• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.10
• /
• pp.86-92
• /
• 2016

A high-capacity battery installed in a hybrid vehicle or electric vehicle is used to power, or as a power supply for, electric sub-assemblies. In order to use a high-capacity battery as a power supply for electric sub-assemblies, such as an electronic control unit or for lighting, radio, and navigation, there is a need for a DC converter that changes a high voltage of 240-400V to a low voltage of 12-14V, which is done with a low-voltage DC-DC converter (LDC). An LDC undergoes long-term aging so as to reduce latent defects in the production process. With regard to the usual aging method, an LDC is a DC-DC converter. So, a DC power supply is connected and used as input, and a programmable DC electronic load is the output. For stable operation, a product having a larger capacity by 10% (compared to an LDC) is used, and has a structure where electric power is dissipated into 100% heat. So, there is a problem with volume, based on the use of two pieces of equipment to test the LDC, and another problem based on the generation of heat in the programmable DC electronic load. Hence, this paper suggests a load test method as a way of recycling, where a significant portion of the electricity dissipated as heat in a load tester is returned as input. The method realizes savings of 80% or more in the electricity dissipated as heat through improvement in the efficiency of the recycling load tester.

• Korean Journal of Soil Science and Fertilizer
• /
• v.21 no.1
• /
• pp.49-54
• /
• 1988

The present experiment was conducted to investigate causes affecting the reduction of red pepper production in the continuous cultivation upland soil from 1985 to 1986 in Imsil Chonbuk Province. The results obstained are summarized as follows: 1. Area ratio of continuous cultivation 2 years was 12.7%, 3 years 6.8% and over 4 years 48.9%. 2. Soil hardness and volume of solid and liguid of red pepper continuous cultivation soil were higher than those of one year cultivation, while pH and content of organic matter of continuous cultivation soil were low. The exceeding optimum level of phosphorus and potassium appeared factors affecting and reduction of red pepper of continuous cultivation soil. 3. Microflora density in continuous cultivation soil was high but bacteria/fungi (B/F) and actinomycetes/fungi (A/F) ratio were low. 4. The density of soil nematodes in continuous cultivation soil were higher than that in one year cultivation soil, however, the steeper and better drainage soil lowered the density of nematodes. 5. Continuous cultivation over 4 years showed 14.3% of plants diseased by phytophthora while 0.7% in one year cultivation soil.

• Korean Journal of Food Science and Technology
• /
• v.51 no.2
• /
• pp.127-132
• /
• 2019

This study investigated the quality of Jeungpyun based on variety, milling method and fermentation time. Rice flour (wet-milled Samkwang and dry-milled Seolgaeng) was used for these experiments. The expansion ratios of wet-milled Samkwang and dry-milled Seolgaeng after 6 h of fermentation showed similar values of 160.66 and 159.52%, respectively, while the specific volume was found to be 1.12 mL/g for both. Hardness values of 475.57 g in dry-milled Seolgaeng and 550.40 g in wet-milled Samkwang were determined to be the lowest values after 6 h of fermentation. Numerous pores were found in wet-milled Samkwang, whereas large-sized pores were found in dry-milled Seolgaeng. Thus, these results show no significant difference between the quality of Jeungpyun produced using dry-milled Seolgaeng or wet-milled Samkwang rice flours. However, dry- milled Seolgaeng without the wet-milled process is considered more suitable for Jeungpyun production.

• Tunnel and Underground Space
• /
• v.29 no.4
• /
• pp.262-279
• /
• 2019

In the engineering barriers of high-level radioactive waste disposal, gases could be generated through a number of processes. If the gas production rate exceeds the gas diffusion rate, the pressure of the gas increases and gases could migrate through the bentonite buffer. Because people and the environment can be exposed to radioactivity, it is very important to clarify gas migration in terms of long-term integrity of the engineered barrier system. In particular, it is necessary to identify the hydro-mechanical mechanism for the dilation flow, which is a very important gas flow phenomenon only in medium containing large amounts of clay materials such as bentonite buffer, and to develop and validate new numerical approach for the quantitative evaluation of the gas migration phenomenon. Therefore, in this study, we developed a two-phase flow model considering the mechanical damage model in order to simulate the gas migration in the engineered barrier system, and validated with 1D gas flow modelling through saturated bentonite under constant volume boundary conditions. As a result of numerical analysis, the rapid increase in pore water pressure, stress, and gas outflow could be simulated when the dilation flow was occurred.

• Journal of fish pathology
• /
• v.32 no.1
• /
• pp.37-43
• /
• 2019

Due to the rapid global expansion of aquaculture industry during the past decades, production volume of aquatic organisms has accordingly grown. This has been accompanied by a rise in the incidence of diseases in aquatic organisms, leading to an increased use of aquatic medicines. While aquatic medicines are essential for the prevention and treatment of diseases of aquatic organisms, misuse can cause evolution of antibiotic-resistant bacteria and pose serious problems to the safety and hygiene of fisheries products. In this study, we surveyed and compared, by analyzing data compiled by all national control centers for aquatic animal diseases in South Korea, to estimate the amount of aquatic medicines sold in different regions between 2012 through 2015. Since we also examined the marketing routes of aquatic medicines, this basic data can be utilized for policy implementation to improve drug safety. In the future research, however, it will be clearly necessary to estimate directly the amounts of drugs actually applied to aquaculture organisms. The current sales figure data should be helpful for preparation of an effective system for aquatic drug use management.

• Asian-Australasian Journal of Animal Sciences
• /
• v.32 no.6
• /
• pp.792-799
• /
• 2019

Objective: This study was conducted to evaluate whether the co-injection of antioxidants together with foot-and-mouth disease (FMD) vaccination has the potential to attenuate the negative effects caused by vaccination in Holstein finishing steers. Methods: A total of 36 finishing Holstein steers (body weight [BW]: $608{\pm}45.6kg$, 17 months old) were randomly allocated to one of three treatments: i) control (CON, only FMD vaccination without any co-injection), ii) co-injection of commercial non-steroidal anti-inflammatory drugs (NSAID) with FMD vaccination at a ratio of 10:1 (NSAID vol/FMD vaccine vol) as a positive control (PCON), iii) co-injection of commercial mixture of vitamin E and selenium with FMD vaccination (VITESEL) (1 mL of FMD vaccine+1 mL of antioxidants per 90 kg of BW). Changes in growth performance and blood parameters because of treatments were determined. Results: No significant difference in BW, average daily gain, and dry matter intake of the steers was observed among the treatments. The FMD vaccination significantly increased white blood cells (WBC), neutrophils, platelets, and mean platelet volume (p<0.01) in blood analysis. The count of lymphocyte tended to increase after vaccination (p = 0.08). In blood analysis, steers in VITESEL tended to have higher numbers of WBC, neutrophils, and platelets compared to that of other treatments (p = 0.09, 0.06, and 0.09, respectively). Eosinophils in VITESEL were higher than those in PCON (p<0.01). Among blood metabolites, blood urea nitrogen and aspartate transaminase were significantly increased, but cholesterol, alanine transferase, inorganic phosphorus, Mg, and albumin were decreased after FMD vaccination (p<0.01). Conclusion: The use of antioxidants in FMD vaccination did not attenuate growth disturbance because of FMD vaccination. The metabolic changes induced by vaccination were not controlled by the administration of antioxidants. The protective function of antioxidants was effective mainly on the cell counts of leukocytes.

• Economic and Environmental Geology
• /
• v.53 no.6
• /
• pp.755-769
• /
• 2020

In 2019, about 134 million ㎥ of aggregate was produced in an estimated 880 quarries and pits in 17 metropolitan governments. Leading producing metropolitan cities were Gyeonggi-do, Gyeongsangnam-do, Chungcheongbuk-do, Gangwon-do, Gyeongsangbuk- do, Chungcheongnam-do, in order decreasing volume, which together accounted for about 71% of total product. Of the total domestic aggregates produced in 2019, about 31 % was sand and about 69% was gravel. It estimated that of the 134 million ㎥ of aggregates in Korea in 2019, about 50.3% was produced by screening crushed aggregate by 41.4% by forest aggregate, 3.3% by land aggregate, 1.7% by sea aggregate and 1.7% by washing each other, and 0.7% by river aggregate. This indicates that screening crushed aggregate and forest aggregate are the main producers of domestic aggregates. The most crushed and forest aggregate was extracted at the Gyeonggi-do and Gyeongsangnam-do, respectively. Land aggregate was mainly extracted at Gyeongsangbuk-do and Gangwon-do. Therefore, in the future supply and demand of aggregate resources, it is judged that there should be a primary policy direction for screening crushed and forest aggregate.

• Journal of Korea Society of Waste Management
• /
• v.35 no.8
• /
• pp.744-753
• /
• 2018

The Stockholm Convention, which was adopted in Sweden in 2001 to protect human health and the environment, includes regulations for Persistent Organic Pollutant Rotors such as toxic and bioaccumulatives. Currently, there are 28 types of materials. This prohibits and limits the production, use, and manufacture of products. Korea is a member of the Convention, and it is necessary to prepare management and treatment plans to address the POP trends. Thus, we experimentally investigate whether the environmentally stable incineration is achieved when the sample is thermally treated using the Lab-scale (1 kg/hr). The target samples is pesticides in liquid phase and solid phase. In this study, organic chlorinated pesticides and their thermal characteristics were analyzed. We calculated the theoretical air volume based on the element analysis results. Because the interior of the reactor is small, more than 10 times of the air ratio was injected. The retention time was set to at least 4 seconds using a margin. The incineration temperature was $850^{\circ}C$ and $1100^{\circ}C$. Thus, we experimentally investigated whether the environmentally stable incineration was achieved when the sample was thermally treated using the Lab-scale (1 kg/hr). We analyzed five types of exhaust gas; the 02 concentration was high, but the CO amount decreased. Complete combustion is difficult because of the small size of the furnace due to the nature of Lab-scale. The organic chlorine-containing pesticide had an average decomposition rate of 99.9935%. Considering the decomposition rates of organic chlorine-containing pesticide in this study, the incineration treatment at over 2 ton/hour, which is typical for a conventional incinerator, is possible. Considering the occurrence of dioxins and unintentional persistent organic pollutants, it can operate at more than $1,100^{\circ}C$.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.24 no.1
• /
• pp.112-125
• /
• 2021

Marine spatial planning(MSP) designates the marine as nine kinds of use zones for the systematic and rational management of marine spaces. One of them is the fishery protection zone, which is necessary for the sustainable production of fishery products, including the protection and fosterage of fishing activities. This study intends to quantitatively identify the fishing activity space, one of the elements necessary for the designation of fisheries protection zones, by mapping of fishery activities using V-Pass data and deriving the fishery activity concentrated zone. To this end, pre-processing of V-Pass data was performed, such as constructing a dataset that combines static and dynamic information, calculating the speed of fishing vessels, extracting fishing activity points, and removing data in non-fishing activity zone. Finally, using the selected V-Pass point data, a fishery activity map was made by kernel density estimation, and the concentrated space of fishery activity was analyzed. In addition, it was confirmed that there is a difference in the spatial distribution of fishing activities according to the type of fishing vessel and the season. The pre-processing technique of large volume V-Pass data and the mapping method of fishing activities performed through this study are expected to contribute to the study of spatial characteristics evaluation of fishing activities in the future.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.46 no.4
• /
• pp.349-360
• /
• 2020

Bio-conversion manufacturing technology has been developed to produce ginsenoside Rd which is increasingly in demand as a cosmetic material due to various possibilities related to improving skin function. In order to convert ginsenoside Rb1 which is contained in red ginseng saponin (RGS) into Rd, several commercial enzymes were tested. Viscoflow MG was found to be the most efficient. In order to optimize the conversion of RGS to ginsenoside Rd by enzymatic transition was carried out using response surface methodology (RSM) based on Box-Behnken design (BBD). The main independent variables were RGS concentration, enzyme concentration, and reaction time. Conversion of ginsenoside Rd was performed under 17 conditions selected according to BBD model and optimization conditions were analyzed. The concentration of the converted ginsenoside Rd ranged from 0.3113 g/L to 0.5277 g/L, and the highest production volume was obtained under condition of reacting 2% RGS and 1.25% enzyme for 13.5 hours. Consequently, RGS concentration, enzyme concentration which is 0.05 less than p-value and among the interactions between the independent variables, the interaction between enzyme concentration and reaction time was confirmed to be the most influential.