• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.7
• /
• pp.966-979
• /
• 1998

Thermodynamic and dynamic analysis has been conducted to investigate performance variations induced by substitution of alternative refrigerants, HFC134a or HC600a for CFC12 in hermetic reciprocating compressors. For the thermodynamic analysis, mass and energy conservation laws are applied to the cylinder volume and Helmholtz resonator modeling method is adopted to describe gas pulsations at suction and discharge system. The modeling of the dynamics of the compressor mechanism has been performed with lumped mass method to analyse the bearing loads and friction losses at each bearing. To verify the correctness of this analysis, results of the performance simulation have been compared to those of calorimetric measurrements of compressor operating with CFC12. Analysis of the various losses, noise and reliability as well as performance has been conducted to present the design guideline for the compressor development with alternative refrigerants. It is found that compressors with alternative refrigerants, HFC 134a or HC600a give better COPs than those with CFC12 under the same operating conditions and especially, compressors with HC600a show better reliability and noise characteristics also.

• Journal of the Korean Ceramic Society
• /
• v.20 no.3
• /
• pp.236-242
• /
• 1983

The purpose of present study is to find the structures physical properties and their inter-relations in the system of (60-x) PbO.xMO.$40B_2O_3$ glasses where MO represents for ZnO and CdO. The experiments such as differential thermal analysis infrared spectral analysis X-ray diffraction analysis density and thermal expansion measurements have been done. From infrared spectral analysis the structural units of glasses and the corresponding crystallized glasses were com-posed of $BO_3$ triangles and $BO_4$ tetrahedra. These basic units found in $PbO-B_2O_3$ binary glass system did not charge even though the divalent metallic oxides were substituted for PbO. The structures of these ternary glasses were more coalescenced than $PbO-B_2O_3$ binary glass system. This fact was supported bydecrease in thermal expansion coeffici-ent and molar volume with substitution of divalent metallic oxide for PbO. Crystalline phases obtained from the heat treatment of the $PbO-ZnO-B_2O_3$ glasses were 4PbO.2ZnO.$5B_2O_3$ PbO.2ZnO.$B_2O_3$ and unknown phases.

• Journal of Magnetics
• /
• v.6 no.2
• /
• pp.57-60
• /
• 2001

Mechanically alloyed $TbCu_7 -type \;Sm_{12.5}Fe_{87.5-x}Ti_x$(x=0, 2.5, 5, 7.5),and their nitrides have been studied systematically by X-ray diffraction, A.C. initial susceptibility, and pulsed magnetization measurement. In this series, the volume expansion by nitriding is 5.6%~7.3%, and the increment of the Curie temperature is in the range of 21$0^{\circ}C$~35$0^{\circ}C$. With increasing Ti content, the remanence decreases linearly due to the substitution of non-magnetic Ti, and the coercivity decreases rapidly from 34.6 kA/cm (43.5 kOe) for $\chi$=0 to 14.3 kA/cm (18 kOe) for $\chi$=7.5. In the $Sm_{12.5}Fe_{87.5-x}Ti_xN_y$ series, the best magnetic properties were obtained from .7Ti7Ny series, the best magnetic properties were obtained from $Sm_{12.5}Fe_{87.5}N_y$($\chi$=0) with $_iH_c$=34.6 kA/cm (43.5 kOe), $B_r=0.75 \;T, \;and (BH)_{max}=113.8 kJ/m^3$(10.9 MGOe).

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2021.11a
• /
• pp.133-134
• /
• 2021

Limestone-calcined clay-Cement (LC3) concrete provides a solution for sustainability, durability, and profitability of concrete industry. This study shows experimental studies of the macro properties (residual compressive strength), the meso properties (mesoscopic images), and micro properties (thermogravimetric (TG) analysis, X-ray powder diffraction (XRD), FTIR spectra, Raman spectra, Mercury intrusion porosimetry, and SEM) of LC3 paste with various mixtures and at high elevated temperatures (20 ℃, 300 ℃, 550 ℃ and 900 ℃). We find (1) Regarding to macro properties, LC3 cementitious materials are at a disadvantage in compressive strength when the temperature is higher than 300 ℃. (2) Regarding to meso properties, when the temperature reached 550 ℃, all samples generated more meso cracks. (3) Regarding to micro properties, first, as the substitution amount increases, its CH content decreases significantly; second, at 900 ℃, for samples with calcined clay, a large amount of gehlenite crystalline phase was found; third, at elevated temperatures (20 ℃, 300 ℃, 550 ℃ and 900 ℃), there is a linear relationship between the residual compressive strength and the cumulative pore volume; fourth, at 900 ℃, a large amount of dicalcium silicate was generated, and damage cracks were more pronounced. The experimental results of this study are valuable of material design of fire resistance of LC3 concrete.

• Applied Chemistry for Engineering
• /
• v.34 no.5
• /
• pp.548-555
• /
• 2023

SAPO-34 catalysts were modified with polyethylene glycol (PEG) and Pb to improve their catalytic lifetime and selectivity for light olefins in the conversion of dimethyl ether to olefins (DTO). Hierarchical SAPO-34 catalysts and PbAPSO-34 catalysts were synthesized according to changes in the molecular weight of PEG (M.W. = 1000, 2000, 4000) and the molar ratio of Pb/Al (Pb/Al = 0.0015, 0.0025, 0.0035), respectively. By introducing PEG into the SAPO-34 catalyst crystals, an enhanced volume of mesopores and reduced acidity were observed, resulting in improved catalytic performance. Pb was successfully substituted into the SAPO-34 catalyst frameworks, and an increased BET surface area and concentration of acid sites in the PbAPSO-34 catalysts were observed. In particular, the concentrations of the weak acid sites, which induce a mild reaction, were increased compared with the concentrations of strong acid sites. Then, the P2000-Pb(25)APSO-34 catalyst was prepared by simultaneously utilizing the synthesis conditions for the P2000 SAPO-34 and Pb(25)APSO-34 catalysts. The P2000-Pb(25)APSO-34 catalyst showed the best catalytic lifetime (183 min based on DME conversion > 90%), with an approximately 62% improvement compared to that of the unmodified catalyst (113 min).

• Advances in concrete construction
• /
• v.16 no.5
• /
• pp.269-276
• /
• 2023

In order to study the effect of rubber particle size and admixture on the frost resistance of self-compacting concrete, three self-compacting concrete specimens with equal volume replacement of fine aggregate by rubber particles of different particle sizes were prepared, while conventional self-compacting concrete was made as a comparison specimen. The degradation law of rubber aggregate self-compacted concrete under freeze-thaw cycles was investigated by fast-freezing method test. The results show that the rubber aggregate has some influence on the mechanical properties and freeze-thaw durability of the self-compacting concrete. With the increase of rubber aggregate, the compressive strength of self-compacting concrete gradually decreases, and the smaller the rubber aggregate particle size is, the smaller the effect on the compressive strength of the matrix; rubber aggregate can improve the frost resistance of self-compacting concrete, and the smaller the rubber particle size is, the more obvious the effect on the improvement of the frost resistance of the matrix under the same dosage. Through the research of this paper, it is recommended to use 60~80 purpose rubber aggregate and the substitution rate of 10% is chosen as the best effect.

• Korean Journal of Mineralogy and Petrology
• /
• v.35 no.3
• /
• pp.345-353
• /
• 2022

This study aimed to fundamentally understand changes of cell parameters of cation-exchanged mordenites using high resolution X-ray powder diffraction for studies that immobilization of various heavy metal cation using synthesis mordenite (Na_6.6Al_6.6Si_41.4O₉₆·20.4H₂O, Na-MOR). As a results of measurement by Thermogravimetric analysis (TGA), it was confirmed that 19.4, 20.4 water molecules per unit cell were present in monovalent-cation substituted MOR (Cs-MOR, Na-MOR), and 21, 23.1, 23.2 water molecules per unit cell were present in divalent-cation substituted MOR (Pb-MOR, Sr-MOR, Cd-MOR). The space group of all the samples were identified as Cmcm belonging to the orthorhombic crystal system. Compared to Na-MOR, starting material, relative peak intensity of (110) and (200) is significantly changed after cation substitution whereas peak position is almost similar. Also, (220) peak that was not found in Na-MOR was clearly observed in Pb-, Cd- and Sr-exchanged MOR. Thus, it was estimated that changes of atomic distribution usually occurred on ab-plane while changes of cell parameters were little. Detailed changes in the cell parameters of cation-exchanged mordenites were derived from whole profile fitting method using the GSAS suite program. Changes in the axial lengths and unit cell volume of cation substitution showed different relationship depending on ionic radius and charge number. In case of monovalent-cation substituted MOR, the length of a-axis increases whereas the length of b- and c-axis decrease by absorbed cation radius. In the case of divalent-cation exchanged MOR, the length of a-axis usually decreases while the length of b- and c-axis increases by cation radius. It was confirmed that unit cell volume of monovalent and divalent cation substituted MORs had an independent tendency by cation radius.

• Food Science and Preservation
• /
• v.18 no.2
• /
• pp.131-142
• /
• 2011

The primary objective of this study is to investigate the quality properties of noodles added with germinated non-waxy (Saesalbori) and waxy (Saechalbori) barley flours at concentrations of 10%, 20% and 30% to wheat flour. The quality characteristics of the samples were assessed for color, cooking characteristics (water absorption, volume increase of noodles and turbidity of cooking water), texture profile analysis (TPA) and sensory evaluation. Regarding the cooking properties of the noodles, adding waxy barley flour did not affect cooking yield and volume increase significantly(p<0.05), but noodles added with germinated Saesalbori at level of 10% had the lowest values of cooking yield and volume increase. Adding both types of flour increased the turbidity of the noodle soups. There was a common downward trend in $L^*$ and $b^*$ values and upward trend in $a^*$ value when increasing the level of barley used progressively. Adding germinated Saechalbori decreased the hardness, springiness and gumminess of noodles but did not cause any change in cohesiveness significantly while adding germinated Saesalbori decreased all the TPA parameters of the samples. Furthermore, the sensory analysis results showed that cooked noodles with 10% added germinated barley had no significantly different overall acceptance from the control sample. 20% substitution still resulted in acceptable sensory qualities. However treatment with both the substituted flours up to 30% was shown to cause unpleasant sensory qualities of noodles.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.4
• /
• pp.626-631
• /
• 2019

The policy-making and technological development for the supply expansion of eco-friendly automobiles has been continuing, but the internal combustion engines still accounts for about 95%. Also, in order to meet the stricter emission regulations of internal combustion engines based on fossil fuels, the proportion of after-treatments for vehicles and (ocean going) vessels is gradually increasing. This study is a basic study for the post-Euro-VI exhaust response of CNG buses, and it is to investigate the basic characteristics according to Pd substitution transition metal effect, catalyst volume effect and space velocity. A catalysts was prepared and tested using a model gas reactor. The NGOC catalyst with 3Pd exhibited the highest catalytic activity with 22% at $300^{\circ}C$, 48% at $350^{\circ}C$ and about 75% at $500^{\circ}C$. 3Co NGOC containing 3wt% of transition metal was excellent in oxidation ability, and it was small in size of 2nm, and the degree of catalyst dispersion was improved and de-NO/CO conversion was high. The volume of the NGOC-LNT-SCR catalyst system was optimal in the combination of 1.5+0.5+0.5 with a total score of 165, considering $de-CH_4/NOx$ performance and catalyst cost. For SV $14,000h^{-1}$, the $CH_4$ reduction performance was the highest at about 20%, while the SV $56,000h^{-1}$ was the lowest at about 5%. If the space velocity is small, the flow velocity decreases and the time remaining in the catalyst volume become long, so that the harmful gas was reduced.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.34 no.9
• /
• pp.1427-1433
• /
• 2005

This study investigated the quality characteristics of sponge cakes with addition of corn starch. The corn starch was added with 0 (control), 10, 20, 30, and $40\%$ substitution ratios by weight per wheat flour, followed by measuring physical and sensory characteristics of product during storage Periods. Batter specific gravity decreased with increasing substitution levels while viscosity increased. The volume tended to increase according to the addition of corn starch. As storage progresses, hardness and chewiness increased in all treatments. $30\%$ treatments showed lower values, compared to other treatments throughout the storage period. Adhesivness increased as the amount of corn starch increased. The results of sensory evaluation showed that the overall acceptability of sponge cakes containing $20\%\;and\;30\%$ corn starch were higher than that of control without corn starch. Therefore, it can be suggested that of corn starch $30\%$ added to tile sponge cake for the quality improvement and functional element.