• Journal of Korean Society of Water and Wastewater
• /
• v.9 no.4
• /
• pp.73-86
• /
• 1995

The propriety of the numerical model application was examined on Paldang resevoir and its inflow tributaries located in the center of the Korean peninsula and the long term water quality forecast of the oxygen profile was carried out in this syduy. The input data of the model was the capacity of the reservoir, catchment area, percolation, diffusion rate, vertical mixing rate, dissolution rate from the bottom of the reservoir, outflow of the resevoir, water quality measurement and meteorology data of the drainage basin, and the output result was the annual estimation value of the dissolved oxygen concentration and the biochemical oxygen demand. The modeling method is based on the measured or calculated boundary condition dividing the water area into several blocks from the macorscopic aspect and considering the mass balance in these blocks. As the result of the water quality forecast, it was expected that the water quality in Northern Han River and Paldang reservoir would maintain the recent level, but that the water quality in the Southern Han River and its inflow tributary would worsen below the grade 4 of the life environmental standard from around 2000 owing to the decrease of DO concentration and the increase of BOD concentration.

• Journal of KIISE:Information Networking
• /
• v.36 no.1
• /
• pp.43-49
• /
• 2009

The Mobile IPv6(MIPv6) has a well-known time gap of packet loss between link down and binding update. To minimize such packet loss, this paper proposes a MIPv6-based dual tunneling mechanism, which keeps exploiting the old tunnel while creating a new tunnel. Superiority of the proposed mechanism is evaluated by quantitative analysis on the lost packets and computer simulation, based on two overlay heterogeneous access networks, such as the UMTS and a WLAN.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 1995.10a
• /
• pp.466-469
• /
• 1995

This paper presents a design and performance of the 6 D.O.F linear motion table with a magnetic bearing suspension. The linear positioning of the table with a 150mm stroke is driven by a brushless DC Linear motor and the other attitudes of the stage are controlled by the analog PD controller with magnetic bearing actuators. Each magnetic bearing unit which consists of 3 electromagnets, 3 capacitance probes and 3 backup bearings affords controlled forces by detecting the air gap between the probes and guideways. An integral type capacitance probe amplifier is equipped on the upper plate of the table so that the probe line to the probe amplifier can be shorter therefore the problems due to the stray capacitance and noise can be reduced. Form the pitch-yaw errormeasured by the autocollimator, the vertical and horizont straightness errors of the table are derived that they are maintained below 1.mu. m over 100mm stroke. The positioning accuracy of the linear motion is maintained below 2 .mu. m and the repeatability error is below 1 .mu. m

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.6
• /
• pp.8-14
• /
• 2005

Understanding of the flow past a bluff body close to a moving ground is very important in automobile and aeronautical fields because of aerodynamic characteristic and instability induced by unsteady vortex shedding. The passive control method that mounted the vertical and horizontal plates at the lower surface of the cylinder is studied to suppress the unsteady oscillation motion. When the grounds moves, the diminish of the shear layer on the ground promotes the interaction between the lower and the upper separated shear layers of the cylinder, hence vortex shedding occurs at the lower gap height than the stationary ground.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.6
• /
• pp.465-471
• /
• 1998

Diamond-like carbon (DLC) films have been prepared by means of the plasma enhanced chemical vapor deposition (PECVD) method using vertical-capacitor electrodes. The deposition rata in our experiment is relatively small compared with that in the conventional PECVD methods, which implies that the accumulation of the neutral $CH_n$ radicals on the substrates due to the gravitational movement may not contribute to the deposition of DLC films. The hardness and the transparency were measured as a function of the ratio of the partial pressure of $CH_4-H_2$ mixtures or the hydrogen contents of specimens. The coefficients of friction between DLC films and a $Si_3N_4$ tip measured by using a lateral force microscope are in the range of 0.024 to 0.033 which depend on the hydrogen contents in DLC, and the surface roughness depends mainly on the deposition rate. The optical gaps increase with increasing the hydrogen contents. DCL films deposited on Pt-coated Si wafers show the stable emission characteristics, and the turn-on fields are in the range of 11 to 20 $V/\mu$m.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.13 no.4
• /
• pp.304-311
• /
• 2001

An experimental study on the countercurrent two-phase flow in narrow rectangular channels has been performed. The void fraction and the pressure gradient were investigated using air and water in 760 mm long, 100 mm wide. vertical test sections with 2, 3 and 5 mm channel gaps. Tests were systematically performed with downward liquid superficial velocities and upward gas velocities covering 0 to 0.08 and 0 to 2.5 m/s ranges. respectively. the experimental results were compared with the previous correlations, which were mainly for round tubes, and the qualitative trends were found to be in good agreements. However the quantitative discrepancies were hardly neglected. as the superficial gas velocities increased, the void fraction increased and the pressure gradient decreased, where the effects of the liquid superficial velocities were infinitesimal. as the gap width of the rectangular channel increased the void fraction and the 2-phase frictional pressure gradient approached those values for the round tubes. Equi-periphery diameter, rather than the hydraulic diameter, seemed to be more effective in the analysis of two-phase flow behavior.

• Journal of The Korean Association For Science Education
• /
• v.11 no.2
• /
• pp.119-131
• /
• 1991

A taxonomy which can be used conveniently for analyzing the vertical articulation of mathematics and science textbooks has been developed. It includes two types sanalysis criterion: one is based on the detail of description and the other is based on the depth of contents in terms of their sequence. These two criterion elements are combined to form groups of 'overlap', 'development' and 'gap' to represent the extent of articulation. Examples of applying the taxonomy are illustrated for the concepts of gemetrical area in mathematics and potential energy in science.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.972-975
• /
• 2003

We have performed computer simulation to obtain electro-optic characteristics of reflective hybrid aligned nematic liquid crystal displays driven by fringe field. The results show that the optimal retardation value of the cell is $0.289{\mu}m$, which allows for the cell to have a practical cell gap of larger than $3{\mu}m$ when manufacturing. A reflectance of the dark state is only 0.114% for an incident light 550nm. At this condition, the light efficiency of white state reaches 92.7%. Further, we have studied a new reflective display with polarizer, optical compensation with half plate, LC plus reflector. The display with optimized cell parameters shows low wavelength dispersion and the contrast ratio greater than 5 over exists about $120^{\circ}$ in vertical direction and $160^{\circ}$ in horizontal direction.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.23 no.2
• /
• pp.103-108
• /
• 2017

The amount of delivered parcels have been increasing according to the change and expansion of consumption pattern through e-commerce, and they are required to minimize breakout or failure under the delivery. In this study, we measured and analyzed the distribution environment data (vibration and impact) occurred in the packaging, which were prepared with 5 types by the weight and dimension, distributed from Seoul to Busan in Korea by 2 parcel delivery service companies through e-commerce order. Date showed the parcels had 3-5 times of drop impact and 0.3-0.7 m of drop height on average, and 0.8 Grms of vibration acceleration from equivalent equation to the vertical direction. The significant gap in service quality was not found between 2 parcel delivery service companies. This study is expected to be useful for designing the suitable packaging in order to enhance safe transportation of the delivered packaging, and furthermore useful for developing Korean testing method for Field-to-Lab simulation.

• Journal of Sensor Science and Technology
• /
• v.16 no.3
• /
• pp.197-201
• /
• 2007

The magnetron reactive ion etching (RIE) characteristics of polycrystalline (poly) 3C-SiC grown on $SiO_{2}$/Si substrate by APCVD were investigated. Poly 3C-SiC was etched by $CHF_{3}$ gas, which can form a polymer as a function of side wall protective layers, with additive $O_{2}$ and Ar gases. Especially, it was performed in magnetron RIE, which can etch SiC at a lower ion energy than a commercial RIE system. Stable etching was achieved at 70 W and the poly 3C-SiC was undamaged. The etch rate could be controlled from $20\;{\AA}/min$ to $400\;{\AA}/min$ by the manipulation of gas flow rates, chamber pressure, RF power, and electrode gap. The best vertical structure was improved by the addition of 40 % $O_{2}$ and 16 % Ar with the $CHF_{3}$ reactive gas. Therefore, poly 3C-SiC etched by magnetron RIE can expect to be applied to M/NEMS applications.