• 한국대기환경학회지
• /
• 제18권1호
• /
• pp.1-10
• /
• 2002

A three-dimensional numerical model which involved the nesting method was developed to reproduce the wind circulation of Kwangyang Bay area which comprises complicated mountains and sea topograph. The calculated results indicated geographical effects of Kwangyang Bay area, sea/land breezes and mount-valley wind which are local circular winds. We also noticed that the northern inland area of Kwangyang Bay formed the very complex wind systems under the influence of such geographic effects when a land breeze was not formed. A good agreement was found between predicted and observed values of temperature. In addition, the calculated results of the wind direction and the wind velocity are in accord with the observed values. They showed only a slight difference in between predicted and the observed values, when the sea breeze and the land breeze are changing.

• 설비공학논문집
• /
• 제10권1호
• /
• pp.1-10
• /
• 1998

A header is the device that makes uniform flow distribution in all branches from header of heat exchangers, pipe burner or chemical equipments. In this study, experimental tests have been performed in order to investigate the flow distribution characteristics in a straight header and tapered header which have 6 and 11 glass pipe branches. The experimental equipment consists of a water circulation system where the fluid velocity in each glass pipe is measured by Ar-ion LDV system. From the experiments and the theoretical equation, it could be recommended that tapered header should be determined so that its internal velocities inside the header become uniform according to taper of the header and number of attached branches for uniform flow distribution in energy systems.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2002년도 학술대회지
• /
• pp.311-312
• /
• 2002

In this paper a systematic design approach to determine the optimum size (height) of circulating fluidized bed heat exchanger for exhaust gas heat recovery is prososed. Unlike the convensional heat exchangers where the length of the heat exchanger section is not very much emphasized, the vertical length of heat exchanger tube in the case of fluidized bed heat exchangers is important because this length determines the time interval during which particles reside and transfer heat in the heat exchanger section. For particles initial conditions are nearly stationary, accelerating particles motion should be considered rather than simply assuming fully developed condition. A way to estimate optimum tube length at different fluid velocity and particle sizes is suggested based on the required conditioning time for heat transfer from the flue gas to solid particles.

• 한국해양학회지
• /
• 제16권1호
• /
• pp.1-11
• /
• 1981

The seasonal variations of surface current patterns in the Japan Sea were drawn out from the results of drift bottle experiments, current measurements and hydrographic observations during 1979∼1980. The North Korean Cold Current(NKCC) and the East Korean Warm Current(EKWC) were common features of circulation in the eastern sea of Korea. The intrusion of NKCC along the Korean coast became strong in summer(average velocity of 47.4cm/sec off Jumunjin and 23.4cm/sec near Jugbyeon) when the Tsushima Current was strong. But there was no indication of the NKCC in November 1979. Dynamic topography(August & November 1979) and satellite picture(November 1979) seemed to show the topographic steering of EKWC beginning off Janggigab. Drift bottles arrived at the Japaness coast were affected significantly by the strong Tsushima Current in summer and by the predominant northwesterlies in winter instead of weak current.

• 한국연초학회지
• /
• 제21권2호
• /
• pp.182-187
• /
• 1999

A bulk curing experiment was carried out to evaluate the effect of air flow reduction in the bulk barn from color fixing stage in the chemical properties of cured leaves, The air flow was controlled by reducing air velocity of a blower from 0.3m/sec to 0.2m/sec using a boltage regulator(Slidac). The bulk curing before color fixing stage was processed in the conventional curing method. Reduction of air circulation in bulk barn did not affected so much on change of the contents of the main chemical components in cured leaved, such as nicotine, total sugar, total nitrogen, petroleum ether extract, and organic acids. Only a slight increase in essential oil contents, such as solanone, damascenone, damascone, $\beta$-ionone, and megastigmatrienone isomer, could be observed in leaves cured in the reduced air flow.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2008년도 춘계학술대회논문집
• /
• pp.609-613
• /
• 2008

The fire whirl occurring by the instability of atmosphere is a rare phenomenon, but highly destructive because it has high inhalation and lift force, caused by the rotating velocity. And it is difficult to extinguish the fire, because of increment of the spread rate with the flame height. In this study, for investigation of the flow characteristic of fire whirl for various heat release rate, numerical analysis is performed in same conditions with experiments, using the FDS which is developed at NIST. For validating of the numerical study, the results are compared with the experiment. The result shows that the relation between the characteristic length and the ratio of circulation versus the buoyancy force is $z_f$/D$^{\ast}$ = 0.304(${\Omega}/{\alpha}$)^2 - 1.334${\Omega}/{\alpha}$ + 5.516.

• 한국관개배수논문집
• /
• 제17권2호
• /
• pp.49-56
• /
• 2010

This study was carried out to survey for morphological change of lower tidal flat near Byunsan-Gosapo beach using single-beam echosounder and sound velocity profiler. Since October 2009 in the center of the region, the erosion occurred about 10~50cm, while either side of the study area is little change. Erosion occurred at the beach, each beach area in the southwest area rather than further accumulation occurred sandbank formed. Observed in the study area near the center of the erosion is the result of ongoing changes that were temporarily due to seasonal changes is not clear. However, the northwestward waves were expected to be a major source of erosion. Because of this, continue to observe the terrain and the local ocean circulation studies will be required.

• 소성∙가공
• /
• 제16권4호
• /
• pp.260-265
• /
• 2007

Rubber compounds have high viscoelastic property. One of the viscoelastic behaviors during profile extrusion is the swelling of extrudate. In this study, die swells of rubber compounds at the capillary die have been investigated through experiment and computer simulation. Experiments and simulations have been performed using fluidity tester and commercial CFD code, Polyflow respectively. Die swells of rubber compounds in a capillary die were predicted using non-linear differential viscoelastic model, Phan-Thien-Tanner(PTT) model for various relaxation times and relaxation modes. The results of simulation were compared with the experiments. Pressure and velocity distribution, and circulation flows at the comer of capillary die have been investigated through computer simulation. It is concluded that the PTT model successfully represented the amount of the die swell of rubber compounds for various relaxation times at different modes.

• 한국가시화정보학회지
• /
• 제4권2호
• /
• pp.76-80
• /
• 2006

The data for friction factor of the pipe correlated by Reynolds number and relative roughness have been reported well as a Moody chart. However, the results for corrugated shapes have been not investigated sufficiently. In this research, therefore, the pressure drop and friction factor are obtained. Flexible metal tubes with corrugations for the measurement are made of stainless steel plates. The kinds of tubes for the measurement are 5 annular types and helical types. The pressure drop & the velocity of the flow are obtained by micromanometer & digital pressure sensor, supplying dry air at several steps. Then the pressure drop is calculated for each tube, using the obtained data. The result shows that the pressure drop is strongly influenced by the viscous dissipation of kinetic energy due to the circulation of flows, rather than a viscous friction loss. The pressure drop increased consistently as the Reynolds number increases.

• 대한토목학회논문집
• /
• 제11권2호
• /
• pp.27-37
• /
• 1991

음부력을 갖는 유체가 소규모 저수지로 유입되어 일어나는 밀도류의 거동 및 순환이 차원해석과 수리실험을 이용하여 해석된다. 무차원침강점 및 밀도류전면속도, 밀도류전면이동거리, 머리 뒤의 밀도층내회석 등은 유입밀도후르드수, Fre의 영향을 받으며 밀도층의 두께, 흐름양상 및 저수지내 밀도의 변화는 밀도류전면이 하류단에 도달하여 반사되기 전과 후의 양상이 현저하게 다르다. 밀도층의 두께는 전자의 경우에는 Fre, 후자의 경우는 시간과 Fre의 영향을 받으며 이들은 지수식으로 표현할 수 있다.