• Journal of the Korean earth science society
• /
• v.38 no.2
• /
• pp.161-171
• /
• 2017

Observed ground motions are composed of three factors such as, seismic source, attenuation, and site amplification effect. Among them, the site amplification characteristics should be considered significantly when estimating seismic source and attenuation characteristics with more confidence. The site effect is also necessary when estimating not only seismic hazard in seismic design engineering but also rock mechanical properties. This study uses the method of H/V spectral ratio of observed ground motion between target site and reference site called a reference site method. In addition to using the vertical Fourier spectrum of the reference site, we try out the horizontal Fourier spectrum as a new method in this study. We analyze H/V spectral ratio of six ground motions respectively, observed at four sites close to Yedang Reservoir. We then compare site amplification effects at each site using 3 kinds of seismic energies including S waves, Coda waves energy, and background noise. The results suggest that each site showed similar site amplification patterns in S waves and Coda waves energy. However, the site amplification of background noise shows much different characteristics from those of S waves and Coda wave energy, which suggests that the background noises at each site have their own developing mechanism. Each station shows its own characteristics of specific resonance frequency and site amplification properties in low, high and specific resonance frequency ranges. Comparison of the method used in this study to the others that used different methods can provide us with more information about the dynamic amplification of a site characteristics and site classification.

• Journal of Positioning, Navigation, and Timing
• /
• v.6 no.3
• /
• pp.125-133
• /
• 2017

Time comparison is necessary for the verification and synchronization of the clock. Two-way satellite time and frequency (TWSTFT) is a method for time comparison over long distances. This method includes errors such as atmospheric effects, satellite motion, and environmental conditions. Ionospheric delay is one of the significant time comparison error in case of the carrier-phase TWSTFT (TWCP). Global Ionosphere Map (GIM) from Center for Orbit Determination in Europe (CODE) is used to compare with Bernese. Thin shell model of the ionosphere is used for the calculation of the Ionosphere Pierce Point (IPP) between stations and a GEO satellite. Korea Research Institute of Standards and Science (KRISS) and Koganei (KGNI) stations are used, and the analysis is conducted at 29 January 2017. Vertical Total Electron Content (VTEC) which is generated by Bernese at the latitude and longitude of the receiver by processing a Receiver Independent Exchange (RINEX) observation file that is generated from the receiver has demonstrated adequacy by showing similar variation trends with the CODE GIM. Bernese also has showed the capability to produce high resolution IONosphere map EXchange (IONEX) data compared to the CODE GIM. At each station IPP, VTEC difference in two stations showed absolute maximum 3.3 and 2.3 Total Electron Content Unit (TECU) in Bernese and GIM, respectively. The ionospheric delay of the TWCP has showed maximum 5.69 and 2.54 ps from Bernese and CODE GIM, respectively. Bernese could correct up to 6.29 ps in ionospheric delay rather than using CODE GIM. The peak-to-peak value of the ionospheric delay for TWCP in Bernese is about 10 ps, and this has to be eliminated to get high precision TWCP results. The $10^{-16}$ level uncertainty of atomic clock corresponds to 10 ps for 1 day averaging time, so time synchronization performance needs less than 10 ps. Current time synchronization of a satellite and ground station is about 2 ns level, but the smaller required performance, like less than 1 ns, the better. In this perspective, since the ionospheric delay could exceed over 100 ps in a long baseline different from this short baseline case, the elimination of the ionospheric delay is thought to be important for more high precision time synchronization of a satellite and ground station. This paper showed detailed method how to eliminate ionospheric delay for TWCP, and a specific case is applied by using this technique. Anyone could apply this method to establish high precision TWCP capability, and it is possible to use other software such as GIPSYOASIS and GPSTk. This TWCP could be applied in the high precision atomic clocks and used in the ground stations of the future domestic satellite navigation system.

• Korean Journal of Applied Biomechanics
• /
• v.26 no.2
• /
• pp.161-166
• /
• 2016

Objective: The purpose of this study was to determine the knee and ankle joint kinematics and kinetics by comparing downhill walking with valley-shape combined slope walking. Method: Eighteen healthy men participated in this study. A three-dimensional motion capture system equipped with eight infrared cameras and a synchronized force plate, which was embedded in the sloped walkway, was used. Obtained kinematic and kinetic parameters were compared using paired two-tailed Student's t-tests at a significance level of 0.05. Results: The knee flexion angle after the mid-stance phase, the mean peak knee flexion angle in the early swing phase, and the ankle mean peak dorsiflexion angle were greater during downhill walking compared with valley-shape combined slope walking (p < 0.001). Both the mean peak vertical ground reaction force (GRF) in the early stance phase and late stance phase during downhill walking were smaller than those values during valley-shape combined slope walking. (p = 0.007 and p < 0.001, respectively). The mean peak anterior GRF, appearing right after toe-off during downhill walking, was also smaller than that of valley-shape combined slope walking (p = 0.002). The mean peak knee extension moment and ankle plantar flexion moment in late stance phase during downhill walking were significantly smaller than those of valley-shape combined slope walking (p = 0.002 and p = 0.015, respectively). Conclusion: These results suggest that gait strategy was modified during valley-shape combined slope walking when compared with continuous downhill walking in order to gain the propulsion for lifting the body up the incline for foot clearance.

• Journal of the Korean earth science society
• /
• v.30 no.7
• /
• pp.810-823
• /
• 2009

One of the critical factors in accurate determination of earthquake source parameters, and in prediction of seismic hazards is the detailed information related to the site amplification characteristics. The site amplification characteristics of the broad-band seismic stations in Korea were estimated as a function of frequency in the range of 0.2 to 20 Hz. A total of 1275 seismograms recorded from 43 earthquakes observed from 2003 to 2008 in the southern Korean Peninsula were used. It was found that the site amplification ratios for 28 stations estimated from the inversion of the ground motion model were approximately concordant with those obtained from the horizontal-to-vertical (H/V) spectral ratio except for some stations. The spectral site amplification characteristics obtained in this study did not show any considerable spatial distribution. It revealed to be largely correlated with the degree of weathering rather than the basement rock type. Considering the spectral site amplification ratio, 28 broad-band stations were classified into four groups and the characteristics of each group were described in the text.

• Korean Journal of Applied Biomechanics
• /
• v.15 no.1
• /
• pp.127-142
• /
• 2005

The purpose of this study was to analysis biomechanics of the lower extremities injury the heights(40cm, 60cm, 80cm) of jump box as performed depth jump motion by 6 females aerobic athletes and 6 non-experience females students. The event of depth jump were set to be drop, landing and jump. The depth jump motions on the force plate were filmed using a digital video cameras, and data were collected through the cinematography and force plate. On the basis of the results analyzed, the conclusions were drawn as follows: 1. The landing time of skill group was shorter than unskill group at 40cm, 60cm drop height during drop-landing-jump phase especially. The landing time of 60cm drop height was significant between two group(p<.05). 2. The peak GRF of sagittal and frontaI direction following drop height improve was variety pattern and the peak vertical force of 40cm drop height was significantly(p<.05). 3. The magnitude of peak passive force was not increase to change the drop height. 4. The peak passive forces was significant at 40cm drop height between two groups(p<.05)

• Journal of the Korean Society of Physical Medicine
• /
• v.8 no.1
• /
• pp.49-58
• /
• 2013

PURPOSE: The purpose of this study was to determine if auditory cues velocity has a greater effect on the gait pattern of patients with Parkinson's disease (PD) than the cues applied individually. METHODS: The subjects were 15 elderly patients diagnosed with PD, 15 healthy elderly persons. Patients were measured of three conditions performed in random order: slow, general, fast. The auditory cue velocity consisted of a metronome beat ${\pm}20%$ than the subject's general gait speed. Using a motion analysis and a force platform measurement system, changes in spatiotemporal variables, kinetic and kinematic variables were compared to gait analysis. RESULTS: Comparison between the auditory cues velocity, there was a significant difference in the spatiotemporal variables with regard to the cadence, stride length, support time, step length, double support time (p<.05). Comparison between the auditory cues velocity, there was a significant increase general and fast velocity gait than slow velocity gait in the maximum flexion in swing phase of knee joint (p<.05). There appears to be the aspect of an increasing ground reaction force (GRF) on the first peak in the vertical axis (p<.05). CONCLUSION: Auditory cues velocity improved of spatio-temporal factors, kinematic and kinetic factors depending on the velocity of the faster. Therefore at the rehabilitation training of PD patients auditory cues velocity would be used for recovery and gait reeducation, may arise through the patients functional ability.

• Korean Journal of Applied Biomechanics
• /
• v.20 no.3
• /
• pp.267-275
• /
• 2010

The purpose of this study was to investigate the effects of balance ability improvement exercise program which applied to the elderly people for increasing balance, stability and range of motion. Ten elderly people and ten university students were recruited as the subjects. Kinematic data were collected by seven real-time infrared cameras while subjects walk stair descent as a pre-test. Korean folk dance exercise program was applied to the elderly for 12 weeks. Same experiment on stair descent walk was performed as post-test. Results indicated that CM movement and selected joint angle patterns of elderly group after treatment changed to the similar patterns of young group. However, ankle joint angle and vertical GRF of elderly group after treatment also increased compared to those of the elderly group before treatment. This might be explained by the fact that elderly used a different walking strategy which maximize support base for increasing stability. Overall, these results indicated that the exercise treatment may affect to adapt and improve the gait pattern of stair descent of elderly people.

• Journal of Biosystems Engineering
• /
• v.30 no.6 s.113
• /
• pp.366-372
• /
• 2005

The objective of this study was to evaluate the bump crossing and loading stability of a proto-type mini-forwarder under development. The evaluation was performed by computer simulation using a multi-body dynamic analysis program, Recur- Dyn 5.21. The proto-type was modeled and its properties such as mass, mass center, and mass moment of inertia were determined using 3D CAD modeler, Solid Edge 8.0. The $\%$ errors of masses, mass center, mass moment of inertia, and vertical motion of the model were within less than $10\%$ and the model's behavior agreed relatively well with those of the proto-type when traversing over a rectangular bump. Using the validated model, bump crossing of the proto-type was simulated and the loading limit was determined. It was found that effects of the shapes of bump on the bump crossing performance was insignificant within the practical heights of bumps. Stability of bump crossing increased with loading. However, loading of longer logs than 2.7 m made the crossing unstable because the ends of logs contacted ground when traversing over the bump. The maximum loading capacity of the proto-type was estimated to be 7.8 kN of 2.7 m long logs.

• Korean Journal of Applied Biomechanics
• /
• v.16 no.2
• /
• pp.25-35
• /
• 2006

The purpose of this study was to investigate the shock attenuation mechanisms while varying the loads in a backpack during drop landing. Ten subjects (age: $22.8{\pm}3.6$, height: $173.5{\pm}4.3$, weight: $70.4{\pm}5.2$) performed drop landing under five varying loads (0, 5kg. 10kg. 20kg. 30kg). By employing two cameras (Sony VX2100) the following kinematic variables (phase time, joint rotational angle and velocity of ankle, knee and hip) were calculated by applying 2D motion analysis. Additional data, i.e. max vertical ground force (VGRF) and acceleration, was acquired by using two AMTI Force plates and a Noraxon Inline Accelerometer Sensor. Through analysing the power spectrum density (PSD), drop landing patterns were classified into four groups and each group was discovered to have a different shock attenuation mechanism. The first pattern that appeared at landing was that the right leg absorbed most of the shock attenuation. The second pattern to appear was that subject quickly transferred the load from the right leg to the left leg as quickly as possible. Thus, this illustrated that two shock attenuation mechanisms occurred during drop landing under varying load conditions.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.14 no.6
• /
• pp.67-74
• /
• 2010

Because of the difference between the actual and computed eccentricity of buildings, symmetrical buildings will be affected by torsion. In provisions, accidental eccentricity is intended to cover the effect of several factors, such as unfavorable distributions of dead- and live-load masses and the rotational component of ground motion about a vertical axis. The torsional amplification factor is introduced to reduce the vulnerability of torsionally imbalanced buildings. The effect of the torsional amplification factor is observed for a symmetric rectangular building with various aspect ratios, where the seismic-force-resisting elements are positioned at a variable distance from the geometrical center in each direction. For verifying the torsional amplification factor in provisions, nonlinear reinforced concrete models with various eccentricities and aspect ratios are used in rock. The difference between the maximum displacements of the flexible edge obtained between using nonlinear static and time-history analysis is very small but the difference between the maximum torsional angles is large.