• 대한기계학회논문집
• /
• 제18권9호
• /
• pp.2454-2462
• /
• 1994

The effects of thermal stratification on the flow of a stratified fluid past a heated circular cylinder were examined in a wind tunnel. Turbulent intensities, rms values of temperature and turbulent convective heat flux distributions in the heated cylinder wake with and without thermal stratification were measured by using a hot-wire and cold-wire combination probe. A phase averaging method was also used to estimated coherent motion in the near wake. It is found that the vertical turbulent motion in the stably stratified flow case dissipates faster than that of the neutral case, i.e., vertical growth of vortical structure is suppressed under the strongly stratified condition. The coherent motion of temperature makes a large contribution like velocity coherent motion. However, the coherent motions of temperature fluctuation become very different with the change of experimental conditions, though the velocity coherent motions are quite similar in all experimental conditions.

• 에너지공학
• /
• 제14권1호
• /
• pp.30-36
• /
• 2005

본 논문에서는 실린더 후류 영역의 열전달 특성에 대한 실험결과를 보고하였다. 정체점(θ=0°)로부터 실린더 뒷면(θ=180°)까지 국소 열전달을 측정하였으며, 축 방향에 대한 누셀트 수의 변화도 조사하였다. 덕트 중앙에 비하여 덕트 벽면근처의 후류영역 열전달계수는 58% 정도 높게 측정되었으며, 종횡비와 열전달 경계조건의 영향도 조사하였다.

• Ocean Systems Engineering
• /
• 제10권3호
• /
• pp.289-316
• /
• 2020

In the present paper, the effect of the location of stern planes on the flow entering the submarine propeller is studied numerically. These planes are mounted on three longitudinal positions on the submarine stern. The results are presented considering the flow field characteristics such as non-dimensional pressure coefficient, effective drag and lift forces on the stern plane, and the wake flow formed at the rear of the submarine where the propeller is located. In the present study, the submarine is studied at fully immersed condition without considering the free surface effects. The numerical results are verified with the experimental data. It is concluded that as the number of planes installed at the end of the stern section along the submarine model increases, the average velocity, width of the wake flow and its turbulence intensity formed at the end of the submarine enhance. This leads to a reduction in the non-uniformity of the inlet flow to the propulsion system.

• 대한기계학회논문집B
• /
• 제28권5호
• /
• pp.553-559
• /
• 2004

Stratified flow past a three-dimensional obstacle such as a sphere has been a long-lasting subject of geophysical, environmental and engineering fluid dynamics. In order to investigate the effect of the stratification on the near wake, in particular, the unsteady vortex formation behind a sphere, numerical simulations of stratified flows past a sphere are conducted. The time-dependent Navier-Stokes equations are solved using a three-dimensional finite element method and a modified explicit time integration scheme. Laminar flow regime is considered, and linear stratification of density is assumed under Bossiness approximation. The computed results include the characteristics of the near wake and the unsteady vortex shedding. With a strong stratification, the separation on the sphere is suppressed and the wake structure behind the sphere becomes planar, resembling that behind a vertical cylinder.

• Wind and Structures
• /
• 제1권2호
• /
• pp.127-144
• /
• 1998

In this paper, the wake structures behind a square cylinder at the Reynolds number of 22,000 are simulated using the large eddy simulation, and the main features of the wake structure associated with unsteady vortex-shedding are investigated. The Smagorinsky model is used for parametrization of the subgrid scales. The finite element method with isoparametric linear elements is employed in the computations. Unsteady computations are performed using the explicit method with streamline upwind scheme for the advection term. The time integration incorporates a subcycling strategy. No-slip condition is enforced on the wall surface. A comparative study between two-and three-dimensional computations puts a stress on the three-dimensional effects in turbulent flow simulations. Simulated three-dimensional wake structures are compared with numerical and experimental results reported by other researchers. The results include time-averaged, phase-averaged flow fields and numerically visualized vortex-shedding pattern using streaklines. The results show that dynamics of the vortex-shedding phenomenon are numerically well reproduced using the present method of finite element implementation of large eddy simulation.

• 한국항공우주학회지
• /
• 제31권8호
• /
• pp.8-18
• /
• 2003

진동하는 에어포일의 근접후류에서의 레이놀즈수 효과를 조사하기 위한 실험적 연구가 수행되었다. NACA 4412에어포일은 1/4 시위 지점을 중심으로 조화적으로 피칭운동을 하고, 순간받음각은 +6$^{\circ}$에서 -6$^{\circ}$까지 진동되도록 하였다. 진동하는 에어포일의 근접후류에서의 난류강도를 측정하기 위하여 열선풍속계를 사용하였다. 본 연구에서 자유류의 속도는 3.4, 12.4, 26.2 m/s이다. 이러한 자유류 속도에 따른 시위 레이놀즈수는 $R_N=5.3{\times}10^4$, $1.9{\times}10^5$, $4.1{\times}10^5$이고, 무차원 진동수는 K=0.1이다. 레이놀즈수가 진동하는 에어포일의 근접후류에 미치는 영향을 나타내는 축방향 난류강도 분포를 제시하였다. 본 측정에서 모든 경우에 난류 강도는 $R_N=5.3{\times}10^4$인 경우에 아주 크고, $R_N=1.9{\times}10^5$과 $4.1{\times}10^5$인 경우에는 작다는 것을 관찰할 수 있었다. 진동하는 에어포일의 근접후류에서 레이놀즈수의 임계값은 층류분리인 경우, 분리가 발생하지 않거나 난류분리인 경우로 구분되며, 그 값은 $R_N=5.3{\times}10^4\;{\sim}\;1.9{\times}10^5$사이에 존재한다.

• Korean Chemical Engineering Research
• /
• 제48권3호
• /
• pp.359-364
• /
• 2010

직경이 0.152 m인 삼상슬러리 기포탑에서 연속 슬러리상 영역(${\varepsilon}_f$), 기포영역(${\varepsilon}_b$) 그리고 기포의 후면에서 기포와 같이 상승하는 소용돌이 영역인 wake 영역(${\varepsilon}_w$)의 세 종류의 기능영역을 분류하여 이들 각 영역의 체류량을 구하였다. 기포탑에서 기포영역과 wake 영역의 체류량은 전기저항 탐침법에 의해 결정하였다. 기체유속($U_G$)과 슬러리상에서 고체입자의 농도($S_c$)가 삼상슬러리 기포탑에서 각 기능영역의 체류량에 미치는 영향을 검토하였다. 슬러리 기포탑에서 기체유속이 증가하면 연속 슬러리상의 체류량은 감소하였으나, 기포와 wake의 체류량은 증가하였다. 슬러리상에서 고체입자의 농도가 증가함에 따라 연속 슬러리상 영역의 체류량은 증가하였으나, 기포와 wake 영역의 체류량은 감소하는 경향을 나타내었다. wake 영역의 체류량은 기포영역 체류량의 15~40% 정도를 나타났으며, 기체유속이 증가함에 따라 wake 영역의 기포영역에 대한 분율은 감소하였다. 본 연구의 범위에서 세 기능영역의 체류량은 각각 실험 변수의 상관식으로 나타낼 수 있었다.

• 대한기계학회논문집
• /
• 제19권5호
• /
• pp.1340-1350
• /
• 1995

The effects of thermal stratification on the flow past a heated circular cylinder with various heating rates were examined in a wind tunnel. Turbulent intensities, r.m.s.values of temperature and turbulent convective heat flux distributions in the cylinder wakes with and without thermal stratification were measured by using a hot-wire and cold-wire combination probe. The phase averaging method was also used to estimate coherent contributions to the turbulent flow field in the near wake. The results show that the scalar mixing process is very different according to the mean temperature fields especially in the upper part of the wake. The coherent structure of the temperature field makes a large contribution to the time mean value like velocity components. However, the coherency of the temperature fluctuation is very different with the change of mean temperature fields, though the velocity coherent motions are quite similar in all experimental conditions.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집B
• /
• pp.36-41
• /
• 2001

In order to simulate wake of stator and a gas turbine engine's balde row, acryl cylinder and a linear turbine cascade were used respectively in this study. Experimental of heat transfer distributions was done on the passage endwall and blade suction surface. Temperature distributions on the experimental regions were obtained through image processing system by using the cholesteric type liquid crystal which has chain structure of metyl$(CH_3)$. To represent the degree of heat transfer, dimensionless St number was used. The results show that heat transfer on the blade suction surface was increased due to the wake from the cylinder and was decreased as the distance between cylinder row and blade row increases. Because of groth of passage vortex, heat transfer distributions on the trailing edge area showed triangular shape which was little changed with wake. On the other hand, heat transfer on the passage endwall was decreased due to the wake from cylinder. As the distance between cylinder row and blade row increases, heat transfer was more decreased.

• Wind and Structures
• /
• 제29권2호
• /
• pp.139-147
• /
• 2019

One of the most important factors in tall buildings design in urban spaces is wind. The present study aims to investigate the aerodynamic behavior in the square and triangular footprint forms through aerodynamic modifications including rounded corners, chamfered corners and recessed corners in order to reduce the length of tall buildings wake region. The method used was similar to wind tunnel numerical simulation conducted on 16 building models through Autodesk Flow Design 2014 software. The findings revealed that in order to design tall 50 story buildings with a height of about 150 meters, the model in triangular footprint with aerodynamic modification of chamfered corner facing wind direction came out to have the best aerodynamic behavior comparing the other models. In comparison to the related reference model (i.e., the triangular footprint with sharp corners and no aerodynamic modification), it could reduce the length of the wake region about 50% in general. Also, the model with square footprint and aerodynamic modification of chamfered corner with the corner facing the wind could present favorable aerodynamic behavior comparing the other models of the same cluster. In comparison to the related reference model (i.e., the square footprint with sharp corners and no aerodynamic modification), it could decrease the wake region up to 30% lengthwise.