• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.13 no.3
• /
• pp.96-106
• /
• 2014

Necessarily traffic policies have been biased in car than pedestrian, so pedestrian's environment is getting worse. Result of this situation our accident rate is high as 36.4%, compared to OECD member countries with average rate of 17.8%(in 2009). Increasing interest for pedestrians environment improvement, and it make an effort to build environment to guarantee walk and safety of pedestrians. Analysis on the binary logistic regression(BLR) was used. The dependent variable is occurring from the road width of less than 9m accident, and independent variable extracted can be obtained from the traffic accident data. Traffic accident on roads having width of less than 9 meters affecting variables is when the driver is straight, when the driver is female, when the pedestrian is walk driveway, and so on. To prevent it, efforts is demanded to protect handicapped, to build safe pedestrians environment using C-ITS and to decrease speed of going straight vehicle on roads having width of less than 9 meters.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.2
• /
• pp.627-635
• /
• 2014

Currently the highest speed limit on the road traffic congestion or because you can not cope with climate change to cause a traffic accident may be a factor. According to the Road Traffic Act as well as 20% to 50% in case of inclement weather, but the driver must slow speed left to the judgment of the difficulties, and to slow the vehicle and the relative velocity between the vehicle does not run longer be a big influence on the environment and safety. Thus, variable speed control for drivers on the road, specify the appropriate maximum speed limit in bad weather It keeps motorists slowed the run rate to prevent accidents or reduce the severity of accident damage is expected to be possible. The purpose of this study is the frequent traffic accidents Continuous Busan (City Freeway) around the variable speed control in the appropriate sections so that it can be done by analyzing the characteristics of traffic accidents were the severity of the accident. Highway and urban environment, the geometry of the structure because it has a lot of Curved planar point compared to wet and dry road surfaces by simulated rain wet had bom the more the speed the greater the risk of an accident was the result. Based on these results, the primary section, first urban highway tunnel, near the lamp, near Toll Plaza, near binary Outlet after considering various factors such as speed reduction is needed in the first period by conducting awareness and recognize the need for the participation of the driver and the future city installation and operation of highways in all sectors is expected to be expanded.

• Journal of Korean Society of Disaster and Security
• /
• v.16 no.2
• /
• pp.75-83
• /
• 2023

In general, bridges are facilities installed for the purpose of easily passing through sections such as valleys and rivers. Railway bridges that run through downtown areas are damaged due to external factors such as earthquakes and collisions with passing vehicles, resulting in serious human casualties. This can cause serious human and properties damage, such as functional paralysis in downtown areas. Depending on the degree of damage, repair work such as partial repair or full replacement is in progress for the bridge where the collision occurred. When damage or deformation occurs due to collision, the repair method is determined according to the degree of deformation and the degree to which the load capacity of the bridge is affected by the deformation. In this study, a numerical analysis review was performed on the repair work for the local deformation caused by the collision of a vehicle on an old railway bridge installed and in operation in an urban area. To this end, a structural safety review of the bridge for local deformations caused by vehicle collisions was conducted. In this paper, a repair method for the accident bridge was presented based on the analysis results.

• Aerospace Engineering and Technology
• /
• v.4 no.2
• /
• pp.163-170
• /
• 2005

According to the KSLV program of KARI, it is planed to develop various launch vehicle and satellite 10 years hereafter. Large-scale test facilities, such as ReTF and PTA-II, are needed to fulfill this launch vehicle/satellite development project. The authors intend to arrange and describe various indexes that are needed in test facility design, construction and operation process. This technical paper is describing model analysis of damage prediction of accident in KSLV Integrated Propulsion System Test Facility based on propellant storage quantity and layout. In addition, the result can be used to produce safer design of test facility.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.3
• /
• pp.240-245
• /
• 2006

Recently, as the road capacity reaches the limit and environmental problems becomes serious, there is gradually increased a need for railroad vehicles that are environment-friendly and have time regularity, reliability, and safety. Accordingly, in addition to conventional railroad vehicles, lots of vehicles are being newly developed. In this study, temperature sensors were adhered to transformer that is used in KHST(Korean High-Speed Train) to verify variation of temperature characteristics about transformer synthetically and efficiently. In the case that temperature of transformer exceeds reference temperature for running of KHST, overheating of transformer may cause a fatal accident of vehicle. Therefore, after on-line measuring system was constructed in vehicle, oil temperature and tank temperature were measured on real-time. Characteristics and main specifications of transformer in KHST were described in this paper. Also, measuring system for temperature measurement of transformer was explained in brief. Temperature data of transformer was acquired using measuring system, KRRI(Korea Railroad Research Institute) analyzed characteristic in contrast with comparing with temperature of transformer about month, running speed and running time.

• International Journal of Highway Engineering
• /
• v.18 no.5
• /
• pp.105-115
• /
• 2016

PURPOSES : This study was initiated to analyze the characteristics of bus traffic accidents, by bus types, using the decision tree in order to establish customized safety alternatives by bus types, including the intra-city bus, rural area bus, and inter-city bus. METHODS : In this study, the major elements involved in bus traffic accidents were identified using decision trees and CHAID algorithm. The decision tree was used to identify the characteristics of major elements influencing bus traffic accidents. In addition, the CHAID algorithm was applied to branch the decision trees. RESULTS : The number of casualties and severe injuries are high in bus accidents involving pedestrians, bicycles, motorcycles, etc. In the case of light injury caused by bus accidents, different results are found. In the case of intra-city bus accidents, the probability of light injury is of 77.2% when boarding a non-owned car and breaching of duty to drive safely are involved. In the case of rural area bus accidents, the elements showing the highest probability of light injury are boarding an owned car, vehicle-to-vehicle accidents, and breaching of duty to drive safely. In the case of intra-city bus accidents, boarding owned car, streets, and vehicle-to-vehicle accidents work as the critical elements. CONCLUSIONS : In this study, the bus accident data were categorized by bus types, and then the influential elements were identified using decision trees. As a result, the characteristics of bus accidents were found to be different depending on bus types. The findings in this study are expected to be utilized in establishing effective alternatives to reduce bus accidents.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.5
• /
• pp.90-102
• /
• 2022

Currently, in our society with a substantial and increasing fraction of the elderly population, transport safety for elderly drivers is becoming the center of attention. However, deficient data on vehicle crashes in South Korea limits the growth of traffic accident research pertaining to the country. So, we complemented South Korean vehicle crash data by examining USA vehicle crash data, especially the data of Ohio State, and analyzing the influential factors of elderly driver-involved crashes of the State. Subsequently, we suggested a way of improving the South Korean dataset. Notably, our study showed that the influential factors were vehicle speed, posted speed, and following other vehicles too close and provided them in the South Korean dataset.

• International Journal of Highway Engineering
• /
• v.18 no.5
• /
• pp.63-73
• /
• 2016

PURPOSES : The objective of this study was to analyze variations in the vehicle driving behavior characteristics on signalized intersections according to the use of traffic enforcement camera (red light camera). METHODS : In order to analyze the driving behavior characteristics on signalized intersections when red light camera are installed, the target sites for investigation were selected depending on whether the red light camera is installed and accident rates increased after the installation. In particular, to analyze the characteristics of dilemma zones in signalized intersections, approach speed and deceleration speed of 3 type vehicles (passing vehicles during a yellow light, stopping at a yellow light, passing vehicles during a green light) were examined. Based on these data, the starting point, ending point, and distance of the dilemma zones were calculated. Also, the locations of increased traffic accidents and decreased accidents after the installation of the equipment were distinguished when analyzing the traffic accident characteristics. RESULTS : Analysis results revealed that there was a tendency for the dilemma zone distance to decrease after the installation of equipment(red light camera) in most sites. This tendency was found to be due to the decrease in the approaching speed of vehicles at intersections after the installation of equipment, resulting in the starting and ending points of dilemma zone to become closer to the stop line. Moreover, analysis showed that the number of traffic accidents decreased for most intersections after the installation of equipment and safety of the intersections increased somewhat. CONCLUSIONS : In general, installation of equipment(red light camera) caused the intersections approaching speed and dilemma zone distance to decrease. Decision-making is difficult for drivers in the dilemma zone, so the decrease in the dilemma zone distance implies an improvement in traffic safety. Furthermore, the number of accidents within intersections significantly decreased after the equipment was installed, leading to the conclusion that installation of the equipment affected the decrease in traffic accidents.

• Journal of Digital Convergence
• /
• v.19 no.10
• /
• pp.241-246
• /
• 2021

Although there have been many studies on laws and systems for the proliferation of autonomous vehicles, studies on the activation of autonomous vehicles from a strategic perspective are insufficient. This study examines the issues and problem solving methods of autonomous vehicles. Based on this, plans to activate autonomous vehicles from a strategic point of view are proposed. In order to solve the issues and problems of autonomous vehicles, it is necessary to clearly establish legal and institutional standards based on the reinforcement of the safety of autonomous vehicles. In the event of a traffic accident, who is responsible for the accident and responsibility for compensation should be prioritized. Diffusion strategies are established according to the level of autonomous driving for the activation of autonomous vehicles in strategic perspective. In addition, governmental support policies should be used as triggers for initial activation, and marketing mix strategies should be implemented based on segmentation, targeting, and positioning strategies.

• Journal of Convergence for Information Technology
• /
• v.10 no.5
• /
• pp.111-116
• /
• 2020

Recently, many safety accidents involving children shuttle buses take place. Without a teacher for help, a safety accident occurs when the driver can't see a child who is getting off in the blind spot of both frontside and backside. A deep learning-based smart mirror allows user authentication and provides various services. Especially, It can be a role of helper for children, and prevent accidents that can occur when drivers or assistant teachers do not see them. User authentication is carried out with children's face registered in advance. Safety accidents can be prevented by an approximate sensor and a camera in frontside and backside of the bus. This study suggests a way of checking out whether children are missed in the process of getting in and out of the bus, designs a system that reduce blind spots in the front and back of the vehicle, and builds a safety system that provide various services using GPS.