• The Journal of the Acoustical Society of Korea
• /
• v.34 no.3
• /
• pp.192-199
• /
• 2015

There is a gap between the inner wall of a pulse tube and an underwater acoustic material when the measurement for transmission loss by the pulse tube is carried out. In this paper, the effect, which is caused by the gap, for the measurement of transmission loss is analyzed. Transmission coefficient is derived from the ratio of the pressures between front and rear of the gap. Then, transmission loss for specimen with a gap is obtained by combining the transmission coefficients of the gap and specimen. The results of experiment and simulation for a specimen of stainless steel with 10 mm thickness are compared in order to evaluate the simulation model. Finally, simulations with respect to the gap size and transmission loss of a specimen are performed to analyze and evaluate the effect of the gap in measurement of transmission loss.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.42 no.2
• /
• pp.23-28
• /
• 2005

This study was to suggest the propagation path loss and predictive model of propagation path analysis in order to apply the frequency in the millimeter-wave band to the real time inter-vehicle communication system. This study was to suppose the case of inter-vehicle communication on the one-way two-lanes road in the big cites with a lot of traffic jams in order to analyze the effect by the reflected wave of multipath. As a simulation of suggested model, it found out that the propagation path by the reflected wave was about 0.1[m]$\sim$5.1[m] longer than the one by the direct wave during the transmission of 100[m] wave direct path. Also, as a result of comparing the propagation path loss, the loss would be about -0.8[dB]$\sim$-4.2[dB] larger in case of wall reflection and -0.8[dB]$\sim$-1[dB] vehicle reflection. From the result above, this researcher found out that the path loss of reflected wave produced by the walls was about -3.2[dB] larger than the path loss produced by the adjacent vehicles.

• Journal of Chest Surgery
• /
• v.18 no.4
• /
• pp.753-758
• /
• 1985

Hemorrhage is an important complication after operation with cardiopulmonary bypass and sometimes necessitates a further emergency operation. Between July, 1962 and June, 1985, reoperation for hemorrhage was carried out on 81 patients [3.1%] out of a total 2634 patients who had previously undergone cardiopulmonary bypass surgery at the Department of Thoracic and Cardiovascular Surgery, Yonsei University Medical Center. There were 38 males and 43 females, with an average age of 25 years [ranging 6 months to 60 years] and an average body weight of 38 kg [ranging 5 to 77 kg].There were 43 patients of cyanotic heart disease, 32 patients of acquired valvular heart disease, 4 patients of coronary artery occlusive disease, 2 patients of ascending aorta aneurysm and annuloaortic ectasia. The average amount of blood loss in the case of cyanotic heart disease was 71.7140ml/kg, in acyanotic heart disease 45.16.3ml/kg, in acquired heart disease, 56.514.4ml/kg and in coronary artery occlusive disease, 50.618.7ml/kg during first post operative day. But there was no statistical difference [p>0.05]. The mean blood loss below 10 years old was 70.412.1 ml/kg. Those below 10 years old were believed to bleed more than any other group. But there was also no statistical difference [p>0.05]. Indications for reoperation were continued excessive blood loss [74%], cardiac tamponade or hypotension [23%] and radiological evidence of a large hematoma in the thorax and pericardium [2%]. Average bypass time was 2.10.1 hours [ranging 30 minutes to 5 hours]. The interval between operation and reoperation was as follows; less than 12 hours in 49 patients [60%], 12 to 24 hours in 20 patients [25%], 24 to 48 hours in 8 patients [10%], more than 48 hours in 4 patients [5%]. The commonest sites for bleeding were chest wall [36%], heart [34%], aorta [12%], pericardium [6%], thymus [5%] and others [6%]. But no definite source was found in ll patients [31%]. Twenty seven out of 81 patients [31%] had wound problems and 5 patients [6%] were expired. [Mean SEM]. In conclusion, in order to decrease the amount of blood loss after open heart surgery with cardiopulmonary bypass, shortening of bypass time and bleeding control at the wire suture site during chest wall closure were important. If the amount of blood loss was over 45 ml/kg or 8 m/kg/hour, reoperation should be considered as soon as possible. After operating, careful wound dressings were applied to prevent wound problems.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.28 no.2
• /
• pp.191-198
• /
• 2008

Flow accelerated corrosion (FAC) phenomenon of low alloy carbon steels in nuclear power plant has been known as one of major degradation mechanisms. It has a potential to cause nuclear pipe rupture accident which may directly impact on the plant reliability and safety. Recently, the equipotential switching direct current potential drop (ES-DCPD) method has been developed, by the present authors, as a method to monitor wall loss in a piping. This method can rapidly monitor the thinning of piping, utilizing either the wide range monitoring (WiRM) or the narrow range monitoring (NaRM) technique. WiRM is a method to monitor wide range of straight piping, whereas NaRM focuses significantly on a narrow range such as an elbow. WiRM and NaRM can improve the reliability of the current FAC screening method that is based on computer modeling on fluid flow conditions. In this paper, the measurements by ES-DCPD are performed with signal sensitivity analyses in the laboratory environment for extended period and showed the viability of ES-DCPD for real plant applications.

• Korean Journal of Agricultural Science
• /
• v.37 no.2
• /
• pp.209-216
• /
• 2010

In order to understand the effects of a single or combined treatments of 1-MCP($1{\mu}L/L$) and $CO_2$(100%) on the firmness of melting type peach fruit(cv. Chunjungdo), fruit were harvested at commercial maturity and examined physiological changes including flesh firmness during 10 days of shelf-life. Firmness loss of fruit was delayed by both single and combined treatments of 1-MCP and $CO_2$. The treatment of 1-MCP was more effective than $CO_2$ treatment but no additive effective on firmness retention was found in the combined treatment. The upsurge of ethylene evolution occurred 5 days of shelf-life in air treated control but ethylene evolution gradually increased in fruit treated by 1-MCP and 1-MCP+$CO_2$. The suppression of ethylene evolution seemed stronger in $CO_2$ treatment. The respiration of fruit significantly inhibited up to 10 days except control where climacteric increase of respiration was found at 10 days of shelf-life. A molecular shift of pectic polymers(an increase of chelator soluble pectins and decrease of water soluble pectins) was induced by both 1-MCP and $CO_2$ treatments. An increase of water soluble pectins was coincident with firmness loss. The delay of firmness loss seemed to be associated with the migration of calcium to wall matrix, especially pectins, resulting in the increase of wall bound calcium. The polygalacturonase activity was significantly reduced by 1-MCP alone 1 day after treatment and increased to similar level of activity 5 days after treatment compared to other treatment except air treated control whereas pectin methylesterase activity seemed not to be affected by both 1-MCP and $CO_2$ treatments. Thus, the molecular shift of pectic polymers appeared not to be related with pectin methylesterase. Further study is required to clarify the softening mechanism associated with molecular shift of pectic polymers and the inter- or intra-cellular movement of calcium ions induced by postharvest treatments of 1-MCP and $CO_2$.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.55 no.6
• /
• pp.145-154
• /
• 2013

Recently, damage occurrence by wind erosion has been increasing in society. In times past, such problems only took place in desert area ; however, in recent years, the wind erosion problem is spreading out to agricultural land. Wind erosion in agricultural land can cause loss of loam soils, the disturbance of the photosynthesis of the crop fields and serious economic losses. To overcome the mentioned problems, installation of windbreak fence can be recommended which function as disturbing strong wind and wind erosion. However, there is still no proper guideline to install the windbreak fence and the installation used to rely on the intuition of the workers due to the lack of related studies. Therefore, this study measured the aerodynamic resistance of screens of the windbreak fence using the apparatus for testing screens. The apparatus for testing screens was designed to measure pressure loss around the screen. Measured pressure loss by wall friction compensated for pressure loss to calculate the aerodynamic resistance of screens. The result of pressure loss by regression analysis derived the aerodynamic coefficient of Darcy-Forchheimer equation and power law equation. The aerodynamic resistance was constant regardless of the overlapped shape when the screen was overlapped into several layers. Increasing the number of layers of the screen, internal resistance increased significantly more, and pressure loss caused by the screen also increased linearly when the wind speed was certain conditions, but permeability had no tendency. In the future, the results of this study will be applied to the computational fluid dynamics simulation. The simulation models will be also validated in advance by wind tunnel experiments. It will provide standard of a design for constructing windbreak fence.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.7
• /
• pp.1465-1472
• /
• 2009

The effect of heat loss rate on NOx formation of $CH_4/air$premixed flame were examined numerically in a perfectly stirred reactor. The following conclusions were drawn. Under the adiabatic wall condition, an increase in the residence time causes a remarkable increases in NOx emission. Under the heat loss conditions, however, NOx decreases significantly as the heat transfer coefficient and residence time increase. As the heat loss rate increases, Thermal NO mechanism and Re-burning NO mechanism play an important role in the NOx reduction, but Prompt NO mechanism and $N_2O$-intermediate NO mechanism lead to the increase in NOx production. Although the NOx formation is actually related to complex NOx mechanism with the changes in the heat transfer coefficient and residence time, it was found that NOx concentration can be represented by independent Thermal NO mechanism. From these results, new NOx correlation combined with the heat loss rate and residence time was suggested for predicting the NOx concentration in a practical $CH_4/air$premixed combustor.

• Transactions of the Korean hydrogen and new energy society
• /
• v.16 no.3
• /
• pp.284-289
• /
• 2005

Thermal analysis of cryogenic-capable vessels with insulations have been carried out to store liquid hydrogen($LH_2$). The combined insulations of MLI(Multi-Layer Insulation) and VCS(Vapor-Cooled Shield) under high vacuum are considered in the analysis for various volumes of vessels. Vapor-Cooled Shields(VCS) are installed at cylinder wall as well as disc side of the $LH_2$ vessels. The results indicate that optimal distribution of boiloff vapor from $LH_2$ vessel into two sides of VCS exists based on the evaporation loss. As the volume of $LH_2$ vessel is increased, mass flow rate of boiloff is increased while the evaporation loss per unit volume is decreased.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 2000.06a
• /
• pp.106-113
• /
• 2000

A pump which is a fundamental device in a hydraulic system affects on overall system performance to a great deal. Such problems as leakage and solid friction loss become important in field applications, especially for the case of operation under high pressure and at high speed. So the research on this kind of subjects is necessary to improve the performance of hydraulic devices. A high pressure radial piston pump is analyzed here, which has a stationary cylinder block. It pumps hydraulic fluid by letting camring push a piston in a cylinder. Fluid leaks between the piston and cylinder so that it deteriorates the pump efficiency. Furthermore, the piston happens to touch the cylinder wall to increase the friction loss and wear. In this research, by means of FDM, volumetric, mechanical and overall efficiencies are observed by varying several design Parameters and operation conditions. Design values or their trends are presented to improve these efficiencies.

• Journal of Mechanical Science and Technology
• /
• v.18 no.8
• /
• pp.1428-1434
• /
• 2004

This paper presents the mean streamline analysis using the empirical loss correlations for performance prediction of cross-flow fans. Comparison of overall performance predictions with test data of a cross-flow fan system with a simplified vortex wall scroll casing and with the published experimental characteristics for a cross-flow fan has been carried out to demonstrate the accuracy of the proposed method. Predicted performance curves by the present mean streamline analysis agree well with experimental data for two different cross-flow fans over the normal operating conditions. The prediction method presented herein can be used efficiently as a tool for the preliminary design and performance analysis of general-purpose cross-flow fans.