• Journal of Korean Society for Atmospheric Environment
• /
• v.30 no.4
• /
• pp.378-386
• /
• 2014

The use of bus stop in the center lane has reduced the emissions of exhaust gas on the road due to the improvement of the traffic speed but has caused a health problem for the citizens who are waiting for the bus in the platform, and thus the air pollution control of bus stop in the center lane is emerging as a more important part. This study was conducted to investigate the air pollution degree for the center lane-bus stops in four regions using mobile air measuring vehicle, and to evaluate the characteristics of air pollution by comparing with the data measured at the urban air monitoring site close to the bus stops. In addition, the correlation analysis was performed to analyze the impact to neighboring region by vehicle exhaust gas. The regional mean concentration of nitrogen dioxide in the center lane-bus stops ranged from 0.025 to 0.043 ppm which shows from 2.5 times to 5.3 times higher than the values of urban air monitoring site selected as a control group. The regional mean concentration of ozone in the center lane-bus stops ranged from 0.023 to 0.034 ppm which shows from 3% to 28% lower than the values of urban air monitoring site selected as a control group. The concentrations of nitrogen dioxide and ozone for the sampling regions did not exceed one hour-air quality environmental standard (0.1 ppm). The mean concentration of particulate matter for four center lane-bus stops was $28{\mu}g/m^3$ which shows about 27% higher than the values of urban air monitoring site selected as a control group, and that of particulate matter did not exceed one day-air quality environmental standard ($100{\mu}g/m^3$). In the results of correlation analysis between data from center lane-bus stops and data from urban air monitoring sites, the correlation coefficient (r) of nitrogen dioxide was relatively low as 0.316 to 0.416, and the correlation coefficient was high as the distance was close and vice versa. However, the correlation coefficient of ozone ranged from 0.167 to 0.658 and the correlation coefficient was high as the distance was far and vice versa.

• International Journal of Highway Engineering
• /
• v.11 no.3
• /
• pp.121-128
• /
• 2009

This study has proposed the signal operating system to use both semi-actuated signal control and pedestrian push-button as a way to make up for the problems of 3 leg intersections which are operated inefficiently in the signal operation, one of the methods of traffic operations. In case of the semi-actuated signal control, it can reduce delay inside the intersection by serving to uncongested traffic on the main road where there is not much traffic volume on the secondary road and push-button signal can reduce unnecessary waiting time it could happen to vehicles by operating it though there is no pedestrian. Quantitative analysis was tried regarding the average delay reduction per vehicle using VISSIM, microscopic simulation program regarding how much effect it has compared with the existing signal control system and semi-actuated signal control system when the above two advantages are collected. The field test was performed for one three-leg intersection of Incheon. According to respectively signal control method pedestrian traffic changed and executed a sensitivity analysis. The result which compares the average delay time per a vehicle of scenarios, the signal control method of using the pedestrian push-button system in comparison with the fixed signal control method showed to decrease effect of a minimum 3.7 second (10%), a maximum 5.8 second (16%). When the pedestrian traffic volume was 20% or less of the measurement traffic volume, The signal control method of using the pedestrian push-button system appeared to be more efficient the semi-actuated signal control with object intersection.

• Journal of Digital Convergence
• /
• v.14 no.11
• /
• pp.241-247
• /
• 2016

As a domestic traffic control signal system, either the system with which a traffic signal turns into green at regular intervals or the system with which an amber or a red signal flickers on local roads without heavy traffic at midnight has been utilized. However, when the former system is used for roads with light traffic at midnight, delays and congestion can be incurred. Besides, in case of the latter signal system, the risk of vehicle crash is high. This study proposes a response type of flickering green signal system that rearranges signal system after analyzing beacon messages including sensor data. The proposed system, on a trunk road or a branch road at midnight, makes the signal keep flickering in green; When a vehicle enters the range of RSE, the transfer coverage, it transmits beacon messages regularly and Agent System analyzes the messages and alters the signal. It is a system by which vehicles move following the altered signal system, which will not only ensure smooth flow but also prevent vehicles from crashing on a road with light traffic. As a result of a simulation, traffic throughput and the average waiting time displayed 10 to 30 percent better improvement than existing signal systems, in terms of performance.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.22 no.1
• /
• pp.276-290
• /
• 2023

Several efforts in Korea are currently underway with the goal of commercializing autonomous vehicles. Hence, various studies are emerging on autonomous vehicles that drive safely and quickly according to operating guidelines. The current study examines the path search of an autonomous vehicle from a microscopic viewpoint and tries to prove the efficiency required by learning the lane change of an autonomous vehicle through Deep Q-Learning. A SUMO was used to achieve this purpose. The scenario was set to start with a random lane at the starting point and make a right turn through a lane change to the third lane at the destination. As a result of the study, the analysis was divided into simulation-based lane change and simulation-based lane change applied with Deep Q-Learning. The average traffic speed was improved by about 40% in the case of simulation with Deep Q-Learning applied, compared to the case without application, and the average waiting time was reduced by about 2 seconds and the average queue length by about 2.3 vehicles.

• Journal of Korean Society of Transportation
• /
• v.30 no.1
• /
• pp.149-159
• /
• 2012

The evaluation of public transit service quality is more complicated than evaluating other aspects of transportation service. Although various measures of effectiveness [MOEs] for transit service have been studied and applied, a more comprehensive and accurate MOE is still required. In the past, either data from user surveys or the experience of bus agency administrators and/or engineers used to measure the quality of service. However, recently, with reliable and accurate real time data from BMS(Bus Management System) and BIS(Bus Information System), more reliable and accurate MOEs are available. This study develops a service evaluation model from users' perspectives, which is based on user' cost models that consider passenger access time, riding time, waiting time, and discomfort due to in-vehicle overcrowding, violation of traffic laws, and accident rate. For validating proposed model, data from the BMS and transit-fare cards (T-Money Card) for Seoul's No. 472 main bus line were used. Models developed in this study provided reliable results.

• Journal of Korean Society of Transportation
• /
• v.18 no.1
• /
• pp.47-59
• /
• 2000

The purpose of this study is to develop travel-time estimation model using neural networks and prediction model using neural networks and kalman-filtering technique. The data used in this study are travel speed collected from inductive loop vehicle detection systems(VDS) and travel time collected from the toll collection system (TCS) between Seoul and Osan toll Plaza on the Seoul-Pusan Expressway. Two models, one for travel-time estimation and the other for travel-time Prediction were developed. Application cases of each model were divided into two cases, so-called, a single-region and a multiple-region. because of the different characteristics of travel behavior shown on each region. For the evaluation of the travel time estimation and Prediction models, two Parameters. i.e. mode and mean were compared using five-minute interval data sets. The test results show that mode was superior to mean in representing the relationship between speed and travel time. It is, however shown that mean value gives better results in case of insufficient data. It should be noted that the estimation and the Prediction of travel times based on the VDS data have been improved by using neural networks, because the waiting time at exit toll gates can be included for the estimation of travel time based on the VDS data by considering differences between VDS and TCS travel time Patterns in the models. In conclusion, the results show that the developed models decrease estimation and prediction errors. As a result of comparing the developed model with the existing model using the observed data, the equality coefficients of the developed model was average 88% and the existing model was average 68%. Thus, the developed model was improved minimum 17% and maximum 23% rather then existing model .

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.5
• /
• pp.77-89
• /
• 2008

The bikes are conflicted with the cars and the pedestrian at the intersection and the road with the bike crossing. To establish the bike signal at this section is one method to solve this conflict. According to the survey for the bike road status and the biker's characters which are crossing the road at the intersection, the bike crossing are established with beside the pedestrian crossing and most of the bikers are crossing the street by the pedestrian signal. Also, the bike queue which is waiting the signal change at the stop line was cleared before the closing the pedestrian signal. Considering the result of this survey, TOUCAN crossing signal type in England for bike signal at the place where the bike crossing are established with beside the pedestrian crossing, in which bike rider and pedestrian can cross by the pedestrian signal operation, is suggested. However, at the place where the bike crossing is apart from the pedestrian crossing, the bike signal which is connected to the vehicle signal is suggested. All these types of bike signals can be accepted for the present bike crossing equipments and the biker's characters and be adapted to the police standard traffic signal controller by adjusting the signal time only without any function change.

• Journal of the Korean Professional Engineers Association
• /
• v.28 no.4
• /
• pp.54-75
• /
• 1995

This synthesis has been prepared from a review of literature on Truck Escape Ramps technology and a survey of current practice by state department of transportation. Their locations have been determined usually from a combination of accident experience and en-gineering judgement, but new tools are emerging that can identify needs and sites without waiting for catastrophic accidents to happen. The Grade Severity Rating Systems holds promise in this regard. Design Procedures for truck excape ramps continue to evolve. Gravel arrester beds are clearly the preferred choice across the country Rounded aggregate, uniformly graded in the approximate size range of 13 to 18mm. Tech-nical publications typically have dassified TER types as paved gravity, sandpile, and ar-rester bed ramps. The design speed for vehicle entry into the ramp in critical to the deter-mination of ramp length. An escape ramp should be designed for a minimum entry speed of 130km/hr, a 145km/hr design being preferred. The ramps should be straight and their angle to the roadway align-ment should be as possible. The grade of truck escape ramps show the adjustment of ramp design to local topography, such as the tradeoff of ramp length against earthwork requirements. A width of 9 to 12m would more safety acommodate two or more outof con-trol vehicles. Reguarding comments on the most effective material, most respondents cited their own specification or referred to single graded, rounded pea gravel. The consensus essentially Is that single graded, well -rounded gravel is the most desirable material for use in arrester beds. The arrester beds should be constructed with a minimum aggregate depth of 30cm. Successful ramps have used depths between 30 and 90cm.

• Korea Science and Art Forum
• /
• v.28
• /
• pp.105-116
• /
• 2017

This study is a basic research to suggest user-centered general hospital environmental design guidelines, which aims to analyze user's behavior characteristics across generation in general hospital. For this purpose, this study constructed an analysis tool through the literature review with regard to generation and behavior characteristics in general hospital. Besides, an online survey regarding user's behavior in general hospital was conducted targeting from 20s to 60s, 300 persons for each group, total 1,500 persons for about 3 weeks since September 1, 2016. The results of this study are as follows: (1) Based on the generation, there were significant differences in relevant categories of their visiting frequency, visiting purpose, visiting hour, transportation, companion, behavior during the wait and selection of a general hospital. (2) In all generation, they responded that they have visited once or twice per year. People in 20s and 30s responded that their visit for the hospital is to receive specific treatment, while other people in 40s, 50s and 60s visit the hospital majorly for routine check-ups. Therefore, it is imperative for a health check-up center to design an environmental plan that reflects the characteristics of elders in 40s, 50s and 60s. (3) People in 40s, 50s and 60s usually visit a general hospital in the mornings of weekdays, while generations in 20s and 30s responded that they mostly visit the hospital in the mornings of weekend. (4) When they visit a general hospital, people in their 20s are usually using public transportations, while people in their 30s to 60s are using their own vehicle. (5) People in their 20s majorly visited 'lobby'. In older generations, they tend to visit 'outpatient clinic'. Therefore, it is necessary to build an outpatient clinic environment that considers the elderly. (6) Patients majorly responded that they are using their cell phone, while waiting for their clinic call. In elder generations, they responded that they are more likely watching TVs, reading books/magazines or doing nothing. Therefore, it is essential to provide cell-phone related services and environmental supports. Visually attractive media can be utilized for this purpose.