109-116
• /
• 2019

Seongbuk Village and Ungcheon Village are Town Wall Villages that reflect social and historical backgrounds. villagers have formed villages based on community life. The streets and places of the villages are accumulated as images in the memory of the inhabitants. Based on their imagination-concept, 30 sketch maps, reflecting residents' cognitive perception were collected. Analysis of 30 sketch maps shows that other forming of Collective maps. In the past, Villages historical facilities had changed roles, but the relationship between the place and the place has been continuous, and according to the development process of the villages, the relationship between streets and places has been formed. Following this, the analysis methodology of social spaces and sketch will be examined in depth.